纳米Zn-Co铁氧体的固相合成及电磁损耗特性研究

采用NH₄HCO₃与FeCl₃·6H₂O，Zn(NO₃)₂·6H₂O，Co(NO₃)₂·6H₂O进行室温固相反应制得前驱物，经微波加热处理后，进而热分解分别制得复合氧化物ZnFe₂O₄、CoFe₂O₄和Co_0.5Zn_0.5Fe₂O₄。由激光粒度分析仪、XRD和SEM表征：获得了颗粒分布比较均一、平均粒度为65 nm左右、立方晶系尖晶石结构的纳米铁氧体粉体。经测试样品的相对介电常数和相对磁导率后，研究了它们的电磁损耗特性。结果表明：Co_0.5Zn_0.5Fe₂O₄在100～1 800 MHz内比另外两种铁氧体具有更好的电磁损耗特性。     

Comparison of chemical properties of food products processed by conventional and ohmic heating

The effect of ohmic and conventional heat processing of different food products on their chemical and physical parameters was studied. Depending on the food being analysed, parameters such as pH, total solids, ash, titratable acidity, ascorbic acid, total sugars, total fatty acids, total phenolic compounds, and anthocyanins content were determined before and after ohmic and conventional pasteurization techniques and the results were compared using one-way analysis of variance. In goat milk samples treated by ohmic technology the pH value (6.58) and total fatty acids content in milk fat (86.5 mass %) were comparable to those found in milk treated by conventional process, however, ohmically treated samples presented a lower content of lactic acid, 0.13 %. In cloudberry jam samples treated by ohmic technology the results of some of the main parameters tested, such as total sugar content 46.1 mass %, ascorbic acid content 2.83 mass %, and titratable acidity 6.01 mass % (as citric acid) did not show significant differences when compared with samples treated by conventional technology. Presented at the 33rd International Conference of the Slovak Society of Chemical Engineering, Tatranské Matliare, 22–26 May 2006.     

A Dynamic Analysis and Numerical Simulation of Explosive Development of an Extratropical Cyclone Over Land

The present paper has made a dynamic and diagnostic study of the process of explosive deepening of an extratropical cyclone over North China on April 25-26, 1983, in order to gain an insight into the physical mechanism of explosive development of cyclone over land. It turns out that this cyclone occurred in the strong baroclinic zone, and the vorticity and thermal advection triggered the initial development of the cyclone. Subsequently, as the rainfall increased, the effect of condensational heating became more and more important. During the time period of rapid intensification (from 1200GMT 25 to 0000GMT 26 April, 1983, the central surface pressure fell down from 998. 2 to 988. 3 hPa), the peak of diabatic heating profile continuously descended, leading to a rapid increase in heating amount in the lower troposphere. This condition is favorable to the explosive development of rotational circulation or vortex. The numerical simulations have further demonstrated the importance of the lowering of heating p     

A novel approach to study the isothermal behaviour of substances after 0.01–1 s from the chemical process initiation

New modifications of a contact heater are suggested for investigating thermal decomposition processes, as well as for determining kinetic characteristics of substances under conditions of intense heating to a fixed constant temperature.

---

Zusammenfassung Zur Untersuchung von thermischen Zersetzungsprozessen und der Bestimmung der Reaktionskinetik von Substanzen bei intensivem Erhitzen auf vorgegebene konstante Temperaturen wird eine neue Abart von Kontakterhitzern beschrieben.

     

Heating rate effect on the DSC kinetics of oil shales

This research was aimed to investigate the combustion and kinetics of oil shale samples (Mengen and Himmetoğlu) by differential scanning calorimetry (DSC). Experiments were performed in air atmosphere up to 600°C at five different heating rates. The DSC curves clearly demonstrate distinct reaction regions in the oil shale samples studied. Reaction intervals, peak and burn-out temperatures of the oil shale samples are also determined. Arrhenius kinetic method was used to analyze the DSC data and it was observed that the activation energies of the samples are varied in the range of 22.4–127.3 kJ mol⁻¹ depending on the oil shale type and heating rate.     

Low-temperature synthesis of allyl dimethylamine by selective heating under microwave irradiation used for water treatment

Low-temperature synthesis of allyl dimethylamine (ADA) by selective heating under microwave irradiation (MI) used for water treatment is investigated. The effect of MI, ultrasound irradiation (UI) and conventional heating on yield of ADA, reaction time and the flocculation efficiency of polydiallyl dimethylammunion chloride (PDADMAC) prepared form ADA were studied. The results show that by selective heating at low temperature, MI not only increases yield of ADA and reduces reaction time, but also greatly enhances the flocculation efficiency of PDADMAC.     

柴油机烟碳的微波加热燃烧Ⅲ.铜催化剂的影响

柴油机烟碳的微波加热燃烧Ⅲ．铜催化剂的影响吕晓慧马建新李平朱兵刘士宁（华东理工大学工业催化研究所，上海２００２３７）方明刘毅庭（香港科技大学研究中心）关键词柴油机烟碳，微波加热，催化燃烧，铜催化剂作者在前文［１，２］研究了柴油机烟碳的微波加热燃...     

Zur Kenntnis der Hydrate M(HSeO3)2 · 4H2O (M = Mg,Co, Ni,Zn). Röntgenstrukturanalytische,schwingungsspektroskopische und thermoanalytische Untersuchungen

On the Hydrates M(HSeO₃)₂ · 4H₂O (M = Mg, Co, Ni, Zn) – Crystal Structures, IR, Raman, and Thermoanalytical Investigations From aqueous solutions of M(HSeO₃)₂ single crystals of Mg(HSeO₃)₂ · 4H₂O and of the hitherto unknown compounds Co(HSeO₃)₂ · 4H₂O, Ni(HSeO₃)₂ · 4H₂O and Zn(HSeO₃)₂ · 4H₂O could be obtained. The crystal structures, X-ray powder, IR, Raman and thermoanalytical (DTA, TG, Raman heating) data are presented and discussed. The crystal data of the isotypic compounds are: monoclinic, space group C2/c, Z = 4, Mg: a = 1 464.6(2), b = 755.3(1), c = 1 099.9(1) pm, β = 126.59(1)°, V = 0.9769(1) nm³, Co: a = 1 462.5(2), b = 756.5(2), c = 1 102.2(2) pm, β = 126.53(1)°, V = 0.9798(2) nm³, Ni: a = 1 452.2(2), b = 751.0(1), c = 1 091.5(1) pm, β = 126.28(1)°, V = 0.9595(1) nm³, Zn: a = 1 468.3(2), b = 755.8(1), c = 1 103.1(1) pm, β = 126.79(1)°, V = 0.9804(2) nm³. The crystal structures consist of hexagonal packed [M(HSeO₃)₂ · 2H₂O]_n chains of [MO₄(H₂O)₂] octahedra linked by Se atoms. They contain trigonal pyramidal SeO₂OH^?ions with “free” hydroxyl groups and also “free” molecules of water of crystallization. The hydroxyl groups build strong H-bonds (O? H …? O distances: 265–268 pm). The IR spectra show AB doublett bands in the OH stretching mode region of the hydroxyl groups. The water molecules of crystallization are linked to planar (H₂O)₄ tetramers by H-bonds with unusually short O? H …? O bond distances of 271–273 pm. DTA and TG measurements indicate that thermal decomposition results in the direct formation of the respective diselenite MSe₂O₅. Raman heating measurements show under quasi static conditions the intermediate formation of the anhydrous hydrogen selenites.     

杂原子Y分子筛的二次合成及其吸附脱硫性能

采用液-固相同晶取代反应制备了骨架含Ga的Y型分子筛, 并对其吸附脱硫性能进行了研究. 在室温, 空速为7 h−1的条件下, 镓化Y型分子筛([Ga]AlY)处理噻吩、四氢噻吩、4,6-二甲基二苯并噻吩(4,6-DMDBT)正壬烷溶液(硫含量500 μg•g−1), 每克吸附剂吸附硫的量分别为7.7、17.4、14.5 mg. 采用密度泛函理论(DFT)中的广义梯度近似方法(GGA)计算各分子中硫原子上的电荷数, 噻吩中硫原子的电荷数为−0.159, 而4,6-DMDBT和四氢噻吩分别为−0.214、0.298. 四氢噻吩和4, 6-DMDBT中硫原子上的电子密度大于噻吩中硫原子上的电子密度, 这就使得四氢噻吩和4,6-DMDBT中的硫原子与吸附位间的作用会远大于噻吩中的硫原子与吸附位间的作用, 吸附容量必然会大很多. 采用[Ga]AlY处理抚顺石油二厂的催化裂化汽油(硫含量：299 μg•g−1), 每克吸附剂处理2.1 mL汽油时, 处理后汽油的硫含量为54.8 μg•g−1, 说明[Ga]AlY对汽油脱硫有一定的效果.