Classify the Higgs decays with the PFN and ParticleNet at electron–positron colliders

Various Higgs factories are proposed to study the Higgs boson precisely and systematically in a model- independent way. In this study, the Particle Flow Network and ParticleNet techniques are used to classify the Higgs decays into multicategories, and the ultimate goal is to realize an "end-to-end" analysis. A Monte Carlo simulation study is performed to demonstrate the feasibility, and the performance looks rather promising. This result could be the basis of a "one-stop" analysis to measure all the branching fractions of the Higgs decays simultaneously.     

Experimental measurements of acoustical properties of snow and inverse characterization of its geometrical parameters

Snow is a sound absorbing porous sintered material composed of solid matrix of ice skeleton with air (+water vapour) saturated pores. Investigation of snow acoustic properties is useful to understand the interaction between snow structure and sound waves, which can be further used to devise non-destructive way for exploring physical (non-acoustic) properties of snow. The present paper discusses the experimental measurements of various acoustical properties of snow such as acoustic absorption coefficient, surface impedance and transmission losses across different snow samples, followed by inverse characterization of different geometrical parameters of snow. The snow samples were extracted from a natural snowpack and transported to a nearby controlled environmental facility at Patsio, located in the Great Himalayan range of India. An impedance tube system (ITS), working in the frequency range 63–6300 Hz, was used for acoustic measurements of these snow samples. The acoustic behaviour of snow was observed strongly dependent upon the incident acoustic frequency; for frequencies smaller than 1 kHz, the average acoustic absorption coefficient was found below than 0.4, however, for the frequencies more than 1 kHz it was found to be 0.85. The average acoustic transmission loss was observed from 1.45 dB cm⁻¹ to 3.77 dB cm⁻¹ for the entire frequency range. The real and imaginary components of normalized surface impedance of snow samples varied from 0.02 to 7.77 and −6.05 to 5.69, respectively. Further, the measured acoustic properties of snow were used for inverse characterization of non-acoustic geometrical parameters such as porosity, flow resistivity, tortuosity, viscous and thermal characteristic lengths using the equivalent fluid model proposed by Johnson, Champoux and Allard (JCA). Acoustically derived porosity and flow resistivity were also compared with experimentally measured values and good agreement was observed between them.     

Wall shear stress and near-wall convective transport: Comparisons with vascular remodelling in a peripheral graft anastomosis

Fluid dynamic properties of blood flow are implicated in cardiovascular diseases. The interaction between the blood flow and the wall occurs through the direct transmission of forces, and through the dominating influence of the flow on convective transport processes. Controlled, in vitro testing in simple geometric configurations has provided much data on the cellular-level responses of the vascular walls to flow, but a complete, mechanistic explanation of the pathogenic process is lacking. In the interim, mapping the association between local haemodynamics and the vascular response is important to improve understanding of the disease process and may be of use for prognosis. Moreover, establishing the haemodynamic environment in the regions of disease provides data on flow conditions to guide investigations of cellular-level responses.     

PIV水下流场测试系统试验研究

基于粒子图像测速技术,设计研制了一套适用于水洞洞体内高速、封闭试验条件的流场测量与显示设备.该系统由光源、成像、图像处理与分析、控制和粒子投放等分系统组成,具有复杂环境下全流场的无接触、无扰动、高准确度测量和显示能力,流场测试误差小于2%,可为水下航行器外形设计及其改进提供相关的实测数据.     

Auxiliary probe design adaptable to existing probes for remote detection NMR, MRI, and time-of-flight tracing

A versatile, detection-only probe design is presented that can be adapted to any existing NMR or MRI probe with the purpose of making the remote detection concept generally applicable. Remote detection suggests freeing the NMR experiment from the confinement of using the same radio frequency (RF) coil and magnetic field for both information encoding and signal detection. Information is stored during the encoding step onto a fluid sensor medium whose magnetization is later measured in a different location. The choice of an RF probe and magnetic field for encoding can be made based solely on the size and characteristics of the sample and the desired information quality without considering detection sensitivity, as this aspect is dealt with by a separate detector. While early experiments required building probes that included two resonant circuits, one for encoding and one for detection, a modular approach with a detection-only probe as presented here can be used along with any existing NMR probe of choice for encoding. The design of two different detection-only probes is presented, one with a saddle coil for milliliter-sized detection volumes, and the other one with a microsolenoid coil for sub-microliter fluid quantities. As example applications, we present time-of-flight (TOF) tracing of hyperpolarized (129)Xe spins in a gas mixture through coiled tubing using the microsolenoid coil detector and TOF flow imaging through a nested glass container where the gas flow changes its direction twice between inlet and outlet using the saddle coil detector.     

Determining NMR flow propagator moments in porous rocks without the influence of relaxation

Flow propagators, used for the study of advective motion of brine solution in porous carbonate and sandstone rocks, have been obtained without the influence of Nuclear Magnetic Resonance (NMR) relaxation times, T₁ and T₂. These spin relaxation mechanisms normally result in a loss of signal that varies depending on the displacement ζ of the flowing spins, thereby preventing the acquisition of quantitative propagator data. The full relaxation behaviour of the system under flow needs to be characterised to enable the implementation of a true quantitative measurement. Two-dimensional NMR correlations of ζ − T₂ and T₁ − T₂ are used in combination to provide the flow propagators without relaxation weighting. T₁ − ζ correlations cannot be used due to the loss of T₁ information during the displacement observation time Δ. Here the moments of the propagators are extracted by statistical analysis of the full propagator shape. The measured displacements (first moments) are seen to correlate with the expected mean displacements for long observation times Δ. The higher order moments of the propagators determined by this method indicate those obtained previously using a correction were overestimated.     

Optical coherence tomography based particle image velocimetry (OCT-PIV) of polymer flows

The measurement of spatially resolved velocity distributions is crucial for modelling flow and for understanding properties of materials produced in extrusion processes. Traditional methods for flow visualization such as particle image velocimetry (PIV) rely on optically transparent media and cannot be applied to turbid polymer melts. Here we present optical coherence tomography as an imaging technique for PIV data processing that allows for measuring a sequence of time resolved images even in turbid media. Time-resolved OCT images of a glass-fibre polymer compound were acquired during an extrusion process in a slit die. The images are post-processed by ensemble cross-correlation to calculate spatially resolved velocity vector fields. The results compared well with velocity data obtained by Doppler-OCT. Overall, this new technique (OCT-PIV) represents an important extension of PIV to turbid materials by the use of OCT.     

停流流动注射-化学发光法测定碘盐中的碘酸根

基于在酸性介质中 ,IO-3 与 I-快速反应产生 I2 ,I2 氧化 Luminol产生化学发光反应的机理 ,建立了Luminol- IO-3 偶合发光体系测定微量 IO-3 的方法。本法测定 IO-3 的线性范围为 5 .0× 10 -8- 3.0× 10 -5g/m L;检出限为 5 .0× 10 -8g/m L ;该法中的采样、停流和进样都由计算机自动控制 ,操作简便 ,灵敏度高 ,选择性好。应用于含碘食盐中微量 IO-3 的测定 ,结果令人满意     

Lattice gas simulation and experiment study of evacuation dynamics

In this paper, evacuation dynamics in an office building is studied by experiment and simulation. A lattice gas (LG) model is developed. A parameter called ‘exit bias’ is introduced into the model to describe the occupants’ familiarity with different exits in a building. The evacuation experiment, which consists of seven scenarios under various conditions, is conducted to verify the model and calibrate the model’s input parameters such as pedestrian speed and exit bias. The effect of exit width on flow rate, and the effect of occupants’ familiarity with the building on their route selections, are studied. It is found that the accuracy of simulation depends a lot on the model’s pedestrian speed. The optimal pedestrian speed is decided by not only occupant characteristics, but also flow features determined by people distribution, building structure, environment pressure, etc. LG models with proper pedestrian speed are capable of simulating the dynamic process of orderly emergency evacuations.     

直接膨胀供液制冷系统性能可视化研究

对直接膨胀供液制冷系统的传热性能进行了理论分析,建立了相应的数学模型.在保温体内对-5℃、0℃、5℃、10℃、15℃、20℃的工况进行了实验.分别测得制冷系统的压力、风量、制冷量、及功耗等技术参数,得到在环境温度一定的情况下的传热系数和制冷量的变化关系.并对蒸发器内制冷剂流动状态进行观察.实验表明:直接膨胀供液制冷系统...