Automatic flow procedure for the determination of glycerol in wine using enzymatic reaction and spectrophotometry

An automatic flow procedure for the determination of glycerol in wines by employing a flow system based on multicommutation and enzymatic reaction is described. Glycerol dehydrogenase was immobilized on aminopropyl glass beads and packed into a column that was coupled to the flow system. The NADH produced by the enzymatic reaction was monitored by spectrophotometry at 340 nm and its radiation absorption presented a relationship with glycerol concentration. The system manifold comprised a set of three-way solenoid valves controlled by a microcomputer, which was furnished with electronic interfaces and runs a software that was designed to carry out on-line sample dilution, reagent addition, and data acquisition. The procedure allows the determination of glycerol in wine samples without any prior pretreatment. The procedure presented as profitable features a linear response range between 2.0 and 10.0 g l⁻¹ glycerol (R=0.998), a detection limit of 0.006 g l⁻¹ glycerol, a relative standard deviation of 1.8% (n=14) for a typical wine sample presenting 5.3 g l⁻¹ glycerol, a sampling throughput of 33 determinations per hour, and a NAD⁺ consumption of 0.8 mg per determination. The results were compared with those obtained using a reference method and no significant difference at 90% confidence level was observed.     

On-line photo-derivatization with flow injection and liquid chromatography-atmospheric pressure electrospray mass spectrometry for the identification of indoles

The application of on-line photochemistry with flow injection (FI) and liquid chromatography (LC) in conjunction with atmospheric pressure electrospray mass spectrometry (LC-APESI-MS) for the identification of similar indole derivatives is reported here. The photo-transformation of the indole compounds is strongly affected by the substituent groups on the aromatic and heterocyclic rings. Upon photolysis for 2.5 min, the mass spectrum of tryptamine (Try) which has no OH substituent on the aromatic ring does not differ greatly from that obtained without photolysis. However, after photolysis of serotonin (Ser) which has one OH group on C5 of the aromatic ring, the mass spectrum indicates the formation of dimers and higher molecular weight ions. The fragmentation pattern of 5-hydroxytryptophol (Phol) without photolysis resembles that of Ser with a base peak of m/z 160. Upon photolysis using MeOH-H₂O (10/90), Phol is found to form a base peak at m/z 375 (100%) and a major peak at m/z 214 (66%) in addition to other ions with lower abundance. Melatonin (Mel) and tryptophan (Phan) upon photolysis are found to form high molecular weight ions with a relative low abundance. The mass spectrum of indole-3-acetic acid (Inaa) with on-line photolysis also shows different ions that are not formed without photolysis.     

Complexity of flow time minimization in a crossdock truck scheduling problem with asymmetric handover relations

We address a novel truck scheduling problem arising in crossdocking logistics, in which inbound trucks carry items (pallets) which must be sorted and loaded onto outbound trucks. We minimize the utilisation of the warehouse by focusing on the synchronisation between the different related trucks. The problem is to assign the trucks to the doors of the warehouse and sequence them, in order to minimize the total time spent in the system by the pallets. We discuss the complexity of the problem, showing that even with a single door the problem is NP-hard in general, and discuss some special cases.     

Flow injection analysis of potassium using an all-solid-state potassium-selective electrode as a detector

The concentration of potassium was determined by a combination of flow injection analysis (FIA) with an all-solid-state potassium sensor detection. The all-solid-state potassium-selective electrode possessing long-term potential stability was fabricated by coating an electroactive polypyrrole/poly(4-styrenesulfonate) film electrode with a plasticized poly(vinyl chloride) membrane containing valinomycin. The simple FIA system developed in this laboratory demonstrated sensitivity identical to that in the batch system and achieved considerably rapid assay (150 samples h⁻¹). Analyses of soy sauce and control serum samples by this FIA system yielded results in good agreement with those obtained by conventional measurements.     

Flow injection manifolds for liquid-liquid extraction without phase separation assisted by ultrasound

Flow injection (FI) manifolds based on iterative change of the flow direction have been designed to study the influence of auxiliary energy on continuous liquid-liquid extraction without phase separation and compare it with the non-assisted process in a single experiment. In order to demonstrate the utility of ultrasounds as auxiliary energy for the extraction of polyphenols from an organic phase, the approach has been applied to samples of extra virgin olive oil, using an alkaline aqueous phase as extractant and subsequent derivatization with the Folin-Ciocalteu reagent. The proposed method provides results similar to those from the official method-recoveries between 97 and 100%. The sensitivity of the proposed method is 3.5 times higher than that of the non-ultrasound-assisted method. The precision, expressed as relative standard deviation (R.S.D.) for n=5, was within 1-5% and the relative errors for the irradiated and non-irradiated method were within 3 and 5%, respectively. The repeatability and within-laboratory reproducibility, studied at two concentration levels (379 and 813 μg ml⁻¹) ranged between 0.7-4.4% and 0.6-4.8%, respectively. The proposed manifolds can also be applied to either other type of auxiliary energies—microwave, thermal—or two different types of auxiliary energies at the same time.     

High throughput continuous titration based on a flow ratiometry controlled with feedback-based variable triangular waves and subsequent fixed triangular waves

We propose a new approach for high-throughput continuous titration based on a flow ratiometry. The method was applied to potentiometric titrations of acids and bases. A base solution, the flow rate F_B of which was varied in response to controller output voltage V_c, was merged with an acid solution under constant total (acid + base) flow rate. Downstream, the pH of the mixed solution was measured with a flow-through glass electrode. Initially, V_c, and thus F_B was increased linearly. At the instant the equivalence point (EP) was sensed, the ramp direction of V_c was reversed from upward to downward. The direction was reversed to upward when EP was sensed again. Such the feedback-based operation gives a triangular waveform of V_c, because there is a delay corresponding mainly to the transit time of merged solutions to reach the sensor. The value of V_c that gives EP composition, V_E, was estimated by averaging the most recent maximum and minimum values of V_c. Next, fixed triangular waves of V_c was used to control F_B. The amplitude and the scan rate of the waves were fixed narrower and faster, respectively, than those in the feedback-based operation in order to improve the throughput rate. The EP can be located as long as the scan range covers V_E. These automated processes limited the titration to just the narrow range around EP, and thus realized extremely high throughput rate of maximally 17.6 titrations per minute (=3.4 s per titration) at R.S.D. = 0.35%.     

Determination of trace elements in human serum by inductively coupled plasma atomic emission spectrometry with flow injection

An analytical method for the simultaneous determination of some trace elements (Au, Fe, Mg, Li, Sr, Zn) in human serum by inductively coupled plasma atomic emission spectrometry (ICP-AES) with flow injection is described. Physical interference caused by the change of sample viscosity is discussed. When 100 μl of serum was injected, the relevant recoveries of > 99% for Li, > 98% for Cu and Mg, > 95% for Fe were obtained for an NIST SRM with R.S.D. > 1.3% using optimized flow injection parameters. The prepared lyophilized control serum for routine analysis in clinical laboratories was analyzed and verified for the validity of the technique employed in this experiment using NIST SRM 909 as a primary reference material.     

Flow injection analysis methods for determination of diffusion coefficients

Two flow injection analyses (FIA) methods for the determination of diffusion coefficients in a straight single tube FIA system were developed. Based on the analytical solution of the convection-diffusion equation, linear relationships of the logarithmic values of the dispersion coefficient (D) and the half-peak width (W_1/2) with the diffusion coefficient (D_m) were obtained. Experiments were designed to verify these methods. For example, for potassium hexacyanoferrate (III) a D_m value of 0.72 × 10⁵ cm² s⁻¹ was found versus a literature value of 0.76 × 10⁵ cm² s⁻¹ (error, 5%). For potassium hexacyanoferrate (II) a D_m value of 0.67 × 10⁵ cm² s⁻¹ was obtained versus a literature value of 0.63 × 10⁵ cm² s⁻¹ (error, 6%). The diffusion coefficients of some important biomedical compounds, such as dopamine, epinephrine, norepinephrine and ascorbic acid, were then determined. The values of 10⁵ D_m/cm² s⁻¹ are 0.60 ± 0.03, 0.44 ± 0.02, 0.60 ± 0.01 and 0.68 ± 0.06, respectively.     

Spectrophotometric flow-injection determination of zinc in plant digests based on a spot test

A spot test was implemented in a flow-injection system for the spectrophotometric determination of zinc in digests of plant materials. It is based on the influence of Zn²⁺ on the oxidation rate of 1-naphthylethylenediamine (NED) by hexacyanoferrate(III) under acidic conditions. In order to control the precipitate formation and to maintain the resulting suspension, a micellar medium was established by adding Triton X-100. The proposed system handles about 65 samples per hour, meaning 72 μg NED and 9.0 mg K₃[Fe(CN)₆] per determination. Baseline drift is usually <0.01 absorbance per hour and the analytical signals for 0.5-2.5 mg l⁻¹ Zn range within ca. 0.07-0.45 absorbance. Linearity of the analytical curve is fair (r>0.999, n=6) and detection limit was estimated as 0.2 mg l⁻¹ Zn. Results are precise (R.S.D.<1%, n=10) and in agreement with flame atomic absorption spectrometry and with certified values of standard reference materials.     

Flow-through microdispenser for interfacing micro-HPLC to Raman and mid-IR spectroscopic detection

A flow-through microdispenser has been coupled to a micro HPLC separation system and used as a solvent elimination interface for Fourier transform infrared (FTIR) and Raman spectroscopic detection of the separated compounds. Using the microdispenser picoliter sized droplets can be generated and deposited on an appropriate target placed on a computerized x, y-stage. Evaporation of volatile solvent and buffer is rapid and allows analysis of the obtained dry deposits by various techniques. Due to the destruction free character of Raman and FTIR spectroscopy they can be applied sequentially to interrogate the same deposit. In the reported application five phenolic acids typically present in wine have been separated on a C-18 column technique using a mixture of water, methanol and acetic acid as mobile phase. For spectrum acquisition infrared and Raman microscopes have been used. The spectra recorded from the dried deposits of the separated compounds agreed well with the reference spectra of corresponding components.