AN INVESTIGATION ON THE ab initio CALCULATION OF INTERMOLECULAR INTERACTION——NON-BONDED INTERACTION IN THE HYDROGEN BOND COMPLEX (HF)_2

An ab initio calculation of the hydrogen bond complex (HF)_2 is given with the 6-311 G~(**) basis set, according to which the potential surface around the balance point of the distancès and the orientations between two HF molecules is obtained. The atomic charges in the system are calculated with the PD/LSF method (potential-derived/least-square-fitting method) and then an analysis of the hydrogen bond interaction between two HF molecules is given with the (exp-6-1) potential function, by means of which it is shown that the main interaction between them is not an electro-static but a charge transfer one. The potential curve between two HF molecules is like a Morse function.     

用动力学方法研究8,9-苯并-2-亚甲基-1,4,6-三氧螺[4,4]壬烷的聚合反应机理

根据在自由基引发剂存在下,8,9-苯并-2-亚甲基-1,4,6-三氧螺(4,4)壬烷(Ⅰ)可能存在的竞争反应,推导了动力学方程式。用红外光谱法测定了单体的消失速率和苯酞的生成速率。实验结果与推导动力学方程式相符。进一步证明了单体(Ⅰ)的增长反应由加成聚合和开环—异构化—加成这两个反应组成。这两个反应对总速率的相对贡献与单体浓度有关。得到了共聚物的结构。     

CuO/TiO2的制备及对NO＋CO反应性能的研究

以三种不同的TiO2为载体，负载6%CuO，在色谱-微反装置上考察了三种Cu6-Ti催化剂对NO＋CO反应的活性。结果表明，由于制备方法不同，活性差别很大，三者活性顺序依次为：Cu6-Ti(T)> Cu6-Ti(S)> Cu6-Ti(nm)，TiO2的比表面积及晶型对活性的影响不明显。H2-TPR结果表明，Cu6-Ti在整个TPR过程中出现了3或4个还原峰，表明有多种CuO物种存在。不同预处理Cu6-Ti的TPR显示，在反应中Cu物种可能以多种价态同时存在。NO-TPD结果亦证明，Cu6-Ti对NO＋CO的反应活性与NO在催化剂表面的解离难易密切相关，而与NO的吸附量关系不大。     

光化学-荧光分析法研究——Ⅲ.片剂及注射液中安定的测定

本文提出了测定安定的光化学—荧光分析新方法。安定在含有十二烷基硫酸钠的稀硫酸介质中,经紫外光照射后,产物能发射荧光(=368nm,=476nm)。安定浓度在0～2.5μg/ml范围内,荧光强度与浓度成良好的线性关系。方法的相对标准偏差为1.5％,检出限为0.044μg/ml,可用于片剂及注射液中安定含量的测定。     

LaC_3~n(n=-1,0,+1)分子簇的理论研究(英文)

用密度泛函方法研究了ＬａＣ３ｎ（ｎ＝－１，０，＋１）分子簇的结构和稳定性，对这个四原子体系，提出了５种可能构型，其中３种具有Ｃ２ｖ对称性，２种为Ｃ∞ｖ对称性．在Ｃ２ｖ对称性结构中，其中１个为Ｌａ接在弯曲的Ｃ３链上，第２个是Ｌａ通过２个键与Ｃ３环相链，第３个是Ｌａ通过１个键与Ｃ３环相连；在Ｃ∞ｖ对称性中，第１个Ｌａ接在Ｃ３链的一端，而在第２个构型中，Ｌａ被插入在Ｃ３链中．结果表明，环状结构当Ｌａ接在弯曲的Ｃ３链上的是局域极小值并且最稳定     

水热法制备高纯超细CeO2-ZrO2复合氧化物

Superfine composite powders of CeO₂-ZrO₂ (CZ) and CeO₂-ZrO₂-La₂O₃ (CZL) were prepared by hydrothermal method. The effects of pH、temperature and time for hydrothermal process on the performance of the resulting powders were studied. The optimized reaction parameters were on follows: the precursor′s pH≈9.0, hydrothermal temperature of 200 ℃ holding for 2 h. Thermal stable powders with average particle size smaller than 10 nm and specific surface area of 171 m²·g^-1 were obtained. A BET specific surface area was still at 44 m²·g^-1 after calcination at 1 000 ℃ for 6 hours.     

双波长K系数—标准加入吸光光度法同时测定锰和锌

研究应用双波长K系数—标准加入吸光光度法同时测定锰和锌二组分混合物.试验确定了锰和锌测定中K_(Mn)与K_(Zn)的回归方程.对合成试样、人发试样测定,结果满意.     

Analysis of thermal behaviour of high power semiconductor laser arrays by means of the finite element method (FEM)

New results of steady-state two-dimensional finite-element computations of temperature distributions of high power semiconductor laser arrays are presented. The influence of different thermal loads on the 2D temperature distribution in AlGaAs/GaAs gain-guided laser arrays is investigated. TheFEM model is tested by comparing it with analytical solutions. For numerical convenience, the latter is rewritten in a novel form, which is free of overflow problems. The maximum temperatures calculated by both methods agree within 1%. Several factors determining the thermal resistance of the device are quantitatively examined: the ratio of light emitting to non-emitting areas along the active zone, the amount of Joule losses, the current spreading, the solder thickness, and voids in the solder. This yields design rules for optimum thermal performance.     

Non-stoichiometry of YBa2Cu3O7-d Observed by Repeated Temperature Scanning

Repeated temperature scanning method was applied to observe non-stoichiometry of YBa₂Cu₃O₇-d, and interesting results were obtained. Two simultaneously occurring processes were separately observed in mass change; one is a fast process and the other is slow, so that their responses to the temperature change are quite different from each other. The fast process follows the cyclic temperature change, but the slow process is observed to be a gradual mass change. Kinetic behaviors of these two processes are also made clear by plotting the mass vs. the temperature. Furthermore, a hysteresis loop was observed in the plot of the mass vs. the temperature in a high temperature range presumably due to the third process, and it depends on the heating and cooling rates. This revised version was published online in July 2006 with corrections to the Cover Date.     

Dynamic headspace liquid-phase microextraction of alcohols

A method was developed using dynamic headspace liquid-phase microextraction and gas chromatography-mass spectrometry for extraction and determination of 9 alcohols from water samples. Four different solvents, hexyl acetate, n-octanol, o-xylene and n-decane were studied as extractants. The analytes were extracted using 0.8 microl of n-octanol from the headspace of a 2 ml sample solution. The effect of sampling volume, solvent volume, sample temperature, syringe plunger withdrawal rate and ionic strength of the solution on the extraction performance were studied. A semiautomated system including a variable speed stirring motor was used to ensure a uniform movement of syringe plunger through the barrel. The method provided a fairly good precision for all compounds (5.5-9.3%), except methanol (16.4%). Detection limits were found to be between 1 and 97 microg/l within an extraction time of approximately 9.5 min under GC-MS in full scan mode.