Evaluation of measurement uncertainty for analytical procedures using a linear calibration function

In the EURACHEM/CITAC draft ”Quantifying uncertainty in analytical measurement” estimations of measurement uncertainty in analytical results for linear calibration are given. In this work these estimations are compared, i.e. the uncertainty deduced from repeated observations of the sample vs. the uncertainty deduced from the standard residual deviation of the regression. As a result of this study it is shown that an uncertainty estimation based on repeated observations can give more realistic values if the condition of variance homogeneity is not correctly fulfilled in the calibration range. The complete calculation of measurement uncertainty including assessment of trueness is represented by an example concerning the determination of zinc in sediment samples using ICP-atomic emission spectrometry. Received: 9 February 2002 Accepted: 17 April 2002     

Rapid determination of protein in plant material by flow injection spectrophotometry with trinitrobenzenesulfonic acid

The rapid determination of protein in plant material based on spectrophotometric determination of amino acids in protein hydrolysates with trinitrobenzenesulfonic acid has been adapted to flow injection analysis. With the manifold described, a routine sampling rate of 120 samples/h is possible, though this, as well as sensitivity, can easily be varied. The method was calibrated against the Kjeldahl method and a good correlation was obtained between the two methods over a wide range of protein values for beans.     

Validation steps for traceability of linear calibrated chemical measurements

Based on the new draft of the EURACHEM/CITAC Guide Traceability in Chemical Measurement, this publication describes how traceability can be achieved for chemical measurements using a linear calibration function. Traceability can be accomplished without larger expenditure, if the measurement is calibrated on the basis of appropriate reference standards and the linear regression employed is selected and validated statistically in a suitable form. The determination of nickel in aqua regia eluates of sediment samples, employed for an ICP-OES measurement, is used as a practical illustration of this approach.     

A computer program for searching the best model for describing different experimental systems

An algorithm for searching the best polynomial analytical function for describing different experimental systems is presented. It is based

1. (1)on the generation of all possible analytical functions of a given order, with a given number of terms and with a given number of independent variables, and

2. (2)on the calculation of the parameters of all selected functions using the linear regression method.

To show the ability of the program two different examples are given:

1. (1) searching the best univariate polynomial model, and

2. (2) modelling of the stability of a two-component mixture as a function of three factors.

Optimization of the Microwave-Assisted Saponification and Extraction of Organic Pollutants from Marine Biota Using Experimental Design and Artificial Neural Networks

Several improvements in sample pretreatment for the determination of organic pollutants (i.e. n-alkanes, polycyclic aromatic hydrocarbons, PAHs) in marine biota (mussels) are presented. The use of liquid nitrogen and homogenization of the samples are shown to be an alternative to the time consuming liophilization step required for the analysis of biota samples. Microwave-assisted hydrolysis and extraction are combined to isolate organic pollutants (19 n-alkanes and 27 PAHs) from biota matrices. Experimental design (ED) and artificial neural networks (ANNs) were used to optimize the experimental conditions. NIST-CRM 2978 was used to test the validity of the developed method which shows a good agreement with certified values.     

Validation of a screening method for the simultaneous identification of fat-soluble and water-soluble vitamins (A,E, B<Subscript>1</Subscript>, B<Subscript>2</Subscript> and B<Subscript>6</Subscript>) in an aqueous micellar medium of hexadecyltrimethylammonium chloride

Simultaneous determination of the fat-soluble vitamins A and E and the water-soluble vitamins B₁, B₂ and B₆ has been carried using a screening method from fluorescence contour graphs. These graphs show different colour zones in relation to the fluorescence intensity measured for the pair of excitation/emission wavelengths. The identification of the corresponding excitation/emission wavelength zones allows the detection of different vitamins in an aqueous medium regardless of the fat or water solubility of each vitamin, owing to the presence of a surfactant which forms micelles in water at the used concentration (over the critical micelle concentration). The micelles dissolve very water insoluble compounds, such as fat-soluble vitamins, inside the aggregates. This approach avoids the use of organic solvents in determining these vitamins and offers the possibility of analysing fat- and water-soluble vitamins simultaneously. The method has been validated in terms of detection limit, cut-off limit, sensitivity, number of false positives, number of false negatives and uncertainty range. The detection limit is about g L^–1. The screening method was applied to different samples such as pharmaceuticals, juices and isotonic drinks.     

Method to determine quadruple points of a two-component system containing a simple hydrate phase and behavior of the system near these points

A method for determining quadruple points of a two-component system containing a simple hydrate phase is proposed. This method utilizes the quasi-static change of the system along three-phase equilibrium lines and was proved to be able to determine the quadruple points as accurately as the conventional method. By using this method, even though some preparation is necessary, a quadruple point can be determined in just a single experimental run. The behavior of the system near the quadruple points was also examined experimentally, for both the quasi-static and the irreversible change cases. At the quadruple points, the temperature and pressure of the system were kept constant for a while, as at the triple point of water. In both cases, the representative point of the state of the system passed through the quadruple point on a p–T diagram.     

A model for short alpha-neurotoxin bound to nicotinic acetylcholine receptor from Torpedo californica: comparison with long-chain alpha-neurotoxins and alpha-conotoxins

Short-chain alpha-neurotoxins from snakes are highly selective antagonists of the muscle-type nicotinic acetylcholine receptors (nAChR). Although their spatial structures are known and abundant information on topology of binding to nAChR is obtained by labeling and mutagenesis studies, the accurate structure of the complex is not yet known. Here, we present a model for a short alpha-neurotoxin, neurotoxin II from Naja oxiana (NTII), bound to Torpedo californica nAChR. It was built by comparative modeling, docking and molecular dynamics using 1H NMR structure of NTII, cross-linking and mutagenesis data, cryoelectron microscopy structure of Torpedo marmorata nAChR [Unwin, N., 2005. Refined structure of the nicotinic acetylcholine receptor at 4A resolution. J. Mol. Biol. 346, 967-989] and X-ray structures of acetylcholine-binding protein (AChBP) with agonists [Celie, P.H., van Rossum-Fikkert, S.E., van Dijk, W.J., Brejc, K., Smit, A.B., Sixma, T.K., 2004. Nicotine and carbamylcholine binding to nicotinic acetylcholine receptors as studied in AChBP crystal structures. Neuron 41 (6), 907-914] and antagonists: alpha-cobratoxin, a long-chain alpha-neurotoxin [Bourne, Y., Talley, T.T., Hansen, S.B., Taylor, P., Marchot, P., 2005. Crystal structure of Cbtx-AChBP complex reveals essential interactions between snake alpha-neurotoxins and nicotinic receptors. EMBO J. 24 (8), 1512-1522] and alpha-conotoxin [Celie, P.H., Kasheverov, I.E., Mordvintsev, D.Y., Hogg, R.C., van Nierop, P., van Elk, R., van Rossum-Fikkert, S.E., Zhmak, M.N., Bertrand, D., Tsetlin, V., Sixma, T.K., Smit, A.B., 2005. Crystal structure of nicotinic acetylcholine receptor homolog AChBP in complex with an alpha-conotoxin PnIA variant. Nat. Struct. Mol. Biol. 12 (7), 582-588]. In complex with the receptor, NTII was located at about 30 A from the membrane surface, the tip of its loop II plunges into the ligand-binding pocket between the alpha/gamma or alpha/delta nAChR subunits, while the loops I and III contact nAChR by their tips only in a 'surface-touch' manner. The toxin structure undergoes some changes during the final complex formation (for 1.45 rmsd in 15-25 ps according to AMBER'99 molecular dynamics simulation), which correlates with NMR data. The data on the mobility and accessibility of spin- and fluorescence labels in free and bound NTII were used in MD simulations. The binding process is dependent on spontaneous outward movement of the C-loop earlier found in the AChBP complexes with alpha-cobratoxin and alpha-conotoxin. Among common features in binding of short- and long alpha-neurotoxins is the rearrangement of aromatic residues in the binding pocket not observed for alpha-conotoxin binding. Being in general very similar, the binding modes of short- and long alpha-neurotoxins differ in the ways of loop II entry into nAChR.     

Performance validation of step-isothermal calorimeters

Isothermal calorimetry is becoming indispensable as a tool for the study of a wide variety of systems. As with all scientific instruments it is essential that robust calibration routines be developed in order to validate the data obtained. Chemical test reactions offer many advantages over (the traditionally used) joule effect heating methods, not least because they have the potential to validate instrument performance (i.e. they can be used to assess all aspects of calorimeter operation). In this work the results of a validation exercise, conducted by Thermal Hazard Technology as part of an installation routine, using the base catalysed hydrolysis of methyl paraben are discussed. In the case described, a systematic misreporting of the reported temperature of a calorimeter was identified, caused by an upgrade to the calorimeter's firmware, a discrepancy which may not have been noted using traditional electrical calibration methods and one which highlights the importance of both manufacturers and end-users adopting chemical test reactions into their test and validation routines.     

Optimisation of a flow injection system with electrochemical detection using the desirability function: Application to the determination of hydroquinone in cosmetics

A procedure is proposed in which the determination of hydroquinone using a flow injection system with electrochemical detection is described. Size and coefficient of variation of the signal are optimised by a desirability function and a central composite design. The robustness of the optimum reached in the optimisation step is evaluated by means a Plackett-Burman design. The optimised FIA system is able to determine hydroquinone with a minimum detectable net concentration of 10 μg l⁻¹ with a false positive probability of 0.05 and a false negative probability less than 0.05. In samples of bleaching cream, the proposed procedure has a recovery of 102.2% with standard deviation of 4.4% and a relative error of 6.2%.