Banach空间二阶周期边值问题解的存在性

利用一些比较结果，讨论了Banach空间中二阶周期边值问题解的存在性，获得了若干解的存在性与唯一性结果。     

Boundary value problems for first order impulsive delay differential equations with a parameter

In this paper, by means of the method of upper and lower solutions and monotone iterative technique, the existence of maximal and minimal solutions of the boundary value problems for first order impulsive delay differential equations is established.     

Theory and experiment of spatially and temporally partially coherent speckle shearing interferometry

The theory and experiment of spatially and temporally partially coherent speckle shearing interferometry is reported in this rapid communication for the first time. The general requirements for the surface roughness and coherence area of a diffuse object surface in spatially and temporally partially coherent speckle shearing interferometry are discussed. An experimental verification is presented and the results of theory and experiment are in good agreement.     

斐索型光学合成孔径系统近轴成像条件研究

从几何光学理论出发，详细推导了斐索型光学合成孔径成像系统的近轴非相干成像条件，即子望远系统的角放大率等于系统的线性缩放因子。对于焦平面上的像点而言，合成孔径成像系统可等效为一个带有特殊形状孔径光阑的望远系统，这要求该孔径光栏的开口形状和位置分布与合成孔径成像系统各子系统孔径大小和位置分布相一致。我们由此得到了斐索型合成孔径成像系统的主要约束条件。     

Prefiltration technique via aggregation for constructing low‐density high‐quality factorized sparse approximate inverse preconditionings

This paper considers a new approach to a priori sparsification of the sparsity pattern of the factorized approximate inverses (FSAI) preconditioner using the so‐called vector aggregation technique. The suggested approach consists in construction of the FSAI preconditioner to the aggregated matrix with a prescribed sparsity pattern. Then small entries of the computed ‘aggregated’ FSAI preconditioning matrix are dropped, and the resulting pointwise sparsity pattern is used to construct the low‐density block sparsity pattern of the FSAI preconditioning matrix to the original matrix. This approach allows to minimize (sometimes significantly) the construction costs of low‐density high‐quality FSAI preconditioners. Numerical results with sample matrices from structural mechanics and thin shell problems are presented. Copyright © 2002 John Wiley & Sons, Ltd.     

一种新的超分辨记录点的读出技术

提出一种新的超分辨记录点的读出技术—超分辨反射膜技术，详细分析了其原理。用该技术，以Sb为超分辨反射膜，SiN为介电层，在激光波长为632．8nm和光学头的数值也径为0．40的读出光学系统中实现了直径为380nm的超分辨记录点的读出。同时研究了Sb薄膜厚度对读出信噪比的影响规律，发现最佳的Sb薄膜厚度为28～30nm，所得的信噪比为38～40dB。     

Study of a vibrating plate: comparison between experimental (ESPI) and analytical results

Real-time electronic speckle pattern interferometry (ESPI) was used for tuning and visualization of natural frequencies of a trapezoidal plate. The plate was excited to resonant vibration by a sinusoidal acoustical source, which provided a continuous range of audio frequencies. Fringe patterns produced during the time-average recording of the vibrating plate—corresponding to several resonant frequencies—were registered. From these interferograms, calculations of vibrational amplitudes by means of zero-order Bessel functions were performed in some particular cases. The system was also studied analytically. The analytical approach developed is based on the Rayleigh–Ritz method and on the use of non-orthogonal right triangular co-ordinates. The deflection of the plate is approximated by a set of beam characteristic orthogonal polynomials generated by using the Gram–Schmidt procedure. A high degree of correlation between computational analysis and experimental results was observed.     

Chip-calorimeter for small samples

A method for measuring heat capacities of small samples using a chip-calorimeter and a heat pulse technique is described. The theoretical background to calculate the heat transport properties and the heat capacity of the sample from the pulse response function is given. Problems and potentials of the method are discussed. An example is given.     

Point load determination of static elastic moduli using laser speckle interferometry

Electronic speckle interferometry (ESPI) is used to determine the Young's modulus E and Poisson ratio ν of an isotropic material. Micron scale deformations of the surface of the block of polymethyl-methacrylate (PMMA) are induced by normal application of a known near-point force. These deformations are recorded in speckle interferometric fringe patterns. An iterative minimum error inversion technique is developed to obtain the elastic properties from the positions of fringe peaks and troughs observed in the fringe patterns. Sensitivity tests of the method on calculated fringe patterns using measured experimental uncertainties suggest the technique will provide measures of the elastic moduli to better than 5%. In an experimental test on a bloc of PMMA (acrylic) the technique gave values of E and ν that differed from corresponding measures obtained using more conventional strain-gauge methods by less than 4%.