Nonexistence of global solutions of wave equations with weak time-dependent damping and combined nonlinearity

In our previous two works, we studied the blow-up and lifespan estimates for damped wave equations with a power nonlinearity of the solution or its derivative, with scattering damping independently. In this work, we are devoted to establishing a similar result for a combined nonlinearity. Comparing to the result of wave equation without damping, one can say that the scattering damping has no influence.     

Laboratory Studies of Depressurization with a High Concentration of Surfactant in Low-Permeability Reservoirs

To solve the problem of high pressure of water injection in low permeability reservoirs, a high concentration of surfactant system was developed in this article. With the solubilization of oil in aqueous surfactant solution as a criterion, a formula was screened from anionic and nonionic-anionic surfactants, and the optimal depressurized system was obtained as follows, 13.3% surfactant HEX +2.23% n-propanol +4.47% n-butanol, the solubilization capability being up to 0.66 g/g. This system had good salt tolerance, and it exhibited water external microemulsion in the range of of 1 to 200 g/L NaCl. Core flooding results show that this high concentration of surfactant system formed water external microemulsion with the residual oil in the core, reducing the displacement pressure over 35%. Meanwhile, the effects of concentration and injection volume on depressurization were also investigated. It is indicated that a good depressurization effect was achieved after injecting 1 pore volume of the system with the salt concentration of 100 g/L.     

Degradation of 4-chloro 2-aminophenol using combined strategies based on ultrasound,photolysis and ozone

The present work investigates the degradation of 4-chloro 2-aminophenol (4C2AP), a highly toxic organic compound, using ultrasonic reactors and combination of ultrasound with photolysis and ozonation for the first time. Two types of ultrasonic reactors viz. ultrasonic horn and ultrasonic bath operating at frequency of 20 kHz and 36 kHz respectively have been used in the work. The effect of initial pH, temperature and power dissipation of the ultrasonic horn on the degradation rate has been investigated. The established optimum parameters of initial pH as 6 (natural pH of the aqueous solution) and temperature as 30 ± 2 °C were then used in the degradation studies using the combined approaches. Kinetic study revealed that degradation of 4C2AP followed first order kinetics for all the treatment approaches investigated in the present work. It has been established that US + UV + O₃ combined process was the most promising method giving maximum degradation of 4C2AP in both ultrasonic horn (complete removal) and bath (89.9%) with synergistic index as 1.98 and 1.29 respectively. The cavitational yield of ultrasonic bath was found to be eighteen times higher as compared to ultrasonic horn implying that configurations with higher overall areas of transducers would be better selection for large scale treatment. Overall, the work has clearly demonstrated that combined approaches could synergistically remove the toxic pollutant (4C2AP).     

Nd∶YVO4/Nd∶GdVO4双波长激光器的功率均衡实验研究

实验研究了Nd∶YVO4/Nd∶GdVO4双波长激光器在不同抽运功率条件下,通过调节热沉温度达到功率均衡时的输出特性.实验结果表明:对于Nd∶YVO4/Nd∶GdVO4双波长激光器,当提高抽运功率,需要重新降低热沉温度达到功率均衡输出,降温幅度与抽运功率增加之比为11.23℃/W.与此同时,随着抽运功率和热沉温度的变化,双波长激光器的中心波长会出现小幅度的漂移,左峰波长随抽运功率增加的蓝移速率为0.056 nm/W,右峰波长随抽运功率增加的蓝移速率为0.054 nm/W.实验还发现功率均衡条件下激光器的输出总功率随抽运功率的增加而增加,拟合斜效率为8.7%,当抽运功率为5.58 W时,输出最大总功率达到115.7 mW.     

蟹壳基氮/氧共掺杂多孔炭的原位制备及其超级电容器性能

采用废弃蟹壳为碳源,KOH为活化剂原位制备了氮/氧共掺杂多孔炭,并研究其作为电极材料在超级电容器中的应用。 固定蟹壳与KOH的质量比为5:3,考察了煅烧温度对所得炭材料产率、孔结构和氮氧含量的影响。 结果表明,蟹壳基炭材料的孔结构和氮/氧含量可通过改变煅烧温度调变。 随着煅烧温度从500 ℃上升至700 ℃,多孔炭的比表面积和孔体积逐渐增大,而氮/氧含量随温度升高则降低。 采用循环伏安和恒流充放电对所得材料的电化学性能进行测试。 结果表明,所得多孔炭的电化学性能取决于其孔结构与氮/氧表面性质的协同作用,其中煅烧温度为600 ℃所得的多孔炭比表面积为612 m²/g,氮和氧含量分别为3.53%和32.8%,在50 mA/g的电流密度下比电容达到310 F/g,循环1000次比电容仍然保持95%以上,展现出良好的电化学性能。     

均苯四甲酸酐改性花生壳粉吸附阳离子红染料的研究

以花生壳粉(PS)为生物基质,甲苯-2,4-二异氰酸酯(TDI)为交联剂,均苯四甲酸酐(PMDA)为改性剂,制备了均苯四甲酸酐改性花生壳粉(PMPS)吸附剂,并研究了PMPS对阳离子红染料吸附效果的影响因素。结果表明,在25℃,吸附时间3 h,pH值为2.0时,PMPS处理浓度为400.0 mg/mL的阳离子红溶液25 mL,最大吸附容量Q为177.2 mg/g,是未改性花生壳粉的2.2倍。改性花生壳粉吸附模式为Langmuir单分子层化学吸附。     

复合还原剂硼氢化钠/三氯化铁对亚砜的还原

硼氢化钠是一种温和、高选择性的亲核还原剂。一般它只能还原醛、酮和酰氯,而对其它功能团不起作用。因而其应用范围有一定的限制。据文献报道,某些金属卤化物能有效地提高硼氢化钠的还原性能^[1]。复合还原剂硼氢化钠/三氯化铁已应用于将β-二烷基氨基共轭烯酮还原为相应的饱和γ-氨基醇^[2]。本文研究了硼氢化钠/三氯化铁对亚砜的还原反应。     

Third body modeling in fretting using the combined finite-discrete element method

A new approach was developed for modeling the effect of the third body on fretting. This was accomplished using the combined finite-discrete element method (FDEM) in which the third body is analyzed as discrete elements while the first bodies are modeled using finite elements. This approach provides a link between large scale models which treat the mass of wear debris as a single or small number of bodies and small scale models which only study a control volume. The FDEM was used to analyze the behavior of third body particles between flat sliding surfaces. When the third body mass is composed of unconnected particles, it behaves as a Newtonian fluid, but this behavior ceases when the particles are connected into platelets. The FDEM was also used to study the behavior of third body particles inside a Hertzian line contact. As the number of particles and platelet size increase the load carried by the worn slip zone grows larger in relationship to the unworn stick zone.     

Microwave absorption properties of rod-shaped Co-Ni-P shells prepared by metallizing Bacillus

The rod-shaped Co-Ni-P shells were prepared by metalling Bacillus. The microstructures and composition of the shells were characterized by scanning electron microscopy (SEM), transmission electron microscopy (TEM) and energy dispersive analysis (EDS). The electromagnetic parameters were measured by the coaxial line method in the frequency of 2-18 GHz. It was found that the Bacillus were successfully coated with Co-Ni-P, and the inner structure of the shells are hollow in structure. The shells exhibit excellent microwave absorption properties in 5-17 GHz frequency. The microwave reflection loss is above −10 dB in 5.38-16.6 GHz frequency. The maximum microwave reflection loss reaches −35.83 dB at 9.12 GHz for samples thickness 2.4 mm, and the widest bandwidth for microwave reflection loss above −10 dB is about ∼5.32 GHz for samples thickness 2.0 mm. These results confirm the feasibility of applying Bacillus as biotemplates for fabrication of the metallic shells as lightweight microwave absorption materials are very promising for applications.