激子复合区厚度对有机磁效应的影响

在常规型有机发光二极管的基础上, 通过改变发光层tri-(8-hydroxyquinoline) aluminum (III) (Alq₃)厚度, 研究了激子复合区厚度对有机发光二极管磁效应的影响.测量了器件在不同温度及偏压下电致发光及注入电流在外加磁场作用下的变化, 着重研究了低温下的有机磁电导效应和有机磁电致发光效应.实验发现, 低温(50 K)高磁场 (500 mT)下, 器件表现出随Alq₃厚度的减薄, 磁电导值由正到负再到正的非单调变化.利用磁场调控的超精细相互作用、 磁场抑制的三重态激子-电荷反应以及激子在界面的淬灭效应, 对有机磁电导在低温下表现出的现象进行了定性的解释.实验结果表明, 通过改变激子复合区的厚度, 可以实现对激子浓度的有效调节, 进而实现对有机磁电导和磁电致发光效应的调节. 该研究进一步丰富了有机磁效应的实验现象, 同时提供了一种调控有机磁效应的手段. 关键词： 激子复合区 激子浓度 有机磁电导 有机磁电致发光     

超临界水临界区域判定方法研究

对超临界水在临界区域进行合理的判定和区域划分,对于深入理解超临界水在临界过渡区域的流动和换热相关特征具有重要的作用。本文分析了超临界水从拟液态区向拟汽态区过渡的过程中,其导热系数、动力粘度、定压比热和膨胀系数等相关参数的变化规律特征,并归纳了已有超临界水在临界区域的划分判定模型。分析结果表明,在临界过渡区域,超临界水的流动特征参数和换热特征参数均会发生一系列连续剧烈的变化;只有同时考虑超临界水的膨胀特性和最大比热特性,才能更加合理地对临界区域进行划分。在此分析基础上,本工作完善了超临界水的三区分析判定模型,得到了新的超临界水在临界区域的判定划分数据,并由此拟合得到了新的超临界水分区边界计算关系式。新的计算关系式的误差范围在±0. 3℃之内,满足计算分析的要求。     

狭缝光栅自由立体显示器立体可视区域的研究

提出了反映观察区域某一点是否是合适的立体观察点立体图像质量因子的概念.根据狭缝光栅自由立体显示器的结构和工作原理并应用几何光学知识,分析得出了立体图像质量因子的计算公式,并给出了立体显示器的立体图像质量因子的计算结果.通过定义立体图像质量因子的阈值,得到狭缝光栅自由立体显示器的立体可视区域.     

利用电磁法研究HMX与TATB混合钝感炸药的冲击起爆特性

为研究含有少量奥克托金(HMX)且以三氨基三硝基苯(TATB)为基的高能钝感炸药PBX-3的冲击起爆反应增长规律,采用火炮驱动蓝宝石飞片的方法和铝基组合式电磁粒子速度计技术进行了一维平面冲击实验。通过实验测量撞击表面及内部不同深度处的冲击波后粒子速度,得到PBX-3炸药的Hugoniot关系。根据冲击波示踪器所测数据绘制了炸药到爆轰的时间-距离(x-t)图,获得了反映炸药冲击起爆性能的Pop关系。将入射压力为12.964 GPa时达到爆轰的6条速度曲线修整成相同零点,通过读取6条曲线的分离点即反应区末端的C-J点,计算出化学反应区时间和宽度。     

Design and optimization of a cavitating device for Congo red decolorization: Experimental investigation and CFD simulation

The aim of this work is to perform design and optimization of a cavitating device based on CFD simulation. A set of operational and geometrical parameters such as convergence angle, divergence angle, length of throat, and inlet pressure that can affect the hydrodynamic cavitation phenomenon generating in a Venturi are evaluated through CFD simulation and experimental approaches. Response surface methodology (RSM) was employed to achieve the optimum geometrical configuration. The CFD results show that the maximum cavitation zone in the Venturi can be obtained when half angle of the convergence section, throat length and half angle of the divergence section are 22.7°, 4 mm, and 6.5°, respectively. A maximum decolorization of 38.8% has been obtained using the designed Venturi at cavitation number (Cv) of 0.12. Additionally, the results were compared to that of various orifice plates. A decolorization of 26.2% using 33 holes orifice plate and 11.55% in one hole orifice plate approved the superiority of the designed Venturi.     

Capillary electrophoresis and ultra-high-performance liquid chromatography methods in clinical monitoring of creatinine in human urine: A comparative study

Creatinine is an important diagnostic marker and is also used as a standardization tool for the quantitative evaluation of exogenous/endogenous substances in urine. This study aimed at evaluating and comparing three analytical approaches, based on hyphenations of different separation [two-dimensional capillary isotachophoresis (CITP–CITP), capillary zone electrophoresis (CZE), ultra-high-performance liquid chromatography (UHPLC)] and detection [conductivity (CD), ultraviolet (UV), tandem mass spectrometry (MS/MS)] techniques, for their ability to provide reliable clinical data along with their suitability for the routine clinical use (cost, simplicity, sample throughput). The developed UHPLC–MS/MS, CITP–CITP–CD, and CZE–UV methods were characterized by favorable performance parameters, such as linearity (r ˃ 0.99), precision (relative standard deviation, 0.22–2.97% for the creatinine position in analytical profiles), and recovery (87.1–115.1%). Clinical data, obtained from the analysis of 24 human urine samples by a reference enzymatic method, were comparable with those obtained by the tested methods (Passing–Bablok regression and Bland–Altman analysis), approving their usefulness for the routine clinical use. In this context, the UHPLC–MS/MS method provides benefits of enhanced orthogonality/accuracy and high sample throughput (threefold shorter total analysis times than the CE methods), whereas advantages of the CE methods for routine labs are simplicity and low cost of both the instrumentation and measurements.     

A mode split,Godunov‐type model for nonhydrostatic,free surface flow

A previously developed model for nonhydrostatic, free surface flow is redesigned to improve computational efficiency without sacrificing accuracy. Both models solve the Reynolds averaged Navier–Stokes equations in a fractional step manner with the pressure split into hydrostatic and nonhydrostatic components. The hydrostatic equations are first solved with an approximate Riemann solver. The hydrostatic solution is then corrected by including the nonhydrostatic pressure and requiring the velocity field to obey the incompressibility constraint. The original model requires the solution of a Riemann problem at every cell face for each vertical layer of cells, which is computationally expensive. The redesigned model instead solves the shallow water (long wave) equations for the hydrostatic solution. Vertical shear is computed by subtracting the shallow water equations from the full three dimensional equations, which removes the hydrostatic thrust terms. Therefore, the required fluxes may be more efficiently computed with velocity based upwind differencing rather than solving a Riemann problem in each vertical layer of cells. This approach is termed mode splitting and has been used in hydrostatic coastal and ocean circulation models, but not surf zone models. Numerical predictions are compared with analytical solutions and experimental data to show that the mode split model is as accurate as the original model, but requires significantly less computational effort especially for large numbers of cell layers. Published 2014. This article is a U.S. Government work and is in the public domain in the USA.     

Capillary zone electrophoresis of lipoarabinomannan by multi-layered concentration

The present article describes a capillary zone electrophoresis method which relies on a multilayered water-alkali solvent stacking with online ionization to enhance detection of mannose, arabinose, and their oligosaccharides, which are used as the migration profile standards but are also the distinctive structural components of lipoarabinomannan. Lipoarabinomannan is detected in patients having tuberculosis. The capillary electrophoresis method with ionization of the whole saccharides without degradation in alkaline solution inside the capillary is based on the structural deprotonation of the molecules under ultrahigh pH conditions. The validation of the capillary electrophoresis parameters revealed that the 15-fold electrolyte–water-injection plug allowed detection of one-third lower concentrations than detected without online concentration. For the first time, the better detectability was seen especially for highly polymerized, but otherwise poorly ionized, arabinooctaose. The applicability of the method for detecting whole large biological saccharide complexes was confirmed by the glycolipid lipoarabinomannan. For the first time also, the migration of the indestructible lipoarabinomannan was detected together with oligosaccharides used representing the capping units, namely mannose, mannobiose, and mannotriose. The myo-inositol-phosphate-lipid unit was seen to migrate separately from the arabinomannan, since it was hydrolyzed from one lipoarabinomannan product under alkaline conditions in capillary electrophoresis.