Approaching compositional limits of perovskite – type oxides and oxynitrides by synthesis of Mg0.25Ca0.65Y0.1Ti(O,N)3, Ca1–xYxZr(O,N)3 (0.1 ≤ x ≤ 0.4), and Sr1–xLaxZr(O,N)3 (0.1 ≤ x ≤ 0.4)

Partial substitution of cations and anions in perovskite-type materials is a powerful way to tune the desired properties. The systematic variation of the cations size, the partial exchange of O²⁻ for N³⁻ and their effect on the size of the optical band gap and the thermal stability was investigated here. The anionic substitution resulted in the formation of the orthorhombic perovskite-type oxynitrides Mg_0.25Ca_0.65Y_0.1Ti(O,N)₃, Ca_1-xY_xZr(O,N)₃, and Sr_1–xLa_xZr(O,N)₃. A two-step synthesis protocol was applied: i) (nano-crystalline) oxide precursors were synthesized by a Pechini method followed by ii) ammonolysis in flowing NH₃ at T = 773 K (Ti) and T = 1273 K (Zr), respectively. High-temperature synthesis of such oxide precursors by solid–state reaction generally resulted in phase separation of the different A-site cations. Changes of the crystal structures were investigated by Rietveld refinements of the powder XRD data, thermal stability by DSC/TG measurements in oxygen atmosphere, oxygen and nitrogen contents by O/N analysis using hot gas extraction technique, and optical band gaps by photoluminescence spectroscopy. By moving from Mg_0.25Ca_0.65Y_0.1Ti(O,N)₃ via Ca_1–xY_xZr(O,N)₃ to Sr_1–xLa_xZr(O,N)₃, the degree of tilting of the octahedral network is reduced, as observed by an increase in the B–X–B angles caused by the simultaneously increasing effective ionic radius of the A-site cation(s). In general, increasing substitution levels on the A-site (Y³⁺ and La³⁺) are accompanied by an enhanced replacement of O²⁻ by N³⁻. In all three systems, this anionic substitution resulted in a reduction of the optical band gap by approximately 1 eV (Ti) and up to 2.1 eV (Zr) compared to the respective oxides. For Mg_0.25Ca_0.65Y_0.1Ti(O,N)₃ an optical band gap of 2.2 eV was observed, appropriate for a solar water splitting photocatalyst. The Zr-based oxynitrides required a by a factor of 2 higher nitrogen contents to significantly reduce the optical band gap and the measured values of 2.9 eV–3.2 eV are larger compared to the Ti-based oxynitride. Bulk thermal stability was revealed up to T = 881 K. In general, the thermal stability decreased with increasing substitution levels due to an increasing deviation from the ideal anionic composition as demonstrated by O/N analysis.     

Effective mass and band gap of strained graphene

The effective mass of strained graphene is investigated by tight-binding and density-functional theory calculations. For graphene strained in the zigzag direction, we find a strong anisotropy in the effective mass near the gap opening, with an abrupt increase of the effective mass at the critical strain in one direction and a smooth variation perpendicular to it. There is no band-gap opening for isotropic strain, but at an expansive strain of about 28%, the lower edge of the s-band reaches the Fermi level and makes the graphene metallic.     

The band gap and transmission characteristics investigation of local resonant quaternary phononic crystals with periodic coating

In this article, the investigation of the Lamb wave propagation in two-dimensional phononic crystals (PCs) composed of an array of periodic coating on a thin plate is presented. Compared with the traditional PCs usually consist of cylindrical scatters with uniform coatings in their exterior structure, the newly exterior coating structures with periodic alternant arrangement of two different materials are proposed. The band structures are calculated using finite element method. We discover that a complete band gap can be exhibited at low frequency. Furthermore, for a finite PCs plate, the computed transmission and resonance spectra shown an evident resonance nature which can be directly related to formation of the low-frequency gaps. The effects of different material parameters and arrangement mode of coating on the acoustic energy transmission and attenuation are also studied. Finally, the experimental transmission spectrum of the periodic coating PCs are also presented and compared with the numerical results. This study will provide useful support to the design of tuning band gaps and isolators in the low-frequency range.     

Structural,optical and photocatalytic properties of (Mg,Al)-codoped ZnO powders prepared by sol–gel method

Structural and optical properties of 1 at % Al-doped Zn_1−xMg_xO (x=0–8%) powders prepared by sol–gel method were systematically investigated by means of X-ray diffraction, scanning electron microscopy, ultraviolet–visible absorbance measurement, photoluminescence and Raman scattering spectra. All the powders retained the hexagonal wurtzite structure of ZnO. The band gap and near band emission energies determined from absorbance and photoluminescence spectra increased linearly with increasing Mg content, respectively, which implied that the Mg worked effectively on ZnO band gap engineering, irrespective of Al codoping. However, according to the PL and Raman scattering studies, for the sample of x=8%, the Al doping efficiency was decreased by higher Mg codoping. On the other hand, the effect of Mg codoping on photocatalytic degradation of methylene orange was explored experimentally. The substitution of Mg ions at Zn sites shifted the conduction band toward higher energies and then enhanced the photocatalytic activity, while the incorporation of interstitial Mg ions and decreased Al doping efficiency for higher Mg doping sample (x=8%) reduced the photocatalytic activity.     

Thermal stability,morphology and electronic band gap of Zn(NCN)

The thermal behavior of zinc carbodiimide Zn(NCN) was examined in the temperature range between 200 and 1100 °C in Ar atmosphere. The material starts to partially decompose at about 800 °C. Heat treatment at temperatures beyond 800 °C results in the formation of the byproducts nitrogen-containing bamboo-like multiwall carbon-nanotubes of 20–50 nm in diameter due to a partial decomposition of Zn(NCN) into dicyan (CN)₂, zinc and nitrogen gas followed by the polymerization of the former product to paracyanogen (CN)_n. At 1100 °C, the yield of the residual carbodiimide depends on the dwelling time and the initial amount of powder used for pyrolysis. One hour dwelling at 1100 °C yields ∼50% of the Zn(NCN) separated as pure material. Temperature-induced change in the band structure, namely indirect-to-direct band gap transition, is registered when compared the Zn(NCN) at room temperature with the residual material annealed at 1100 °C. The transition from indirect (E_g = 4.32 eV) to direct band gap (E_g = 4.93 eV) is due to the thermal annealing process which results in healing of crystal defects.     

The first representative of a new class of charge transfer complexes in o-quinone series for organic semiconductors

The first representative of a new class of charge transfer complexes for organic semiconductors was synthesized. The reaction of p-nitroaniline (PNA) with [1,10]-phenanthroline-5,6-dione (PD) results in the formation of a stable molecular charge transfer (CT) complex PNA₃-PD₂ in a ratio of 3:2. The structure of the molecular CT complex PNA₃-PD₂ was established by X-ray diffraction studies. Using the density functional theory method, it is shown that several types of intermolecular interactions are realized in the complex: between the PNA amino group and the nitro group of another PNA molecule, carbonyl groups, and PD nitrogen atoms. Complex PNA₃-PD₂ is stable only in solid form. The diffuse reflectance UV–vis spectrum of PNA₃-PD₂ crystal powder is characterized by the intense weakly structured long-wavelength absorption band up to 650 nm. Quantum chemical calculations of the electronic structure have shown that the complex PNA₃-PD₂ is a straight-band semiconductor with a band gap of 2.11 eV.     

Study on structure and properties of transition metal doped BiF3 by first-principles

Structure and physical properties of BiF₃ doped with M=Cr, Cu, Fe, Mn, Ni, Ti, V and Co are calculated by the DFT+U method. Effect of metal doping on the electronic structure and optical response of host materials BiF₃ is investigated systematically. New energy levels are formed and located within the band gap, which could decrease the recombination rate of e⁻/h⁺ pairs. Furthermore, transition metal doping extends the optical absorption of BiF₃ to the visible spectral region.     

纳米氧化锌的过饱和控制生长与大小分布控制.

"在非水介质中合成了纳米氧化锌,测定了纳米氧化锌的紫外吸收光谱,并用有效质量模型计算了粒子大小,开发并命名了一种称之为纳米粒子过饱和控制生长的技术,该技术涉及将小的纳米粒子悬浊液加入到大的粒子悬浊液中,结果因为不同大小粒子间的溶解度差异小的粒子将全部溶解,大的粒子将整体长大,大粒子悬浊液的粒子数将保持不变,大粒子的生长速度显著比Ostwald老化的高．该技术最显著的特征是只要最初两悬浊液粒子大小的差异足够大,分布不是太宽,则粒子大小的分布将会因为粒子如此长大而变窄．"     

双原子正方晶格光子晶体边界模式的光传输特性

利用平面波展开法,发现双原子正方晶格光子晶体中ΓM方向边界面存在着快慢两类边界模式,并且通过计算色散关系和电场分布研究了边界参量对这两类边界模式传输特性的影响.依据两种模式的色散关系,计算了群指数和群速度色散参量,结果表明边界参量的变化对第一类边界模式传输特性的影响较小,该模式的平均群指数始终维持在5.0左右;第二类边界模式与第一类模式明显不同,边界参量的变化能够有效地影响到这种模式的传输特性,该模式的最大平均群指数可达178左右.利用时域有限差分法记录了不同时刻电场强度在边界附近的分布及监测点处的电场幅度变化情况,结果表明,两类模式都能够被限制在边界附近并向前传播,时域有限差分法得到的群速度与平面波展开法的结果完全吻合.     

Electronic properties of α-graphyne nanoribbons under the electric field effect

In this paper, we investigate the electronic structure of both armchair and zigzag α-graphyne nanoribbons. We use a simple tight binding model to study the variation of the electronic band gap in α-graphyne nanoribbon. The effects of ribbon width, transverse electric field and edge shape on the electronic structure have been studied. Our results show that in the absence of external electric field, zigzag α-graphyne nanoribbons are semimetal and the electronic band gap in armchair α-graphyne nanoribbon oscillates and decreases with ribbon's width. By applying an external electric field the band gap in the electronic structure of zigzag α-graphyne nanoribbon opens and oscillates with ribbon width and electric field magnitude. Also the band gap of armchair α-graphyne nanoribbon decreases in low electric field, but it has an oscillatory growth behavior for high strength of external electric field.