Resistance analysis for enhanced wastewater membrane filtration

This study investigated enhancement techniques for synthetic wastewater filtration in a membrane bioreactor (MBR) at mixed liquor suspended solids concentrations (MLSS) of 12–18 g/L. Air sparging (AS), backflushing (BF) and a combined application of both (AS + BF) were applied to increase permeate flux compared to the conventional application (NON). Scanning electron microscope (SEM) measurements of cake thickness served for evaluating cleaning effectiveness and as input data for some of the model calculations. AS + BF showed the lowest overall resistance, and thus the highest permeate yield, for about 2 weeks of observation. The contribution of fouling resistance, cake resistance and membrane resistance to the overall resistance was evaluated, based on experimental data. Air sparging significantly lowered cake thickness and consequently cake resistance. The experimental cake resistance and the model resistances were compared. A model based on the measured cake thickness and literature values for the specific surface area proved most successful. Finally, a relationship between the backflush resistance and the permeate flow resistance was observed.     

Sampling and sample-preparation strategies based on solid-phase microextraction for analysis of indoor air

Applications of solid-phase microextraction (SPME) to the sampling and analysis of volatile organic compounds in indoor air are reviewed, including a summary of quantification methods, coatings, compounds, concentrations, sampling locations and times, and detection limits. Strategies for on-site and off-site sampling and analysis, advantages and challenges associated with SPME for air sampling are discussed.     

Continuous chemiluminescence determination of formaldehyde in air based on Trautz-Schorigin reaction

A new continuous method for the determination of formaldehyde in air is described. A cylindrical wet effluent diffusion denuder is used for the collection of formaldehyde from air into a thin film of absorption liquid (distilled-deionized water). Formaldehyde in the denuder concentrate is on-line detected employing a chemiluminescence flow method based on a reaction of formaldehyde and gallic acid with hydrogen peroxide in an alkaline solution. The collection efficiency of formaldehyde is quantitative at the air flow rate of 0.5 L min⁻¹ (absorption liquid flow rate of 336 μL min⁻¹). The limit of detection (S/N = 3) is 0.60 μg m⁻³ HCHO (0.49 ppb). The calibration graph is linear up to 300 μg m⁻³ HCHO (244 ppb). The relative standard deviations of chemiluminescence method for 1 × 10⁻⁶ and 5 × 10⁻⁶ M HCHO are 2.87% and 1.49%, respectively. Acetaldehyde interferes negligible, other compounds do not interfere. The method was employed for formaldehyde measurement in ambient air. The comparison measurement illustrates the good agreement of results obtained by proposed method with those obtained by reference fluorimetric method.     

无处不在的化学——吹进人间的清凉之风

The invention of air conditioner (AC) has undoubtedly saved the world from the heat of summer. The development of AC is an important embodiment of continuous development and perfection of science and technology. This article explains the mechanism of freon pollution from the perspective of chemistry, and enumerates the important role of fluoride in daily life, to eliminates people's misunderstanding of fluorine element. The hardships of extracting fluorine reflect the chemists' research experience of collecting experience from failure and the scientific spirit of pursuing the truth.     

Methane production from synthesis gas using a mixed culture ofR. rubrum M. barkeri,and M. formicicum

The components of synthesis gas, CO, H₂, and CO₂, may be converted into CH₄ biologically through either acetate or H₂/CO₂ as intermediates. Of these two routes, conversion through H₂/CO₂ is preferred. This paper presents results of mixed-culture studies employing the photosynthetic bacteriumR. rubrum for converting CO to CO₂ and H₂ by the water gas shift reaction and two methanogens,M. formicicum andM. barkeri, for converting CO₂ and H₂ into CH₄. Results are presented for triculture operation in two types of reactors, the packed bubble column and the trickle-bed reactor.     

A simple and fast micromethod for the analysis of polychlorinated biphenyls in air by sorbent enrichment and ultrasound-assisted solvent extraction

A combination of sorbent enrichment and ultrasound-assisted solvent extraction has been used to determine polychlorinated biphenyls in air. Analytes were sampled by pumping a known volume of air through a porous polymer (Tenax TA). The enriched adsorbent was transferred into a glass vial, and ultrasound-assisted extraction of the analytes was then performed in n-hexane. Quantification was carried out by using gas chromatography coupled to tandem mass spectrometry. Breakthrough volume of the sampling step was studied, indicating that 10 m³ of air could be processed without losses of the most volatile compounds. Good recoveries (75–96%) were obtained, and limits of detection at the sub ng m^–3 were achieved for all the analytes. The proposed method is very simple and fast, avoiding the use of large solvent volumes and time-consuming preconcentration steps.     

Determination of methylmercury fluxes across the air–water and air–soil interfaces by gas chromatography with electron capture detection

A method for the determination of methylmercury (MeHg) fluxes across the air–water and air–soil interfaces was developed using an in situ chamber. The MeHg in the air coming out of the chamber was captured by a column containing sulfhydryl cotton fiber adsorbent. MeHg was then desorbed from the column by using 2 mol L^–1 HCl. The MeHg in the effluent was extracted with benzene, and determined by gas chromatography with electron capture detection. Finally, the MeHg flux was calculated using the chamber. The method was applied to simulated experiments, and the results showed that the MeHg fluxes in the air–water system were higher than those in the air–soil–water system. The method was also successfully applied to the field measurements of an environment polluted by a chemical factory, and the results showed that the MeHg fluxes across the air–soil and air–water interfaces were 0.21–3.09 and 0.14–0.79 ng m^–2 h^–1, respectively. The method will be a useful tool in the environmental study of MeHg.     

Polypyrrole-based sensor for hydrazine and ammonia

An ultra-thin layer of polypyrrole can be coated on non-conducting substrates, e.g., acrylic, by dip coating into a colloidal suspension of polypyrrole. This thin coating reversibly combines with low concentrations of ammonia or hydrazine with a concomitant reversible increase in resistance; 0.1 μg cm^?3 of ammonia can readily be detected with a 1 cm² area of sensor.     

Dynamic surface tension of micellar solutions studied by the maximum bubble pressure method

A theoretical model for the dynamic surface tension of an air bubble expanding in micellar surfactant solution is proposed. The model accounts for the effect of expansion of the bubble surface during the adsorption of surfactant molecules (monomers) and the effect of disintegration of polydisperse micelles on the surfactant diffusion. Assuming small deviations from equilibrium and constant rate of expansion analytical expression for the surface tension and the subsurface concentration of monomers as a function of time is derived. The characteristic time of micellization is computed from the experimental data for two surfactants (sodium dodecyl sulfate and nonylphenol polyglycol ether) obtained by the maximum bubble pressure method.     

多片导模法蓝宝石晶体的缺陷研究

使用导模法(EFG)生长了多片a面蓝宝石晶体。显微拉曼光谱结合电感耦合等离子体发射光谱(ICP-AES)测试得出晶体的气泡中可能存在含S化合物。晶体表面明显的生长条纹主要与温度、生长速度的波动以及模具的加工精度有关。化学腐蚀分析表明晶体位错密度在4.2×10⁴ cm^-2,未存在小角度晶界缺陷,双晶摇摆曲线半峰宽(FWHM)为70.63″。由于采用石墨保温材料,晶体中存在F心与F⁺色心。晶体在400~3 000 nm波段透过率高于80%,空气中退火后可减弱色心吸收。本文研究结果可为蓝宝石晶体缺陷形成理论研究提供参考,也可为导模法蓝宝石工业生产技术改进提供借鉴。