基于高阶累计量的大气光通信自适应信号处理

针对强湍流信道下信号衰落的特点,分析了对数正态分布模型与K分布模型的适用范围.基于K分布模型建立大气光通信接收信号模型,并给出了自适应最优门限检测方法.采用四阶和六阶累计量对强湍流信道参量进行估计,采用二阶累计量对其它高斯噪音进行估计,得到K分布参量及高斯噪音统计量的预测值,实现自适应门限更新.基于Monte Calro算法进行仿真,给出了门限更新算法对通信系统误码率的影响,同时分析了信号采样率对估计参量偏差的影响.计算表明,在强湍流情况下,大气光通信系统的误码率性能得到极大的改善,优于基于MLSD检测的接收机.     

大功率高温超导滤波器的设计与功率测试

本文在双面YBCO高温超导薄膜上设计并制备了两节大功率超导滤波器,根据滤波器功率承载能力与最大电流密度之间的关系,减小电流密度和分散电流密度的分布是提高功率承载能力的关键.本文采用增加超导谐振器尺寸、优化几何结构及改进馈线耦合方式的方法,设计了两节2 GHz频段梭型谐振器结构的滤波器.设计及测量结果显示了馈线结构及谐振器几何尺寸优化程度对超导滤波器功率承载能力有不同程度的影响,说明了在大功率超导滤波器设计中应选用无结点间隙耦合式馈线以抑制电流密度的聚集.采用优化后的谐振器结构制备的梭型两节超导滤波器经测试功率承载能力为2 W.超导滤波器的尺寸为25×12 mm LaAlO3基片,中心频率2.022 GHz,相对带宽为2.4%.同时给出了超导滤波器功率测试的结构和方法.     

大功率限幅器的研制

介绍了一种L波段大功率限幅器的研制情况,该限幅器具有体积小、插入损耗小、输入承受功率高及限幅输出电平低等特点。文中给出了限幅二极管在高/低输入信号电平时的等效电路以及同轴滤波器的设计分析过程。实验测试结果表明,限幅器完全达到技术指标要求。     

一种超混沌映射的单双参量自适应同步

利用参量自适应法实现了超混沌系统Kawakami映射的同步.通过严密的数学推导,给出了Kawakami映射在单参量自适应下实现同步的充分条件,并在双参量自适应控制下系统同样实现了同步.数值模拟结果显示,该映射输出具有类似于白噪声的宽谱特性,因此比较适合用于保密通信.     

基于CIC的数字正交锁相放大器的甲烷检测实验研究

针对甲烷在大气中背景气体成分复杂、检测难度大、稳定性差等问题,本文基于可调谐二极管激光吸收光谱技术和波长调制光谱技术,将积分梳状滤波器与有限脉冲响应滤波器相结合应用于数字正交锁相放大器,开展大气中甲烷气体的痕量检测实验研究.实验表明,与传统的数字正交锁相放大器相比较,改进的数字正交锁相放大器提取的二次谐波信号的信噪比从...     

基于卷积神经网络的红外与可见光户外图像融合

针对户外环境下红外与可见光图像融合效果不足的问题,提出一种基于卷积神经网络的红外与可见光户外图像融合方法。该方法先利用滚动引导滤波器对输入的红外图像进行预处理,过滤噪声并消除无用信息。然后,利用Curvelet变换将红外图像与可见光图像分解成高频系数与低频系数,利用基于卷积神经网络的深度特征融合规则融合高频系数,采用最小融合规则融合低频系数。实验结果表明,该方法的融合图像在主观视觉与客观定量两方面均获得了较好的结果。     

Optimization designed large-stroke MEMS micromirror for adaptive optics

A novel micromirror based on the PolyMUMPs process is designed and presented. The hexagonal micromirror with a diameter of 450 μm consists of three supporting bilayer cantilevers and a mirror plate. The bilayer cantilevers, formed with a polysilicon layer and a gold layer, elevate the mirror plate according to residual stress-induced bending. Both analytical and finite element analysis (FEA) models are built to calculate the elevated height of the free end of the cantilever. The analytical solution is in accordance with the FEA simulation results, with longitudinal stresses applied only. Results of a three-dimensional (3D) simulation with two direction stresses applied also show the elevated height to be proportional to the width of the cantilever and the length of the gold layer. Due to the torque of the joint, the elevated heights of the two kinds of cantilevers assembled with the mirror plates are much smaller than those of the free end of the cantilevers. Both micromirrors with different cantilevers are fabricated. The elevated heights of the fabricated micromirrors are measured using Veeco optical profiler, which show good coincidence with simulation results.     

一种基于二进提升方案的医学图像增强

通过分析和研究二进提升方案,得到一种新的提升二进小波滤波器的构造方法.以新的B-样条二进小波作为初始二进小波滤波器,结合二维6 trous算法对原始医学图像进行多层分解,根据分解后系数特点,一方面对不同级数的高频系数利用单阈值和双阈值函数增强,对低频子带系数用线性拉升来扩大图像的整体对比度.另一方面结合消失矩条件,调整滤波器的提升参数,构造了具有线性相位、紧支撑、高阶消失矩及有限长的单位脉冲响应的提升二进小波,并将其与初始二进小波滤波器增强后图像进行比较.仿真结果表明提升后的滤波器对于对比度低、弱光照图像比初始滤波器的增强效果有了进一步提高,噪声放大问题有明显改善,更好地突出图像边缘特征、保留了图像更多细节信息.     

Single-material guided-mode resonance filter for TE waves under normal incidence

<正>A guided-mode resonance(GMR) filter with the same material(Ta_2O_5) for both the grating layer and the waveguide layer is designed and fabricated.This simple structure is easy to fabricate and can avoid the defects at the grating/waveguide interface using different materials.The spectral response measured with a Lambda 900 spectrophotometer under normal incidence for TE waves exhibits a peak reflectance exceeding 80%at the wavelength of 1040 nm with a full-width half-maximum(FWHM) linewidth of 23 nm.We evaluate the deviations of the fabricated structure from the designed parameters.     

THEORY OF DIELECTRIC ELASTOMERS

In response to a stimulus, a soft material deforms, and the deformation provides a function. We call such a material a soft active material （SAM）. This review focuses on one class of soft active materials： dielectric elastomers. When a membrane of a dielectric elastomer is subject to a voltage through its thickness, the membrane reduces thickness and expands area, possibly straining over 100%. The dielectric elastomers are being developed as transducers for broad applications, including soft robots, adaptive optics, Braille displays, and electric generators. This paper reviews the theory of dielectric elastomers, developed within continuum mechanics and thermodynamics, and motivated by molecular pictures and empirical observations. The theory couples large deformation and electric potential, and describes nonlinear and nonequilibrium behavior, such as electromechanical instability and viscoelasticity. The theory enables the finite element method to simulate transducers of realistic configurations, predicts the efficiency of electromechanical energy conversion, and suggests alternative routes to achieve giant voltage-induced deformation. It is hoped that the theory will aid in the creation of materials and devices.