ITO上AuPd合金和Au阵列图案的制备及电催化活性的SECM表征

利用电化学湿法印章技术在氧化铟锡(ITO)导电玻璃上制备AuPd合金和Au的双组分阵列图案. 采用具有微浮雕图案的琼脂糖印章存储足够多的溶液,并通过控制电沉积的时间来控制图案厚度. 应用场发射扫描电子显微镜(FE-SEM),X射线能谱分析(EDX)和原子力显微镜(AFM)分别对ITO表面上的AuPd合金和Au的形貌和组分进行表征,并通过循环伏安(CV)技术和扫描电化学显微镜(SECM)研究比较了Au和AuPd合金的催化活性. 利用扫描电化学显微镜(SECM)的针尖产生-基底收集(TG-SC)模式和氧化还原竞争(RC)模式,发现Au电极对二茂铁甲醇氧化物(FcMeOH⁺)电催化还原能力高于AuPd合金电极,而在AuPd合金上催化还原H₂O₂的能力显著高于Au.     

低温热分析标准物质的研制

研制了两种0~100℃热分析标准物质,分别为金属镓和水杨酸苯酯标准物质。研制的标准物质具有良好的均匀性和稳定性,采用与NIST,LGC相应标准物质比较的方法定值。NIST为SRM 2234镓,其定值采用288.6~314.35 K范围内的绝热热量计测得温度及热量值;LGC用绝热法为水杨酸苯酯的熔化温度和熔化热定值,两种方法都可以直接溯源至SI单位。对定值结果的不确定度进行了分析和评定。镓和水杨酸苯酯标准物质的熔化温度分别为(29.77±0.20)℃(k=2),(41.81±0.34)℃(k=2);熔化热分别为(80.52±0.48)J/g(k=2),(88.94±0.62)J/g(k=2)。研制的两种标准物质满足国家标准物质的技术要求,申报已获批准。     

线性扫描伏安法测定辣椒制品中苏丹红Ⅰ含量

基于苏丹红Ⅰ分子中的-C=C-和-N=N-基团的电活性,在悬汞电极上还原产生还原波,其还原峰高与苏丹红的浓度呈线性关系。据此提出用线性扫描伏安法测定辣椒制品中苏丹红Ⅰ的含量。试验中用悬汞电极为工作电极,饱和甘汞电极为参比电极,铂微电极为对电极,饱和硼砂缓冲溶液(pH 9.2)为支持电解质,并以丙酮作为样品的溶剂,记录在-1 050mV处还原峰电流ip。测得苏丹红Ⅰ的质量浓度在0.1~1.4mg·L-1范围内与其峰高呈线性关系,检出限(3s/k)为9.8μg·L-1。用标准加入法进行回收试验,测得回收率在88.0%~98.4%之间,测定值的相对标准偏差(n=5)在0.72%~5.4%之间。     

Synthesis and electrochemical performance of LiNi0.6Co0.2Mn0.2O2 as a concentration-gradient cathode material for lithium batteries

A well-ordered and spherical LiNi0.6Co0.2Mn0.2O2 cathode material was successfully synthesized from Ni and Mn concentration-gradient precursors via co-precipitation. The crystal structure, morphology and electrochemical properties of LiNi0.6Co0.2Mn0.2O2 were characterized by X-ray diffraction, scanning electron microscopy, energy-dispersive spectroscopy, and charge-discharge tests. The material delivered an initial discharge capacity of 174.3 mAh/g at 180 mA/g （1 C rate） between 2.8 and 4.3 V and more than 93.1% of that was retained after 100 cycles. In addition, it also exhibited excellent rate capability, high cut-off voltage and temperature performance.     

Fabrication of hollow silica microspheres utilizing a hydrothermal approach

Hollow silica microspheres(HSMSs) have been successfully fabricated via a facile hydrothermal route using D-glucose as the sacrificial template and sodium silicate powder as the silica precursor.The resulting silica hollow particles were characterized by scanning electron microscopy(SEM),transmission electron microscopy(TEM),X-ray diffraction(XRD),and infrared spectroscopy(IR).The surface area was determined using the BET method.SEM and TEM images exhibited micro-sized silica hollow particles with a size of ~1.5μm.     

多壁碳纳米管修饰玻碳电极测定铜离子

以多壁碳纳米管(MWCNTs)修饰玻碳电极为工作电极,采用阳极溶出线性扫描法研究了铜离子的电化学测定方法。探讨了MWCNTs修饰层数、富集电位、富集时间、溶液pH、支持电解质对峰电流的影响。实验表明,铜离子浓度在1.0×10-8~1.0×10-5mol·L-1范围内与峰电流呈良好的线性关系,检测限为2.0×10-9mol·L-1,且该电极具有良好的稳定性和抗干扰能力。     

数字离子阱质谱仪低质量截止值的改进方法

本研究在实验室自制的线形数字离子阱质量分析器上,通过改变数码电源的频率扫描方式,在CID过程中,通过扫描数字束缚方波电源的频率和数字激发方波的频率实现母体解离。例如对于利血平母体离子,当将离子数字束缚方波频率从500 kHz扫描到560 kHz,可以测量到低质荷比的碎片离子,成功实现了串级质谱分析的低质量碎片离子的分析。通过与利血平三重四极质谱串级质谱分析实验结果的比较,发现可以在数字离子阱质谱仪上获得与三重四极质谱相同的串级质谱测量结果。结果表明,本方法可以用于低质量离子的测量,克服了传统离子阱质谱进行串级质谱分析的一个主要难点,显著提高数字离子阱质谱的性能。     

Study of In Situ Formation of Magnesium Hydroxide Whisker via Basic Magnesium Chloride Whisker Regulated by Organic Parcels at Low Temperature

In this work, we demonstrate an in situ phase conversion from basic magnesium chloride（BMC） into magnesium hydroxide whisker by using polar organic solvent at low temperature. The morphology and phase composition of magnesium hydroxide whiskers prepared at different reaction temperature, alkali concentration and organic solvent were analyzed by X-ray diffraction（XRD） and scanning electronic microscope（SEM）. It was found that when one of the organic solvents such as absolute ethyl alcohol, butanol, polyethylene glycol（PEG-400）, acetone, et al. was selected as the template, the precursor BMC can transform into whisker-like magnesium hydroxide through precipitate transformation in low temperature and non-hydrothermal system. It can be reasonably explained that the regulation of Mg^2＋ solubility by those organic solvents and the sustained release of Mg^2＋ dissolution by organic adsorption played a significant role in the formation of magnesium hydroxide whisker via BMC whisker as the precursor.     

Vulcanization kinetics of graphene/styrene butadiene rubber nanocomposites

This paper presents the influence of graphene on the vulcanization kinetics of styrene butadiene rubber （SBR） with dicumyl peroxide. A curemeter and a differential scanning calorimeter were used to investigate the cure kinetics, from which the kinetic parameters and apparent activation energy were obtained. It turns out that with increasing graphene loading, the induction period of the vulcanization process of SBR is remarkably reduced at low graphene loading and then levels off; on the other hand, the optimum cure time shows a monotonous decrease. As a result, the vulcanization rate is suppressed at first and then accelerated, and the corresponding activation energy increases slightly at first and then decreases. Upon adding graphene, the crosslinking density of the nanocomposites increases, because graphene takes part in the vulcanization process.     

Synthesis,characterization, thermal stability and antibacterial activity of coumarin based methacrylate copolymers

Monomer of 7-methacryloyloxy-4-methylcoumarin(MAOMC) was synthesized and characterized by FTIR, 1H-NMR and 13C-NMR spectroscopy. Copolymers of MAOMC with butoxyethylmethacrylate(BOEMA) at different feed compositions were prepared by free radical solution polymerization at(70 ± 1) °C in ethylmethylketone(EMK) using benzyl peroxide(BPO) as an initiator. The copolymers were characterized by FTIR and 1H-NMR spectroscopy. Thermogravimetric analysis(TGA) and differential scanning calorimetry(DSC) of the copolymers showed moderate thermal stability and higher Tg values. Gel permeation chromatography(GPC) was used to find out the molecular weights of the different copolymers. Antibacterial activities of the copolymers were also investigated against the selected pathogenic bacteria's. The antibacterial activity of the copolymer increases as the MAOMC content increases in the copolymer. This shows that coumarin moiety plays a very important role in the antibacterial activity.