聚偏氟乙烯的氯化改性

研究了聚偏氟乙烯 (PVDF)自由基引发的氯化反应。考察了各种因素 ,如氯化剂、引发剂的种类及浓度 ,反应介质、反应温度和反应时间的影响 ,确定了合成氯化PVDF的最佳反应条件。采用碱熔法测定氯含量 ,用HNMR进行了结构表征 ,并用溶度参数法、接触角法、DTA TG等方法对PVDF氯化前后的溶解性、附着力、熔点等性能进行了测试。结果表明 ,氯原子成功地引入到了PVDF上 ,当氯含量增加到 8 3 %时 ,氯化PVDF的熔点由 1 63℃降至 1 3 0℃左右 ,附着力也有了明显的改善 ,与水的接触角由 90°降至 5 4°,由不溶于丙酮变为溶于丙酮 ,对甲醇和四氯化碳的溶度参数的变化也说明了氯化PVDF的溶解性能变好 ,由TG曲线可知 ,氯化PVDF的热稳定性比改性前虽有一定的降低 ,但其分解温度仍在 3 0 0℃以上     

Modification of solids with volatile organics III: Natural zeolites

Summary The effect of pre-adsorbed benzene and ethanol on the adsorptive properties of natural zeolite (clinoptilolite) has been studied by gas-solid chromatography. It has been shown that modification of the solid surface by volatile organics has a significant influence on the adsorptive properties. The modification is of the same order as the more difficult modification by inorganics, as illustrated here by clinoptilolite modification with Co²⁺. Energy distribution of surface adsorptive sites appears to be continuous and confirms previous finding that only a small proportion of active sites is responsible for most adsorbate retention. Part II reference [4]     

液膜法分离钒(Ⅳ)的研究

本文用P204-兰113A-煤油组成的滤膜体系处理钒(Ⅳ)的溶液,并考察了表面活性剂、载体、外相pH值、内相酸度、起始钒(Ⅳ)浓度以及乳水比等因素对分离的影响。     

Synthesis and Characterization of a Novel Biomaterial： Maleic Anhydride-modified Poly（dl-lactic acid）

A novel modified poly(dl-lactic acid) (PDLLA) was obtained by covalently grafting of maleic anhydride onto the backbone of PDLLA, attempting to improve PDLLA‘s hydrophilicity and cell affinity and to provide reactive groups for further chemical modification. FTIR, ^13 C NMR and DSC were used to characterize the maleic anhydride-modified PDLLA.     

Synthesis of the Biomimetic Polymer： Aliphatic Diamine and RGDS Modified Poly（d,l-lactic acid）

A novel poly（d, /-lactic acid） （PDLLA） based biomimetic polymer was synthesized by grafting maleic anhydride, butanediamine and arg-gly-asp-ser （RGDS） peptides onto the backbone of PDLLA, aiming to overcome the acidity and auto-accelerating degradation of PDLLA during degradation and to improve its biospecificity and biocompatibility. The synthetic copolymer was characterized by FTIR, ^13C NMR and amino acid analyzer （AAA）.     

KIT-1介孔分子筛的化学修饰及吸附性能

介孔分子筛MCM-41具有较大、可调的孔径和较高的比表面积，其骨架组成具有较强的可调变性．为该材料的应用提供了很大的空间。但全硅MCM-41分子筛在潮湿空气中，即使在室温条件下也会发生水解反应，使其介孔结构遭到破坏。前人已针对MCM-41分子筛稳定性不足的问题相继合成了稳定性较高的介孔分子筛KIT-1,     

无机添加剂对硝酸铵拒爆性的影响研究

考察了无机添加剂对农用硝酸铵拒爆性的影响。结果表明，当硝酸铵中添加3%的无机改性剂GXJ 1和10%的无机改性剂GXJ 2后，其拒爆性能明显增强；改性后的硝酸铵按照工业炸药配方配制成铵油炸药，不能被8号雷管起爆。而且改性后的硝酸铵颗粒强度高，不易粉化、结块和吸潮，具有优良的肥料品质。经济效益分析也表明，改性硝酸铵具有广阔的市场应用前景。通过X射线衍射分析、扫描电子显微镜分析等对改性硝酸铵进行了表征，并对拒爆机理进行了初步探讨。     

Surface structure and electrochemical characteristics of natural graphite fluorinated by ClF3

Natural graphite samples with average particle sizes of 5, 10 and 15 μm (NG5 μm, NG10 μm and NG15 μm, respectively) were fluorinated by ClF₃ (3 × 10⁴ Pa) at 200 and 300 °C for 2 min. X-ray photoelectron spectra of surface-fluorinated samples showed that surface fluorine concentration increased with increase in the particle size of graphite and reaction temperature. Small amounts of chlorine were also detected in all the fluorinated samples. Raman spectra of original and surface-fluorinated samples indicated that the surface disordering was increased for NG10 μm and NG15 μm. Surface areas were decreased by the fluorination for NG5 μm and NG10 μm but unchanged for NG15 μm. The mesopores with diameter of 1.5-2 nm increased while those of 2-3 nm decreased for all the samples. First coulombic efficiencies for NG10 μm and NG15 μm were highly increased by surface fluorination in 1 mol/dm³ LiClO₄-EC/DEC/PC (EC: ethylene carbonate, DEC: diethyl carbonate, PC: propylene carbonate) solution.     

Vanadium Doped Sol-Gel TiO2 Coatings

A study of the experimental conditions required to obtain vanadium doped sol-gel TiO2 coatings is presented. Tetraethyl orthotitanate was employed as the TiO2 source and VCl3, VOSO4 · H2O and VOSO4 dissolved H2SO4 where employed as vanadium sources.Dip coating has been used to produce coatings on silicon wafers, spectral carbon electrodes and titanium electrodes. Both supported and unsupported films have been studied by UV-Vis spectra, IR spectroscopy and X-ray diffraction (XRD). The measurements have been made on samples as prepared and treated thermally at temperatures between 100°C and 300°C. The thermal treatment temperatures have been established from DTA/TGA measurements.The vanadium doped sol-gel TiO2 coatings have been tested as sensors for redox potential measurements in electrochemical processes. The influence of both the thickness of films and the nature of substrate has been investigated.     

Zur Struktur und Reaktivität des Diammoniumhexafluoromanganats(IV)

About the Structure and Reactivity of Diammonium Hexafluoromanganate(IV) Electrolytic oxidation of an aqueous suspension of MnF₂ containing NH₄F, and subsequent crystallization in 40% HF yields yellow crystals of (NH₄)₂MnF₆. It crystallizes in the hexagonal K₂MnF₆ type structure with the space group P6₃mc and a = 5.903; c = 9.565 Å; Z = 2. With in situ powder diffraction studies it is shown, that (NH₄)₂MnF₆ is gradually reduced in a NH₃ atmosphere between 30 and 230 °C to afford (NH₄)₃MnF₆, (NH₄)₂MnF₅, and finally NH₄MnF₃. (NH₄)₃MnF₆, thereby, forms a hitherto unknown cubic (a = 9.082 Å) high temperature modification with the cryolite type structure. Under N₂ the thermal decomposition of (NH₄)₂MnF₆ proceeds via NH₄MnF₄ to yield MnF₂.