表面修饰二氧化锡纳米微晶的制备与表征

制备了硅烷偶联剂KH-570表面修饰的SnO2纳米微晶，通过FT-IR、XPS、TEM和TG-DTA对其结构和表面特性进行表征和研究. FT-IR和XPS分析结果确证了KH-570与SnO2表面是以化学键合或物理吸附方式相结合,粒子表面存在酯基等有机官能团的红外吸收特征；观测到KH-570中Si原子的Si2s和Si2p谱线. TEM分析表明，表面修饰反应增强了SnO2纳米微晶的疏水性和分散性.由XPS和TG的实测数据探讨了纳米粒子具有较低包覆量的可能原因.     

Ni(phen)(H2O)(V2O6)的水热合成和晶体结构（英）

A novel compound Ni(phen)(H₂O)(V₂O₆) has been hydrothermally synthesized and structurally determined to be a two-dimensional compound, which contains {V₂O₆}_n^2n- chains interconnected by nickel(Ⅱ) complexes via oxygen atoms. The crystallographic data measured by single-crystal X-ray diffraction analysis are as follows: C₁₂H₁₀N₂NiO₇V₂, M_r=454.81, monoclinic, space group P2₁/c, a=0.784 6(3), b=2.103 6(8), c=0.942 3(4) nm, β=112.872(5)°, V=1.433 0(10) nm³, Z=4, D_c=2.104 Mg·m^-3, μ(Mo Kα)=2.615 mm^-1, F(000)=904, T=298(2) K, 4 480 reflections collected, 2 470 independent (R_int=0.032 2), the final R=0.058 4 and wR₂=0.145 7 for 2 303 observed reflections with I>2σ(I). CCDC: 192520.     

High Lithium Capacity MxV2O5Ay·nH2O for Rechargeable Batteries

The aqueous synthesis and electrochemical properties of nanocrystalline M_xV₂O₅A_y·nH₂O are described. It is easily and quickly prepared by precipitation from acidified vanadate solutions. M_xV₂O₅A_y·nH₂O has been characterized by X-ray powder diffraction, electron microscopy, TGA, chemical analyses, and electrochemical studies. The atomic structure is related to that of xerogel-derived V₂O₅·nH₂O. In M_xV₂O₅A_y·nH₂O, M is a cation from the starting vanadate salt and A is an anion from the mineral acid. This material exhibits high, reversible Li capacity and may be considered for use in a cathode in primary and secondary batteries. The lithium capacity of an electrode composed of M_xV₂O₅A_y·nH₂O/EPDM/carbon (88/4/8) is ∼380(mA h)/g (C/80 rate) and the energy density is ∼1000(W h)/kg (120-μm-thick cathode, 4-1.5 V, versus Li metal anode). Critical parameters identified in the synthesis of M_xV₂O₅A_y·nH₂O, with respect to achieving high Li-ion insertion capacity, are acid/vanadium ratio, starting vanadate salt, and temperature. Inclusion of carbon black in the synthesis yields a composite that maintains the high Li capacity, lowers the electrochemical-cell polarization, and preserves the lithium capacity at higher discharge rates. Li-ion coin cells, using pre-lithiated graphite anodes, exhibit electrochemical performance comparable to that of Li-metal coin cells.     

Preparation and properties of surface modified ceramic membranes. Part III. Gas permeation of 5 nm alumina membranes modified by trichloro-octadecylsilane

Stable trichloro-octadecyl silane (ODS) derivatives of a 5 nm γ-alumina ceramic membrane were prepared. Gas permeabilities of the untreated membrane did not show Knudsen diffusion at 20°C. Gas permeabilities of the ODS membrane were three orders of magnitude lower; He, Ne, Ar, CO₂, C₃H₈ have near constant permeabilities 360 mol s⁻¹ m⁻² bar⁻¹, except methane which has the highest permeability of the group, 481 mol s⁻¹ m⁻² bar⁻¹. The mechanism of diffusion is solution/diffusion. Remarkably, permeabilities of ODS-alumina membrane were reduced by 5 X after exposure to a pressure difference of 1 atm (active layer side) against vacuum for only 10 min. The effect was metastable but could be reversed on standing for several hours, reversal of pressure difference or after washing with (hydrocarbon solvent) toluene. The mechanism was presumed to be due to movement of the octadecyl-hydrocarbon chains of the silane monolayer causing a partially blocked pore structure; perhaps a unique example of self-fouling.     

Cu/SO42-/La2O3-ZrO2-Al2O3催化剂的制备及其对C3H6选择还原NO的催化性能

以Al₂O₃为基质，添加ZrO₂和La₂O₃，制成La₂O₃-ZrO₂-Al₂O₃复合载体，然后采用SO₄^2-进行改性，再负载上Cu²⁺，制备了铜基SO₄^2-改性的复合载体催化剂(Cu/SO₄^2-/La₂O₃-ZrO₂-Al₂O₃)。考察了它在富氧条件下对丙烯选择还原NO的催化性能，并借助XRD、SEM、TG、Py-IR、NH₃-TPD、FTIR和TPR等方法研究了Cu/SO₄^2-/La₂O₃-ZrO₂-Al₂O₃的结构和性能的关系。结果表明，ZrO₂的加入主要有利于提高催化剂的低温活性；La₂O₃的加入则主要有利于提高催化剂的热稳定性和还原性能；SO₄^2-能够与Zr形成螯合双配位结构，大幅度促使催化剂表面酸量增加并且酸性增强；因此，有效地提高了Cu/SO₄^2-/La₂O₃-ZrO₂-Al₂O₃在富氧条件下对丙烯选择还原NO的催化活性和水热稳定性。在无水条件下，Cu/SO₄^2-/La₂O₃-ZrO₂-Al₂O₃能使NO的最大转化率高达84.3%，即使在275 ℃ 10%水蒸气存在的情况下，仍能使NO的转化率高达81.2%。     

MoO3—SiO2表面复合物金属催化剂载体的制备与表征

采用ＭｏＯＣｌ４的盐酸溶液负载于ＳｉＯ２的表面反应法，制备了负载型和键联型两种ＭｏＯ３－ＳｉＯ２（ＭｏＳＯ）表面复合物载体。利用红外光谱法研究了ＭｏＳＯ的表面构造及其化学吸附性能；并利用ＴＰＲ技术考察了该表面复合物载体对负载金属Ｐｄ，Ｃｕ氧化物还原过程的影响。     

Determination of residual levels of unsaturation in partially hydrogenated poly(2,3-diphenyl-1,3-butadiene) using TG

The thermal degradation characteristics of head-to-head poly(styrene) [HHPS] should provide insight with respect to the impact of head-to-head placement on the thermal stability of traditional atactic head-to-tail polymer [HTPS]. The synthesis of head-to-head poly(styrene) must be accomplished indirectly. The head-to-head polymer is most satisfactorily obtained by dissolving metal reduction of poly(2,3-diphenyl-1,3-butadiene) [PDBD] generated by radical polymerization of the corresponding diene monomer. Full saturation of the polymer mainchain requires several iterations of the reduction procedure. Since the decomposition of poly(2,3-diphenyl-1,3-butadiene) is prominent at 374°C and that for head-to-head poly(styrene) is similarly facile at 406°C, it seemed feasible that TG of partially hydrogenated PDBD might be utilized as a convenient means of monitoring the extent of hydrogenation. This has been demonstrated for various levels of unsaturation remaining - from approximately 90 to less than 10%. Within this range the peak areas from the DTG plots of the partially hydrogenated polymer provide a good reflection of the ratio of unsaturated to saturated units in the polymer. Even low levels of unsaturation in the polymer may be detected by the asymmetry of the decomposition peak for the polymer. This revised version was published online in August 2006 with corrections to the Cover Date.     

Surface modification of γ-alumina membranes by silane coupling for CO2 separation

Top layers of γ-Al₂O₃ composite membranes have been modified by the silane coupling technique using phenyltriethoxysilane for improving the separation factor of CO₂ to N₂. The separation efficiency of the modified membranes was strongly dependent upon the hydroxylation tendency of the support materials and the amount of the special functional group (i.e. phenyl radical) which was coupled onto a top layer. The separation factor through the TiO₂ supported γ-Al₂O₃ membrane was found to be fairly enhanced by silane coupling, but in case of the -Al₂O₃ supported membrane was not. The CO₂/N₂ separation factor through the modified γ-Al₂O₃/TiO₂ composite membrane is 1.7 at 90°C and ΔP = 2 × 10⁵ Pa for the binary mixture containing 50 vol% CO₂. The separation factor is proportional to the CO₂ concentration in the gas mixture, and the modified membrane is stable up to 100°C. The main mechanism of the CO₂ transport through the modified γ-Al₂O₃ layer is known to be a surface diffusion.     

V2O5/TiO2 Catalytic Xerogels Raman and EPR Studies

Raman spectroscopy and Electron Paramagnetic Resonance (EPR) studies were performed on a series of V₂O₅/TiO₂ catalysts prepared by a modified sol-gel method in order to identify the vanadium species. Two species of surface vanadium were identified by Raman measurements, monomeric vanadyls and polymeric vanadates. Monomeric vanadyls are characterized by a narrow Raman band at 1030 cm^–1 and polymeric vanadates by two broad bands in the region from 900 to 960 cm^–1 and 770 to 850 cm^–1. The Raman spectra do not exhibit characteristic peaks of crystalline V₂O₅. These results are in agreement with those of X-ray Diffractometry (XRD) and Fourier Transform Infrared (FT-IR) previously reported (C.B. Rodella et al., J. Sol-Gel Sci. Techn., submitted). At least three families of V⁴⁺ ions were identified by EPR investigations. The analysis of the EPR spectra suggests that isolated V⁴⁺ ions are located in sites with octahedral symmetry substituting for Ti⁴⁺ ions in the rutile structure. Magnetically interacting V⁴⁺ ions are also present as pairs or clusters giving rise to a broad and structureless EPR line. At higher concentration of V₂O₅, a partial oxidation of V⁴⁺ to V⁵⁺ is apparent from the EPR results.     

表面改性对CeO2纳米粉体特性的影响

研究了表面改性对CeO2纳米粉体特性的影响，采用表面活性剂．十二烷基硫酸钠对CeO2粉末颗粒表面进行了改性。未改性和改性的纳米氧化铈用粉体综合性能测试仪、激光粒度仪、比表面积测试仪、X射线仪、扫描电子显微镜进行了表征。结果表明，用十二烷基硫酸钠表面改性能提高纳米氧化铈的流动性和分散性，减小比表面积和团聚，同时也对CeO2粉体颗粒表面改性的机制进行了探讨。