活性炭孔隙结构对催化氧化脱除单质汞的影响

研究活性炭在硫化氢存在条件下催化氧化脱除煤气中单质汞的吸附机理和探讨提高其吸附能力的方法,在模拟煤气气氛下对3种活性炭和一种活性焦进行汞的吸附性能实验,并进一步分析活性炭(焦)的孔隙结构。用BET方程处理N₂等温吸附数据,计算比表面积;用HK法进行微孔分析;用BJH法计算中孔孔径分布。结果表明,硫化氢被催化氧化后,生成吸附在活性炭孔壁上的活性硫促进了对汞的吸附;随着活性炭微孔和中孔体积的增大,活性炭对汞的吸附能力得到提高。     

Application of enriched stable 196Hg isotope for monitoring the stability of total mercury in water samples

A novel tool for the investigation of stability of total mercury in water samples is presented. The study focuses on the application of enriched ¹⁹⁶Hg stable isotopic reagent for the stability studies. Natural abundance of ¹⁹⁶Hg in water samples is only 0.15%. Thus, the use of the ¹⁹⁶Hg isotope spike represents a major advantage, when it can be assumed that all the measured isotope is the same as is accurately added by the analyst, and the change in its mass concentration can be followed simply and reliably. Tests were carried out with industrial waste water and two type of the natural water. Cold vapour (CV) inductively coupled plasma mass spectrometer (ICP-MS) technique was applied for the mercury measurements. Monitoring was continued for approximately 100 days. It is commonly advised that the measurement for total mercury in water samples should be carried out within 14 days. In this study the samples were observed to be stable for more than three months, if they were stored at a temperature of 4–6°C. The results of this stability study were in line with the guidance presented in EPA standard 1631. However, the samples were noticed to be stable for a much longer time than is presented in the standard method ISO 17852.     

A Ratiometric Fluorescent Probe for Gold and Mercury Ions

A fluorescent probe that displays a ratiometric fluorescence response towards gold and mercury ions has been devised. Emitting at a relatively longer wavelength, the conjugated form of the fluorescent dye transforms in the presence of the gold or mercury ions into a new dye, the molecular structure of which lacks the conjugation and consequently emits at a distinctly shorter wavelength.     

HPLC–ICP–MS法测定农田土壤中甲基汞和乙基汞

采用HPLC反相C18柱分离、ICP–MS检测,建立了农田土壤中甲基汞和乙基汞的分析方法。以0.5mol/L的硝酸溶液为浸提剂,超声波提取1 h,在优化的仪器条件下测定,甲基汞和乙基汞的质量浓度在0.1~50ng/m L范围内与谱线强度呈良好线性关系(r≥0.999),检出限分别为0.1,0.2 ng/m L;加标回收率分别为89.26%~94.26%,76.88%~79.27%;相对标准偏差分别为1.67%~2.38%,2.58%~3.84%(n=5)。该方法样品前处理简单、重现性好、检出限低、准确度高,适合于农田土壤中甲基汞和乙基汞的同时测定。     

抗坏血酸对等离子体质谱法测定汞的增敏作用研究

研究了将抗坏血酸加入到样品中作为增敏剂,以电感耦合等离子体质谱测定汞的增敏效应。考察了硝酸浓度、抗坏血酸浓度、水浴温度和时间等实验条件对增敏作用的影响。结果表明,在5%硝酸,500 mg·L~(-1)的抗坏血酸,水浴温度50℃,时间为20 min的条件下,汞的灵敏度最高,此时,汞的灵敏度增强近30倍,其检出限低至1 ng·L~(-1)。在汞浓度为0.005~10.0μg·L~(-1)范围内线性关系良好,相关系数为0.999,相对标准偏差为5.6%(0.1μg·L~(-1),n=7)。该文还进一步探讨了抗坏血酸产生增敏作用的机理。     

波长校准用低压石英汞灯驱动电源的研制

研制波长校准用低压石英汞灯电源,用于驱动汞灯起辉并维持稳态发光。电路由EMI滤波电路、桥式整流电路、LCC半桥谐振逆变电路、控制电路和保护电路5部分组成。采用系统建模与仿真验证电路的可行性并计算电路参数理论值,利用示波器和功率表验证电源输出参数,功率输出稳定性不大于0.03 W。根据紫外可见近红外分光光度计国防最高计量标准对研制的电源驱动汞灯的工作效果进行评价。结果表明,汞灯能够输出系列特征谱线,谱线相对强度稳定性不大于5.16%;汞灯工作3 h后,灯管外壳表面温度为43℃。该驱动电源的性能参数满足JJG112–2015《低压石英汞灯波长标准器检定规程》的要求。     

合并通道–原子荧光光谱法测定地表水中汞

建立合并通道–原子荧光光谱法测定地表水中超痕量汞的分析方法。采用微孔滤膜过滤、盐酸酸化处理地表水,以合并通道技术提高原子化效率,研究了合并通道对灵敏度以及检出限的影响。在优化的实验条件下,汞含量在0~2μg/L范围内与原子荧光响应值呈良好的线性关系,相关系数为0.999 1,检出限为0.000 3μg/L,测定结果的相对标准偏差小于5%(n=7),加标回收率在82.0%~110.0%之间。该法准确可靠,检出限低,可用于地表水中超痕量汞的检测。     

Calix[4]arene-based crab-like molecular sensors for highly selective detection of mercury and copper ions

In this work, two novel chemosensors based on calix[4]arene bearing (thio)barbituric acid groups (BC1 and BC2) were synthesised, and their structures were characterised by HRMS, NMR and FTIR. Furthermore, their binding properties towards various biologically relevant metal ions were studied by fluorescence titrations, ¹H NMR spectroscopies and Job’s plot evaluations. The chemosensor BC1 displayed excellent binding affinity and selectivity towards Cu²⁺, which was characterised using fluorescence spectroscopy. On the other hand, BC2 exhibited a very remarkable fluorescence enhancement as well as visible colour change from pale green to sunset yellow, in presence of Hg²⁺ ions. Finally, Job’s plot method revealed 1:1 binding stoichiometry for both BC1:Cu²⁺ complex and BC2:Hg²⁺ complex.     

Synthesis and evaluation of a tri-armed molecular receptor for recognition of mercury and cyanide toxicants

A tri-armed-pyrene-linked molecular receptor, 5 has been designed, synthesised and evaluated for ionic recognition. It has been observed that the synthesised molecular receptor can recognise mercury and cyanide ions through a change in colour, UV–Vis and fluorescence intensity. The binding stoichiometry of the receptor and these ionic species has been found to be 1:1 through Job’s plots, Benesi–Hildebrand plots and isothermal titration calorimetry (ITC).     

Multiscale Structures to Describe Porous Media Part I: Theoretical Background and Invasion by Fluids

A porous medium with a broad pore-size distribution is described on the basis of the Multiscale Percolation System concept. The representative structure is the superposition of several constitutive elementary networks, of which mesh sizes are proportional to the diameter of the class of pores considered. To account for the contribution of each class to the connection of the medium, a recurrent building process, involving rescaling and superposition, is defined. This process leads to an equivalent monoscale network, involving elements representative of the various classes. Mercury intrusion at increasing pressure into a finite-size sample of this equivalent network is modelled. The inverse problem is solved, leading to the identification of the representative multiscale structure of a given material from the experimental intrusion curve.