电感耦合等离子体发射光谱法测定锌精矿中的铟

应用电感耦合等离子体发射光谱法测定锌精矿中的铟,确定了最佳工作条件,选择了最佳分析谱线,并利用标准加入法和基体匹配法验证了方法的准确性。样品用氟化氢铵、盐酸、硝酸、高氯酸溶样,用盐酸定容。结果表明,电感耦合等离子体发射光谱法与萃取分离盐酸羟胺示波极谱法测定的铟含量结果一致。方法准确,快速,加标回收率为99.6%～101.7%,相对标准偏差为0.97%～2.1%。     

氮化铝纳米锥的低温生长与场发射性能

考察了在600℃以下通过反应AlCl³+NH₃→AlN+3HCl制备AlN纳米锥的规律,结果表明在500℃时仍可获得AlN纳米锥,当温度为480℃时则无氮化物生成。场发射测试显示在500~600℃温区内制得的AlN纳米锥的开启电场处于14.2~20V·μm^-1范围,且随制备温度升高而减小。本工作的结果表明AlN纳米锥可在低温条件下获得,且具有较好的场发射性能。     

Quantitative analysis of memantine in human plasma by gas chromatography/negative ion chemical ionization/mass spectrometry

A sensitive and specific method for the determination of memantine in human plasma is presented. Memantine was extracted from plasma and derivatized to the pentafluorobenzoyl derivative in a one-step procedure avoiding any sample concentration steps. Amantadine was used as an internal standard. The compounds were measured by gas chromatography/negative ion chemical ionization mass spectrometry without any further processing. Using this detection mode, the fragment ions at m/z 353 and 325 were obtained at high relative abundance. Calibration graphs were linear over the range 0.117-30 ng ml(-1). At the limit of quantification (LOQ), the inter-assay precision was 2.00% and the intra-assay variability was 3.22%. The accuracy at the LOQ showed deviations of -1.42% (intra-assay) and -2.47% (inter-assay). The method is rugged, rapid and robust and was applied to the batch determination of memantine during pharmacokinetic profiling of the drug.     

Determination of total phosphorus and nitrogen in turbid waters by oxidation with alkaline potassium peroxodisulfate and low pressure microwave digestion, autoclave heating or the use of closed vessels in a hot water bath: comparison with Kjeldahl digestion

The evaluation of the use of alkaline peroxodisulfate digestion with low pressure microwave, autoclave or hot water bath heating for the determination of total phosphorus and nitrogen in turbid lake and river waters is described. The efficiency of these digestion procedures were compared to a Kjeldahl digestion procedure with sulphuric acid-potassium sulfate and copper sulfate. The final solution before digestion was 0.045 M in potassium peroxodisulfate and 0.04 M in sodium hydroxide. Procedures were evaluated by the analysis of suspensions of two reference materials, National Institute of Environmental Science, Japan, no. 3 Chlorella and no. 2 pond sediment and natural turbid waters. Best recoveries of phosphorus and nitrogen by microwave heating were obtained when solutions were digested at 95 °C for 40 min. Quantitative recoveries of phosphorus from Chlorella suspensions up to 1000 mg/l were obtained by all three heating procedures, but incomplete recoveries of nitrogen occurred above 20 mg N/l in the digested sample. Good recoveries of phosphorus and nitrogen from suspended sediment suspensions were obtained only from solutions containing <150 mg/l of suspended sediments. Recoveries of phosphorus from phosphorus compounds containing COP and CP bonds added to distilled water were quantitative (94-113%) except for polyphosphates (microwave, 34±8; autoclave, 114±6; water bath, 96±4) and aluminium phosphate (8-23%). Recoveries of nitrogen compounds containing CN bonds added to distilled water were quantitative (94-96%). The analysis of a range of natural turbid water samples by alkaline peroxodisulfate and microwave, autoclave and water bath heating gave similar total phosphorus and nitrogen results. All procedures using alkaline peroxodisulfate underestimate phosphorus concentrations at high suspended sediment concentrations (>150 mg/l) and are only suitable for the analysis of very turbid samples when the turbidity is due to organic matter (algal cells, plant detritus). Underestimation of nitrogen occurs when samples contain more than 20 mg N/l.     

反相高效液相色谱法测定血浆中的辅酶Q10

建立了一种检测血浆中辅酶Q10含量的高效液相色谱法。血浆经甲醇脱脂蛋白后,以正己烷萃取,萃取液依次经硅胶柱净化、C18柱固相萃取,再进行高效液相色谱分析。色谱柱为Hypersil ODS2柱(5 μm,150 mm×4.6 mm i.d.),以异丙醇-甲醇(体积比为45∶55)溶液作流动相,辅酶Q9作内标,检测波长为275 nm。在0.1-50.0 mg/L质量浓度范围内,辅酶Q10与辅酶Q9的峰面积比与相应CoQ10的质量浓度呈良好的线性关系(r2=0.999),血浆中辅酶Q10的检测限为0.03 mg     

On-line sample-pre-treatment schemes for trace-level determinations of metals by coupling flow injection or sequential injection with ICP-MS

Within the last decade, the first generation of flow injection (FI) has been supplemented by sequential injection (SI), also termed the second generation, and, recently, by the third generation, i.e., SI-Lab-on-Valve (SI-LOV). As apparent from the literature, FI and/or SI have become dominant as substitutes for labor-intensive, manual, sample-pre-treatment and/or solution-handling procedures prior to analyte detection by inductively coupled plasma mass spectrometry (ICP-MS). The present review presents and discusses the progress of the state of the art in implementing miniaturized FI/SI systems for on-line matrix separation and pre-concentration of trace levels of metals with detection by ICP-MS. It highlights some of the frequently applied on-line, sample-pre-treatment schemes, including solid phase extraction (SPE), on-wall molecular sorption and precipitate/(co)-precipitate retention using a polytetrafluoroethylene (PTFE) knotted reactor (KR), solvent extraction-back extraction and hydride/vapor generation. It also addresses a novel, robust approach, whereby the protocol of SI-LOV-bead injection (BI) on-line separation and pre-concentration of ultra-trace levels of metals by a renewable microcolumn is interfaced to ICP-MS, as conducted in the present authors' group. It discusses the future outlook in this field.     

Determination of sulfur and selected trace elements in metallothionein-like proteins using capillary electrophoresis hyphenated to inductively coupled plasma mass spectrometry with an octopole reaction cell

The determination of sulfur in biologically relevant samples such as metalloproteins is described. The analytical methodology used is based on robust on-line coupling between capillary electrophoresis (CE) and octopole reaction cell inductively-coupled plasma mass spectrometry (ORC–ICP–MS). Polyatomic ions that form in the plasma and interfere with the determination of S at mass 32 are minimised by addition of xenon to the collision cell. The method has been applied to the separation and simultaneous element-specific detection of sulfur, cadmium, copper, and zinc in commercially available metallothionein preparations (MT) and metallothionein-like proteins (MLP) extracted from liver samples of bream (Abramis brama L.) caught in the river Elbe, Germany. Instrumental detection limits have been calculated according to the German standard procedure DIN 32645 for the determination of sulfur and some simultaneously measured trace elements in aqueous solution. For sulfur detection limits down to 1.3 g L^–1 (³⁴S) and 3.2 g L^–1 (³²S) were derived. For the other trace elements determined simultaneously detection limits ranging from 300 ng L^–1 (⁵⁸Ni) to 500 ng L^–1 (⁶⁶Zn, ⁵⁵Mn) were achieved. For quantification of sulfur and cadmium in a commercially available MT preparation under hyphenated conditions the use of external calibration is suggested. Finally, the need for proper sample-preparation technique will be discussed.     

Dielectric-Barrier Discharges: Their History, Discharge Physics, and Industrial Applications

Dielectric-barrier discharges (silent discharges) are used on a large industrial scale. They combine the advantages of non-equilibrium plasma properties with the ease of atmospheric-pressure operation. A prominent feature is the simple scalability from small laboratory reactors to large industrial installations with megawatt input powers. Efficient and cost-effective all-solid-state power supplies are available. The preferred frequency range lies between 1 kHz and 10 MHz, the preferred pressure range between 10 kPa and 500 kPa. Industrial applications include ozone generation, pollution control, surface treatment, high power CO₂ lasers, ultraviolet excimer lamps, excimer based mercury-free fluorescent lamps, and flat large-area plasma displays. Depending on the application and the operating conditions the discharge can have pronounced filamentary structure or fairly diffuse appearance. History, discharge physics, and plasma chemistry of dielectric-barrier discharges and their applications are discussed in detail.     

Simple method for the determination of rosiglitazone in human plasma using a commercially available internal standard

To the best of our knowledge, bioanalytical methods to determine rosiglitazone in human plasma reported in literature use internal standards that are not commercially available. Our purpose was to develop a simple method for the determination of rosiglitazone in plasma employing a commercially available internal standard (IS). After the addition of celecoxib (IS), plasma (0.25 mL) samples were extracted into ethyl acetate. The residue after evaporation of the organic layer was dissolved in 750 microL of mobile phase and 50 microL was injected on to HPLC. The separation was achieved using a Hichrom KR 100, 250 x 4.6 mm C(18) with a mobile phase composition potassium dihydrogen phosphate buffer (0.01 m, pH 6.5):acetonitrile:methanol (40:50:10, v/v/v). The flow-rate of the mobile phase was set at 1 mL/min. The column eluate was monitored by fluorescence detector set at an excitation wavelength of 247 nm and emission wavelength of 367 nm. Linear relationships (r(2) > 0.99) were observed between the peak area ratio rosiglitazone to IS vs rosiglitazone concentrations across the concentration range 5-1000 ng/mL. The intra-run precision (%RSD) and accuracy (%Dev) in the measurement of rosiglitazone were <+/-10.69 and <-12.35%, respectively across the QC levels (50-1000 ng/mL). The extraction efficiency was >80% for both rosiglitazone and IS from human plasma. The lower limit of quantitation of the assay was 5 ng/mL. In summary, the methodology for rosiglitazone measurement in plasma was simple, sensitive and employed a commercially available IS.     

Pressure-induced metastable phase transition in orthoenstatite (MgSiO3) at room temperature: a Raman spectroscopic study

Phase behavior of a synthetic orthoenstatite in a diamond-anvil cell has been studied up to ∼22 GPa by using Raman spectroscopy at room temperature. Under quasi-hydrostatic conditions, orthoenstatite undergoes a reversible phase transformation at an apparent transition pressure of ∼10 GPa for compression and ∼9.5 GPa for decompression. The 3d transition-metal cations, e.g., Fe²⁺ and Ni²⁺, show only a minor effect on the transition pressure within 10 wt% of addition. All the Raman frequencies in both orthoenstatite and its high-pressure phase increase monotonically with increasing pressure. The amount of forward or backward transition is fixed at a given pressure and forms a hysteresis loop in the transition %-pressure plan. The type for the present metastable phase transition is inferred to be of first order and the high-pressure polymorph may be the intermediate between orthoenstatite and the high-pressure clinoenstatite (i.e., the high-P C2/c phase). A mechanism based on Mnyukh's edgewise model of interface motion has been suggested to account for the observed phenomena.