SYNTHÉSE DE THIOÉTHERS D'ACIDES PROPYLBORONIQUES S - BENZYLÉS

The protection of the hydroxy group of p-cresol 1 by o-silylation gives derivatives 2 and 3 , the methyl group of which can be brominated by NBS. The phase transfer catalysis applied to 4 and 5 is a good way which permits the mild introduction of the allylthio group ( 6 and 7 ). Hydroboration applied to silylated compounds 8 and 9 , followed by methanolysis and hydrolysis leads to target acids 10 and 11 in a good yield.

La protection du groupement hydroxy du p-crésol 1 par o-silylation donne les dérivés 2 et 3 ce qui permet de bromer le substituant méthyle par le N-bromosuccinimide (NBS). La catalyse par transfert de phase (CTP) appliquée aux produits 4 et 5 est une bonne méthode pour introduire un groupement allylthio (composés 6 , 7 ). L'hydroboration des composés silylés 8 et 9 , suivie d'une méthanolyse et d'une hydrolyse permet d'accéder aux acides cibles 10 et 11 avec de bons rendements.     

卟啉单晶微纳米棒的合成及光电性能研究

通过相界面反应制备了一维卟啉微纳米棒,并通过紫外、红外和X衍射仪等多种表征方法对其进行了表征.结果表明,在无机酸的作用下,卟啉分子通过-,氢键和静电作用等多种相互作用聚集成有序的J-聚集体.将此一维卟啉微纳米棒构筑为微纳米器件,并测试其光电性能.该纳米器件在可见光照射下的光电流很大,关闭光源,电流在40 s内降到最低,再次打开光源,电流又在120 s内升到了最大.经过多次＂开＂、＂关＂光源,电导的光响应依旧没有降低.这种具有光电响应的卟啉微纳米棒有望成为微纳电子器件的光电元件.     

硫脲修饰ZnSe:Cu量子点的水相合成及荧光特性

以3-巯基丙酸为稳定剂在水相中合成了Cu掺杂的ZnSe量子点(QDs), 并利用硫脲(CH₄N₂S)对其进行表面修饰, 制备出核壳结构的ZnSe:Cu/ZnS 量子点. 制得的量子点呈闪锌矿结构, 尺寸约为5 nm, 有较好的分散性, 其荧光发射峰在460 nm左右. 经CH₄N₂S修饰后, 量子点表面形成了宽禁带的ZnS包覆层, 将电子和空穴限域在了ZnSe:Cu 核内, 减少了表面发生非辐射复合的载流子, 显著提高了量子点的荧光强度. 与Na₂S、硫代乙酰胺(TAA)等常用硫源相比, 以CH₄N₂S为硫源制得的ZnSe:Cu/ZnS 量子点壳层厚度可控, 表面钝化效果更好, 显示出更佳的荧光效率和稳定性. ZnSe:Cu/ZnS 量子点经过紫外线照射后消除了表面的悬空键, 进一步提高了其量子产率, 最终获到了具有较好荧光性质的ZnSe:Cu/ZnS量子点.     

Structure and wettability relationship of coelectrospun poly (L‐lactic acid)/gelatin composite fibrous mats

Coelectrospun polylactide(PLA)/gelatin (GE) composite fibrous matrixes have been identified to exhibit much improved performances compared to the respective components; however, the reasons for their water contact angles decreasing to zero at proper PLA/GE ratios remain unclear. To get a deep understanding of the phenomenon, PLA and GE were coelectrospun with different PLA/GE ratios in this study. Although the resulting composite fibers were homogeneous in appearance, they were detected different microscopic structures by transmission electron mircroscope (TEM) and via morphological observations after selective removal of either PLA or GE component. Together with the results of degradation study in phosphate buffered solution, a kind of cocontinuous phase separation microstructure could be identified for the PLA(50 wt%)/GE(50 wt%) composite fibers, which also showed the water contact angle of 0°. This value was far lower than those of electrospun PLA (～123°) and GE (～42°) fibrous matrixes. The X‐ray photoelectron spectrometry (XPS) data revealed that the polar side groups of protein macromolecules have moved toward composite fiber surface with solvent evaporation during electrospinning, due to the hydrophobic interaction between PLA and GE. Then the excellent hydrophilicity of PLA(50 wt%)/GE(50 wt%) composite fibers could be suggested as the consequence of: (1) the cocontinuous phase separation structure could provide more interface and void for water molecules penetrating; and (2) the accumulation of polar groups on composite fiber surface significantly increased the surface wettability. Copyright © 2010 John Wiley & Sons, Ltd.     

The Role of Solvent Ligated Metal Complexes Associated with Weakly Coordinating Counteranions (WCAs) in Isobutylene Polymerization

Summary: Polyisobutylene is an industrially important polymer which is conventionally prepared by polymerization at temperatures below 0 °C. The application of solvent ligated metal complexes associated with weakly coordinating counteranions (WCAs), however, allows the room temperature (30 °C) polymerization of isobutylene resulting in highly reactive polyisobutylene (HR-PIB) containing a high content of terminal double bonds. Recently described complexes include manganese (II), copper(II), molybdenum(III) and zink(II) complexes which were coordinated octahedrally with the boron and alumina based WCAs, each with its own advantages and traits.     

Optical band gap and conductivity measurements of polypyrrole-chitosan composite thin films

Electrical conductivity and optical properties of polypyrrole-chitosan（PPy-CHI） conducting polymer composites have been investigated to determine the optical transition characteristics and energy band gap of composite films.The two electrode method and I-V characteristic technique were used to measure the conductivity of the PPy-CHI thin films,and the optical band gap was obtained from their ultraviolet absorption edges.Depending upon experimental parameter,the optical band gap（E_g） was found within 1.30-2.32 eV as estimated from optical absorption data.The band gap of the composite films decreased as the CHI content increased.The room temperature electrical conductivity of PPy-CHI thin films was found in the range of 5.84×10^-7-15.25×10^-7 S·cm^-1 depending on the chitosan content.The thermogravimetry analysis（TGA） showed that the CHI can improve the thermal stability of PPy-CHI composite films.     

液相色谱-串联质谱法测定小麦中T-2、ZEN及DON 3种镰刀菌毒素

采用液相色谱-串联质谱建立了小麦中T-2、玉米赤霉烯酮（ZEN）和脱氧镰刀菌烯醇（DON）的测定方法。样品经80% 乙腈-水提取,氨基柱（500 mg,6 mL）杂质吸附模式净化,以5 mmol/L乙酸铵溶液和甲醇为流动相,ZORBAX Extend-C18柱（150 mm×2.1 mm,1.8 μm）进行色谱分离;在电喷雾正离子化模式下,多反应监测方式测定。结果表明：T-2、ZEN和DON分别在0.5~500、5~500、10~2 000 μg/L质量浓度范围内呈良好线性,相关系数分别为0.998 9、0.999 7和0.999 1。通过对空白小麦样品进行3个水平的加标回收实验,T-2、ZEN和DON的回收率分别为86%~94%、80%~101%和81%~105%,相对标准偏差（RSD）分别为2.6%~5.5%、3.6%~8.9%和2.2%~8.1%,方法检出限分别为0.5、8.0、10.0 μg/kg。该方法准确、灵敏、成本低,适用于小麦中T-2、ZEN和DON的同时分析。     

Analysis of nitro-PAHs in diesel exhaust particulate extracts with multicolumn HPLC

Summary A method is described for the determination of nitrated polynuclear aromatic hydrocarbons (nitro-PAHs), in particular 1-nitropyrene, in diesel particulate extracts. The method employs a multidimensional HPLC (column switching) technique with final on-line peak identification by UV-VIS spectral comparison with standards. To achieve exceptional chromatographic selectivity for nitro-PAHs, a new pyrene butyric acid amide phase has been prepared which is capable of forming donor-acceptor complexes with them. With this technique it is possible to confirm the presence of 1-nitropyrene in the range 3–100 ng/mg on filter-collected diesel soot. Its utility was demonstrated with diesel exhaust extracts spiked with varying levels of 1-nitropyrene and proved to be highly selective.Parts of this work have been presented at the 15th International Symposium on Chromatography, Nürnberg, October 1984.Dedicated to Prof. J. F. K. Huber at the occasion of his 60th birthday.     

Chemically modified multiwalled carbon nanotubes as efficient and selective sorbent for separation and preconcentration of trace amount of Co(II), Cd(II), Pb(II), and Pd(II)

Multi-walled carbon nanotubes (MWCNTs) were chemically functionalized by glutaric dihydrazide (GDH) and characterized with FT-IR technique. This new sorbent was used for enrichment and preconcentration of Co(II), Cd(II), Pb(II), and Pd(II) ions. The adsorption was achieved quantitatively on MWCNTs at pH 4.0, and then the retained metal ions on the adsorbent were eluted with 1.5 mol L^?1 HNO₃. The effects of analytical parameters including pH of the solution, eluent type, sample volume, and matrix ions were investigated for optimization of the presented procedure. The adsorption capacity of the adsorbent at optimum conditions was found to be 33.6, 29.2, 22.1, and 36.0 mg g^?1 for Co(II), Cd(II), Pb(II), and Pd(II), respectively. The LOD values of the method were 0.16, 0.19, 0.17, and 0.12 ng mL^?1 (3Sb, n = 10) for Co(II), Cd(II), Pb(II), and Pd(II), respectively. The RSDs values of the method were 0.75, 0.85, 1.16, and 1.30 ng mL^?1 for Co(II), Cd(II), Pb(II), and Pd(II), respectively. The method was applied for the determination of analytes in soil, well water, and wastewater samples with satisfactory results.