HgCl2/I2复合催化剂协同催化合成异丙醇钇的研究

以金属钇和异丙醇为原料，以HgCl2/I2为复合催化剂，通过对金属钇的机械加工以增加其比表面，并将异丙醇脱水使其含水量降低至0．05％，体系在82℃回流5h，经过滤、减压蒸馏，得到了白色海绵状异丙醇钇，其产率高达83％，合成时间比文献报道的缩短了19h，产率提高了8％。文章确定了催化剂的最佳用量为20gY加入60mg HgCl2/I2，研究了合成产率与HgCl2/I2催化剂和HgCl2催化剂的依赖关系及异丙醇中含水量对合成产率的影响，并对HgCl2/I2的催化作用机理进行了初步探讨。     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.     

A study of structural, compositional and optical properties of spray-deposited non-stoichiometric (Zn,Fe)S thin films

Non-stoichiometric ternary chalcogenides (Zn,Fe)S were prepared in the film form by pyrolytic spray deposition technique, using air/nitrogen as the carrier gas. The precursor solution comprised of ZnCl₂, FeCl₂ and thiourea. The depositions were carried out under optimum conditions of experimental parameters viz. carrier gas (air/nitrogen) flow rate, concentration of precursor constituents, nozzle substrate distance and temperature of quartz substrate. The deposited thin films were later sintered in argon at 1073 K for 120 min.The structural, compositional and optical properties of the sintered thin films were studied. X-ray diffraction studies of the thin films indicated the presence of (Zn,Fe)S solid solution with prominent cubic sphalerite phase while surface morphology as determined by scanning electron microscopy (SEM) revealed a granular structure.The chemical composition of the resulting thin films as analyzed by energy dispersive X-ray analysis (EDAX) reflected the composition of the precursor solutions from which the depositions were carried out with Fe at% values ranging from 0.4 up to 33.SEM micrographs of thin films reveal that the grain sizes of the thin films prepared using air as carrier gas and N₂ as carrier gas are in the vicinity of 300 and 150 nm, respectively.The diffuse transmittance measurements for thin films, as a function of wavelength reveal the dependence of direct optical band gap on Fe content and type of phase.     

A convenient semicarbazide resin for the solid-phase synthesis of peptide ketones and aldehydes

Use of a semicarbazide resin for the solid-phase preparation of peptide ketones and aldehyde led to optimal results in terms of both purity of the final product and overall yield. This resin was prepared without complication by activation of the commercial available aminomethyl polystyrene with CDI at room temperature, followed by treatment with tert-butyl carbazate. Furthermore, the TNBSA colorimetric assay has been adapted for checking the incorporation of the carbonyl moiety onto hydrazine-based resins.     

模糊对向传播网络数据融合目标识别方法

重点研究了模糊对向传播网络 (FCPN)模型。针对数据融合和目标识别的特点 ,提出了基于模糊对向传播网络的融合目标识别方法和改进的模糊对向传播网络 (MFCPN)融合结构。利用仿真数据对网络的训练算法和融合结构进行了实验研究。结果表明 ,模糊对向传播网络较误差后向传播网络 (BPN)能够有效地实现融合识别 ;改进的模糊对向传播网络融合结构是可行的。同时还对FCPN和MFCPN应用于前视红外 (FLIR)和可见光摄像机目标跟踪系统进行了应用研究。     

A Facile Synthesis of α-Phenylthio-α,β-Unsatuated Esters

α-phenylthio-α，β-unsaturated esters 6 were synthesized by Witting reaction of 3.which were prepared by a phenylsulfenyllation-trans-ylidation reaction.     

A convenient strategy of dimerization by microwave heating and using 2,5-diketopiperazine as scaffold

A novel and convenient microwave-assisted dimerization of an active peptide compound using the DKPs as scaffold is described. The key reaction giving rise to the diketopiperazine scaffold is the intermolecular coupling. No epimerization was detected in the reactions used. Conventional and microwave heating of the reactions are compared. Synthesis by microwave irradiation gave the desired compounds in higher yields and in shorter reaction times than those obtained by conventional heating.     

Fluorous osmium tetraoxide (OsO4): a recoverable and reusable catalyst for dihydroxylation of olefins

A fluorous osmium catalyst was firstly developed. It had been effectively used as recoverable and reusable catalyst in the dihydroxylation of olefins.     

Preparation of novel analgesics via diastereoselective nucleophilic addition to 1-dimethylamino-2-methylpentan-3-one

The diastereoselective synthesis of naphthyl amino alcohols via nucleophilic addition to racemic 1-dimethylamino-2-methylpentan-3-one was studied. The use of the appropriate experimental conditions allowed the synthesis of both diastereoisomers. The relative configurations were established via NOESY experiments.