非傍轴平顶高斯光束M2因子两种定义的比较研究

基于功率密度的二阶矩方法,推导出了非傍轴平顶高斯(FG)光束束宽和远场发散角的解析表达式·研究表明,当w0/λ→0时,远场发散角趋于渐近值θmax=63.435°,与阶数无关·使用非傍轴高斯光束代替傍轴高斯光束作为理想光束,研究了非傍轴FG光束的M2因子,并与传统定义的M2因子作了比较·在非傍轴范畴,非傍轴FG光束的M2因子不仅与阶数N有关,而且与w0/λ有关·按照定义,当w0/λ→0时,非傍轴FG光束的M2因子不等于0,对阶数N=1,2,3时,M2因子分别趋于0.913,0.882和0.886·当N→∞时,M2因子取最小值M2min=0.816·     

O在Au(111)表面吸附的密度泛函理论研究

应用密度泛函理论，本文系统地研究了O在Au(111)表面上的吸附能、吸附结构、功函数、电子密度和投影态密度，给出了覆盖度从0.11ML到1.0ML的范围内，O的吸附特性随覆盖度变化的规律.研究发现O的稳定吸附位为3重面心立方(fcc)洞位，O在fcc洞位的吸附能对覆盖度比较敏感，其值随着覆盖度的增加而减小；O诱导Au(111)表面功函数的变化量与覆盖度成近线性关系，原因是Au表面电子向O偏移，形成表面偶极子；O—Au的相互作用形成成键态和反键态，且反键态都被占据，造成O—Au键很弱，O吸附能较小. 关键词： 表面吸附 Au(111)表面 密度泛函理论 电子特性     

非傍轴平顶高斯光束M2因子两种定义的比较研究

基于功率密度的二阶矩方法，推导出了非傍轴平顶高斯(FG)光束束宽和远场发散角的解析表达式.研究表明，当w0/λ→0时，远场发散角趋于渐近值θmax=63.435°，与阶数无关.使用非傍轴高斯光束代替傍轴高斯光束作为理想光束，研究了非傍轴FG光束的M2因子，并与传统定义的M2因子作了比较.在非傍轴范畴，非傍轴FG光束的M2因子不仅与阶数N有关，而且与w0/λ有关.按照定义，当w0/λ→0时，非傍轴FG光束的M2因子不等于0，对阶数N=1, 2, 3时，M2因子分别趋于0.913,0.882和0.886.当N→∞时，M2因子取最小值M2min=0.816.     

双纠缠原子在耗散腔场中的纠缠动力学

研究了能量损耗腔中,两纠缠二能级原子与单模辐射场相互作用过程中原子的纠缠动力学.结果表明:双纠缠原子的纠缠度演化特性决定于初始两原子间的纠缠度、纠缠形式、腔场的平均光数、腔场的衰变系数.当原子初始处于一特定纠缠态时,其纠缠度可以放大,并且不受腔场损耗的影响. 关键词： 二能级原子 纠缠度 密度算符 单模辐射场     

Chemical bonding in isolated molecules and crystals of zwitterionic pentacoordinate silicon chelates

The electronic structures of a number of zwitterionic pentacoordinate silicon chelates were investigated using the results of X-ray diffraction studies and quantum-chemical calculatoins by the MPW1PW91/6-311G(d) method. The topological analysis of the electron density distribution function and the study in the framework of the natural bond orbital partitioning scheme showed that the character of chemical bonding in the axial fragments of the molecules under consideration changes from dative to three-center, four-electron as the silicon atom assumes a trigonal-bipyramidal coordination.     

On additives, morphological evolution and dielectric breakdown in low density polyethylene

A series of low density polyethylene systems has been studied with respect to structural evolution and short-term dielectric breakdown behaviour. All materials were based upon a single polymer, that is commonly used in high voltage applications, but with different additives. In all three of these systems, multiple melting transitions were observed, as a result of molecular fractionation effects during crystallization. In the virgin polymer, a space-filling banded spherulitic morphology was found to develop at low temperatures (102 °C and below) whereas, at higher temperatures, only a few isolated axialites were observed. Inclusion of the antioxidant resulted in greatly increased nucleation densities, such that, at low temperatures, no evidence of spherulitic organisation remained. At higher temperatures, sheaf-like lamellar aggregates developed, which were much smaller and much more numerous than in the case of the virgin polymer. Further addition of dicumyl peroxide (DCP) resulted in the rapid formation of a crosslinked network at 200 °C. Some crosslinking also occurred at 150 °C, but over a much longer timescale. Where extensive crosslinking occurred prior to crystallization, the resulting gel inhibited structural development, such that only a few small, isolated sheaves were able to form at 102 °C. In view of the principal application area of this material, the breakdown strength of each of the above systems was then measured and the whole data set was analysed statistically. When structural factors were considered alongside the statistics, no clear trends emerged to indicate that either the compositional or morphological variations were reflected in the short-term electrical failure processes.     

The Heat Equation with Initial Data Corrupted by Measurement Error and Missing Data

In this work the Cauchy problem for the one-dimensional heat equation is considered. In contrast to existing literature it is assumed that the initial state f is unknown and that information regarding f is obtained by some process of measurement. To enhance realism, both measurement errors and missing data are allowed for. Under assumptions on f in the Fourier-domain first an approximation to f is derived from the data by means of a novel uncertainty principle. Then, it is studied how this perturbation in the initial state propagates with time.      

A novel tridentate nitrogen donor as ligand in copper catalyzed ATRP of methyl methacrylate

A tridentate ligand, BPIEP: 2,6‐bis[1‐(2,6‐diisopropyl phenylimino) ethyl] pyridine, having central pyridine unit and two peripheral imine coordination sites was effectively employed in controlled/“living” radical polymerization of MMA at 90°C in toluene as solvent, Cu^IBr as catalyst, and ethyl‐2‐bromoisobutyrate (EBiB) as initiator resulting in well‐defined polymers with polydispersities M_w/M_n ≤ 1.23. The rate of polymerization follows first‐order kinetics, k_app = 3.4 × 10^?5 s^?1, indicating the presence of low radical concentration ([P*] ≤ 10^?8) throughout the reaction. The polymerization rate attains a maximum at a ligand‐to‐metal ratio of 2:1 in toluene at 90°C. The solvent concentration (v/v, with respect to monomer) has a significant effect on the polymerization kinetics. The polymerization is faster in polar solvents like, diphenylether, and anisole, as compared to toluene. Increasing the monomer concentration in toluene resulted in a better control of polymerization. The molecular weights (M_n,SEC) increased linearly with conversion and were found to be higher than predicted molecular (M_n,Cal). However, the polydispersity remained narrow, i.e., ≤1.23. The initiator efficiency at lower monomer concentration approaches a value of 0.7 in 110 min as compared to 0.5 in 330 min at higher monomer concentration. The aging of the copper salt complexed with BPIEP had a beneficial effect and resulted in polymers with narrow polydispersitities and higher conversion. PMMA obtained at room temperature in toluene (33%, v/v) gave PDI of 1.22 (M_n = 8500) in 48 h whereas, at 50°C the PDI is 1.18 (M_n = 10,300), which is achieved in 23 h. The plot of lnk_app versus 1/T gave an apparent activation energy of polymerization as (ΔE^≠_app) 58.29 KJ/mol and enthalpy of equilibrium (ΔH⁰_eq) to 28.8 KJ/mol. Reverse ATRP of MMA was successfully performed using AIBN in bulk as well as solution. The controlled nature of the polymerization reaction was established through kinetic studies and chain extension experiments. © 2005 Wiley Periodicals, Inc. J Polym Sci Part A: Polym Chem 43: 4996–5008, 2005     

乌桕类可可脂结晶过程中表现体积变化

为了解乌桕类可可脂(CTCBE)缓冷结晶横向胀罐爆裂原因，研究CTCBE结晶过程中的膨胀特性，采用流体静力法测试了不同等温结晶条件下CTCBE结晶形成的表观密度和表观体积及其横纵向膨胀状况。结果表明，CTCBE缓冷结晶后形成外部和中部两个晶区。在5-25℃的各等温结晶范围内，当结晶温度增加时，外部结晶区域减小、表观密度变化不大；中部结晶区域增大、表观密度明显减小，CTCBE的表观体积、横向、纵向膨胀率均增大，膨胀横向大于纵向。进一步表明CTCBE在自然缓冷固化的表观体积根本上由其结晶温度决定。为有效防止横向胀罐，自然缓冷固化温度应低于10℃。     

Spin polarization effect for Tc2 molecule

Density functional method (DFT) (B3p86) of Gaussian98 has been used to optimize the structure of the Tc_2 molecule. The result shows that the ground state for Tc_2 molecule is an 11-multiple state and its electronic configuration is {}^{11}Σ_g^-, which shows the spin polarization effect of Tc_2 molecule of a transition metal element for the first time. Meanwhile, we have not found any spin pollution because the wavefunction of the ground state does not mingle with wavefunctions of higher energy states. So, that the ground state for Tc_2 molecule is an 11-multiple state is indicative of the spin polarization effect of Tc_2 molecule of a transition metal element: that is, there exist 10 parallel spin electrons. The non-conjugated electron is greatest in number. These electrons occupy different spacious tracks, so that the energy of Tc_2 molecule is minimized. It can be concluded that the effect of parallel spin of the Tc_2 molecule is larger than the effect of the conjugated molecule, which is obviously related to the effect of electron d delocalization. In addition, the Murrell--Sorbie potential functions with the parameters for the ground state {}^{11}Σ_g^- and other states of Tc_2 molecule are derived. Dissociation energy D_e for the ground state of T_{c2} molecule is 2.266eV, equilibrium bond length R_e is 0.2841nm, vibration frequency ω_e is 178.52cm^{-1}. Its force constants f_2, f_3, and f_4 are 0.9200aJ·nm^{-2}, --3.5700aJ·nm^{-3}, 11.2748aJ·nm^{-4} respectively. The other spectroscopic data for the ground state of Tc_2 molecule ω_eχ_e, B_e, α_e are 0.5523cm^{-1}, 0.0426cm^{-1}, 1.6331×10^{-4}cm^{-1} respectively.