ICP－AES同时测定土壤和沉积物中全硼与其它微量及常量元素

本文阐述了用Ｈ３ＰＯ４、ＨＦ、ＨＮＯ３及ＨＣｌＯ４消化土壤及水系沉积物样品。其中磷酸的作用是避免在样品消化过程中硼的挥发损失。应用电感耦合等离子体发射光谱（简称ＩＣＰ－ＡＥＳ）同时测定样品中全硼及其它微量、常量元素的含量。该法具有高的准确度及精密度。方法快速、简便、适合土壤和沉积物的多元素测定。     

Quantitative measurements of Ge surface segregation during SiGe alloy growth

Ge segregation during the growth of Si_{1 − x}Ge_x alloys (x = 5, 10, 20, and 40%) was studied using X-ray photoelectron spectroscopy. The alloys were grown in thicknesses up to 20.0 nm at 500°C to measure quantitatively the amount of segregated surface Ge. The length of alloy needed to reach steady-state growth edge was found to decrease with increasing alloy concentration (4.8, 2.8, 2.4, and 2.0 nm, respectively). It was found that each alloy had a complete monolayer of Ge on the surface and an increasing amount of segregated Ge in the second layer (20, 55, 80, and 95%, respectively) during steady-state growth. An increase in the temperature of alloy growth (400–750°C) resulted in an increase in the leading edge of alloy growth but did not change the amount of segregated Ge during steady-state growth. We propose that film stress is responsible for the amount of Ge segregation.     

Combined X-ray-electron imaging techniques: Limitations on lateral resolution

Capabilities of the imaging techniques, in which X-rays are converted to electrons and then the emitted electrons are registered by means of an electron microscope, are analyzed, the focus being on the factors limiting lateral resolution at the stage of electron emission. Bearing in mind the tendency to use harder synchrotron X-rays for some combined X-ray-electron microscopy methods, calculations were made for two significantly different X-ray energies: E = 1.828 keV (K-edge of Si) and E = 11.923 keV (L₃-edge of Au). By using Monte Carlo simulations of the electron trajectories beneath the surface of the sample we show that the radius of the spot from which photoelectrons are emitted could be as small as 1 nm. However, when proper account is taken of an entire electron cascade associated with the re-building of electron shells after photoelectron emission, spots more than one order of magnitude larger result, limiting the best lateral resolution to 20–30 nm.     

Spectral distributions in nuclei: General principles and applications

The subject of spectral distribution methods where one derives and applies the locally smoothed forms of observables in nuclei is briefly reviewed. It is well understood that the local forms (with respect to energy) of the level density function, expectation values and strength densities are Gaussian, linear (or ratio of Gaussians) and a bivariate Gaussian respectively. To accomodate symmetries in the above forms, one has to deal with multivariate distributions in general; for example the angular-momentum (J) decomposition leads to a bivariate Gaussian form for the level density. These results extend to indefinitely large spaces by method of partitioning and they generate convolution forms. The origin of these remarkable spectral properties is discussed and shell model examples are given to substantiate their applicability to nuclear systems. Spectral distribution theory is a practical, usable theory because the smoothed forms are defined in terms of traces of low particle-rank operators, and the trace information propagates. Finally we discuss the application of the spectral methods for a wide range of nuclear problems; these include binding energies, orbit occupancies, electromagnetic andβ-decay sum rule quantities, analysis of operators, symmetry breaking, numerical level densities, and determination of bounds on time-reversal non-invariant part of nucleon-nucleon interaction.     

Optical design of a toroidal grating monochromator based beam line on Indus-1

In this paper, we discuss the detailed optical design of a beam line that is under construction on the synchrotron radiation source, Indus-1. Toroidal mirrors are used as pre-and post- focusing elements and a toroidal grating monochromator as a dispersing element. Using three interchangeable gratings, this monochromator will give, at a moderate resolution, a good throughput on the sample in the wavelength range 40 to 1000 Å. Effect of various parameters and their optimization on the resolution and throughput characteristics have been studied by ray tracing calculations, and presented.     

X-ray fluorescence in some rare earth and high Z elements excited by 661.6 keV γ-rays

The K-shell X-ray fluorescence cross sections are determined experimentally for 10 elements such as Pb, Hg, Ir, W, Lu, Tm, Dy, Tb, Gd and Nd at excitation energy of 661.6 keV associated with γ-rays of ¹³⁷Cs radioisotope. The technique employed involves the measurement of total intensity of fluorescent K X-rays that follow the photoeffect absorption of a known flux of γ-rays using a well type Nal(Tl) detector. The obtained results are compared with the available theoretical values and other measured values.     

Possible application of X-ray optical elements for reducing the spectral bandwidth of an X-ray SASE FEL

A new design for a single pass X-ray Self-Amplified Spontaneous Emission (SASE) FEL is proposed. The scheme consists of two undulators and an X-ray monochromator located between them. The first stage of the FEL amplifier operates in the SASE linear regime. After the exit of the first undulator the electron bunch is guided through a non-isochronous bypass and the X-ray beam enters the monochromator. The main function of the bypass is to suppress the modulation of the electron beam induced in the first undulator. This is possible because of the finite value of the natural energy spread in the beam. At the entrance to the second undulator the radiation power from the monochromator dominates significantly over the shot noise and the residual electron bunching. As a result the second stage of the FEL amplifier operates in the steady-state regime when the input signal bandwidth is small with respect to that of the FEL amplifier. Integral losses of the radiation power in the monochromator are relatively small because grazing incidence optics can be used. The proposed scheme is illustrated for the example of the 6 nm option SASE FEL at the TESLA Test Facility under construction at DESY. As shown in this paper the spectral bandwidth of such a two-stage SASE FEL (Δλ/λ 5 × 10⁻⁵) is close to the limit defined by the finite duration of the radiation pulse. The average brilliance is equal to 7 × 10²⁴ photons/(s × mrad² × mm² × 0.1% bandw.) which is by two orders of magnitude higher than the value which could be reached by the conventional SASE FEL. The monochromatization of the radiation is performed at a low level of radiation power (about 500 times less than the saturation level) which allows one to use conventional X-ray optical elements (grazing incidence grating and mirrors) for the monochromator design.     

Search for a precursor crystal-to-crystal phase transition to amorphization in α-GeO2 and α-AlPO4 under pressure

Recent X-ray diffraction studies on α-quartz (SiO₂) by Kingmaet al [1], have shown the occurrence of a reversible, crystalline-to-crystalline, phase transition just prior to amorphization at ≈ 21 GPa. This precursor transition has also been confirmed by our recent molecular dynamics simulation study [2]. In order to investigate the possibility of a similar behaviour in other isostructural compounds, which also undergo pressure induced amorphization, α-GeO₂ and α-AlPO₄ (berlinite form) were studied using energy dispersive X-ray diffraction. In either of these materials, no such phase transition is detected prior to amorphization. The onset of amorphization and its reversal is found to be time dependent in GeO₂.     

Structural and spectroscopic studies of silylated cyclo- and bicyclosilanes

A number of cyclo-and bicyclosilanes have been prepared and structurally characterized by X-ray crystallography and Raman spectroscopy. 1,1,4,4- and 1,1,3,3-tetrakis(trimethylsilyl)octamethylcyclohexasilanes were found to exhibit unusual twist- and twisted boat-conformations. The UV absorption properties of all compounds were studied and found to show absorption maxima red shifted compared to the parent compound dodecamethylcyclohexasilane. Dedicated to Prof. Mitsuo Kira on the occasion of his reception of the Wacker Silicon Award 2005 and in recongnition of his numerous outstanding achievements in organosilicon chemistry.     

Study of thermal aging effect on space charge in poly(methyl methacrylate)

Charges evolution in poly(methyl methacrylate) (PMMA) samples under thermal aging effect has been studied by means of two complementary techniques, thermal step method (TSM) and thermally stimulated depolarization current (TSDC). For the first method, measurements reveal that injected charges, whose quantity is found depending on the number of applied temperature cycles, remain close to the surface sample. TSDC measurements have been carried out for different temperatures ranging from 25 °C to 140 °C. Three distinguishable dipolar relaxations (β₁, β₂ and α) have been highlighted. In the same way, the presence of polarization and injected charges has been confirmed. In support of electric characterization, X-ray reflectometry has been used. The obtained results equally emphasized the thermal aging effect on the material.