Optimization of selenium determination in plant samples by hydride generation and axial view inductively coupled plasma atomic emission spectrometry

The use of hydride generation coupled with axial view inductively couple plasma atomic emission spectrometry was presented for the determination of selenium in plant samples. The chemical factors affecting potentially the hydride generation efficiency (hydrochloric acid, sodium borohydride and sodium hydroxide concentrations) were assessed through investigation of chemical interference, accuracy and repeatability. The accuracy of measurements was not affected by elements present in high concentration in the plant matrix (K, Ca, Mg, and P). No interference was also observed with transition metals. Using a real sample (maize) with standard additions, decreases of recoveries were sometimes observed for 0.1% (m/v) NaOH, and attained 13.8% in the most unfavourable case. The final accuracy of the method was verified by using two certified reference materials: CRM 402 (white clover) and CRM 279 (sea lettuce). No statistically significant differences were obtained between the measured concentrations and the certified values. The optimized method was found sensitive (detection limit 0.15 μg l⁻¹), reliable and repeatable (R.S.D. between 1.3% and 4.0%).     

Simultaneous determination of arsenic, antimony and selenium by gas-phase diode array molecular absorption spectrometry, after preconcentration in a cryogenic trap

This paper describes a method for the simultaneous determination of As(III), Sb(III) and Se(IV) by combining hydride generation and gas phase molecular absorption spectrometry. A system for continuous hydride generation has been designed and developed, based on the use of a double process of gas-liquid separation, and optimal compromise operation conditions for the three compounds have been found. After generation, the hydrides are collected in a liquid nitrogen cryogenic trap, and then evaporated and driven to the flow cell of a diode array spectrophotometer, in which the transient signals over the 190–250 nm wavelength interval are measured. Under the recommended conditions (sample flow: 35 ml min⁻¹, 0.5 M HCl; reductor flow: 4 ml min⁻¹ of 4% NaBH₄, solution) linear response ranges above 50 μg 1⁻¹ for As(III), 30 μg 1⁻¹ for Sb(III) and 200 μg 1⁻¹ for Se(IV) are obtained with detection limits of 22 μg 1⁻¹, 15 μg 1⁻¹ and 65 μg 1⁻¹, respectively. Multiwavelength linear regression equations were used for the simultaneous determination of the three elements in different synthetic samples, with good precision and accuracy and to study simultaneously the interference from different chemical species for the three compounds. Results were similar to those obtained by other techniques using hydride generation.     

Synthesis, spectroscopic characterization and reactivities of linear and butterfly chromium/selenium complexes containing substituted cyclopentadienyl ligands: crystal structures of [{η-MeC5H4Cr(CO)2}2Se] and [{η-EtO2CC5H4Cr(CO)2}2Se2]

The Cr-Cr singly-bonded dimers [{η⁵-RC₅H₄Cr(CO)₃}₂] (1, R=Me; 2, R=CO₂Et) reacted with an equivalent of elemental selenium in THF at room temperature to give the linear Cr₂Se complexes [{η⁵-RC₅H₄Cr(CO)₂}₂Se] (3, R=Me; 4, R=CO₂Et), whereas the linear Cr₂Se complex (5, R=MeCO) reacted with excess NaBH₄, Ph₃PCHPh or 2,4-dinitrophenylhydrazine under respective conditions to afford the linear Cr₂Se derivatives [{η⁵-RC₅H₄Cr(CO)₂}₂Se] (6, R=MeCH(OH); 7, R=PhCHCMe; 8, R=2,4-(NO₂)₂C₆H₃NHNCMe). Similarly, while the butterfly Cr₂Se₂ complexes [{η⁵-RC₅H₄Cr(CO)₂}₂Se₂] (9, R=Me; 10, R=CO₂Et) could be produced either by reaction of dimers 1 and 2 with an excess amount of elemental selenium, or by reaction of the linear complexes 3 and 4 with an equivalent of elemental selenium, the butterfly Cr₂Se₂ derivatives [{η⁵-RC₅H₄Cr(CO)₂}₂Se₂] (12, R=MeCH(OH); 13, R=PhCHCMe; 14, R=2,4-(NO₂)₂C₆H₃NHNCMe) were yielded by reaction of the butterfly Cr₂Se₂ complex (11, R=MeCO) with an excess quantity of NaBH₄, Ph₃PCHPh and 2,4-dinitrophenylhyazine. Both the linear complexes 3, 4, 6-8 and the butterfly complexes 9, 10, 12-14 are new, which have been fully characterized by elemental analysis, spectroscopy and X-ray crystallography.     

Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Determination of selenium in human milk by electrothermal atomic absorption spectrometry and chemical modification

A method was developed for the determination of selenium in human milk using electrothermal atomic absorption spectrometry. The use of chemical modifiers as well as their implications during the pyrolysis step was examined. The chemical modifiers that were studied were Zr, Ir as well as the mixed modifier Zr-Ir. The Ir modifier stabilized selenium at 1000 °C, Zr at 800 °C, while the mixed modifier at 1200 °C. The effect of modifier mass was studied and was found that better results are achieved with addition of 2 μg Zr and 2 μg Ir. The characteristic masses of selenium in the presence of Zr, Ir and the mixed modifier were found to be 73.3, 18.0 and 14.7 pg, respectively, while the corresponding limits of detection were found 2.0, 0.50 and 0.41 μg l⁻¹. Consequently better results were obtained with the mixed modifier. The developed method was applied for the determination of selenium in human milk, which was digested with a HNO₃ + H₂O₂ mixture in a microwave oven. The limit of detection of the method was 1.37 μg l⁻¹, the characteristic mass, m₀, was 48.8 pg and the repeatability was less than 5% as R.S.D.(%). Matrix matched calibration was used. Recoveries were estimated to be 93-105%. The method was applied to breast milk of Greek women (n = 9) and the Se content was found to be in the range 16.7-42.6 μg l⁻¹ with mean value 27.4 ± 5.5 μg l⁻¹.     

甲状腺机能亢进症头发锌、硒、钒、锂、锗5种微量元素的动态变化

测定了２４例甲亢治疗前后及３０例健康对照的头发锌、硒、钒、锂及锗的含量，发现未治疗的甲亢头发锌、硒、钒、锂及锗含量较对照组低，Ｚｎ、Ｓｅ、Ｌｉ、Ｇｅ，Ｐ＜０．００１，Ｖ，Ｐ＜０．０１．甲亢经６～１２周抗甲亢药物治疗后．头发中５种元素均较治疗前上升（Ｐ＜０．００１），且头发钒和锂含量治疗后已达到对照组水平，Ｖ，Ｐ＞０．２，Ｌｉ，Ｐ＞０．１，而头发锌、晒及锗含量治疗后仍低于对照组（Ｐ＜０　．００１）．结论：甲亢头发锌、硒、钒、锂及锗含量降低．经６～１２周抗甲亢治疗可使头发钒及锂含量恢复正常水平，而其余３种元素则可能需要更长时间的抗甲亢治疗才能恢复至正常水平。     

Electrochemical vapor generation of selenium species after online photolysis and reduction by UV-irradiation under nano TiO<Subscript>2</Subscript> photocatalysis and its application to selenium speciation by HPLC coupled with atomic fluorescence spectrometry

An online UV photolysis and UV/TiO₂ photocatalysis reduction device (UV–UV/TiO₂ PCRD) and an electrochemical vapor generation (ECVG) cell have been used for the first time as an interface between high-performance liquid chromatography (HPLC) and atomic fluorescence spectrometry (AFS) for selenium speciation. The newly designed ECVG cell of approximately 115 L dead volume consists of a carbon fiber cathode and a platinum loop anode; the atomic hydrogen generated on the cathode was used to reduce selenium to vapor species for AFS determination. The noise was greatly reduced compared with that obtained by use of the UV–UV/TiO₂ PCRD–KBH₄–acid interface. The detection limits obtained for seleno-DL-cystine (SeCys), selenite (Se^IV), seleno-DL-methionine (SeMet), and selenate (Se^VI) were 2.1, 2.9, 4.3, and 3.5 ng mL^–1, respectively. The proposed method was successfully applied to the speciation of selenium in water-soluble extracts of garlic shoots cultured with different selenium species. The results obtained suggested that UV–UV/TiO₂ PCRD–ECVG should be an effective interface between HPLC and AFS for the speciation of elements amenable to vapor generation, and is superior to methods involving KBH₄.     

Inorganic speciation of As(III, V), Se(IV, VI) and Sb(III, V) in natural water with GF-AAS using solid phase extraction technology

The paper presents a procedure for the multi-element inorganic speciation of As(III, V), Se(IV, VI) and Sb(III, V) in natural water with GF-AAS using solid phase extraction technology. Total As(III, V), Se(IV, VI) and Sb(III, V) were determined according to the following procedure: titanium dioxide (TiO₂) was used to adsorb inorganic species of As, Se and Sb in sample solution; after filtration, the solid phase was prepared to be slurry for determination. For As(III), Se(IV) and Sb(III), their inorganic species were coprecipitated with Pb-PDC, dissolved in dilute nitric acid, and then determined. The concentrations of As(V), Se(VI) and Sb(V) can be calculated by the difference of the concentrations obtained by the above determinations. For the determination of As(III), Se(IV) and Sb(III), palladium was chosen as a modifier and pyrolysis temperature was 800 °C. Optimum conditions for the coprecipitation were listed for 100 ml of sample solution: pH 3.0, 15 min of stirring time, 40.0 μg l⁻¹ Pb(NO₃)₂ and 150.0 μg l⁻¹ APDC. The proposed method was applied to the determination of trace amounts of As(III, V), Se(IV, VI) and Sb(III, V) in river water and seawater.     

Selective pre-concentration of selenite from aqueous samples using mercapto-silica

Silica gel modified with 3-mercaptopropyl-trimethoxysilane was used for the selective separation and pre-concentration of selenite (Se(IV)) from aqueous solutions containing Se(IV) and selenate (Se(VI)). Over a wide range of acidity, from 2 mol l⁻¹ HCl to pH 9.00, Se(IV) was taken up by the mercaptopropyl-silica with nearly 100% efficiency; Se(VI) however was unretained. Se(IV) content was determined by hydride generation atomic absorption spectrometry (HGAAS), following batch release of the selenium from the pre-concentration medium by acidic periodate. The overall pre-concentration efficiency, including both take-up and elution, in the range of 89-106%. The method was applied to spiked seawater samples containing as low as 800 ng l⁻¹ Se in selenite form. This solid-phase extraction system offers several major advantages over conventional solvent extraction procedures. It firstly exhibits high selectivity for Se(IV) over Se(VI). Using the solid-phase media, pre-concentration of Se(IV) in dilute water samples can be carried out in the field, stabilizing the selenite-selenium in a convenient form for transport and storage. In addition, selenium stored on silica is derived solely from Se(IV) overcoming problems of selenium redox speciation changes and loss during storage.