各向异性材料中共线刚性线夹杂的纵向剪切问题

本文研究各向异性材料中共线刚性线夹杂，（有时称作“硬裂纹”或“反裂纹”问题）的纵向剪切问题。利用复变函数方法，提出了一般问题的公式和某些实际重要问题的封闭形式解，考察了刚性线端点附近的应力分布．从本文解答的特殊情形，可以直接导出各向同性材料相应问题的公式和结果，包括某些已有的结果￣［７］．     

The Fundamental Experiments of Red Tide Chemical Forecast

Many food algae and red tide algae were cultivated in the f/2 medium, and the nitric oxide (NO) concentration of the medium and the cell density were determined. The experiments on algae were conducted when different concentrations of NO were added into the medium using two methods. The results show that low concentrations of NO were self-produced by marine algae during the exponential growth period and were about nmol/L level. But at the end of the period, i.e., 2 or 3 days before the cell density reaches the maximum, an NO peak appeared, with the NO concentration reaching 10 nmol/L. The NO threshold concentration exists according to the influence of exogenous NO on the marine phytoplankton growth. One type is the threshold concentration that can promote algae growth, and its value is between 10 and 1 nmol level, or even lower. The other type can inhibit the phytoplankton growth, which is about μmol level or higher. The results indicate that red tide algae are far more sensitive to NO than are food algae. The fundamental experimental outcome above may provide a new clue for red tide chemical forecast by inspecting the NO change.     

Stress concentration around a circular hole in a transversely isotropic spherical shell

Analytical expressions for the stresses near a circular hole in a transversely isotropic shallow spherical shell under uniform pressure are derived. The form of the solution depends on the range of change in the compliance to transverse shear. The influence of the relative radius of the hole and the compliance to transverse shear on the stress concentration is analyzed.__________Translated from Prikladnaya Mekhanika, Vol. 40, No. 12, pp. 99–106, December 2004.     

Reagent concentration effects in the REM resin solid phase synthesis of tertiary amines

The use of reagent concentration has resulted in increased rates for all stages of the REM resin synthesis of tertiary amines. These increases in rate translate into faster reaction times, higher yields and lower reagent consumption. Of the methods examined, the most successful was the use of perfluorous solvents, either alone or with a small amount of organic co-solvent.     

用光学差分吸收光谱监测大气中污染气体浓度

在实验室内模拟测量了实际大气中污染气体的差分吸收光谱 (DOAS) .本文在介绍差分吸收光谱技术同时 ,分析计算了污染气体的浓度 .实验设计中被测气体为大气中的 2种主要污染气体 :工业锅炉的主要排放物SO2 和机动车尾气的主要成分NO .用氘灯作为光源测量其在紫外波段的特征吸收 ,并通过光纤束连接光栅光谱仪 ,由计算机自动采集和处理数据 .     

Behavior of zirconium in the ZrOW(100) system at high temperature, studied by ISS, AES and work-function measurements

The behavior of zirconium atoms at the W(100) surface associated with oxygen adsorption at different sample temperatures has been studied by Auger electron spectroscopy (AES), ion scattering spectroscopy (ISS), and the relative change of the work function (Δф) measured by the onset of the secondary electron energy distribution. The results have revealed: (i) adsorption of zirconium onto the W(100) surface followed by the elevation of the sample temperature up to 1710 K in an oxygen partial pressure of 2.7 × 10⁻⁴ induces complete diffusion of zirconium atoms into the W(100) substrate; (ii) further exposure of oxygen induces co-existence of oxygen and tungsten on the surface at 1710 K, resulting in a work function of 4.37 eV; (iii) keeping the sample temperature at 1710 K, simple evacuation of the system has resulted in surface segregation of zirconium atoms to the surface to form a zirconium atomic layer on the top-most surface, reducing the work function to 2.7 eV. The results have revealed that this specific behavior of zirconium atoms at high temperature assures, with very good reproducibility, the highly stable performance and long service life of Zr---O/W(100)-emitters in practical use, even in a low vacuum of 10⁻⁶ Pa.     

Effects of oxygen in gamma irradiated aromatic polyesters in film

The effect of gamma irradiation in air is investigated on four thermoplastic polyesters (PET, PBT, PEN, PCT-co-ET) in films containing aromatic rings, in order to evaluate the influence of aromatic density and the role of oxygen on radiation resistance. Physical-chemical-nuclear analyses were used to this purpose. EPR measurements were carried out to detect radical stability against oxygen permeation. Viscometric investigations reported a very similar trend for all the investigated polyesters: a chain break effect that decreases at the highest doses. FT-IR analyses focused on the formation of oxidized species. Positron annihilation spectra pointed out a decrease of the intensity of ortho-positronium formation, while its lifetime remains unchanged with radiation dose.     

Thermodynamic and surface properties of Sb-Sn and In-Sn liquid alloys

The thermodynamic properties of Sb-Sn and In-Sn liquid alloys have been studied using the quasi-chemical model for compound forming binary alloys and that for simple regular alloys. The concentration fluctuation S _cc(0) and the Warren-Cowley short-range order parameter (α ₁) were determined for the whole concentration range at a temperature of 770 K. The surface tensions of these liquid alloys were determined for the whole concentration range by using energetics determined from thermodynamic calculations. In all calculations, In-Sn manifested properties very close to alloys of ideal mixing, while Sb-Sn showed properties that are asymmetric about equiatomic composition. Our results suggest that a weak complex of the form SbSn₂ could be present in the Sb-Sn alloy at a temperature of about 770 K.     

IR and XPS investigation of visible-light photocatalysis—Nitrogen-carbon-doped TiO2 film

To use solar irradiation or interior lighting efficiently, we sought a photocatalyst with high reactivity under visible light. Nitrogen and carbon doping TiO_2−x−yN_xC_y films were obtained by heating the TiO₂ gel in an ionized N₂ gas and then were calcined at 500 °C. The TiO_2−x−yN_xC_y films have revealed an improvement over the TiO₂ films under visible light (wavelength, 500 nm) in optical absorption and photocatalytic activity such as photodegradation of methyl orange. X-ray photoemission spectroscopy, infrared spectrum and UV-visible (UV-vis) spectroscopy were used to find the difference of two kinds of films. Nitrogen and carbon doped into substitutional sites of TiO₂ has been proven to be indispensable for band-gap narrowing and photocatalytic activity.