Use of chlorinated carbon and silicon precursors for epitaxial growth of 4H‐SiC at very high growth rates

A possibility to apply the advantages of chlorinated carbon precursors, which had been previously used in low‐temperature epitaxial growth of 4H‐SiC, to achieve very high growth rates at higher growth temperatures was investigated. Silicon tetrachloride was used as the silicon precursor to suppress gas‐phase homogeneous nucleation. The temperature increase from 1300 °C (which is the temperature of the previously reported low‐temperature halo‐carbon epitaxial growth) to 1600 °C enabled an increase of the precursor flow rates and consequently of the growth rate from 5 to more than 100 μm/h without morphology degradation. High quality of the epilayers was confirmed by low‐temperature photoluminescence spectroscopy and time‐resolved luminescence. No evidences of homogeneous nucleation were detected, however, liquid Si droplet formation on the epilayer surface seems to remain a bottleneck at very high growth rate. (© 2009 WILEY‐VCH Verlag GmbH & Co. KGaA, Weinheim)     

Direct construction of the effective action of chiral gauge fermions in the anomalous sector

The anomaly implies an obstruction to a fully chiral covariant calculation of the effective action in the abnormal-parity sector of chiral theories. The standard approach then is to reconstruct the anomalous effective action from its covariant current. In this work, we use a recently introduced formulation which allows one to directly construct the non-trivial chiral invariant part of the effective action within a fully covariant formalism. To this end we develop an appropriate version of Chan’s approach to carry out the calculation within the derivative expansion. The result to four derivatives, i.e., to leading order in two and four dimensions and next-to-leading order in two dimensions, is explicitly worked out. Fairly compact expressions are found for these terms.     

On the problem of vacuum energy in brane theories

We point out that modern brane theories suffer from a severe vacuum energy problem. To be specific, the Casimir energy associated with the matter fields confined to the brane, is stemming from the one and the same localization mechanism which forms the brane itself, and is thus generically unavoidable. Possible practical solutions are discussed, including in particular spontaneously broken supersymmetry, and quantum mechanically induced brane tension.     

Visualized measurement of the acoustic levitation field based on digital holography with phase multiplication

By using digital holographic interferometory with phase multiplication, the visualized measurement of the acoustic levitation field (ALF) with single axis is carried out. The digital holograms of the ALF under different conditions are recorded by use of CCD. The corresponding digital holographic interferograms reflecting the sound pressure distribution and the interference phase distribution are obtained by numerical reconstruction and phase subtraction, which are consistent with the theoretical results. It indicates that the proposed digital holographic interferometory with phase multiplication can successfully double the fringe number of the interference phase patterns of the ALF and improve the measurement precision. Compared with the conventional optical holographic interferometory, digital holographic interferometory has the merits of quasi real-time, more exactitude and convenient operation, and it provides an effective way for studying the sound pressure distribution of the ALF.     

Optical properties of MOVPE-grown a-plane GaN and AlGaN

a-Plane GaN and AlGaN were grown on r-plane sapphire by low-pressure metal-organic vapor epitaxy (LP-MOVPE), and the effects of reactor pressure (from 40 to 500 Torr) and growth temperature (from 1020 to 1100 °C) on the crystalline quality and surface morphology of a-plane GaN were studied. The a-plane GaN grown under 40 Torr had a smooth-surface morphology but a poor crystalline quality; however, the a-plane GaN grown under 500 Torr had higher crystalline quality and optical properties, whose full-width at half-maximum of the X-ray rocking curve (XRC-FWHM) and intensity of yellow luminescence (YL) were smaller. Furthermore, the optical properties of a-plane GaN were investigated by photoluminescence (PL) in detail. We also studied the emission properties of a-plane Al_0.35Ga_0.65N grown at room temperature.     

Fabrication of freestanding m-plane GaN wafer by using the HVPE technique on an aluminum carbide buffer layer on an m-plane sapphire substrate

A freestanding m-plane GaN wafer is fabricated by using the hydride vapor-phase epitaxy (HVPE) technique on an aluminum carbide buffer layer on an m-plane sapphire substrate. X-ray pole-figure measurements show a clear m-plane orientation of the GaN surface. The full-width at half-maximum (FWHM) of GaN (1 1¯ 0 0) X-ray rocking curve (XRC) with the scattering vector along the [1 1 2¯ 0] direction is approximately 800 arcsec; this indicates good crystallinity. On the other hand, the FWHM for the case in which the scattering vector is oriented along the [0 0 0 1] direction is broad; this suggests the influence of structural defects along this direction. In fact, basal plane stacking faults (BSF) with a density of approximately 3×10⁵ cm⁻¹ is observed by transmission electron microscopy (TEM). The preparation of a 45-mm-diameter m-plane GaN wafer due to spontaneous separation of the GaN layer from the sapphire substrate is demonstrated.     

The effect of temperature and ammonia flux on the surface morphology and composition of InxAl1−xN epitaxial layers

An interesting recent development in the Group III nitrides is the growth of InAlN lattice matched to GaN, with applications in distributed Bragg reflectors (DBRs), high electron mobility transistors (HEMTs) and as etch-layers. This work presents a systematic study of the effects of changing the key growth conditions of ammonia flux and growth temperature in InAlN growth by metal-organic vapour phase epitaxy (MOPVE) and describes our current optimised parameter set. We also particularly concentrate on the details of surface morphology assessed by atomic force microscopy (AFM). The nanoscale surfaces are characterised by low hillocks and dislocation pits, while at a larger scale microscopic indium droplets are also present. However, these droplets are eliminated when the layers are capped with GaN. Other trends observed are that increasing the growth temperature will lower the indium incorporation approximately linearly at a rate of approximately 0.25% per °C, and that increasing the ammonia flux from 44.6 to 178.6 mmol min⁻¹ increased the indium incorporation, but further increases to 446 mmol min⁻¹ did not result in any further increase.     

Leakage current and capacitance characteristics of Si/SiO2/Si single-barrier varactor

We investigate, both experimentally and theoretically, current and capacitance (I–V/C–V) characteristics and the device performance of Si/SiO₂/Si single-barrier varactor diodes (SBVs). Two diodes were fabricated with different SiO₂ layer thicknesses using the state-of-the-art wafer bonding technique. The devices have very low leakage currents (about 5×10^-2 and 1.8×10^-2 mA/mm²) and intrinsic capacitance levels of typically 1.5 and 50 nF/mm² for diodes with 5-nm and 20-nm oxide layers, respectively. With the present device physical parameters (25-mm² device area, 760-μm modulation layer thickness and ≈10¹⁵-cm^-3 doping level), the estimated cut-off frequency is about 5×10⁷ Hz. With the physical parameters of the present existing III–V triplers, the cut-off frequency of our Si-based SBV can be as high as 0.5 THz. Received: 9 February 2001 / Accepted: 9 February 2001 / Published online: 23 March 2001     

Characterization of free-standing GaN substrate grown through hydride vapor phase epitaxy with a TiN interlayer

Large-scale GaN free-standing substrate was obtained by hydride vapor phase epitaxy directly on sapphire with porous network interlayer. The bottom surface N-face and top surface Ga-face showed great difference in anti-etching and optical properties. The variation of optical and structure characteristics were also microscopically identified using spatially resolved cathodoluminescence and micro-Raman spectroscopy in cross-section of the GaN substrate. Three different regions were separated according to luminescent intensity along the film growth orientation. Some tapered inversion domains with high free carrier concentration of 5 × 10¹⁹ cm⁻³ protruded up to the surface forming the hexagonal pits. The dark region of upper layer showed good crystalline quality with narrow donor bound exciton peak and low free carrier concentration. Unlike the exponential dependence of the strain distribution, the free-standing GaN substrate revealed a gradual increase of the strain mainly within the near N-polar side region with a thickness of about 50 μm, then almost kept constant to the top surface.     

Ultrarelativistic sources in nonlinear electrodynamics

The fields of rapidly moving sources are studied within nonlinear electrodynamics by boosting the fields of sources at rest. As a consequence of the ultrarelativistic limit the δ-like electromagnetic shock waves are found. The character of the field within the shock depends on the theory of nonlinear electrodynamics considered. In particular, we obtain the field of an ultrarelativistic charge in the Born–Infeld theory.