Synthesis of New Lithium Ionic Conductor Thio-LISICON—Lithium Silicon Sulfides System

The new lithium ionic conductors, thio-LISICON (LIthium SuperIonic CONductor), were found in the ternary Li₂S-SiS₂-Al₂S₃ and Li₂S-SiS₂-P₂S₅ systems. Their structures of new materials, Li_4+xSi_1−xAl_xS₄ and Li_4−xSi_1−xP_xS₄ were determined by X-ray Rietveld analysis, and the electric and electrochemical properties were studied by electronic conductivity, ac conductivity and cyclic voltammogram measurements. The structure of the host material, Li₄SiS₄ is related to the γ-Li₃PO₄-type structure, and when the Li⁺ interstitials or Li⁺ vacancies were created by the partial substitutions of Al³⁺ or P⁵⁺ for Si⁴⁺, large increases in conductivity occur. The solid solution member x=0.6 in Li_4−xSi_1−xP_xS₄ showed high conductivity of 6.4×10^-4 S cm⁻¹ at 27°C with negligible electronic conductivity. The new solid solution, Li_4−xSi_1−xP_xS₄, also has high electrochemical stability up to ∼5 V vs Li at room temperature. All-solid-state lithium cells were investigated using the Li_3.4Si_0.4P_0.6S₄ electrolyte, LiCoO₂ cathode and In anode.     

Study of non-isothermal crystallization of amorphous Cu<Subscript>50</Subscript>Ti<Subscript>50</Subscript> alloy

The crystallization kinetics of amorphous Cu₅₀Ti₅₀ has been studied using differential scanning calorimetry (DSC) under non-isothermal conditions. The curves at different linear heating rates (2, 4, 8 and 16 K min^–1) show sharp crystallization peaks. The crystallization peak shifts to higher temperatures with increasing heating rate. The Kissingers method of analysis of the shift in the transformation peak is applied to evaluate the activation energy (E _c). The KJMA formalism, which is basically developed for isothermal experiments, is also used to obtain E _c and the Avrami parameter (n).The DSC data have been analysed in terms of kinetic parameters, viz. activation energy (E _c), Avrami exponent (n) and frequency factor K ₀ using three different theoretical models. It is observed that the activation energy values derived from KJMA approach and modified Kissinger equation agree fairly well with each other. The activation energy values obtained from normal Kissinger method, and Gao and Wang expression underestimate the activation energy.The financial support provided by All India Council for Technical Education (AICTE), New Delhi (Govt. of India) is gratefully acknowledged.     

Spectrophotometry Determination of Cobalt after Extraction of its Ternary Complex with 3-(4-Phenyl-2-Pyridyl)-5,6-Diphenyl-1,2,4-Triazine and Tetraphenylborate into Molten Naphthalene

The reaction of 3-(4-phenyl-2-pyridyl)-5,6-diphenyl-1,2,4-triazine (PPDT) and tetraphenylborate (TPB) with cobalt (II) has been studied to determine the optimum conditions for the extraction and quantitative spectrophotometry determination of this metal. The ternary complex is extracted into molten naphthalene at pH 3.6–7.4. The solid naphthalene containing the cobalt associated complex is separated by filtration and dissolved in acetonitrile. Beer's law is obeyed in the concentration range 8–140 μg cobalt in 10 ml of acetonitrile solution. The molar absorptivity and sensitivity are 4.2×10³ l·mol^?1·cm^?1 and 0.01408 μg/cm², respectively. The other factors such as pH, amounts of reagents and naphthalene, shaking and standing times, and the effect of diverse ions are studied. The method has been applied to the determination of cobalt in iron steel alloys.     

Ab initio and DFT studies on tautomerism of indazole in gaseous and aqueous phases

Electronic structure of optimized Ge₅, Ge₁₇, Ge₅–O and Ge₅ embedded in SiO₂ nanoparticles have been studied by density functional theory to find out the effect of cluster size and Ge–O bond(s) on the optical energy gap between LUMO and HOMO. It was found that the optical energy gap depends on both cluster size and the number of Ge–O bonds nonlinearly. The optical energy gap was found to be in visible light range when the Ge₅ nanoparticle has been embedded in SiO₂ matrix.     

Catalytic Adsorptive Stripping Voltammetry of Germanium(IV) in the Presence of Gallic Acid and Vanadium(IV)‐EDTA

A highly sensitive and selective catalytic adsorptive cathodic striping procedure for the determination of trace germanium is presented. The method is based on adsorptive accumulation of the Ge(IV)‐gallic acid (GA) complex onto a hanging mercury drop electrode, followed by reduction of the adsorbed species. The reduction current is enhanced catalytically by addition of vanadium(IV)‐EDTA. The optimal experimental conditions include the use of 0.03 mol/L HClO₄ (pH1.6), 6.0×10^?3 mol/L GA, 3.0×10^?3 mol/L V(IV), 4.0×10^?3 mol/L EDTA, an accumulation potential of ?0.10 V(vs. Ag/AgCl), an accumulation time of 120 s and a differential pulse potential scan mode. The peak current is proportional to the concentration of Ge(IV) over the range of 3.0×10^?11 to 1.0×10^?8 mol/L and the detection limit is 2×10^?11 mol/L for a 120 s adsorption time. The relative standard deviation at 5.0×10^?10 mol/L level is 3.1%. No serious interferences were found. The method was applied to the determination of germanium in ore, mineral water and vegetable samples with satisfactory results.     

Static atomic displacements of Sn in disordered NiAs/Ni2In type HT-Ni1+δSn

The crystal structures of the intermediate solid solution HT (high temperature) Ni_1+δSn with δ=0.28, 0.52 and 0.61 (refined Ni contents) have been analyzed in detail by X-ray diffraction on single crystals. The previously reported basic atomic arrangement, i.e., a NiAs/Ni₂In structure type (P6₃/mmc, Ni(1) on 2a, 0 0 0, Ni(2) with an occupancy δ on 2d, and Sn on 2c, ), is confirmed. However, strong anisotropic atomic displacements occur for Sn within the a-b plane of the hexagonal unit cell, which require a Gram-Charlier expansion of the probability density function of Sn in order to obtain a good fit to the diffraction data. Direction, magnitude and the concentration dependence of the displacements can be interpreted in terms of the geometrical requirements of the different local atomic configurations in the planes z=±1/4, so that the displacements can be identified as static ones.     

氢化物发生ICP-AES法测定药用植物中的痕量锗

本文应用氢化物发生ＩＣＰ－ＡＥＳ法研究了药用植物样品中痕量锗的测定方法，系统地研究了ＩＣＰ－ＡＥＳ仪器参数及氢化物发生条件对锗谱线信背比的影响，考察了１３种共存元素的干扰，并比较了植物样品的３种前处理方法。选定Ｈ３ＰＯ４－ＨＮＯ３－Ｈ２Ｏ２消化，在３ｍｏｌ／ＬＨ３ＰＯ４介质中，以１５ｇ／ＬＮａＢＨ４还原，测定药用植物样品中的锗，相对标准偏差≤２．９％，回收率为９４％～１０３％。方法检出限达０．１３μｇ／Ｌ。     

The interactions of (=O→Si)-(benzoyloxymethyl)trifluoro-and -(benzoyloxymethyl) methyldifluorosilanes with a solvent

The IR spectra of solutions of (=OSi)-(benzoyloxymethyl)trifluorosilane (1),-(benzoyloxymethyl)methyldifluorosilane (2), and butyl benzoate (3) are examined in the region of thev(C=O) stretching vibrations in 24 solvents. The ability of compounds1—3 to undergo specific intermolecular interactions is evaluated from the dependence ofv(C=O) on the Kamlet-Taft (^*,, ) parameters, which was obtained for the carbonyl groups involved in the intramolecular coordinate (=OSi) bond and for free carbonyl groups. The corresponding values of the coefficients in the Kamlet-Taft equations are indicative of a weak ability of pentacoordinate silicon compounds1 and2 to undergo acid-base interactions.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 4, pp. 689–692, April, 1995.     

Optimizing Cs-exchange in titanosilicate with the mineral pharmacosiderite topology: framework substitution of Nb and Ge

Titanosilicates with complete or partial substitution of Ge or Nb in the framework and having the mineral pharmacosiderite topology were hydrothermally prepared and their ion-exchange properties towards Cs were studied for Ti/Ge/Si, Ti/Si, Nb/Ti/Si and pure Ge phases. The basis for the differences in the ion exchange properties measured as distribution coefficients (K_d) for these materials are detailed via structural characterization using the Rietveld refinement technique on the X-ray powder diffraction data. The differences in affinity towards Cs⁺ result either from the degree of hydration of the exchanger resulting in different coordination environments or the position of cesium ion in the eight-ring channel.     

Electroreduction of α-glucose on CNT/graphite electrode modified by Zn and Zn–Fe alloy

Electroreduction of -glucose to form sorbitol on Zn/CNTs and Zn alloy/CNTs electrodes has been investigated in this paper. Carbon nanotubes (CNTs) used in this paper are grown directly on graphite disks by chemical vapor deposition. Zn and Zn alloy are electrodeposited on the activated CNTs/graphite electrode by pulse galvanostatic method. The micrographs of Zn/CNTs and Zn alloy/CNTs electrodes are characterized by scanning electron microscopy. The results show that the current efficiency of -glucose reduction on CNTs electrodes is much better than that on flat Zn electrodes. The order of the current efficiency on different electrodes is as follows: Zn/CNT (0.58) Zn–Fe/CNT (0.57)>Zn–Ni/CNT (0.43) Zn/graphite (0.42)>Zn (0.40). It indicates that CNTs have good potential application in electrosynthesis. Additionally, effects of some operating parameters, such as pH, temperature and -glucose concentration, on the current efficiency of -glucose reduction are also discussed.