On the origin of 1.5 μm luminescence in porous silicon coated with sol–gel derived erbium-doped Fe2O3 films

Sol–gel derived Fe₂O₃ films containing about 10 wt% of Er₂O₃ were deposited on porous silicon by dipping or by a spin-on technique followed by thermal processing at 1073 K for 15 min. The samples were characterized by means of PL, SEM and X-ray diffraction analyses. They exhibit strong room-temperature luminescence at 1.5 μm related to erbium in the sol–gel derived host. The luminescence intensity increases by a factor of 1000 when the samples are cooled from 300 to 4.2 K. After complete removal of the erbium-doped film by etching and partial etching the porous silicon, the erbium-related luminescence disappears. Following this, luminescence at 1.5 μm originating from optically active dislocations (“D-lines”) in porous silicon was detected. The influence of the conditions of synthesis on luminescence at 1.5 μm is discussed.     

钢中Si、Mn的电子探针定量分析与标样

采用特制的Fe-Si、Fe-Mn合金系列标样，用电子探针测定了钢或铁基合金中低含量的Si和Mn元素、与用纯元素作标样、经ZAF修正的结果相比较，提高了分析准确度．     

杂氮硅三环成环反应的研究

本文报导了与硅原子直接相连的有机基团(R)对杂氮硅三环成环速率的影响。利用气相色谱检测成环反应的产物之一——乙醇的生成速率和数量,并同与硅相连的R基团对成环反应速率的影响作比较。实验结果表明五种杂氮硅三环成环速度顺序为Cl_2CH—>ClCH_2—>ClCH_2CH_2CH_2—>CH_2=CH—>CH_3—,这与理论推断相符。     

Thermal evolution of ferromagnetic metallic glasses

A traditional TG apparatus was modified by placing two permanent magnets producing a controlled magnetic field (TG(M): Magneto Thermogravimetry). This technique proved to be useful to study both structural relaxation and crystallisation of ferromagnetic metallic glasses. Results obtained for the amorphous alloys Fe₄₀Ni₄₀P₁₄B₆ and Fe_62.5Co₆Ni_7.5Zr₆Nb₂Cu₁B₁₅, are reported in this paper. Structural relaxation can be evaluated by measuring changes in Curie temperature induced by thermal treatments. Crystallisation in TG(M) is detected through a change in the measured apparent mass (difference between the sample mass and magnetic force driving it upward). These results were confirmed by DSC analysis. Whether the obtained crystalline phase is ferromagnetic, it can be identified through its Curie temperature, measured by TG(M). In fact the value of 770°C measured as Curie temperature of crystallised Fe_62.5Co₆Ni_7.5Zr₆Nb₂Cu₁B₁₅led to conclude that the only ferromagnetic crystalline phase is a-Fe. These hypothesis was confirmed by XRD analysis, showing that the first crystallisation yields to a-Fe nanocrystals. This revised version was published online in July 2006 with corrections to the Cover Date.     

Immobilization of thiabendazole-specific monoclonal antibodies to silicon substrates via aqueous silanization

Monoclonal antibodies specific for thiabendazole were immobilized to silicon, silicon dioxide, stoichiometric silicon nitride, and silicon-rich silicon nitride surfaces. This work provides the foundation for the development of a homogeneous sensor system for rapid detection and quantification of thiabendazole residues in produce and animal tissue. Immobilization was performed via aqueous silanization of the substrate followed sequentially by treatment with glutaraldehyde and contact with antibody solution in the presence of detergent. Surfaces were challenged with thiabendazole-horseradish peroxidase conjugate in an ELISA format to estimate immobilized antibody load. A stable and reproducible surface loading of 2 x 10¹¹ antibodies/cm² was obtained only after surfaces received postimmobilization treatments to remove nonspecifically adsorbed antibody. No difference in surface loading was noted when using 30% hydrogen peroxide rather than nitric acid for silanol activation. Little difference was noted among the antibody loadings achieved on the various silicon substrates. Bound antigen-enzyme conjugate was eluted with 0.1N acetic acid and reproducible surface activity was measured for up to four consecutive antigen challenges. Immobilized antibody surfaces were stabilized with 2% sucrose, dehydrated at 37‡C and stored in vacuum or stored at 4‡C in phosphate buffered saline containing 0.01% sodium azide without significant loss of activity.     

多孔硅的电化学制备

单晶硅在氢氟酸溶液中阳极氧化可制得多孔硅, 多孔硅是一种以新形态存在的硅, 与单晶硅相比, 它表现出独特的物理性质和化学活性。荧光光谱峰的蓝移表明, 在p-型低掺杂衬底硅上形成的多孔硅中存在量子尺寸效应, 新近获得的Raman光谱也证实了这一点。     

三氯化钛存在下碘酸钾滴定法测定锡

提出了采用铝加铁混合还原剂还原,三氯化钛存在下碘酸钾滴定法测定锡的绝对测量方法,研究了三氯化钛抑制氧的作用效果及作用机理。应用于巴氏合金中锡含量的测定,方法简便、快速,结果准确可靠。     

Mass spectrometric analysis of low molecular mass polyesters by laser desorption/ionization on porous silicon

A low molecular mass polyester was analyzed by desorption/ionization on porous silicon (DIOS) mass spectrometry. The results were compared with those of matrix-assisted laser desorption ionization (MALDI) mass spectrometry using matrixes of alpha-cyano-4-hydroxycinnamic acid (CHCA) and 10,15,20-tetrakis(pentafluorophenyl)porphyrin (F20TPP). The CHCA matrix was not suitable for characterization of low molecular mass components of the polyester because the matrix-related ions interfered with the component ions. On the other hand, the F20TPP matrix showed no interference because no matrix-related ions appeared below m/z 822. However, the solvent selection for determining optimal conditions of sample preparation was limited, because F20TPP does not dissolve readily in any of the available organic solvents. In the DIOS spectra, the polymer ions were observed at high sensitivity without a contaminating ion. No matrix is needed for DIOS spectra of low molecular mass polyesters, facilitating sample preparation and selectivity of a precursor ion in post-source decay measurements.     

吸附溶出催化伏安法测定痕量锗

利用吸附溶出伏安法、极谱催化法测定痕量锗已有报道。但将吸附溶出伏安法与极谱催化法结合进行测定,尚未见报道。我们选择适当的体系和配位体3,4-二羟基苯甲醛(DHB)及氧化剂钒(V),首先使Ge(Ⅳ)-DHB络合物在悬汞电极上于一定电位处吸附富集一定时间,然后电位向负的方向扫描。当达到Ge(Ⅳ)-DHB络合物的还原电位时,Ge(Ⅳ)还原