CeO_2和Y_2Ba_1Cu_1O_(5-δ)共同掺杂对Y_1Ba_2Cu_3O_(7-δ)的超导电性及其晶格结构的影响

采用固相反应法成功制备出一批Y123与Y211的摩尔比为1∶0.47的混合物,并在此混合物的基础上掺入CeO2,掺入的比例x分别为0.5wt%、1.0wt%、2.0wt%、3.0wt%、4.0wt%。采用了X-射线衍射仪对样品的晶格结构进行了分析,测量结果表明:x=1.0wt%时掺杂效果最好,同时也充分说明Y123的晶格结构与其超导电性之间存在着一种内在的必然关联。并通过对其测试临界转变温度以及转变宽度,测量结果也充分验证了上述结论。     

基于第一性原理计算Mn掺杂MoS2对油中溶解气体的吸附性能

CO、C₂H₂、CH₄是溶解在变压器油中的典型故障特征气体,其种类和浓度能够反映油浸式变压器绝缘故障的不同类型和严重程度,进行油中溶解气体分析是在线检测变压器运行状态的重要方法.基于第一性原理,通过Mn-MoS₂单层对三种气体的吸附能、转移电荷、态密度和形变电荷密度等参数以及解吸性能分析和灵敏度计算,提出了一种基于Mn-MoS₂材料的气敏传感器对油中溶解气体进行分析的方法.结果表明Mn-MoS₂对CH₄是物理吸附,对CO和C₂H₂是化学吸附.对于Mn-MoS₂来说,CH₄在常温下吸附能力差且灵敏度低,CO在不同温度下均有较强的吸附能力,而C₂H₂在常温下吸附稳定,高温下易解吸且响应灵敏度高.因此,Mn掺杂的MoS₂体系可预期作为CO的气体吸附剂和检测C₂H     

Raman and optical absorption spectroscopic investigation of Yb-Er codoped phosphate glasses containing SiO_2

Yb-Er codoped Na2O-Al2O3-P2O5-xSiO2 glasses containing 0 - 20 mol% SiO2 were prepared successfully. The addition of SiO2 to the phosphate glass not only lengthens the bond between pS＋ and non-bridging oxygen but also reduces the number of P=O bond. In contrast with silicate glass in which there is only four-fold coordinated Si4＋, most probably there coexist [SiO4] tetrahedron and [SiO6] oetahedron in our glasses. Within the range of 0 - 20 mol% SiO2 addition, the stimulated emission cross-section of Era＋ ion only decreases no more than 10%. The Judd-Ofelt intensity parameters of Er3＋, Ω2 does not change greatly, but Ω4 and Ω6 decrease obviously with increasing SiO2 addition, because the bond between Er3＋ and O2- is more strongly eovalently bonded.     

稀土掺杂锰氧化物庞磁电阻效应

过去十多年来，具有庞磁电阻效应的稀土掺杂锰氧化物成为了凝聚态物理研究的重要领域。锰氧化物的载流子自旋极化率高，且在居里温度附近表现出很大的磁电阻效应，因此在自旋电子学中有潜在的应用前景。另一方面，锰氧化物是典型的强关联电子体系，它对目前有关强关联体系的认识提出了很大挑战。本文综述了锰氧化物的各种性质及其物理原因。全文首先概述了锰氧化物的庞磁电阻效应及其晶格和电子结构，简单介绍了其他一些庞磁电阻材料；随后综述了锰氧化物的电荷／轨道有序相及其输运性质；在第四部分简单介绍了锰氧化物中庞磁电阻效应的机制；最后讨论了锰氧化物的一些可能的应用，如低场磁电阻效应、磁隧道结、磁p-n结以及全钙钛矿的场效应管和自旋极化电子注入装置等。     

掺杂聚苯乙烯制备研究

讨论了惯性约束聚变研究中采用化学及物理手段在聚苯乙烯（PS）材料掺杂卤素、硅、氘等非金属元素以及铁、铬、钛等金属元素的原理和方法。利用硅烷偶联剂对氧化物表面进行了预处理,采用本体聚合的方式将氧化物掺杂在PS网络之中,简述了它们在ICF中的应用。     

Mo掺杂调控电子结构增强NiS电催化固氮性能

以泡沫镍为骨架,通过水热法制备了Mo掺杂的NiS多级纳米花状结构(Mo-NiS).在偏压为-0.7 V(vs RHE)下,2 h内,0.83 Mo-NiS(制备时钼、镍物质的量之比为0.83)的电催化固氮速率平均可达4.21μg·cm-2·h-1,法拉第效率平均为18％.XPS测试和DFT计算表明,Mo掺杂增加了Ni活...     

Frequency and voltage-dependent electrical and dielectric properties of Al/Co-doped PVA/p-Si structures at room temperature

In order to investigate of cobalt-doped interracial polyvinyl alcohol （PVA） layer and interface trap （Dit） effects, A1/p- Si Schottky barrier diodes （SBDs） are fabricated, and their electrical and dielectric properties are investigated at room temperature. The forward and reverse admittance measurements are carded out in the frequency and voltage ranges of 30 kHz-300 kHz and -5 V-6 V, respectively. C-V or er-V plots exhibit two distinct peaks corresponding to inversion and accumulation regions. The first peak is attributed to the existence of Dit, the other to the series resistance （Rs）, and interfacial layer. Both the real and imaginary parts of dielectric constant （er and err） and electric modulus （Mr and Mrr）, loss tangent （tan~）, and AC electrical conductivity （aac） are investigated, each as a function of frequency and applied bias voltage. Each of the M~ versus V and Mrr versus V plots shows a peak and the magnitude of peak increases with the increasing of frequency. Especially due to the Dit and interfacial PVA layer, both capacitance （C） and conductance （G/w） values are strongly affected, which consequently contributes to deviation from both the electrical and dielectric properties of A1/Co-doped PVA/p-Si （MPS） type SBD. In addition, the voltage-dependent profile of Dit is obtained from the low-high frequency capacitance （CLF-CHF） method.     

Synthesis and Characterization of Titanium-doped Ordered Mesoporous Alumina

Titanium-doped ordered mesoporous alumina with specific structural properties has been prepared by the evaporation induced self-assembly sol-gel method. The results show that the doped titanium helps to stabilize the ordered mesoporous alumina material without influencing the ordered mesoporosity. The textural properties of the obtained sample are related to the amount of doped titanium. When the molar ratio of aluminum to titanium(n(Al)/n(Ti)) is controlled as 10.2, the titanium-doped ordered mesoporous alumina exhibits high surface area(up to 218 m2 g-1), large pore volume(0.42 cm3 g-1) and narrow pore diameter(6.1 nm) after treating at 900 ℃, showing high thermal stability. Moreover, the obtained sample calcined at 900 ℃ still maintains ordered mesoporous structure and exhibits high thermal stability.     

镨铁硼低温波荡器机械结构的传热分析

对镨铁硼材料在低温和室温下的热学和力学物性进行了测量;使用实测的镨铁硼物性并结合数值模拟的方法对镨铁硼低温波荡器的传热特性进行了分析;结果表明,磁极和磁极夹持机构与磁铁间的热传导是冷却磁铁的关键因素,冷却管道宜采用双通道同向并联的方式。使用该设计通过液氮可以冷却磁铁至82K,同时能够控制由于温差带来的磁极间相位误差小于0.1度,满足镨铁硼低温波荡器设计要求。