金钢石的制备研究

本文研究了两种不同质异构体石墨—金刚石的转化条件，以及在实验室现有条件下，利用石墨材料制备金刚石颗粒的具体方法和试验结果。     

阴极还原处理对多孔硅发光性能的影响

对经过阴极还原处理后的多孔硅样片进行了光致发光测试和稳定性测试.实验结果表明这种处理能明显改善多孔硅的发光稳定性,使其表面结构更加稳定.利用原子力显微镜对不同还原时间的多孔硅微结构及形貌进行了比较,在一定范围内随着还原时间的增长多孔硅表面粗糙度增大,PL谱增强.     

石墨炉原子吸收法测定化妆品中的砷

在过氧化氢溶液及硝酸镍存在下，用石墨炉原子吸收法测定化妆品中砷的含量，砷的浓度在0-1mg/L时与吸光度线相关，线性方程为A=0.838c 0.003，相关系数为0.99994。对液体和固体化妆品中的砷进行测定，砷的加标回收率为98.3%-98.7%，测定结果的相对标准偏差为0.65%-1.50%。     

Efficient Visible Electroluminescence from Porous Silicon Diodes Passivated by Carbon Films

By using n-butylamine as a carbon resource,carbon film is deposited on the p-n porous silicon (PS) surface with a radio-frequency glow discharge plasma system.Raman spectra and infrared reflection (IR) spectra of the carbon films indicate that there are amine-group and hydrogen atoms therein.The IR spectra of the passivated PS samples exhibit that the PS surfaces are mainly covered with Si-C,Si-N and Si-O bonds.Electroluminescence (EL) spectra show that the EL intensity of the passivated PS diodes increases greatly and the blueshift of the EL peak occurs compared with the diodes without treatment.Both of these are stable while the passivated diodes are exposed to the air indoors.The I-V characteristics reveal that the passivated diodes have a smaller series resistance and a lower onset voltage.The influence of the carbon film passivation on EL properties of PS has also been discussed.The results have proven that carbon film passivation is a good way to enhance the PS luminescent intensity and stability.     

POROSITY CALCULATION OFMIXTURES OF FIBROUS PARTICLES

The initial forming of fiber blend to high green density, i.e. the packing of fibrous particles, is important to the reinforcement of composite materials. It is very useful to develop a general predictive method for the optimum selection of particle mixtures for the property control of ceramic or composite products. This paper presents such a mathematical model developed on the basis of the similarity analysis between the spherical and non-spherical particle packings and assesses its applicability to the packing of fibrous particles with discrete and/or continuous length distributions. The results indicate that the model can predict this packing system well and hence provide an effective way to solve various packing problems in the composite materials processing.     

多孔硅制备过程中B,P杂质原子的作用

采用DV-Xα方法对多孔硅形成过程中位于表层的B和P杂质原子的作用进行研究,结果表明位于顶层硅原子层中的B和P杂质原子均可削弱其邻近的Si-Si键强度,因而可能导致出现腐蚀的突破点,再通过分析杂质对表面区势场的改变,可以认为位于顶层硅原子层中的B杂质原子产生腐蚀的突破点的可能性更大。 关键词：     

元素在石墨炉内石墨探针表面上的原子化机理研究：Ⅶ.锗的原子化机理

本文应用Ｘ－射线衍射，Ｘ－射线光电子能谱，俄歇电子能谱和其它一些实验，考察石墨炉升温过程中氟化锗，锗酸钠在石墨探针表面上的形态变化，阐明了它们的原子化机理：ＧｅＦ２与Ｎａ２ＧｅＯ３首先分解为ＧｅＯ２，ＧｅＯ２还原为ＧｅＯ，后者在＞２４００Ｋ热分解产生自由态的锗原子，ＧｅＦ２和Ｎａ２ＧｅＯ３的原子化均源于ＧｅＯ（ｇ）的气相分解。原子化的升温过程中，在１４００－２４００Ｋ ＧｅＦ２和Ｎａ２ＧｅＯ３都产     

塞曼石墨炉原子吸收光谱法测定粉尘降尘中痕量锡

以KOH熔样,又以KOH作基体改进剂,研究了测定锡的灰化温度、原子化行为和消除干扰及试样前处理的方法,以KOH熔解的粉尘及降尘样液,特别适用于塞曼石墨炉的测定,背景可完全扣除。方法简便、快速、准确,灵敏度和精度高。相对标准偏差为4.0%,回收牢在96.4～110%范围内。     

加压下的石墨炉原子吸收光谱分析

本文评述了压力对电热原子化的影响。惰性气体压力对石墨炉原子吸收光谱分析特性的影响归结为压力对试样蒸发速率的影响和原子蒸气的吸收系数随气体压力增加而降低（罗伦兹效应）。加压下原子化有下列优点：（1）非线性校准曲线的线性化；（3）增加校准曲线的线性动态范围；（3）减小光源放电条件变化引起的影响，提高了精密度和降低检出极限；（4）减小了气相干扰。但是，峰高与峰面积灵敏度随压力增加而降低。采用连续光源和加压原子化能显著提高灵敏度和降低检出极限。