Analysis of the disaccharides derived from hyaluronic acid and chondroitin sulfate by capillary electrophoresis with sample stacking

CE conditions for monitoring the unsaturated disaccharides of hyaluronic acid (di-HA) and chondroitin sulfate (di-CS) using an alkaline tetraborate buffer, electrokinetic sample injection, and UV absorption detection at 232 nm are reported. Separations were performed in an uncoated fused-silica capillary having reversed polarity and reversed electroosmosis generated with the addition of CTAB to the buffer. The influence of various separation parameters, including the concentration of CTAB, buffer pH, concentration of tetraborate, and applied voltage, on the resolution of the two disaccharides was investigated. Baseline separation was obtained with 25 mM tetraborate at pH 10.0 and having 0.05 mM CTAB. Chloride and phosphate in the sample are beneficial for the stacking of the disaccharides, with di-HA forming a much sharper peak than di-CS. Using samples prepared in 25 mM Tris-HCl (pH 7.5) and electrokinetic injection at the cathode at -10 kV for 40 s, linear relationships between the corrected peak area and the concentration of the disaccharides have been found in the ranges of 1.0-400.0 and 0.1-1.0 microg/mL (0.2-1.0 microg/mL for di-CS), with correlation coefficients being >0.9933 in all cases. The RSDs of detection times and corrected peak areas were between 1.13-1.24 and 1.57-2.13%, respectively. Applied to human serum samples that were prepared by ethanol precipitation and depolymerization of the two polysaccharides with chondroitinase ABC reveals comigration of endogenous compounds with di-HA and a sample-dependent detection time. The di-HA content in the serum sample can be estimated via subtraction of the blank peak that is obtained without enzymatic hydrolysis.     

Effect of lithium oxide dopants on electrophysical and sorption properties of zinc oxide

The effects of lithium oxide dopants (0.5–0.8 at. % Li) on the electrophysical and sorption properties of ZnO were studied in the temperature range from 150 °C to 410 °C. The introduction of lithium increases the activation energy of the conductivity of ZnO, decreases its conductivity, and increases the amount of S0₂ sorbed. Two forms of chemisorbed SO₂ (donor and acceptor) are observed on the surface.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 5, pp. 1096–1100, May, 1996.     

Molecular structure of mixed adsorption layers surfactant—polymer at a liquid—liquid interface

Isotherms of the binding of dodecyl sulfate anions (DDS^–)and Na⁺ counterions during their coadsorption with a nonionic polymer. proxanol (PR). at the interface of dodecane-water emulsions have been measured by conductometry and Na-selective potentiometry. The adsorption of DDS^– and PR is concurrent. The affinity constant of PR to the interface determined by the Langmuir model decreases as the concentration of PR increases, and the surface concentration of DDS^– tends to a nonzero limiting value at high concentrations of PR. The surface (_o) and electrokinetic () potentials at the interface have been determined at various polymer concentrations by the spin probe and electrophoresis methods. The average dielectric permeability and density of polymer segments in We adsorption layer have been determined by ESR. The lower boundary of the hydrodynamic thickness of the polymer adsorption layer at the interface has been estimated from the dependences of _o and on the ionic strength.Translated fromIzvestiya Akademii Nauk. Seriya Khimicheskaya, No. 7, pp. 1653–1661, July, 1996.     

催化裂化汽油脱硫添加剂USY/ZnO/Al2O3的性能评价

 在固定流化床催化裂化装置上，以减压蜡油为原料，对制备的U\r\nSY／ZnO／Al2O3催化裂化汽油脱硫添加剂的性能进行了评价．结果表明\r\n，随着添加剂添加量和剂油比的增加，生成汽油的硫含量降低．在500\r\n℃和剂油比为5的条件下，在FCC平衡催化剂中添加30％的添加剂时，汽\r\n油的硫含量可由不加添加剂时的1230μg／g降低到770μg／g左右．添\r\n加剂的添加量（10％）较低时，对催化裂化产物的分布基本没有影响；\r\n添加30％的添加剂时，焦炭的产率有所增加，但汽油收率基本不变．X\r\nRD表征结果表明，USY／ZnO／Al2O3添加剂中的ZnO对USY的晶相结构有\r\n一定的破坏作用，但随着反应与再生次数的增多，ZnO与Al2O3之间形成\r\n较为稳定的锌铝尖晶石结构，使添加剂的性能趋于稳定．     

钙黄绿素蓝荧光法测定食品中的微量锌（Ⅱ）

本文研究了在ＣＴＭＡＢ存在下，用钙黄绿素蓝荧光法测定食品中的微量锌（Ⅱ）的实验条件。在本实验条件下，Ｚｎ（Ⅱ）与钙黄绿素蓝生成１：１的配合物使钙黄绿素蓝的荧光增强，最大激发波长和最大发射波长分别为３５３ｎｍ和４４０ｎｍ。     

以金属硫酸氢盐为催化剂在无溶剂条件下高效合成3,4-二氢嘧啶-2(1H)-酮

以金属硫酸氢盐M(HSO4)n(Ca(HSO4)2,Zn(HSO4)2和过硫酸氢钾制剂oxone○R)为催化剂催化醛、1,3-二羰基化合物和尿素进行缩合反应,在90℃及无溶剂的条件下高收率、一锅法合成了3,4-二氢嘧啶-2(1H)-酮.     

离子液体［bmim］HSO4中合成的苯胺与环氧丙烷共聚物的电催化性能

 采用恒电流电解法,在1-丁基-3-甲基咪唑硫酸氢盐(［bmim］HSO4)离子液体中合成了苯胺与环氧丙烷共聚物(PAN-PPO). 扫描电镜观察表明, PAN-PPO由直径小于80 nm的纳米纤维组成. PAN-PPO对草酸氧化具有较好的电催化活性. 采用电化学原位红外光谱技术对草酸的电催化氧化进行了简单的分析.     

Synthesis and crystal structures of heterobimetallic Fe-Cd,Fe-Zn,and Fe-In complexes containing hemilabile phosphorus/oxygen and silicon/oxygen bridging ligands

The reactions of K[Fe{Si(OMe)₃}(CO)₃(PY)][PY=Ph₂PCH₂C(O)Ph, Ph₂PCH₂C(O)[(-C₅H₄)FeCp] (Cp=⁵-C₅H₅), Ph₂P(CH₂)₂CN] with CdCl₂·2.5H₂O, ZnX ₂ (X=Cl, I) or InCl₃ afforded Fe-Cd-Fe or Fe-M(-X)₂ M-Fe (M=Cd, Zn, In;X=Cl, I) and Fe-InCl₂ complexes. Some of them contain an unusual and labile -²-SiO alkoxysilyl bridge which may be associated with a bridging mode for the ketophosphine ligand (first such example structurally established), thus providing original results in bimetallic chemistry on the intramolecular coordination of oxygendonor functions ofchemically different hemilabile ligands firmly attached to a neighboring metal center. The structures of the trinuclear complex (3), of the chlorobenzene solvate of the tetranuclear complex (4a·C₆H₅Cl) and of [mer-(OC)₃{(EtO)₃Si} (4e) have been determined by X-ray diffraction. Crystals of 3 are orthorhombic, space groupPbcn, witha=19.010(4),b=11.766(5),c=26.998(7)Å, andZ=4. Crystals of4a·C₆H₅Cl are monoclinic, space groupC2/c witha=22.455(3),b=17.680(2),c=16.627(4)Å, =90.80(4)°, andZ=4. Crystals of4e are monoclinic, space groupC2/c witha=25.392(5),b=18.554(6),c=16.28(1)Å, =120.73(3)°, andZ=4. The structures were solved using direct methods and Fourier difference techniques and refined by blocked full-matrix least squares toR=0.035 (R _w =0.049) for 2719 observed reflections, toR=0.042 (R _w =0.056) for 3082 observed reflections, and toR=0.057 (R _w =0.075) for 1850 observed reflections for3, 4a·C₆H₅Cl and4e, respectively. The Fe-Zn complexes (9a), (9b) and (9c) were prepared and characterized by spectroscopic methods.Part 21 in the Series: Complexes with Functional Phosphines. Part 20: P. Braunstein, S. Coco Cea, A. DeCian, and J. Fischer (1992).Inorg. Chem. 31, 4203.     

胶束增溶(增敏)配合体系的高效液相色谱研究 Ⅴ.Fe、Co、Pd-3,5-diBr-PADAT-SLS 体系

本文用反相高效液相色谱法研究了铁、钴,钯-3,5-diBr-PADAT-SLS体系。在pH5.5的HAc-NaAc介质中,七种金属离子可与试剂生成配合物。用Spherisorb 5 ODS柱,含有4.02×10~(-2)mol/L KCl和0.06mol/L pH3.0HAc-NaAc甲醇/乙腈/水(83/0.5/16.5)溶液作为流动相,分离出了Fe~(2+)、Co~(2+)和Pd~(2+)配合物。对分离机理进行了初步研究。建立了铁、钴、钯的同时测定的HPLC-光度法。用于对虾饵料中铁、钴的测定,结果令人满意。     

Facile preparation of organozinc bromides using electrogenerated highly reactive zinc and its use in cross-coupling reaction

Highly reactive zinc was readily prepared by electrolysis of a DMF solution containing pyrene as a mediator with a platinum cathode and a zinc anode. Preferential reduction of pyrene occurred to generate the corresponding radical anion, which reduced zinc ions generated from anodic dissolution to give zero valent zinc with high reactivity. The reactive zinc was successfully used for an efficient transformation of bromoalkanes into the corresponding organozinc bromides. Organozinc bromides obtained were further used successfully in Pd-catalyzed cross-coupling reaction with various aryl iodides and bromides.