Solution viscosity behavior of polystyrene-based cationic ionomers. Effects of ion content and solvent

Dilute-solution viscosities of polystyrene-based cationic ionomers containing ammonio or phosphonio groups were measured in several solvents. In polar solvents with dielectric constant (ε_r) beyond 10, the ionomers showed a typical polyelectrolyte behavior, indicating that a large part of ionic groups were dissociated into ions. In nonpolar solvents with low ε_r, the reduced viscosity of the ionomers linearly decreased with a decreasing ionomer concentration. At low polymer concentrations, every ionomer gave a reduced viscosity lower than that of the corresponding chloromethylated polystyrene. With an increasing ion content, the intrinsic viscosity progressively decreased if the nonpolar solvents had a low acceptor number (A_N), such as toluene or tetrahydrofran (THF). In the halogenated solvents with high A_N value, such as chloroform, however, the intrinsic viscosity was hardly dependent on the ion content. This indicates that the intramolecular aggregation among the ionic groups is inhibited in the halogenated solvents due to a strong anion solvation. An addition of a protic solvent to a nonpolar solvent eliminates the aggregation between ionic groups and leads to polyelectrolyte behavior. © 1994 John Wiley & Sons, Inc.     

Radiation formation of polymeric nanogels

An alternative method of synthesis of polymeric nanogels is proposed, based not on polymerization, but on intramolecular crosslinking of polymer chains, initiated by pulse irradiation in dilute aqueous solutions. Kinetic data show that for many water-soluble polymers irradiation under these conditions result in intramolecular crosslinking. Preliminary product studies on poly(vinyl alcohol) indicate that in fact internally crosslinked macromolecules can be obtained by this technique.     

Photochemical degradation of hyaluronic acid by singlet oxygen

Changes of the rheological properties of hyaluronic acid (sodium-magnesium salt) solutions after exposure to UV radiation indicate a vigorous decrease in their viscosity, but its still strong shear rate dependence. Whereas the presence of the singlet oxygen sensitizer (anthracene-1-sulphonic acid) brings about a loss of shear dependence; the studied solutions show newtonian behavior.     

Nonequilibrium Brownian dynamics simulations of shear thinning in concentrated colloidal suspensions

The effect of interparticle forces on shear thinning in concentrated aqueous and nonaqueous colloidal suspensions was studied using nonequilibrium Brownian dynamics. Hydrodynamic interactions among particles were neglected. Systems of 108 particles were studied at volume fractions of 0.2 and 0.4. For the nonaqueous systems, shear thinning could be correlated with the gradual breakup of small flocs present because of the weak, attractive secondary minimum in the interparticle potential. At the highest shear rate for=0.4, the particles were organized into a hexagonally packed array of strings. For the strongly repulsive aqueous systems, the viscosity appeared to be a discontinuous function of the shear rate. For=0.4, this discontinuity coincided with a transition from a disordered state to a lamellar structure for the suspension.     

Transport phenomena in a plane shock wave

With the use of the nonpolynomial closure 1/ _z in the Mott-Smith approximation of the solution of the Boltzmann equation, we obtain a value of the density gradient in the limit of a very weak shock wave that is close to the correct value. For the determination of the transverse temperature gradient we calculated the _x ² / _z moment of the Mott-Smith collision integral. The effective values of viscosity and thermal conductivity in the limit of a very weak shock wave were calculated for inverse-power potentials and found to agree almost exactly with the Chapman-Enskog values. Such a comparison can serve as a criterion for the evaluation of different bimodal theories. Various bimodal theories give different values of viscosity and thermal conductivity, but all of them give 33 % too high a value of the Eucken ratio.     

Efficient synthesis of magnetic nanoparticle-Musa acuminata peel composite for the adsorption of anionic dye

The impregnation of magnetite (Mt) nanoparticle (NPs) onto Musa acuminata peel (MApe), to form a novel magnetic combo (MApe-Mt) for the adsorption of anionic bromophenol blue (BPB) was studied. The SEM, EDX, BET, XRD, FTIR and TGA were used to characterize the adsorbents. The FTIR showed that the OH and CO groups were the major sites for BPB uptake onto the adsorbent materials. The average Mt crystalline size on MApe-Mt was 21.13 nm. SEM analysis revealed that Mt NPs were agglomerated on the surface of the MApe biosorbent, with an average Mt diameter of 25.97 nm. After Mt impregnation, a decrease in BET surface area (14.89 to 3.80 m²/g) and an increase in pore diameter (2.25–3.11 nm), pore volume (0.0052–0.01418 cm³/g) and pH point of zero charge (6.4–7.2) was obtained. The presence of Pb(II) ions in solution significantly decreased the uptake of BPB onto both MApe (66.1–43.8%) and MApe-Mt (80.3–59.1%), compared to other competing ions (Zn(II), Cd(II), Ni(II)) in the solution. Isotherm modeling showed that the Freundlich model best fitted the adsorption data (R² > 0.994 and SSE < 0.0013). In addition, maximum monolayer uptake was enhanced from 6.04 to 8.12 mg/g after Mt impregnation. Kinetics were well described by the pseudo-first order and liquid film diffusion models. Thermodynamics revealed a physical, endothermic adsorption of BPB onto the adsorbents, with ΔH^o values of 15.87–16.49 kJ/mol, corroborated by high desorption (over 90%) of BPB from the loaded materials. The viability of the prepared adsorbents was also revealed in its reusability for BPB uptake.     

A bound on the number of bound states in the Schrödinger equation

A boundS _l is given for the number of bound statesn _i in thelth partial wave corresponding to a spherically symmetric potential in non-relativistic quantum mechanics. This bound is given by whereV _a(l, r) is the attractive part of the effective potentialV(r)+l(l+1)/r ². Extensive comparative study ofS _i and the Bargmann inequality is made.     

Aging Process Effects on the Characteristics of Vacuum Residue Oxidation Products with the Addition of Crumb Rubber

This paper considers the effect of aging processes on viscoelastic characteristics of vacuum residue oxidation products modified with crumb rubber. Viscoelastic properties were compared to original bitumen raw material-vacuum residue and vacuum residue oxidation products during short-term and long-term aging. The complex shear modulus of the vacuum residue and its oxidation products decreased with an increase in temperature. Short-term aging resulted in increased shear modulus for all samples.The vacuum residue oxidation product modified with crumb rubber had the maximum values of the rutting parameter and fatigue parameter. There was an expansion of the temperature range of plasticity: for the vacuum residue oxidation product with crumb rubber, its value was 67.2 °C. The curves of the black diagram of the modified vacuum residue oxidation product are shifted towards smaller phase angles with the increase in the shear modulus, which indicates the increase in the stiffness and elasticity of the rubber bitumen binders. The vacuum residue oxidation product modified with crumb rubber corresponded to the rubber bitumen binder of the grade RBB 60/90, according to its physical and mechanical indicators.     

HKD-1型航空润滑油特征剪切应力及有效粘压系数确定的研究

在球盘式拖动力试验机上,对HKD-1型航空润滑油进行拖动力测量,给出了根据拖动力试验曲线的非线性上升段确定润滑油有效粘压系数和特征应力的方法,对HKD-1型航空润滑油在试验条件下的粘压系数和特征应力进行分析,并建立了其计算公式.结果表明:特征应力和有效粘压系数的求解方法简单合理,其计算公式的拟合精度较高,可为轴承动态特性设计提供计算依据;随着接触压力、入口油温和滚动速度增加,HKD-1型航空润滑油的特征应力增大,其粘压系数减小;滚动速度对特征应力和粘压系数的影响小于接触压力和入口油温.