Application of the Volterra filter in experimental diffraction data processing

The effective signal in x-ray diffraction analysis of material properties often contains high frequency (noise) and low frequency (trend) components as additive parts. It is necessary to extract the effective signal from the noise to ensure high quality of signal processing. Digital filters of Volterra type are proposed for filtering purposes and a comparison of Volterra filtration implemented on x-ray diffraction data versus results from a set of other digital filters is given.     

Measurement of wire diameter by optical diffraction

A combined interference and diffraction pattern, in the form of equidistant interference fringes, resulting from illuminating a vertical metallic wire by a laser beam is analyzed to measure the diameter of four standard wires. The diameters range from 170 to 450 μm. It is found that the error in the diameter measurements increases for small metallic wires and for small distances between the wire and the screen due to scattering effects. The intensity of the incident laser beam was controlled by a pair of sheet polaroids to minimize the scattered radiation. The used technique is highly sensitive, but requires controlled environmental conditions and absence of vibration effects. The expanded uncertainty for k=2 is calculated and found to decrease from U(D)=±1.45 μm for the wire of nominal diameter 170 μm to ±0.57 μm for the diameter 450 μm.     

Solid state phase equilibria in the Gd-Si-B system at 1270 K

Solid state phase equilibria in the ternary Gd-Si-B phase diagram have been proposed at 1270 K using X-ray diffraction, scanning electron microscopy and electron probe microanalysis. Prior to this work, the binary systems Gd-B, Gd-Si and Si-B have also been reinvestigated. The main characteristic of the ternary diagram is the occurrence of two new ternary compounds Gd₅Si₂B₈ and Gd₅Si₃B_0.64. The former crystallizes in tetragonal symmetry, space group P4/mbm with unit cell parameters a=7.2665(3), c=8.2229(7) Å, the second one presents hexagonal symmetry, space group P6₃/mcm with unit cell parameters a=8.5080(4),c=6.4141(2) Å. The X-ray structures of the two structurally related phases Gd₅Si₃B_0.64 and host binary Gd₅Si₃ have been refined from three-dimensional single-crystal intensity data to the final R values of 0.036 (R_w=0.046) and 0.046 (R_w=0.055) for 457 and 401 reflections, respectively with [F>4σ(F)]. Both structures exhibit the Mn₅Si₃-type structure, with in addition for Gd₅Si₃B_0.64 a partial occupancy by boron of the normally vacant interstitial site at the center of the Gd₆ octahedron, which corresponds to the origin of the unit cell. Bonding between the interstitial boron atoms and the gadolinium ones forming the Gd₆B polyhedra is indicated by the decrease in the corresponding Gd-Gd distances and consequently in the unit cell volume. Finally, the Gd-Si-B phase diagram is compared with the previously reported Er-Si-B, at 1070 K.     

软x射线近贴显微技术

软x射线近贴显微技术不但可使活的生物样品成象,分辨率高于光学显微镜,而且人为的样品准备程序在该技术中都可避免。本文描述了用高功率激光打靶产生的等离子体作为软x射线源而进行的近贴显微研究,并得到了分辨率好于1μm的结果。     

CsBr高压X光研究

 采用同步辐射X光源和能散法，对CsBr粉末样品进行高压原位X光衍射实验。由金刚石对顶压砧高压装置（DAC）产生高压，用已知状态方程的Pt粉末作内标，由Pt的衍射数据确定样品压力，最高压力达64.4 GPa。实验结果表明：室温常压下原始CsBr样品是具有简单立方结构的晶体，其晶格常数α＝0.428 5 nm。高压下CsBr的结构有所变化，在51.3~58.4 GPa的压力范围内，(110)线和(211)线发生劈裂，从而形成了四方相。     

Electron diffraction investigation of PPTA/nylon 3T blends from shear-oriented anisotropic solutions

Nematic solutions of PPTA and nylon 3T were prepared in H₂SO₄ Optical microscopy was used to ascertain the phase behaviour of the blends. In the studied concentration range, no phase separation was observed. The solutions were shear-oriented and coagulated, and the resulting samples were studied by x-ray and electron diffraction. Nylon 3T crystallised even at a low concentration, which is indicative of a phase separation. Electron diffraction investigations of the oriented samples showed that well-oriented areas, which were predominantly composed of PPTA, adjoined areas where the major component, nylon 3T, showed no orientation. The relative proportion of the unoriented areas increased with increasing nylon concentration. It was concluded that, upon coagulation, the nylon was segregated into separate phases and crystallised unoriented, whereas for PPTA, crystallisation proceeded with very little chain rearrangement therefore preserving the orientation.     

聚合物分散液晶光栅的衍射特性的研究

报道了一种由聚合物分散液晶膜与具有周期性条状电极结构板结合的新型光栅器件，借助于聚合物分散液晶膜的电光特性，这种栅对入射光的散射或衍射取决于对其施加的电压，即它是电场可调的，实验结果显示出当驱动电压超过器件器件阈值电压时，衍射光的强度和衍射斑的可见级次被电场调制，而且它能入射光的线性偏振态变为椭圆偏振态。     

Structure induced by irradiation of femtosecond laser pulse in dyed polymeric materials

We investigated the structures induced by an irradiation of a near‐infrared (NIR) femtosecond laser pulse in dye‐doped polymeric materials {poly(methyl methacrylate) (PMMA), thermoplastic epoxy resin (Epoxy), and a block copolymer of methyl methacrylate and ethyl acrylate‐butyl acrylate [p(MMA/EA‐BA) block copolymer]}. Dyes used were classified into two types—type 1 with absorption at 400 nm and type 2 with no absorption at 400 nm. The 400‐nm wavelength corresponds to the two‐photon absorption region by the irradiated NIR laser pulse at 800 nm. Type 1 dye‐doped PMMA and p(MMA/EA‐BA) block copolymer showed a peculiar dye additive effect for the structures induced by the line irradiation of a NIR femtosecond laser pulse. On the contrary, dye‐doped Epoxy did not exhibit a dye additive effect. The different results among PMMA, p(MMA/EA‐BA) block copolymer, and Epoxy matrix polymers are supposed to be related to the difference of electron‐acceptor properties. The mechanism of this type 1 dye‐additive‐effect phenomenon for PMMA and p(MMA/EA‐BA) block copolymer is discussed on the basis of two‐photon absorption of type 1 dye at 400 nm by the irradiation of a femtosecond laser pulse with 800 nm wavelength and the dissipation of the absorbed energy to the polymer matrix among various transition processes. Dyes with a low‐fluorescence quantum yield favored the formation of thicker grating structures. © 2002 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 40: 2800–2806, 2002     

闪光Ⅰ号应用于X射线爆轰照相——研究金属射流的穿甲效应

闪光X射线照相技术是研究动载荷及其效应的重要测试手段,特别适用于研究物质在爆炸作用下的瞬变过程,本文介绍了闪光Ⅰ号加速器应用于X射线爆轰照相的基本状况,以及用于观察金属射流穿过高密度物质钨靶的实验技术。     

高斯光束照射下的圆盘夫琅禾费衍射

推导了高斯光束照射圆孔或圆盘的衍射场普遍表达式，计算了半波带数接近于零的情况下上述衍射场的数据，进而分析了圆盘衍射场在艾里斑中增加一个暗环的原因。