Effect of Bamboo Flour (BF) Content on the Dynamic Rheological Characteristics of BF-filled High-density Polyethylene (HDPE)

The effects of bamboo flour (BF) content on the dynamic rheological properties of BF-filled HDPE composites were investigated. Our findings showed that the addition of BF caused an enhancement of the non-Newtonianism of wood-plastic composites (WPCs) melt as well as the appearance of some new relaxation processes. In addition, the viscosity and modulus of the BF-filled HDPE composites showed a remarkable increase at 170?°C and 190?°C when the BF content exceeded 30%, which could be associated with the solid-like property of the WPCs at high BF loading, we propose. The present study we suggest will be useful to the formula design as well as the optimization of processing parameters for WPCs in general.     

Comparison of direct solid sampling and slurry sampling for the determination of cadmium in wheat flour by electrothermal atomic absorption spectrometry

Two analytical methods for the determination of cadmium in wheat flour by electrothermal atomic absorption spectrometry without prior sample digestion have been compared: direct solid sampling analysis (SS) and slurry sampling (SlS). Besides the conventional modifier mixture of palladium and magnesium nitrates (10 μg Pd + 3 μg Mg), 0.05% (v/v) Triton X-100 has been added to improve the penetration of the modifier solution into the solid sample, and 0.1% H₂O₂ in order to promote an in situ digestion for SS. For SlS, 30 μg Pd, 12 μg Mg and 0.05% (v/v) Triton X-100 have been used as the modifier mixture. Under these conditions, and using a pyrolysis temperature of 800 °C, essentially no background absorption was observed with an atomization temperature of 1600 °C. About 2 mg of sample have been typically used for SS, although as much as 3-5 mg could have been introduced. In the case of SlS multiple injections had to be used to achieve the sensitivity required for this determination. Calibration against aqueous standards was feasible for both methods. The characteristic mass obtained with SS was 0.6 pg, and that with SlS was 1.0 pg. The limits of detection were 0.4 and 0.7 ng g⁻¹, the limits of quantification were 1.3 and 2.3 ng g⁻¹ and the relative standard deviation (n = 5) was 6-16% and 9-23% for SS and SlS, respectively. The accuracy was confirmed by the analysis of certified reference materials. The two methods were applied for the determination of cadmium in six wheat flour samples acquired in supermarkets of different Brazilian cities. The cadmium content varied between 8.9 ± 0.5 and 13 ± 2 ng g⁻¹ (n = 5). Direct SS gave results similar to those obtained with SlS using multi-injections; the values of both techniques showed no statistically significant difference at the 95% confidence level. Direct SS was finally adopted as the method of choice, due to its greater simplicity, the faster speed of analysis and the better figures of merit.     

Surface and interfacial properties of water-soluble wheat proteins

Surface and interfacial properties of water-soluble wheat proteins were investigated and compared with six reference proteins (bovine serum albumin, ovalbumin, β-lactoglobulin, trypsin, cytochrom C and β-amylase). Albumins extracted from wheat flour were separated by the free solution isoelectric focusing. The surface activity at the air/water, dodecane/water interfaces and dilatational rheological behaviour of the adsorbed layers was determined by pendant drop technique. Considerably high surface activity of wheat proteins was found at both interfaces exceeding the corresponding values of most of the reference proteins. Exceptionally, low dilatational moduli (typically  < 10 mN/m) were obtained for wheat fractions in the continuous and the stepwise compression experiments with no age effect (1–20 min) and almost no relaxation. Surface/interfacial activity and rheological properties observed imply that water-soluble wheat proteins are generally characterized by strong hydrophobicity and more flexible molecular structure than the reference proteins.     

Study of allelopathic effects of Eucalyptus erythrocorys L. crude extracts against germination and seedling growth of weeds and wheat

Allelopathic materials inside a tree can produce positive or negative change in the survival, growth, reproduction and behaviour of other organisms if they escape into the environment. To assess these effects, this work was carried out to evaluate the allelopathic impact of Eucalyptus erythrocorys L. on seed germination and seedling growth of two weeds: Sinapis arvensis L. and Phalaris canariensis L.; on one cultivated crop: Triticum durum L. Aqueous; and on ethanolic leaf extracts of E. erythrocorys L. The study was effected using four concentrations (10, 20, 25 and 30 μL/mL) while distilled water was used as a control. The results showed that the E. erythrocorys L. crude extracts had an inhibitory effect on seed germination and seedling growth of both studied weeds and wheat. The inhibition rate was increased by the increase in extract concentration. Only ethanolic extracts of E. erythrocorys L. induced a significant inhibition of seed germination of durum wheat. The effect of E. erythrocorys L. crude extracts was more severe on weeds than on durum wheat. These results indicate that the seedling growth, especially radicle elongation, was the more sensitive indicator to evaluate the effects of extracts than was the seed germination.     

毛细管区带电泳分离小麦种子醇溶蛋白的研究

利用毛细管区带电泳（ＣＺＥ）检测了在不同电泳条件下分离小麦种子醇溶蛋白的效果。结果显示,用碱性缓冲液（０．０６ｍｏｌ／Ｌ硼酸钠,ｐＨ９．０,并含有２０％乙腈和１％ＳＤＳ）及４７ｃｍ×５０μｍｉ．ｄ．毛细管柱,在１５ｋＶ电压和３０℃的条件下可获得较高的分辨度和重复性。     

对甲基二溴偶氮胂的合成及其与稀土显色反应的研究

本文报道了对甲基二溴偶氮胂的合成,该显色剂在酸性介质中与稀土元素产生高灵敏度显色反应,大多数常见元素不干扰,所拟分析方法已成功地应用于小麦和铝合金中稀土总量的测定     

Preparation of ethyl levulinate from wheat stalk over Zr(SO4)2/SiO2

A series of Zr(SO₄)₂/SiO₂ solid acid catalysts with different Zr(SO₄)₂ loadings were prepared by water-soluble-impregnation method at room temperature. Then, the prepared catalysts were characterized by Fourier transform infrared spectroscopy, transmission electron microscopy and energy-dispersive X-ray spectrum, X-ray diffraction, adsorption/desorption of N₂, and temperature-programmed desorption of NH₃. The results showed that the active component Zr(SO₄)₂ was successfully adhered to the mesoporous SiO₂, and the acid amount of Zr(SO₄)₂/SiO₂ increased with the increasing of the Zr(SO₄)₂ loadings. Finally, the wheat stalk was used as raw material and depolymerized over Zr(SO₄)₂/SiO₂ to produce ethyl levulinate (EL). The reaction mixture was separated and purified by filtration and vacuum distillation. The kinetic characteristics and the reaction pathway were also studied. A comparative study showed that 20 wt.% Zr(SO₄)₂/SiO₂ exhibited higher catalytic activity. When reaction temperature, time, catalyst dosage and Zr(SO₄)₂ loadings were 190 °C, 50 min, 20 wt.% and 30 wt.%, the EL yield reached a maximum of 17.14%. The relative content of EL exceeded 90% after three steps of distillation.     

正交实验法在小麦粉中甲醛振荡提取条件的应用研究

小麦粉中甲醛的提取问题是一个比较复杂的多因素问题。采用正交实验法,选用L9(34)正交实验表,在提取试剂、提取温度、提取时间等多个因素和水平中优选小麦粉中甲醛振荡提取的最佳条件。实验中甲醛提取量采用Nash试剂柱前衍生高效液相色谱法测定。结果表明,提取温度是小麦粉中甲醛提取的最主要因素,最佳的提取条件为提取温度30℃、提取液为硫酸钠、提取时间为40min。     

Comparative Analysis of Herbaceous and Woody Cell Wall Digestibility by Pathogenic Fungi

Fungal pathogens have evolved combinations of plant cell-wall-degrading enzymes (PCWDEs) to deconstruct host plant cell walls (PCWs). An understanding of this process is hoped to create a basis for improving plant biomass conversion efficiency into sustainable biofuels and bioproducts. Here, an approach integrating enzyme activity assay, biomass pretreatment, field emission scanning electron microscopy (FESEM), and genomic analysis of PCWDEs were applied to examine digestibility or degradability of selected woody and herbaceous biomass by pathogenic fungi. Preferred hydrolysis of apple tree branch, rapeseed straw, or wheat straw were observed by the apple-tree-specific pathogen Valsa mali, the rapeseed pathogen Sclerotinia sclerotiorum, and the wheat pathogen Rhizoctonia cerealis, respectively. Delignification by peracetic acid (PAA) pretreatment increased PCW digestibility, and the increase was generally more profound with non-host than host PCW substrates. Hemicellulase pretreatment slightly reduced or had no effect on hemicellulose content in the PCW substrates tested; however, the pretreatment significantly changed hydrolytic preferences of the selected pathogens, indicating a role of hemicellulose branching in PCW digestibility. Cellulose organization appears to also impact digestibility of host PCWs, as reflected by differences in cellulose microfibril organization in woody and herbaceous PCWs and variation in cellulose-binding domain organization in cellulases of pathogenic fungi, which is known to influence enzyme access to cellulose. Taken together, this study highlighted the importance of chemical structure of both hemicelluloses and cellulose in host PCW digestibility by fungal pathogens.     

Effect of High Humidity Exposure to Wheat Starch Based High Conducting Flexible Polymer-in-Salt-Electrolyte

Polymer-in-salt-electrolytes (PISEs) are an important class of electrolytes as they carry the promise of faster and single ion transport. Unfortunately, due to unavailability of a suitable polymer host PISE has still not reached to commercial level. In the present work, using a novel synthesis protocol developed by the group, glutaraldehyde crosslinked wheat starch has been successfully modified with sodium iodide (NaI) to synthesize a flexible PISE membrane with desired electrochemical properties. Present paper reports the effect of crosslinker and exposure to high humidity ambience on electrochemical and morphological properties. It has been established that on exposure to higher humidity atmosphere starch-based PISEs stabilize at lower resistance value, but with higher ion relaxation time, which indicates that effect of high humidity treatment is more on salt dissociation instead of assisting the ion transport. The studied materials have conductivity ≈0.01 S cm⁻¹ range with ESW >2.5 V, ensuring its usability in electrochemical devices. The developed synthesis protocol does not require any complicated synthesis route and/or sophisticated instrument hence the overall process is economical also, adding up to its potentiality for energy device fabrication.