Separation and determination of metals as complexes of 1-nitroso-2-naphthol-6-sulphonic and 2-nitroso-1-naphthol-6-sulphonic acids

A sensitive ion-pair liquid-liquid extraction-spectrophotometric method has been developed for the determination of copper, palladium, iron and cobalt, based on the formation of metal complexes with 1-nitroso-2-naphthol-6-sulphonic acid or 2-nitroso-1-naphthol-6-sulphonic acid as primary ligand, and zephiramine as counter-ion. The coloured metal complexes obtained over different pH ranges are easily and quantitatively extracted into dichloromethane. The method has been tested with samples containing known amounts of copper, palladium, iron and cobalt in ultrapure water. The reagents provide a sensitive spectrophotometric method for determining these metals.     

Hydrogen peroxide in basic media for whole blood sample dissolution for determination of its lead content by electrothermal atomization atomic absorption spectrometry

Hydrogen peroxide in basic media is proposed as a means for dissolving whole blood samples to be analyzed by electrothermal atomization atomic absorption spectrometry, ET AAS. Approximately 2 g of the whole blood sample were directly weighed in a 150 mL volumetric flask; 3 mL of a NaOH 0.2 mol L⁻¹ solution, two drops of 1-octanol, as an antifoaming agent, and 1 mL of 30% volume hydrogen peroxide were added to the flask to promote oxidation. The solution was then manually shaken and after approximately three minutes of shaking, a clear solution, with no apparent suspended solids or greasy layers, was obtained. Distilled-deionized water was used to complete the volume. Ten μL of the resulting solution along with 10 μL of a solution containing 5000 mg L⁻¹ of NH₄H₂PO₄ and 300 mg L⁻¹ of Mg(NO₃)₂ as a modifier, were injected into transversely heated graphite tubes for lead determination. Both aqueous standards and standard addition calibration curves produced results not significantly different at a 95% confidence limit level. Accuracy of the measurements was assessed by analysis of the IAEA A-13 (concentration of trace and minor elements in freeze dried animal blood) standard reference material containing 0.18 mg L⁻¹ lead on a dry basis and by means of recovery tests. Analysis of the IAEA A-13 standard produced 0.17 ± 0.02 mg L⁻¹ lead on a dry basis; recovery tests afforded values from 95 to 105%. Ten consecutive measurements of a 5 ppb lead solution gave a characteristic mass of 47.2 pg and a (3S) detection limit of 1.77 μg L⁻¹ Pb. Results obtained from analysis of whole blood samples of volunteer donors covered a lead concentration range between 8 and 21 μg L⁻¹ with a mean value of 11.9 ± 4.7 μg L⁻¹.     

焙烧富集分离－氢化物原子荧光法测定地质物料中痕量硒

本文研究了一种焙烧富集分离、氢化物－原子荧光法测定地质物料中痕量Ｓｅ的方法。系统地研究了Ｓｅ富集分离条件、考查了３０多种元素在焙烧前后对测定Ｓｅ的影响，在选定的最佳实验条件下，方法检出下限为０．０１μｇ／ｇ，线性范围为０．００１～０．３μｇ／ｍＬ。样品中Ｓｅ含量水平为０．０３６μｇ／ｇ和０．０８９μｇ／ｇ时的测量精度（ＲＳＤ）分别为１０％和５．８％。加标回收率为９７～９９％。采用本方法分析了２６个地球化学标准参考样中痕量硒，获得满意结果。     

二氧化碳和氧气的快速电化学方法联合测定

根据Ｏ２和ＣＯ２在二甲亚砜（ＤＭＳＯ）介质中Ｐｔ电极上的伏安特性，采用微电极并结构计算机控制的电位调制技术，建立了快速联合测定ＣＯ２和Ｏ２的调制电位脉冲库仑法和调制电位脉冲电流法，取得了满意的结果。一次测量时间快达４０ｍｓ。ＣＯ２检测范围０￣１０％（体积百分比）；Ｏ２检测范围不受限制。通过编程设计特定的调制电位－时间波形，可保持连续检测的长期稳定性。     

Synthesis of Hexadentate Hexahydro-1,3,5-triazine-Based Ligands and their Copper(I) Complexes

Summary.  Hexadentate ligands were formed by the reaction of primary dimethylaminoethyl- or methoxyethylamines with formaldehyde. The resulting N, N′, N″-functionalized hexahydro-1,3,5-triazines contain pending amino or ether functionalities which are able to coordinate to metals in addition to the ring nitrogen atoms. Both ligands were reacted with CuBr, and novel tricopper clusters were isolated and characterized by X-ray structure analysis. In these compounds a ring nitrogen atom, the pending amino or ether functionality, and two bridging bromine atoms coordinate each of the copper atoms. Received January 22, 2002; accepted (revised) March 22, 2002     

Determination of paraquat in human blood plasma using reversed-phase ion-pair high-performance liquid chromatography with direct sample injection

This report describes the determination of paraquat (PQ) in human blood plasma samples by a direct-injection reversed-phase ion-pair chromatographic method. Blood plasma filtrate was injected directly into the LiChrospher® RP-18 alkyl-diol silica (ADS) precolumn integrated in a column switching system using a mixture of 3% 2-propanol and 10 mM sodium octane sulfonate (SOS) in a 0.05 M phosphate buffer (pH 2.8). After washing with this phase, the ADS precolumn was back-flushed with the analytical mobile phase consisting of 40% of methanol and 10 mM SOS in a 0.05 M phosphate buffer (pH 2.8) at a flow rate of 1.0 ml min⁻¹, in order to carry the analyte to a conventional reversed-phase analytical column, where the separation of PQ was achieved and finally detected by UV at 258 nm. The recoveries of PQ from human blood plasma samples ranged between 95.0 and 99.5% at nine different concentrations (from 0.05 to 3.00 μg of PQ ml⁻¹) with coefficients of variation <2.5% (n=3). The precision expressed as relative standard deviation was below 3.5% for between-day and below 4.3% for within-day measurements (n=5). The detection limit (signal-to-noise ratio, S/N>3) was 0.005 μg ml⁻¹ with an injection volume of 200 μl. The proposed method is promising for the identification and quantification of PQ at low concentration levels and is suitable for its analysis in human blood plasma samples from intentional or accidental poisonings cases with a sample throughput of 5 samples per hour.     

高镍钢中镍的测定

以王水溶解试样，用氨水作沉淀剂，并加入适量三乙醇胺及柠檬酸进行掩蔽，以消除铁及铬等元素的干扰，在pH=3-6的酸性介质中，加入过量的EDTA标准溶液，使镍与EDA形成稳定的络合物，以PAN为指示剂，用硫酸铜标准溶液滴定过量的EDTA标准溶液，从而求得镍的含量。     

Spectrophotometric determination of lead in vegetables with dibromo-p-methyl-carboxysulfonazo

A new highly sensitive and selective chromogenic reagent dibromo-p-methyl-carboxysulfonazo (DBMCSA) was synthesized and studied for the spectrophotometric determination of lead in detail. In 0.25 M phosphoric acid medium, which greatly increases the selectivity, lead reacts with DBMCSA to form a 1:2 blue complex, having a sensitive absorption peak at 648 nm. Under the optimal conditions, Beer's law is obeyed over the range from 0 to 0.8 μg ml⁻¹ Pb(II) and the apparent molar absorptivity is 1.04×10⁵ l mol⁻¹ cm⁻¹. The detection limit and the variation coefficient were found to be 2.14 ng ml⁻¹ and 1.0%, respectively. It is found that, except for Ca(II) and Ba(II), all foreign ions studied do not interfere with determination. The interference caused by Ca(II) and Ba(II) can be easily eliminated by prior extraction with potassium iodide-methylisobutylketone. The method has been applied to the determination of lead in vegetables with satisfactory results.     

Cobalt(II) and nickel(II) complexes of a cyclam derivative as carriers in iodide-selective electrodes

The ligand 1,4,8-tri(n-octyl)-1,4,8,11-tetraazacyclotetradecane (L¹) containing pendant octyl groups has been synthesised. L¹ is a tetraazamacrocycle derived from the well-known cyclam unit, and the Ni²⁺ and Co²⁺ complexes, [Ni(L¹)]²⁺ and [Co(L¹)]²⁺, have been isolated and characterised. The ability of the nickel(II) and cobalt(II) complexes to act as anion receptors has been studied by using them as ionophores in membrane-based ion-selective electrodes (ISEs). The PVC membrane containing the complex [Ni(L¹)]²⁺ and 2-nitrophenyloctylether as plasticizer shows a Nernstian response against iodide in a concentration range from 1×10⁻¹ to 4×10⁻⁵ M I⁻ with a detection limit of 1.6×10⁻⁵ M I⁻ and a slope of 58.6 mV/pI⁻ at pH 7 (25 °C). In comparison, the electrode containing [Co(L¹)]²⁺ as ionophore gave a sub-Nernstian slope and a low lifetime. A comparison between the iodide-selective electrode containing [Ni(L¹)]²⁺ and other reported iodide-selective electrodes is also reported.     

混合食用色素的卡尔曼滤波光度分析

本文用联机卡尔曼滤波光度法成功地同时测定了混合合成食用色素样品中五个组分。它们分别是40号红、苋菜红、柠檬黄、日落黄和亮蓝。方法准确、快速,无需予分离。