聚N-异丙基丙烯酰胺溶液的粘度的温度依赖关系

用自由基聚合法合成了聚Ｎ 异丙基丙烯酰胺（ＰＮＩＰＡＡＭ）样品，用乌氏粘度计考查了该聚合物的四氢呋喃（ＴＨＦ）溶液和水溶液的粘度与温度的依赖关系．发现ＰＮＩＰＡＡＭ ＴＨＦ体系的特性粘数随温度升高而增大，ＰＮＩＰＡＡＭ Ｈ２Ｏ体系的特性粘数 温度曲线表现出较为复杂的变化规律．并用实验确定的特性粘数对合成样品的分子量进行了表征Ｍｎ＝８４４×１０５ｇ·ｍｏｌ－１．     

Influence of operational parameters on retention of ultra-high molecular weight polystyrenes in thermal field-flow fractionation

Summary The influence of various parameters (concentration of the injected polymer solution, flow rate, temperature gradient, relaxation conditions) on the retention and shape of the fractogram of ultra-high molecular weight polystyrenes in thermal field-flow fractionation was investigated. Under the operating conditions adopted, reproducible oscillations in the peak shape are observed for molecular weights larger than a few millions, especially at relatively high polymer concentration. They are attributed to some hydrodynamic instabilities. The retention of ultra-high molecular weight polystyrenes at high flow rate is strongly dependent on the initial relaxation period. All of the investigated operational variables have a complex effect on the resulting shape of the fractogram. Consequently, the confirmation of the shear-induced focusing of macromolecules across the channel thickness requires further study. Experiments on reinjection of fractions collected after an initial high speed pass through the separation system leads to the conclusion that shear degradation of the ultra-high molecular weight polymers did not occur under the investigated experimental conditions even at the highest flow rates.     

聚苯胺在一些有机溶剂中溶解性

本文通过改变反应条件用化学方法制得了不同分子量的聚苯胺，考察了它们在有机溶剂中的溶解性．实验结果表明：分子量的大小是影响它们在有机溶剂中溶解度的主要因素，能在有机溶剂中溶解的只是聚苯胺中分子量较小的级分．我们还用聚苯胺（［η］＝０．４９ｄｌ／ｇ）与－ＣＯＣＩ封端的果对苯二甲酰对苯二胺（ＰＰＴＡ）进行嵌段共聚，经过产物的元素分析与计算结果比较，确定出特性黏数为０．４９ｄｌ／ｇ的聚苯胺平均分子量．     

A new Co(II) complex with N,O-donor Schiff base: Synthesis, structure and characterization

A new Co(II) complex with tridentate Schiff base ligand with a N,N,O donor set has been synthesized and characterized by single X-ray technique and spectroscopic techniques. The thermochemical properties have been studied. X-ray structure analysis of the title compound Co(II)L₂ [HL = 2-methyl-6-(2′-hydroxybenzylideneamino) pyridine] shows that the polyhedron around Co(II) is a distorted tetrahedron, and the self-assembly via intermolecular π-π interactions leads to a three-dimensional network. Crystal data for the title complex C₂₆H₂₂CoN₄O₂: Monoclinic, space group Ia, a = 11.741(7) Å, b = 8.149(5) Å, c = 22.764(16) Å, β = 98.530(12)°, V = 2154(2) ų, Z = 4.     

凝胶过滤色谱法测定泥鳅多糖的组成及分子量

从泥鳅粘液中分离提取到中性的粗多糖 ,采用凝胶过滤色谱柱在高效液相色谱仪上进行分离和测定 ,结果表明 ,该多糖由一个高聚糖 (MAP ,19 1% )和一个寡糖 (MAO ,80 9% )组成。用标准的Pullulan(P 112 0 0 0 ,P 4 730 0 ,P 2 2 80 0 ,P 5 90 0 ,P 2 70 0 )作标准曲线 ,测得其重均分子量分别为 130 2 5 2 (约 72 3个糖基 )和 15 39(约 9个糖基 )。粗多糖经SephadexG 10 0凝胶柱 (1cm× 5 0cm)过滤 ,分离得到纯化的MAP和MAO。     

平菇多糖稀溶液行为的研究

平菇多糖属生物高分子, 文章对平菇多糖稀溶液性质进行了研究。实验系采用Elias浊点滴定法测定平菇多糖溶液的θ组成, 用快速动态膜渗透计和粘度法测定平菇多糖的数均分子量、维利系数与分子链的构型参数。探讨其在θ条件下的分子形态及用Tung函数法等处理分级数据, 从而获得平菇多糖的分子量分布。     

自由基活性聚合及其最新进展

本文介绍了实现自由基活性聚合的动力学、热力学条件及可能的途径。在这些条件下自由基保持稳定的低浓度，增长链自由基与休眠种处于动力学平衡动态，可有效地控制聚合反应，使聚合反应具有聚合物分子量随反应时间、单体转化率成线性增长关系及所得聚合物分子量分布较窄的特征，并且在加入第二单体时可继续生成嵌段共聚物。     

单体极性对甲基丙烯酸甲酯/丙烯酸丁酯/甲基丙烯酸钠无皂乳液共聚合的影响

研究了少量甲基丙烯酸钠（ＮａＭＡ）存在下单体极性对甲基丙烯酸甲酯（ＭＭＡ）／丙烯酸丁酯（ＢＡ）无皂乳液共聚合的影响．单体极性降低，使粒径减小、聚合速率提高、乳液表面张力和粘度降低、粒子表面电荷密度增大、聚合物分子量提高．ＭＭＡ／ＮａＭＡ无皂乳液聚合物只呈现一个玻璃化温度Ｔｇ，ＢＡ／ＮａＭＡ无皂乳液聚合物呈现两个Ｔｇ，ＭＭＡ／ＢＡ比为２∶１～１∶２的ＭＭＡ／ＢＡ／ＮａＭＡ无皂乳液聚合物呈现四个Ｔｇ，这是由于粒子外面相对富含ＯＳＯ－３和ＣＯＯ－基聚合物的亚层溶解了较多的水，使ＢＡ向粒子中心扩散，ＭＭＡ向外扩散，造成组成差异和相分离而引起的．     

聚硅烷亚芳弹性体的凝胶渗透色谱测量

用简易GPC柱研究了在未知合适的Mark-Houwink 系数的情况下,通过GPC和特性粘度的数据,同时计算出宽分布硅烷亚芳弹性体聚合物的分子量和这种类型聚合物的 Mark-Houwink 系数的方法。装柱填料为多孔硅胶球,理论塔板数 4200—5500块/米以上,塔板高度 0.7—0.9毫米。其分子量分布宽度指数在2左右。素炼后,分子量分布变窄,分子量下降。     

拟合粘度曲线法研究高聚物的长链支化

本文介绍了用计算机试误法拟合粘度曲线,讨论支化参数的方法,本法可以同时确定支化临界分子量和支化程度,在此基础上可以同时得到支化参数及平均分子量、分子量分布.以聚乙烯标准参考物:SRM 1475(线型)、1476(支化物)及镍催化顺式聚丁二烯为对象介绍了上述方法.