Effect of Polyaniline (Emeraldine Base) Addition on α to β Phase Transformation in Electrospun PVDF Fibers

A facile and effective transformation of α to β phase in electrospinning of PVDF was demonstrated by adding emeraldine base polyaniline (PANI). Results from FTIR and X-ray studies revealed that a very large amount of the electraoctive β-phase can be obtained by controlling the amount of PANI loading and the electrospinning parameters, whereas the γ-phase normally showed a very tiny amount, much lower than the β-phase, for all samples with PANI loading. The above results indicate that the addition of PANI into the PVDF solution during electrospinning is a powerful way to enhance the electroactive β-phase of the fibers, which is significant for developing high-performance fiber-based piezoelectric devices.     

Surface characteristics and hemocompatibility of PAN/PVDF blend membranes

Polyacrylonitrile (PAN) was blended with polyvinylidine fluoride (PVDF) at various ratios and made into membranes. The hemocompatibility of the resulting membranes was evaluated based on human plasma proteins adsorption, platelet adhesion, thrombus formation, and blood coagulation time. The PAN/PVDF blends exhibited partial miscibility according to the inward shifting of their two glass transition temperatures. The microstructures of blend membranes examined using atomic force microscopy (AFM) indicated that the roughness increased with the PVDF content, and the phase separation was too severe to form a membrane when the PVDF content was more than 30%. The water contact angle of PAN/PVDF blend membranes increased with the PVDF content. By blending with 20 wt% apolar PVDF the adsorption of blood proteins could be reduced, and hence the platelet adhesion and thrombus formation was also reduced. However, when the PVDF content was 30 wt%, severe thrombogenicity was observed due probably to the more porous structure of blend membrane. These results demonstrated that the hemocompatibility would be improved for PAN/PVDF blend membranes with appropriate hydrophilicity and roughness. Copyright © 2005 John Wiley & Sons, Ltd.     

BaF2替代BaO 对钡镓锗酸盐玻璃光学性质的影响

在摩尔分数组成x(BaO),r(Ga2O),r(GeO2)为0．20,0．15,0．65的玻璃中,分别以摩尔分数0．05,0．10．0．15和0．20的BaF2替代BaO,研究了氟化物对玻璃折射率和光吸收性质的影响。结果表明,在玻璃中加入氟化物．玻璃折射率和色散降低,玻璃的紫外吸收边向短波侧迁移,而红外吸收边无明显变化。不含氟化物的氧化物玻璃中含有大量的OH基．这些OH基在2．24μm、2．97μm和4．23μm附近引起光吸收．在含氟化物的玻璃中,2．24μm的吸收峰消失,而2．97μm和4．23μm附近的吸收大大减弱。讨论了各OH基吸收峰的起源,利用计算机技术对2．97μm附近的OH基吸收峰进行了高斯峰分离。玻璃在2．24μm的弱吸收可能来自H2O分子的一个伸缩模和两个振动模的结合(p 2ρ)．4．23μm吸收带是由与非桥O形成强氢键的OH基(T-OH…O^--T)伸缩振动引起,而中心位于2．7～3．2μm的OH吸收带为受不同程度氢键影响的OH基伸缩振动吸收．这些吸收带叠加导致OH吸收带出现非对称性加宽,吸收中心随玻璃中OH含量不同发生移动。     

氟-铝络合滴定计算分析法测定乙醇-水溶液介质中的铝

导出了氟离子标准溶液滴定铝离子的络合滴定计算分析的数学模型。以氟离子选择性电极作指示电极,利用氟离子与铝离子在乙醇-水溶液中产生沉淀,仅形成3种络合物的现象,先计算出3个条件累积稳定常数,再计算出铝离子的分析浓度。通过氢氧化铝的条件溶度积常数,求出溶液控制的pH值约为4．7。讨论了滴定数据的位置对测定结果的影响。     

氟化钡晶体电注入着色

在不同的温度,电压和时间条件下,经点阴极电注入,有效地使氟化钡晶体着色.在室温下,分别对着色前后的晶体进行系统光谱测量.在着色前的氟化钡晶体中未观测到明显的吸收峰.在着色后的氟化钡晶体中,观测到大量的F和FA色心以及一些未知色心.对不同电注入温度、电压和时间条件下的着色氟化钡晶体光谱进行比较分析,得到了经点阴极电注入着色氟化钡晶体色心强度随着色温度,电压和时间的变化规律并给出了色心形成机理以及色心强度随温度、电压和时间变化机理.     

高低温条件下氟化锂材料的离子激发发光光谱分析

在北京师范大学GIC4117串列加速器原有离子激发发光(ion beam induced luminescence,IBIL)分析靶室基础上,安装了可实现80—900 K温度范围内精确控温的冷热样品台,实现高低温条件下IBIL光谱的测量.添加金硅面垒探测器,在离子辐照材料样品过程中同步采集背散射离子的计数,实现束流的在线监测.在不同温度下,利用2 MeV H~+束轰击氟化锂样品,获得的IBIL光谱中可明显观察到温度对不同发光中心发光效果的影响:激子峰和杂质峰发光在低温条件下更为清晰;高温时各类型F色心的发光强度在较小的注量下即可达到饱和值或开始衰减.辐照初期受扰激子峰(296 nm)发光强度的上升过程表明不能排除受扰激子峰与点缺陷发光中心相关的可能性,激子峰强度的上升源自低注量时核弹性碰撞产生的应变键;温度对空位迁徙速率及非辐射复合的影响是造成发光强度随注量演变差异的重要原因.     

PDA/PVDF紫外线屏蔽复合膜的制备及性能表征

利用多巴胺在溶液中自聚得到聚多巴胺(PDA)颗粒, 然后将其作为填料加入聚偏氟乙烯(PVDF)中, 采用溶液成膜法制备具有紫外线屏蔽功能的PDA/PVDF复合膜. 通过傅里叶变换红外光谱(FTIR)、 扫描电子显微镜(SEM)和紫外可见分光光度计(UV-Vis)对制备的PDA颗粒的结构、 形貌以及吸光度进行表征, 并且进一步利用X 射线衍射仪(XRD)、 差示扫描量热仪(DSC)、 热失重分析仪(TGA)、 接触角测量仪(CA)以及紫外老化箱等对PDA/PVDF复合膜的结构、 热性能、 润湿性能与紫外线屏蔽性能进行测试. 结果表明, 制备的PDA颗粒的粒径约为160 nm; 掺杂PDA之后的PVDF膜的结晶度以及接触角均减小; 并且PDA质量分数为5%时得到的PDA/PVDF复合膜在200400 nm范围内的透过率均低于1%, 能够吸收所有的紫外线, 表现出优异的紫外线屏蔽功能.     

热致相分离法偏二氯乙烯-氯乙烯共聚物多孔膜的制备及性能

以偏二氯乙烯-氯乙烯共聚物[P(VDC-co-VC)]为成膜聚合物, 邻苯二甲酸二甲酯(DMP)为稀释剂, 采用热致相分离(TIPS)法制备了具有多孔结构的P(VDC-co-VC)膜. 通过聚合物-稀释剂二元体系相图、 场发射扫描电镜(FESEM)、 差示扫描量热仪(DSC)、 X射线衍射(XRD)、 原子力显微镜(AFM)、 纯水通量、 接触角、 孔径及其分布、 截留率及力学性能等研究了聚合物含量对P(VDC-co-VC)多孔膜结构和性能的影响. 结果表明, P(VDC-co-VC)-DMP二元体系成膜过程以液-液(L-L)分相为主, 随着聚合物含量增加, 膜的横截面由类花瓣状结构向胞腔状结构转变, 膜的孔连通性降低, 结构变得较为致密, 同时膜上表面孔隙率降低, 粗糙度增大. L-L分相时间和聚合物含量的变化, 导致膜结晶度先降低后增大. 聚合物含量的增加使膜上表面接触角、 断裂强度及蛋白截留率增加, 但膜的平均孔径、 孔隙率及纯水通量先增加后减小. 当聚合物质量分数为30%时, 所得膜通透性较优, 断裂强度可达7.5 MPa.     

Hydrophilic modification of polyvinylidene fluoride membrane by blending amphiphilic copolymer via thermally induced phase separation

A new amphiphilic copolymer TD‐A is melt‐blended with polyvinylidene fluoride to fabricate hollow fiber membranes in order to improve the hydrophilicity and anti‐fouling property. Membrane samples with different blending ratios are prepared via thermally induced phase separation method. An optimum blending ratio of TD‐A (10 wt%) is determined by a series of characterizations to evaluate the effects of TD‐A contents on membrane properties. The hydrophilicity of the blended membrane samples increases with the increasing blending ratio, but excessive content of TD‐A in blended membranes can lead to structural defects and reduction of mechanical properties. TD‐A blended hollow fiber membrane with optimum blending ratio shows excellent bi‐continuous structure and high water flux. Membrane fouling is remarkably reduced due to the incorporation of TD‐A by static absorption and cyclic filtration tests of bovine serum albumin. Moreover, constant surface chemical compositions and stable flux during long‐term chemical cleaning demonstrate the hydrophilic stability of the blended membrane.     

Chromenone-rhodamine conjugate for naked eye detection of Al3+ and Hg2+ ions in semi aqueous medium

Chromenone-rhodamine conjugate 1 has been synthesized and its metal ion binding properties have been studied in CH₃CN/water (3:1, v/v; 10 mM HEPES buffer; pH = 6.85). Compound 1 senses multiple metal ions such as Al³⁺ and Hg²⁺ by exhibiting turn on fluorescence and color change (colorless to pink). Al³⁺ and Hg²⁺ ions have been distinguished with the aid of tetrabutylammonium iodide (TBAI). While in the presence of I^? the pink color of the 1.Hg²⁺ complex was completely discharged; under identical conditions the pink color of 1.Al³⁺ complex was retained.