The effect of compatibilization and rheological properties of polystyrene and poly(dimethylsiloxane) on phase structure of polystyrene/poly(dimethylsiloxane) blends

The compatibilization effect of polystyrene (PS)‐poly(dimethylsiloxane) (PDMS) diblock copolymer (PS‐b‐PDMS) and the effect of rheological properties of PS and PDMS on phase structure of PS/PDMS blends were investigated using a selective extraction technique and scanning electron microscopy (SEM). The dual‐phase continuity of PS/PDMS blends takes place in a wide composition range. The formation and the onset of a cocontinuous phase structure largely depend on blend composition, viscosity ratio of the constituent components, and addition of diblock copolymers. The width of the concentration region of the cocontinuous structure is narrowed with increasing the viscosity ratio of the blends and in the presence of the small amount diblock copolymers. Quiescent annealing shifts the onset values of continuity. The experimental results are compared with the volume fraction of phase inversion calculated with various theoretical models, but none of the models can account quantitatively for the observed data. © 2004 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 898–913, 2004     

The interaction between poly(N-isopropylacrylamide) and salts in aqueous media: The “salting-out” phenomenon as studied by attenuated total reflection/fourier transform infrared spectroscopy

The effect of two strong salting-out salts (Na₂SO₄ and K₂SO₄) on the temperature-induced phase-separation process in aqueous solutions of poly(N-isopropylacrylamide) (PNIPA) was examined by attenuated total reflectance/Fourier transform infrared spectroscopy, differential scanning calorimetry, and viscosity measurements. On the basis of these measurements, a detailed scenario of the phase-separation process was deduced. The phase-separation scenario of solutions containing PNIPA and water was altered in the presence of sulfate ions. Here, the sulfate ions induced partial intrachain collapse, manifested by a relatively compact structure well below the lower critical solution temperature. This led to a more gradual, smooth phase transition, with temperature-resolved intrachain collapse and interchain aggregation and a lesser extent of hysteresis. Although at the macrolevel one may not be able to differentiate among various scenarios altering the solvent into a poor solvent, the aforementioned microlevel measurements provided a way to expose the difference between raising the temperature and adding cosolutes. Follow-up studies on the effect of salting-in salts will be presented. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 33–46, 2004     

Structure and properties of the mesophase of syndiotactic polystyrene—III. Selective sorption of the mesophase of syndiotactic polystyrene

Syndiotactic polystyrene (sPS) has various crystalline forms such as α, β, γ, and δ forms, and a mesophase depending on the preparation method. In this study, we focused on the mesophase with the molecular cavity of sPS, which is obtained by step‐wise extraction of the guest molecules from the sPS δ form. To prepare the mesophase containing different shapes and sizes of the cavity, two kinds of the sPS δ form membrane cast from either toluene or chloroform solution were first prepared and then the guest molecules were removed by a step‐wise extraction method using acetone and methanol. We could succeed in the preparation of two kinds of mesophase with different shapes and sizes of the molecular cavity. Either toluene or chloroform vapor sorption to the sPS mesophase membranes was examined at 25 °C. Sorption analysis indicates that the mesophase with large molecular cavities can mainly sorb large molecules; on the other hand, the mesophase with small cavities can sorb only the small molecules, and is unable to sorb a large amount of large molecule because the cavity was too small to sorb the large molecules. Therefore, the sPS mesophase membrane has sorption selectivity based on the size of the molecular cavity. © 2003 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 42: 238–245, 2004     

采用空心阴极放电等离子体化学气相沉积方法制备a-CH薄膜

 研究了不同衬底-阴极距离、直流电压和H₂流量对a-CH薄膜沉积速率的影响。结果表明：衬底-阴极距离必须大于0.5cm，随着该距离的增加，薄膜的沉积速率减少；直流电压达550V时沉积速率最大；随着H2含量的增加，CH₄含量相对减少，沉积速率随之降低。用AFM观察了以该方法制得的448.4nm CH薄膜的表面形貌，表面粗糙度约为10nm。最后测出了不同条件下CH薄膜的UV-VIS谱，由此可以计算得到薄膜的禁带宽度及折射率。     

Solid Phase Synthesis of 2-Substituted 1,3-Oxazin-6-ones Using Resin-bound Cyclic Malonic Acid Ester

A facile solid phase synthesis of 2-substituted 1,3-oxazin-6-ones using polymer-supported Meldrum‘s acid has been reported. Reaction of the resin-bound cyclic malonic acid ester with triethyl orthoformate and subsequent double substitution with amide, afforded the corresponding polymer-supported acylaminomethylene cyclic malonic acid ester, which upon thermal treatment led to 1, 3-oxazin-6-ones in good yields and with high purity.     

Stable nonequilibrium probability densities and phase transitions for meanfield models in the thermodynamic limit

A nonlinear Fokker-Planck equation is derived to describe the cooperative behavior of general stochastic systems interacting via mean-field couplings, in the limit of an infinite number of such systems. Disordered systems are also considered. In the weak-noise limit; a general result yields the possibility of having bifurcations from stationary solutions of the nonlinear Fokker-Planck equation into stable time-dependent solutions. The latter are interpreted as non-equilibrium probability distributions (states), and the bifurcations to them as nonequilibrium phase transitions. In the thermodynamic limit, results for three models are given for illustrative purposes. A model of self-synchronization of nonlinear oscillators presents a Hopf bifurcation to a time-periodic probability density, which can be analyzed for any value of the noise. The effects of disorder are illustrated by a simplified version of the Sompolinsky-Zippelius model of spin-glasses. Finally, results for the Fukuyama-Lee-Fisher model of charge-density waves are given. A singular perturbation analysis shows that the depinning transition is a bifurcation problem modified by the disorder noise due to impurities. Far from the bifurcation point, the CDW is either pinned or free, obeying (to leading order) the Grüner-Zawadowki-Chaikin equation. Near the bifurcation, the disorder noise drastically modifies the pattern, giving a quenched average of the CDW current which is constant. Critical exponents are found to depend on the noise, and they are larger than Fisher's values for the two probability distributions considered.     

随机化交通灯的二维元胞自动机交通模型

元胞自动机交通模型以简单的规则反映交通系统中的多种因素，可以分析各种交通现象，且可在计算机上方便、高效地运作·Ｂｉｈａｍ－Ｍｉｄｄｌｅｔｏｎ－Ｌｅｖｉｎｅ模型（ＢＭＬ模型）实现了二维交通问题的元胞自动机模型的模拟研究·本文对ＢＭＬ模型作了改进，解除了该模型中关于交通灯同步变化的限制·在新模型中，每个路口的交通灯可以自由选定起始工作时间和变化节奏，于是可以更全面、准确地反映交通灯对交通系统性能的影响·本文还对新模型中出现的若干新效应作了解释·     

A highly selective solid phase extraction sorbent for pre-concentration of sameridine made by molecular imprinting

Summary A novel approach to solid phase extraction, based on the use of a highly selective molecularly imprinted polymer, is presented. The versatility of this type of sorbent for solid phase extraction was demonstrated in a model batch-wise pre-concentration of sameridine prior to gas chromatography. Problems associated with leakage of remaining imprint molecules during the desorption phase could be eliminated by the use of a close structural analogue of sameridine as the imprint species. It was found that a major benefit of the imprinted polymer was its specificity, which lead to distinctly cleaner chromatographic traces and ability to improve sensitivity by extracting sameridine from larger sample volumes.     

Solid phase synthesis of azapeptides using an automatic synthesizer

Peptides containing azaglycine located terminally or within the backbone have been prepared in the solid phase by means of an automatic synthesizer.