吸光度比值-导数光谱法同时测定铜(Ⅱ)和铬(Ⅲ)的研究

提出了运用吸光度比值-导数光谱法同时测定Cr(Ⅲ)与Cu(Ⅱ)含量的新方法。在pH 5.7的HAc-NaAc的缓冲溶液中,Cr3+,Cu2+与铬天青S(CAS)和溴化十六烷基三甲胺(CTMAB)可分别形成蓝色三元络合物。其摩尔吸光系数分别为2.52×105 L·mol-1·cm-1和1.01×105 L·mol-1·cm-1。Cu2+和Cr3+的浓度分别在0.08～1.2 μg·mL-1和0.05～0.52 μg·mL-1范围内符合比尔定律,其检测限分别为0.014和0.013 μg·mL-1。此方法应用于环境水中Cr(Ⅲ),Cu(Ⅱ)的同时测定,取得了满意的结果。     

水稻糙米粗蛋白近红外光谱定量分析模型的优化研究

筛选有代表性的191份糙米样品为试材,其中42份来自国家稻种资源库、149份来自水旱稻杂交产生的DH系,蛋白质含量变幅5.90％～14.50％,采用偏最小二乘法(PLS)建立模型,并构造模型的评价参数——目标函数[R/(1+RMSECV)], 同时借助校正集和验证集两个载荷向量得分二维空间投影图,对近红外定量模型进行评价和优化。结果表明: 在5 000～9 000 cm-1范围内,预处理方法为一阶导数,校正模型和外部检验的目标函数值分别为0.701和0.687;两载荷向量得分直观分布图显示样品的聚类结果与目标函数筛选结果一致,也进一步验证了目标函数是模型评价和优化的有效指标。     

近红外光谱结合共识模型快速检测果酒的总酚含量

果酒发酵中的多酚是引起果酒口感、颜色变化的重要因素。为保证果酒品质,有必要开发一种快速监测发酵过程中多酚含量变化的技术。收集不同批次成熟期的蓝莓、桑葚为原料,分别碾压成汁,同时按比例混合二者,于小型发酵罐进行发酵。通过离线收集不同发酵时段的发酵液于离心管,高速离心后取上清液置于棕色瓶保存,共计得到48个果酒发酵样本。将上清液置于三个平行样比色皿,以傅里叶快速变换近红外光谱仪(FT-NIR)采集其透射光谱,取平均值作为该样本的光谱信号。然后将棕色瓶内的发酵液以国标法(即以标准液的吸光度值制定标准曲线)测定各样品的总酚含量,以duplex法计算样本光谱之间的距离且按2∶1的比例划分为训练集和预测集。采用间隔偏最小二乘法(iPLS)将训练集样本的透射光谱与总酚含量之间构建定量模型,间隔数从2依次变化到60个。该研究创新之处是使用共识方法融合多个已构建好的iPLS成员模型,按一定的共识规则分配权系数。通过各成员模型交互验证的残差及其残差之间的相关性来优化各成员模型的线性组合,以拉格朗日乘数法求解各成员模型的权系数,使间隔偏最小二乘-共识模型(consensual iPLS,CiPLS)的交互验证均方根误差最小。相比于全局PLS模型、划分不同间隔数量时的iPLS模型,CiPLS均具有较小的预测误差。当划分39个间隔时由三个iPLS成员模型(即14th,16th,18th)组成的共识模型误差最小为124.2,交互验证相关系数为0.944,对预测集样本的预测均方根误差为163.4,预测相关系数为0.931,预测性能均优于PLS和iPLS模型。另外,作为对比选用连续投影算法与无信息变量剔除法来优化光谱模型,其预测性能均不及本文提出的共识模型。分析各iPLS模型预测残差之间的相关性,发现共识模型主要是融合那些具有较高预测性能且模型间较低相关性的成员模型。结果表明,光谱分析结合共识方法可提高回归模型的预测精度、减少建模所需变量数,能够用于果酒总酚含量的离线快速检测。     

紫外导数光谱法直接测定含油污水中的苯胺类

在ｐＨ为２．５的盐酸介质中，用紫外四阶导数光谱法直接测定含油污水中的苯胺类，不需要预蒸馏、萃取、显色等繁杂过程。苯酚、石油类、悬浮物、硫化物等均不干扰测定。含油污水中苯胺类测定的结果与禁乙二胺偶氮比色法的测定结果基本吻合。本方法检出限低、回收率好、操作简便。适用于油矿区污水中苯胺类的监测。     

偏最小二乘法用于同步荧光法同时测定维生素B1,维生素B2和维生素B6

本文将偏最小二乘法结合同步荧光扫描技术对含维生素Ｂ１，Ｂ２和Ｂ６的混合物进行了同时测定。对同步荧光法的测定条件及△λ的选择进行了试验和讨论，比较了△λ分别为６５ｎｍ和３０ｎｍ时的计算结果。所建立的方法用于复合维生素Ｂ片等药片叶Ｂ１，Ｂ２和Ｂ６孤同时测定，获较满意的结果。     

微分电位溶出法测定人发中铜铅镉锌的研究

本文报道了０．００２５ｍｏｌ·Ｌ￣（－１）ＨＣｌ－０．２ｍｏｌ·Ｌ￣（－１）ＮＨ＿（４）Ｃｌ底液中连续测定人发中铜、铅、镉、锌的微分电位溶出法。四元素峰电位分别为－０．２０Ｖ，－０．４６Ｖ，－０．６７Ｖ，一１．０２Ｖ（ＳＣＥ），峰形好，灵敏度高，干扰少，测定发样相对标准偏差≤４．３％，回收率为９７．６％～１０４．６％。并对ＨＮＯ＿３－ＨＣｌＯ＿４和ＨＮＯ＿（３）Ｈ＿（２）Ｏ＿２消化发样进行了比较。     

微量元素添加剂促进赤霉素分泌及赤霉素速测技术研究

研究了赤霉素快速分光光度法测定，并首次应用于微量元素添加剂促进赤霉素分泌的研究．结果表明，固体发酵培养基中添加了硼酸、磷酸二氢钾、硫酸镁对促进赤霉素分泌有重要作用．结合使用作者多次筛选得到的高产赤霉素产生菌株等措施，终于研制得含量高达约１５０００×１０－５的固体粉剂，其含量高出一般固体发酵产品的３～５倍．     

[η~5-Bz_5C_5(CO)_nM]_2的合成及结构

本文通过η~5-Bz_5C_5MNa与氧化偶联试剂Fe_2(SO_4)_3/HOAc/H_2O的反应合成了含η~5-五苄基环戊二烯基配体的两个金属-金属单键化合物[η~5-Bz_5C_5(CO)_3M]_2(1:M=Mo;2:M=W),产率分别为45％和19％。1在沸腾的甲苯中可进一步脱羰而以98％的产率生成金属-金属三键化合物[η~5-Bz_5C_5(CO)_2Mo]_2(3)。1～3的结构均经碳氢分析,IR,~1H NMR和MS鉴定。3的结构尚被单晶X射线衍射分析确证。该晶体属单斜晶系,空间群P2_1/c,晶体学数据:。α=1.1335(5),b=1.3823(4),c=2.1655(6)nm;β=102.33(3)°;V=3.315(2)nm~3;Z=2;D_x=1.34g/cm~3;F(000)=1380。     

一种新的光致变色膜：Na2WO4-PAA-Glycerol体系研究

A method for preparing Na₂WO₄-PAA-Glycerol photochromic films was reported. The film was composed of Na₂WO₄, PAA and Glycerol, which were coated on a glass substrate. The film turned blue in the sun, and bleached to transparent in the darkness. The UV-Visible spectra showed strong absorbance at 300～500 nm, and the ABS changed signifanctly at 500～800 nm. The film showed the best photochromic behavior when n_Na2WO4∶n_PAA is 4%～5%. The mechanism was suggested that after irradiation, poly tunstate produced by Na₂WO₄ and PAA formed the tungsten blues. The tungsten blues were bleached due to oxidation back to poly tunstate by oxygen. The film showed not only an excellent photochromism property with rapid response and good reversibility, but also the simple techniques and good stability.     

A multicommuted stop-flow system employing LEDs-based photometer for the sequential determination of anionic and cationic surfactants in water

It has been developed an automatic stop-flow procedure for sequential photometric determination of anionic and cationic surfactants in a same sample of water. The flow system was based on multicommutation process that was designed employing two solenoid micro-pumps and six solenoid pinch valves, which under microcomputer control carry out fluid propelling and reagent solutions handling. A homemade photometer using a photodiode as detector and two light emitting diodes (LEDs) with emission at 470 nm (blue) and 650 nm (red) as radiation sources, which was tailored to allow the determination of anionic and cationic surfactants in waters. The procedure for anionic surfactant determination was based on the substitution reaction of methyl orange (MO) by the anionic surfactant sodium dodecylbenzene sulfonate (DBS) to form an ion-pair with the cetyl pyridine chloride (CPC). Features such as a linear response ranging from 0.35 to 10.5 mg L⁻¹ DBS (R = 0.999), a detection limit of 0.06 mg L⁻¹ DBS and a relative standard deviation of 0.6% (n = 11) were achieved. For cationic surfactant determination, the procedure was based on the ternary complex formation between cationic surfactant, Fe(III) and chromazurol S (CAS) using CPC as reference standard solution. A linear response range between 0.34 and 10.2 mg L⁻¹ CPC (R = 0.999), a detection limit of 0.05 mg L⁻¹ CPC and a relative standard deviation of 0.5% (n = 11) were obtained. In both cases, the sampling throughput was 60 determinations per hour. Reagents consumption of 7.8 μg MO, 8.2 μg CPC, 37.2 μg CAS and 21.6 μg Fe(III) per determination were achieved. Analyzing river water samples and applying t-test between the results found and those obtained using reference procedures for both surfactant types provide no significant differences at 95% confidence level.