Determination of Inorganic Arsenic Species by Electrochemical Hydride Generation Atomic Absorption Spectrometry with Selective Electrochemical Reduction

A new direct procedure for the determination of inorganic arsenic species was developed by electrochemical hydride generation atomic absorption spectrometry （EcHG-AAS） with selective electrochemical reduction. The determination of inorganic arsenic species is based on the fact that As（Ⅲ） shows significantly higher absorbance at low electrolytic currents than As（Ⅴ） in 0.3 mol·L^-1 H2SO4. The electrolytic current used for the determination of As（Ⅲ） without considerable interferences of As（Ⅴ） was 0.4 A, whereas the current for the determination of As（Ⅲ） and As（Ⅴ） was 1.2 A. For equal concentrations of As（Ⅲ） and As（Ⅴ） in a sample, the interferences of As（Ⅴ） during the As（Ⅲ） determination were smaller than 5%. The absorbance for As（Ⅴ） could be calculated by subtracting that for As（Ⅲ） measured at 0.4 A from the total absorbance for As（Ⅲ） and As（Ⅴ） measured at 1.2 A, and then the concentration of As（Ⅴ） can be obtained by its calibration curve at 1.2 A. The methodology developed provided the detection limits of 0.3 and 0.6 ng·mL^-1 for As（Ⅲ） and As（Ⅴ）, respectively. The relative standard deviations were of 3.5% for 20 ng·mL^-1 As（Ⅲ） and 3.2% for 20 ng·mL^-1 As（Ⅴ）. The method was successfully applied to determination of soluble inorganic arsenic species in Chinese medicine.     

Simple Method for Simultaneous Determination of Selenium and Arsenic in Human Hair by Means of Atomic Fluorescence Spectrometry with Hydride Generation Technique

This study describes a simple, rapid and reliable method for simultaneous determination of selenium and arsenic in human hair by means of atomic fluorescence spectrometry combined with a hydride generation technique (HG-AFS). The procedure developed encompasses microwave digestion of a sample in the nitric acid environment only. The interferences caused by nitrous oxides are eliminated by removing a gas from above the digested solution with a stream of argon. The sample is then chemically treated in a flow-through hydride generation system and exposed to measurements in a double-channel atomic fluorescence spectrometer. The method permits determining both analytes in the linear range of 0.5–100µgL^–1 with a detection limit equal to 0.2µgL^–1, as well as with very good repeatability not exceeding 1% for Se and 2% for As. No mutual interferences from either of the analytes in the concentrations ranges matching the hair composition were found. The method was verified in terms of accuracy with the use of a reference material and then applied to the analysis of the natural samples of human hair.     

Cooled internal reflection element for infrared chemical sensing of volatile to semi-volatile organic compounds in the headspace of aqueous solutions

In this study, the cooling effect was applied to an evanescent wave type infrared (IR) chemical sensing method to effectively trap volatile organic compounds (VOCs), which have been absorbed in the hydrophobic film coated around the internal reflection element (IRE). The detection of VOCs in aqueous solutions was taken in the headspace of the aqueous solution. This method eliminates the long-term instability of hydrophobic film soaked in an aqueous solution and the potential spectral interference caused by the matrix of the aqueous solution. Thermal energy has been applied to the aqueous solution to assist in the evaporation of VOCs out of the aqueous matrix. By applying a cooling system to the IRE, the excess thermal energy can be removed leading to more stable IR signals. After examination of organic compounds with vapour pressure (P_v) ranging from 0.017 to 150 Torr, significant differences were found between IR signals from cooled and un-cooled systems. Because the thermal conductivity of the IRE used in IR detection is typically low; the efficiency in removing the thermal energy is limited. By heating the aqueous solutions to different temperatures, the IR signals showed that the sample temperature was limited to around 80 °C. The IR signal determination results for five different volatility organic compounds indicated that the optimal heating temperature was not necessary to match with the volatilities of organic compounds in cooling system. The linear regression coefficient (R²) of the standard curve for sample concentrations in the range 5-200 μg ml⁻¹ was generally higher than 0.991 and the detection limit was around a few hundred ng ml⁻¹, which was two to three times lower than that of un-cooled system.     

Study of spectral analytical data using fingerprints and scaled similarity measurements

A new chemoinformatic model has been developed for enlarging the differences between spectra and applied to differentiation of wines according to the criteria grape origin and variety and ageing process. The model is based on generation of fingerprints from normalised spectra, using empirical parameters and a set of 120 samples. After generation of the fingerprints, similarity matrixes were built on the basis of the Tanimoto similarity index between the fingerprints of the samples. Calculation of the Tanimoto index was modified to adapt the index to the characteristics of the analytical measurements. Thus, scaling factors taking into account pattern fingerprints generated from a group of samples with common characteristics were used. In addition, a modified expression for calculating the Tanimoto index was employed. Principal-components analysis (PCA) and soft independent modelling of class analogy (SIMCA) were applied to the similarity matrixes. The results obtained are discussed as a function of the normalisation method employed, the empirical factor used in generation of the fingerprints, and selection of samples for building the pattern fingerprint, etc. Finally, results from differentiation of wines are compared with those obtained by applying PCA to the unprocessed spectra as stated by the proposed model.     

Speciation of inorganic arsenic by electrochemical hydride generation atomic absorption spectrometry

A simple procedure was developed for the speciation of inorganic arsenic by electrochemical hydride generation atomic absorption spectrometry (EcHG–AAS), without pre-reduction of As(V). Glassy carbon was selected as cathode material in the flow cell. An optimum catholyte concentration for simultaneous generation of arsine from As(III) and As(V) was 0.06 mol l⁻¹ H₂SO₄. Under the optimized conditions, adequate sensitivity and difference in ratio of slopes of the calibration curves for As(III) and As(V) can be achieved at the electrolytic currents of 0.6 and 1 A. The speciation of inorganic arsenic can be performed by controlling the electrolytic currents, and the concentration of As(III) and As(V) in the sample can be calculated according to the equations of absorbance additivity obtained at two selected electrolytic currents. The calibration curves were linear up to 50 ng ml⁻¹ for both As(III) and As(V) at 0.6 and 1 A. The detection limits of the method were 0.2 and 0.5 ng ml⁻¹ for As(III) and As(V) at 0.6 A, respectively. The relative standard deviations were of 2.1% for 20 ng ml⁻¹ As(III) and 2.5% for 20 ng ml⁻¹ As(V). The method was validated by the analysis of human hair certified reference material and successfully applied to speciation of soluble inorganic arsenic in Chinese medicine.     

On the estimation of the field constant of 35Cl nuclear quadrupole resonance frequency in the series of [R1R2R3AsCl]+M? compounds

The field constant of the NQR frequency of a chlorine atom (³⁵Cl) in a series of arsenic derivatives [R¹R²R³AsCl]⁺M⁻ was estimated from correlations. The field frequency is ∼41.5±3.5 Hz cm kV⁻¹, which is nearly twice as much as that in analogous phosphorus compounds. __________ Published in Russian in Izvestiya Akademii Nauk. Seriya Khimicheskaya, No. 8, pp. 1758–1760, August, 2005.     

Total Synthesis of Sialylated Glycans Related to Avian and Human Influenza Virus Infection

Human and avian influenza type A viruses bind sialylated pentasaccharides. Herein, the total synthesis of four of these glycans is reported. Efficient sialylations relied on two N‐Troc‐protected (Troc=2,2,2‐trichloroethoxycarbonyl) sialic acid building blocks. The first, a thiophenyl glycoside, readily produced the sialyl‐α(2‐6)galactose disaccharide. Combination of the second building block, a novel glycosyl phosphite, and a benzylidene‐protected galactoside produced the best results for the formation of the sialyl‐α(2‐3)galactose. Two common trisaccharides were assembled by the introduction of glucose, galactose, and glucosamine building blocks followed by selective deprotection. Two sets of pentasaccharides were obtained by the union of two sialylgalactose N‐phenyl trifluoroacetimidate building blocks with the two trisaccharides above. Global deprotection furnished the desired pentasaccharides. The products of these total syntheses are currently employed on the surface of carbohydrate microarrays to detect and type different strains of the influenza virus.     

改性凹凸棒的制备及对砷离子的吸附研究

针对日益严重的砷离子污染问题，本文采用灵敏简便的原子荧光分析法，探究了凹凸棒石粘土吸附剂对砷离子的吸附性能，测定了pH、吸附时间、砷离子的初始浓度等因素对凹凸棒石粘土负载铁氧化物对砷离子吸附能力的影响，并通过SEM、EDX、FTIR对所制得的吸附剂进行了表征研究，同时进行了吸附动力学和吸附等温模型的分析。研究结果表明，改性后的凹凸棒对砷离子的吸附性能有了显著提升，在较低浓度时吸附效率可达98%，该吸附符合Langmuir等温吸附模型和准二级动力学方程。     

Arsenidostannate mit Arsen-analogen [SnAs]-Schichten: Darstellung und Struktur von Na[Sn2As2], Na0,3Ca0,7[Sn2As2], Na0,6Sr0,6[Sn2As2], Na0,6Ba0,4[Sn2As2] und K0,3Sr0,7[Sn2As2]

Arsenidostannates with [SnAs] Nets Isostructural to Grey Arsenic: Synthesis and Crystal Structure of Na[Sn₂As₂], Na_0.3Ca_0.7[Sn₂As₂], Na_0.4Sr_0.6[Sn₂As₂], Na_0.6Ba_0.4[Sn₂As₂], and K_0.3Sr_0.7[Sn₂As₂] The metallic lustrous compounds Na[Sn₂As₂], Na_0.3Ca_0.7[Sn₂As₂], Na_0.4Sr_0.6[Sn₂As₂], Na_0.6Ba_0.4[Sn₂As₂] and K_0.3Sr_0.7[Sn₂As₂] were prepared from melts of mixtures of the elements. The compounds crystallize in the trigonal system (space group R3 m, No. 166, Z = 3) with lattice constants see in “Inhaltsübersicht”. The structures are isotypic to Sr[Sn₂As₂] containing puckered [SnAs] nets which are stacked with a sequence of six layers. The E(I)/E(II) atoms are located between each second [SnAs] layer in trigonal antiprismatic interstices formed by As atoms. In the resulting [Sn₂As₂] double layers the _∞²[SnAs] nets are stacked in such a way that additional Sn—Sn contacts arise.     

Total synthesis and biological evaluation of (-)apicularen A and analogues thereof

Apicularen A (1) and related benzolactone acylenamines belong to a growing class of novel natural products possessing highly cytotoxic properties. The challenging structure of 1 includes a 10-membered macrolactone ring, a tetrahydropyran system, an o,m-substituted phenol and a doubly unsaturated acyl group attached on the side chain enamine functionality. The total synthesis of apicularen A described herein involves a strategy equivalent to its proposed biosynthesis and entails a reiterative two-step procedure featuring allylation and ozonolytic cleavage to grow the molecule's chain by one acetate unit at a time. The developed synthetic technology was applied to the construction of a series of apicularen A analogues whose biological evaluation established a set of structure-activity relationships in this new area of potential importance in cancer chemotherapy.