Spectrum analysis of U-doped LaBr3 single crystals. Part 1: crystal-field analysis

Single crystals of U³⁺:LaBr₃ were grown by the Bridgman-Stockbarger technique. High-resolution polarized absorption spectra of the crystals were recorded at 4.2 K in the 4000-50,000 cm⁻¹ range. Sixty-four experimental crystal-field energy levels of the U³⁺ ion were fitted to a semiempirical Hamiltonian employing free-ion, one-electron crystal-field as well as two-particle correlation crystal-field (CCF) operators with an r.m.s. deviation of 28 cm⁻¹. The performed analysis of the spectra enabled the determination of crystal-field parameters and assignment of the observed 5f³→5f³ transitions. The effects of selected CCF operators on the splitting of some specific U³⁺ multiplets have been investigated and the obtained values of Hamiltonian parameters are discussed and compared with those reported in previous analyses.     

伏安型植物组织生物微电极的研究：混合不同植物组织碳糊微电极的研究

由于香蕉组织中含有的氧化酶能够生物催化氧化多巴胺，去甲肾上腺素，Ｌ－多巴等，大大地提高了植物组织电极的灵敏度；又由于茄子组织中所含有的氧化酶在催化氧化儿茶酚的同时，能有效地抑制抗坏血酸在电极上的反应，将上述两种植物组织混合制成电极，使其更适于神经递质的测定，线性范围：２．４×１０＾－６－－９．８×１０＾－４ｍｏｌ／Ｌ；检出下限３．２×１０＾－７ｍｏｌ／Ｌ。     

高效液相色谱-串联质谱法测定小鼠组织中的新型抗心力衰竭化合物AF-HF001

建立了基于高效液相色谱-质谱联用技术的新型抗心力衰竭化合物AF-HF001在小鼠组织中的测定方法,并考察了其在小鼠体内的组织分布。采用液-液萃取对样品进行预处理,以Thermo Hypersil Gold C18色谱柱进行分离,流动相为乙腈-0.1%甲酸水溶液,梯度洗脱,采用选择性反应监测(SRM)正离子模式检测分析物。小鼠组织中AF-HF001含量在0.5~10μg/mL范围内线性关系良好(r>0.996),在加标量为1.5,4,10μg/mL的组织样品中,提取回收率大于58%,基质效应在100.38%~109.99%之间,日内和日间精密度RSD均小于15%。该方法为AF-HF001的体内分布研究及进一步药物研发提供了依据。初步结果表明,该化合物能够迅速到达心脏并迅速代谢,主要分布在肝脏组织中,其他组织中分布较少。     

Microscale sample deposition onto hydrophobic target plates for trace level detection of neuropeptides in brain tissue by MALDI-MS

A sample preparation method that combines a modified target plate with a nanoscale reversed-phase column (nanocolumn) was developed for detection of neuropeptides by matrix-assisted laser desorption/ionization time-of-flight mass spectrometry (MALDI-TOF MS). A gold-coated MALDI plate was modified with an octadecanethiol (ODT) self-assembled monolayer to create a hydrophobic surface that could concentrate peptide samples into a approximately 200-500-microm diameter spot. The spot sizes generated were comparable to those obtained for a substrate patterned with 200-microm hydrophilic spots on a hydrophobic substrate. The sample spots on the ODT-coated plate were 100-fold smaller than those formed on an unmodified gold plate with a 1-microl sample and generated 10 to 50 times higher mass sensitivity for peptide standards by MALDI-TOF MS. When the sample was deposited on an ODT-modified plate from a nanocolumn, the detection limit for peptides was as low as 20 pM for 5-microl samples corresponding to 80 amol deposited. This technique was used to analyze extracts of microwave-fixed tissue from rat brain striatum. Ninety-eight putative peptides were detected including several that had masses matching neuropeptides expected in this brain region such as substance P, rimorphin, and neurotensin. Twenty-three peptides had masses that matched peaks detected by capillary liquid chromatography with electrospray ionization MS.     

Allowed transitions in silicon isoelectronic ions

Dipole‐allowed transitions have been studied for the first few members of the Si isoelectronic sequence. Transition energies, oscillator strengths, transition probabilities and quantum defect values have been estimated for the low‐ and high‐lying excited states of s and d symmetries up to the principal quantum number n=7 for these 3p open shell ions from P⁺ to Cr¹⁰⁺. Time‐dependent coupled Hartree–Fock (TDCHF) theory has been utilized to calculate such transition properties. Most of the results for transition energies, oscillator strengths, and transition probabilities for higher excited states are new. The transition energies for low‐lying excited states agree well with experimental data wherever available. © 2001 John Wiley & Sons, Inc. Int J Quantum Chem, 2001     

Error Levels of Different Methods of Evaluation of TG Measurements

It follows from an analysis of the error levels of TG evaluation methods that it is a conceptual error to disregard the analogies of mass, energy and momentum streams of subordinate partial processes. This error is bypassed by means of the introduced method of dimensionless analysis and by determining the characteristic, constants-like data of thermal processes by using the measured data directly. These methods are very suitable for increasing the consistency of the calculated results by seeking for similarity, even in comparisons of measurements made under very different conditions and for emphasizing the differences too, quantitatively. With this new interpretation of TG processes, the idea of the kinetic compensation effect becomes only a consequence of the discussed conceptual error. This revised version was published online in August 2006 with corrections to the Cover Date.     

Potential energy surfaces and nonadiabatic transitions in the asymptotic regions of ICN photodissociation to study the interference effects in the F1 and F2 spin-rotation levels of the CN products

One of the most spectacular yet unsolved problems for the ICN -band photodissociation is the non-statistical spin-rotation F₁ = N + 1/2 and F₂ = N − 1/2 populations for each rotation level N of the CN fragment. The F₁/F₂ population difference function f(N) exhibits strong N and λ dependences with an oscillatory behavior. Such details were found to critically depend on the number of open-channel product states, namely, whether both I (²P_3/2) and I (²P_1/2) are energetically available or not as the dissociation partner. First, in the asymptotic region, the exchange and dipole-quadrupole inter-fragment interactions were studied in detail. Then, as the diabatic basis, we took the appropriate symmetry adapted products of the electronic and rotational wavefunctions for the F₁ and F₂ levels at the dissociation limits. We found that the adiabatic Hamiltonian exhibits Rosen–Zener–Demkov type nonadiabatic transitions reflecting the switch between the exchange interaction and the small but finite spin-rotation interaction within CN at the asymptotic region. This non-crossing type nonadiabatic transition occurs with the probability 1/2, that is, at the diabatic limit through a sudden switch of the quantization axis for CN spin S from the dissociation axis to the CN rotation axis N . We have derived semiclassical formulae for f(N) and the orientation parameters with a two-state model including the 3A′ and 4A′ electronic states, and with a four-state model including the 3A′ through 6A′ electronic states. These two kinds of interfering models explain general features of the F₁ and F₂ level populations observed by Zare's group and Hall's group, respectively. © 2018 Wiley Periodicals, Inc.     

Microrobotics and MEMS-based fabrication techniques for scaffold-based tissue engineering

Scaffold based tissue engineering strategies use cells, biomolecules and a scaffold to promote the repair and regeneration of tissues. Although scaffold-based tissue engineering approaches are being actively developed, most are still experimental, and it is not yet clear what defines an ideal scaffold/cell construct. Solid free form fabrication (SFF) techniques can precisely control matrix architecture (size, shape, interconnectivity, branching, geometry and orientation). The SFF methods enable the fabrication of scaffolds with various designs and material compositions, thus providing a control of mechanical properties, biological effects and degradation kinetics. This paper reviews the application of micro-robotics and MEMS-based fabrication techniques for scaffold design and fabrication. It also presents a novel robotic technique to fabricate scaffold/cell constructs for tissue engineering by the assembly of microscopic building blocks.