Thermal Equilibrium Between Radiation and Matter

In 1916, Einstein rederived the blackbody radiation law of Planck that originated the idea of quantized energy one hundred years ago. For this purpose, Einstein introduced the concept of transition probability, which had a profound influence on the development of quantum theory. In this article, we adopt Einstein's assumptions with two exceptions and seek the statistical condition for the thermal equilibrium of matter without referring to the inner details of either statistical thermodynamics or quantum theory. It is shown that the conditions of thermodynamic equilibrium of electromagnetic radiation and the energy balance of thermal radiation by the matter, between any of its two energy-states, not only result in Planck's radiation law and the Bohr frequency condition, but they remarkably yield the law of the statistical thermal equilibrium of matter: the Maxwell–Boltzmann distribution. Since the transition probabilities of the modern quantum theory of radiation coincide with their definition in Einstein's theory of blackbody radiation, the presented deduction of the Maxwell–Boltzmann distribution is equally valid within the bounds of modern quantum theory. Consequently, within the framework of the fundamental assumptions, the Maxwell–Boltzmann distribution of energy-states is not only a sufficient, but a necessary condition for thermal equilibrium between the matter and radiation.     

Lanthanum nitrate decomposition by both temperature programmed heating and citrate gel combustion

Thermal decomposition of lanthanum nitrate to lanthanum oxide was carried out by both temperature programmed heating (TPH) and citrate-gel combustion. The temperature programmed heating was carried out under flow of oxidizing (air), neutral (nitrogen) and reducing (25 vol.% hydrogen+argone mixture) gases, and the processes were controlled by simultaneous thermogravimetry and differential thermal analysis. It was shown that hydrogen atmosphere helps to reduce temperatures of all decomposition steps. The results of TPH were utilized to check the nature of residues in the products of lanthanum nitrate-to-oxide conversion performed via citrate-gel combustion technique.     

Molecular flow and wall collision age distributions

The use of storage cells has become a standard technique for internal gas targets in conjunction with high energy storage rings. In case of spin-polarized hydrogen and deuterium gas targets the interaction of the injected atoms with the walls of the storage cell can lead to depolarization and recombination. Thus the number of wall collisions of the atoms in the target gas is important for modeling the processes of spin relaxation and recombination. It is shown in this article that the diffusion process of rarefied gases in long tubes or storage cells can be described with the help of the one-dimensional diffusion equation. Mathematical methods are presented that allow one to calculate collision age distributions (CAD) and their moments analytically. These methods provide a better understanding of the different aspects of diffusion than Monte Carlo calculations. Additionally it is shown that measurements of the atomic density or polarization of a gas sample taken from the center of the tube allow one to determine the possible range of the corresponding density weighted average values along the tube. The calculations are applied to the storage cell geometry of the HERMES internal polarized hydrogen and deuterium gas target. Received 9 July 2001 and Received in final form 18 September 2001     

复合多层介质在可变温度和集中荷载作用下的位移和应力

研究了多层介质中的热弹性位移和应力.多层介质具有不同厚度,各层又具有不同的弹性性质,最上层表面上作用热荷载和集中荷载.假设各层分别是均匀、各向同性弹性材料,各层相关的位移分量是轴对称的,对称轴为各层表面的垂线.因此,各层应力函数满足无体力的单一方程.利用积分变换法求解了该方程,对由任意多个层数构造的多层介质,给出了其相应层数基础热弹性位移和应力的解析表达式.并对3层介质和4层介质时的数值结果进行了比较.     

热动力学问题的数值计算

 对含热传导的流体动力学方程组，用有限元方法进行数值求解。采用傅里叶热传导计算热流、用热流连续条件计算单元间接触面的温度、用三角形传热法计算体单元表面的热流，考虑各向同性弹塑性流体材料模型、三项式物态方程和导热系数与状态的相关性，给出了傅里叶热传导、接触传热、热应力应变效应、以及混合物冲击压缩特性等算例。对混合物冲击温度的数值模拟表明，小颗粒混合物在冲击压缩过程中，颗粒间的温度有差别、稍有波动，并随时间趋向于一致，以至热平衡。     

服装主观热感觉的统计分析

本文用多因子方差分析模型和多重比较分析了服装穿着时的主观热感觉与服装品种、环境条件、穿着者的活动状态与籍贯之间的关系。通过主成分回归建立了用生理指标预测主观热感觉的模型，从而得出一种定量地评价服装属性的方法。     

Intrinsic thermal stability and quenching recovery of thin-film superconductors with thermal boundary resistance

The stability behaviour of a thin-film superconductor under a localized release of thermal disturbance is investigated. Two-dimensional conjugate film/substrate conduction equation with anisotropic thermal conductivity of the film, and Joule heat are employed to investigate effects of substrate and thermal properties on the intrinsic stability and quenching recovery. To consider the thermal boundary resistance between film and substrate, an interfacial-layer model (ILM) with very low diffusivity and an acoustic mismatch model (AMM) are employed. Results show that the thermal boundary resistance influences strongly the intrinsic stability. Thermal boundary resistance increases intrinsic stability if the thermal conductivity of the substrate or the disturbance energy is large. Higher Biot numbers and thermal conductivity ratios of film to substrate in longitudinal direction influence stability favorably. We demonstrate also that operation of a film/substrate system, such as YBCO/MgO, is either intrinsically stable or irrecoverably unstable.The authors wish to express their sincere appreciation to Dr. R. C. Chen for his invaluable advice and suggestions during the course of this paper. This research was supported by the National Science Council of the R. O. C. through grant NSC 83-0401-E-009-006. The computations were performed on the IBM ES/9000 at the National Center For High-Performance Computing.     

Ageing of wet-synthesized oxide powders

Wet chemical synthesis of precursor oxide ceramics is a method to obtain small particulate powders. Such powders are far more prone to ageing in air than more traditional precursors. Thermogravimetric analysis is used to highlight the species responsible for the ageing of ceramic precursors. Indeed water and carbon dioxide are observed to evolve from aged powders. Ceramics obtained from aged precursors can reach a very low final density with respect to the theoretical value. A large degree of the original sintering properties can be recovered after washing the aged powders with ethanol in a basic medium.     

Graphitic nanofillers in PMMA nanocomposites—An investigation of particle size and dispersion and their influence on nanocomposite properties

Mechanical, thermal, and electrical properties of graphite/PMMA composites have been evaluated as functions of particle size and dispersion of the graphitic nanofiller components via the use of three different graphitic nanofillers: “as received graphite” (ARG), “expanded graphite,” (EG) and “graphite nanoplatelets” (GNPs) EG, a graphitic materials with much lower density than ARG, was prepared from ARG flakes via an acid intercalation and thermal expansion. Subsequent sonication of EG in a liquid yielded GNPs as thin stacks of graphitic platelets with thicknesses of ～10 nm. Solution‐based processing was used to prepare PMMA composites with these three fillers. Dynamic mechanical analysis, thermal analysis, and electrical impedance measurements were carried out on the resulting composites, demonstrating that reduced particle size, high surface area, and increased surface roughness can significantly alter the graphite/polymer interface and enhance the mechanical, thermal, and electrical properties of the polymer matrix. © 2007 Wiley Periodicals, Inc. J Polym Sci Part B: Polym Phys 45: 2097–2112, 2007