自由电子激光的预群聚

研究了自由电子激光预群聚产生的辐射,表明预群聚不仅可以提高效率而且使低增益得到增强,从而在理论上解释了由射频直线加速器驱动的自由电子激光预群聚器(prebuncher)的作用。同时还指出,预群聚有在不增加电子束能量情况下缩短激光波长和降低对电子束质量要求等作用。     

Experimental investigation and numerical simulation of the influence of resonator-length detuning on the output power,pulse duration and spectral width of a cw mode-locked picosecond optical parametric oscillator

We report on a cw mode-locked non-critically phase matched KTP optical parametric oscillator synchronously pumped by a picosecond Ti:Sapphire laser. High average signal output power of up to 950 mW over a large tuning range has been achieved. For this OPO the influence of resonator-length detuning on the output power, pulse duration and spectral bandwidth has been investigated. The measured data are in good agreement with the results of a numerical simulation using a split-step Fourier method which considers the group-velocity mismatch, the group-velocity dispersion and the self-phase modulation. The numerical simulation also describes the measured strong pump depletion and its influence on the OPO output and efficiency.     

ICP－AES法测定金属矿产品中的磷

本文研究了铁矿石、铬矿石、锰矿石中的微量磷的电感耦合等离子体发射光谱法的测定。方法简便，具有很好的精密度和准确度。标准样品的分析结果基本与标称值相吻合，回收率在９５％－１０５％之间。     

Pseudo-epitaxial C60 films prepared by a hot-wall method

We have used both reflection-geometry and grazing-incidence-geometry X-ray scattering to study thin films of C₆₀ evaporated onto mica substrates via a hot-wall technique. The growth mode yields close-packed C₆₀ planes, which are parallel to the substrate surface and which exhibit out-of-plane correlation lengths of 850 Å. In the film plane the C₆₀ is at best pseudo-epitaxial, with a 0.9° distribution of crystallite orientations, a 450 Å in-plane correlation length, and a 3.7% lattice mismatch, better than obtained by other thin film techniques but far from the accepted definition of single crystal thin film epitaxy.     

Surface grating formation and erasing on a-Se films

Surface relief formation at holographic recording on amorphous selenium films was demonstrated and investigated. The presence of this optical phase modulation component is essential for ensuring significant, stable and erasable optical recording in a-Se films at 290–320 K temperatures, where conventional photodarkening was known as insignificant and unstable. Photocrystallization can only be observed in super-exposed a-Se films at the given experimental conditions of hologram recording. Erasing behavior of surface relief gratings under heat treatment was also investigated in order to reveal further details of the mechanism. Photoinduced structural transformations within the amorphous phase, connected to local ordering under the condition of light-induced fluidity, are proposed as an explanation for the relief formation and erasing. The observed reversible optical recording process may be useful for the various optoelectronic applications of photoconductive a-Se layers. Received: 12 June 2000 / Accepted: 6 June 2001 / Published online: 30 August 2001     

Optimization of the surface texture for silicon carbide sliding in water

Surface texturing has been recognized as an effective means to improve the tribological performances of sliding surfaces. Usually, generation additional hydrodynamic pressure to increase the load carrying capacity is regarded as the most significant effect of surface texture. In the case of silicon carbide sliding against identical material in water, the experimental results indicate that surface texture is also helpful to improve the running-in progress to smooth the contact surfaces, showing another reason to result in low friction. Based on the consideration of enhancing the generation of hydrodynamic pressure and improving running-in progress, a surface texture pattern, which was combined with large (circle, 350 μm in diameter) and small (rectangular, 40 μm in length) dimples, was designed to maximize the texture effect on the load carrying capacity of SiC surfaces sliding in water. The friction coefficient of such textured surface was evaluated and compared with that of untextured and those only with large or small dimples only. The friction reduction mechanisms of the patterns with different dimples in size are discussed.     

Dielectric and optical properties of polymer-liquid crystal composite

Dielectric properties of polymer-liquid crystal mixture, having constituent polymer, poly-butyl methacrylate (PBMA) and liquid crystal, cholesteryl nonanoate, are reported as a function of frequency and temperature. The measurement has been done in a temperature range of 300-375 K and frequency range of 100 Hz-10 MHz. The dielectric permittivity and dielectric loss shows significant changes with the addition of polymer molecules in liquid crystal. The significant feature of composite formation is that the pure liquid crystal and polymer do not show dielectric relaxation in the frequency range covered, while the composite shows relaxation peak at a particular frequency. The optical transmittance of pure liquid crystal and composite has also been measured and compared.     

Isotopic families of contact manifolds for elliptic PDE

A test for a function to be a solution of an elliptic PDE is given in terms of extensions, as solutions, from the boundaries inside the domains belonging to an isotopic family. It generalizes a result of Ehrenpreis for spheres moved along a straight line.

     

Experimental intensity patterns obtained from a 2D shearing interferometer with adaptable sensitivity

The interferometric intensity patterns from a 2D shearing interferometer are shown and discussed. The intensity patterns can be obtained in two different approaches incorporating differential and extended wavefront controlled displacements. The reliable directional sensitivity of this interferometer allows the optimization of the measurement parameters to estimate the wavefront of the intensity patterns by regularization techniques.     

Banach空间二阶非线性微分方程的弱Carathéodory解

本文定义了二阶微分方程的弱 Carathéodory解 ,在不涉及紧型条件的情形下 ,直接用迭代法证明了 Banach空间二阶非线性常微分方程两点边值问题存在唯一解 ,并给出逼近解迭代序列的误差估计 ,对周期边值问题得到类似的结果