纳米氧化铜的制备及常温脱硫效能研究

采用硝酸铜为原料、氢氧化钠溶液为沉淀剂、使用体积比为1∶1的乙醇-水溶液为分散剂的直接沉淀法制备，通过改变工艺条件得到了三种纳米氧化铜产品，平均粒径分别为25.63，10.74和7.57 nm。采用TG-DTA、FIR、XRD和TEM等对纳米氧化铜进行表征。对产品的常温脱硫活性进行了穿透试验，并与已开发的其他常温精脱硫产品进行了比较，结果表明纳米氧化铜应用于H₂S脱硫，可在常温条件下具有优异的脱硫活性，对H₂S的脱除精度可以达到0.05 mg·m^-3以下。经过优选，产品在3 000 h^-1空速下穿透硫容达到25.3%，高于同类型的其他脱硫剂产品。     

Thermal evolution of ferromagnetic metallic glasses

A traditional TG apparatus was modified by placing two permanent magnets producing a controlled magnetic field (TG(M): Magneto Thermogravimetry). This technique proved to be useful to study both structural relaxation and crystallisation of ferromagnetic metallic glasses. Results obtained for the amorphous alloys Fe₄₀Ni₄₀P₁₄B₆ and Fe_62.5Co₆Ni_7.5Zr₆Nb₂Cu₁B₁₅, are reported in this paper. Structural relaxation can be evaluated by measuring changes in Curie temperature induced by thermal treatments. Crystallisation in TG(M) is detected through a change in the measured apparent mass (difference between the sample mass and magnetic force driving it upward). These results were confirmed by DSC analysis. Whether the obtained crystalline phase is ferromagnetic, it can be identified through its Curie temperature, measured by TG(M). In fact the value of 770°C measured as Curie temperature of crystallised Fe_62.5Co₆Ni_7.5Zr₆Nb₂Cu₁B₁₅led to conclude that the only ferromagnetic crystalline phase is a-Fe. These hypothesis was confirmed by XRD analysis, showing that the first crystallisation yields to a-Fe nanocrystals. This revised version was published online in July 2006 with corrections to the Cover Date.     

溶液酸度和反应温度对CaMoO4薄膜电化学制备的影响

本工作研究了恒电流电化学技术制备CaMoO₄薄膜工艺中，溶液酸度和反应温度对薄膜形成的影响。结果表明，酸度会影响薄膜的生长时间和光致发光特性，在较低酸度沉积薄膜时，容易造成薄膜的团簇生长和不确定相的形成；适当升高反应温度会加快晶粒的生长、提高薄膜的纯度、增加薄膜发射光谱的相对强度。在CaMoO₄薄膜电化学制备工艺中，溶液pH值控制在12.0附近和反应温度控制在60 ℃的左右比较好。     

Freezing temperatures and densities of solutions of some hydrocarbons and sodium oleate inN-methylacetamide. Evidence for a solvophobic interaction

The freezing temperatures and densities (at 31°C) of solutions of octane, nonane, decane, 3,3-diethylpentane, and sodium oleate inN-methylacetamide (NMA) have been measured. The molality of the freezing solution was calculated from the density. The solubilities of octane, nonane, and decane inN-methylacetamide are also reported. Apparent molal volumes calculated from the densities are close to the values in the pure hydrocarbons and are not strong functions of the concentration. This indicates the absence of any unusual packing effect. The calculated free energies of transfer of the hydrocarbons from pure hydrocarbon to NMA solution are much less negative than the corresponding values for water, showing that the bulk solvophobic interaction inN-methylacetamide is smaller than in water. This is consistent with the freezing temperatures of sodium oleate which show that micelles do not form below 0.1 mole-kg^–1. The osmotic coefficients of the hydrocarbons calculated from the freezing temperatures showed negative deviations from ideality that were larger for the hydrocarbons with the higher molecular weights. Two estimates of the pairwise solvophobic interaction inN-methylacetamide indicate that it is also smaller than in water. The solvophobic effect in this solvent does not include the large entropy and enthalpy effects found in aqueous solutions.     

以国产微晶纤维素膜作固体基质五种多环芳烃的室温磷光法研究

本文考察了10种国产纤维素膜用于多环芳烃固体基质室温磷光(SS-RTP)的可行性。实验表明:MN-C和MN-P两种型号的微晶纤维素膜用于多环芳烃的SS-RTP是适宜的。阴离子交换纤维素膜、CM-纤维素膜和聚酰胺-6膜也能诱导出多环芳烃的RTP来,但其性能逊于前两种。故本文应用MN-C和MN-P两种微晶纤维素膜基质考察了五种多环芳烃的RTP特征,并建立了它们的SS-RTP新方法。并与用滤纸作基质的实验结果进行了比较,表明两种新的固体基质的RTP性能优于滤纸基质。     

Kinetics of thermoset cure and polymerization in the glass transition region

A theoretical approach to thermoset cure kinetics based on Arrhenius kinetics and mobility was developed by considering the activation of the reacting group and chain mobility as elementary steps for reaction. This extended kinetic equation was successfully applied to the curing of an epoxy by an amine, the trimerization of a cyanate, and to the polymerization of methyl methacrylate. Full agreement between theory and experimental data was obtained in all cases. The activation energies for chain mobility were exceptionally low (0.3–1 kJ/mol for bisphenol-A-based epoxy and cyanate) which indicates that the structural units must undergo only small-angle rotational oscillations to allow a reaction. A theoretical time–temperature–transformation (TTT) diagram is also presented. © 1993 John Wiley & Sons, Inc.     

Adducts of Rh2[MTPA]4 with some phosphine chalcogenides: nature of binding and ligand exchange

Adducts of four phosphine chalcogenides with the chiral dirhodium complex ([Rh-Rh]) were investigated by variable-temperature 1H and 31P NMR spectroscopy in order to compare their properties as axial ligands. Whereas the selenide (1) and the sulfide (2) are strong ligands with electrostatic attraction and, in addition, a significant orbital (HOMO-LUMO) interaction, the phosphine oxide compounds (P=O) bind primarily via electrostatic attraction and are relatively weak donors. Moreover, the overall bond strength in these adducts depends on steric congestion around the P=O group.     

Obtaining Kinetic Parameters by Modulated Thermogravimetry

A new technique, called modulated thermogravimetry, is introduced as a tool for obtaining continuous kinetic information for decomposition and volatilization reactions. The approach makes use of an oscillatory temperature program to obtain kinetic parameters during a mass loss. MTGA™ may be used under quasi-isothermal conditions to observe a single mass loss or may be combined with linear heating rate or Hi-Res™ controlled rate thermogravimetry to scan from one mass loss region to another. Results obtained are in agreement with those obtained by other kinetic methods. This revised version was published online in July 2006 with corrections to the Cover Date.     

原子转移自由基聚合原位合成温敏性微球

以过硫酸钾为引发剂、丙酮-水[V(丙酮)∶V(水)＝4∶6]的混合溶剂为反应介质, 在少量二乙烯苯存在的条件下使苯乙烯(St)和对氯甲基苯乙烯(CMSt)进行无皂乳液共聚反应, 得到了粒径大小均匀的交联型聚苯乙烯(PSt)微球, 由X射线光电子能谱对表面组分测定发现: CMSt上的氯原子在聚合过程中富集于交联微球的表面. 以此交联型PSt微球为原子转移自由基聚合(ATRP)的引发剂, 在22 ℃下引发N-异丙基丙烯酰胺(NIPAAm)进行原位ATRP反应, 得到了表面原子转移自由基聚合接枝的交联聚苯乙烯(PNIPAAm-g-PSt)温敏性微球. 借助傅立叶变换红外光谱、差示扫描量热仪、扫描电子显微镜及激光光散射仪等对PNIPAAm-g-PSt的结构、相转变温度、形态及不同温度下的粒径变化进行了测定, 结果表明NIPAAm单体成功地原位ATRP接枝在交联PSt微球的表面, 接枝微球的球形更规整, 在水中的相转变温度约为32 ℃, 具有明显的温度敏感性.