HgCl2/I2复合催化剂协同催化合成异丙醇钇的研究

以金属钇和异丙醇为原料，以HgCl2/I2为复合催化剂，通过对金属钇的机械加工以增加其比表面，并将异丙醇脱水使其含水量降低至0．05％，体系在82℃回流5h，经过滤、减压蒸馏，得到了白色海绵状异丙醇钇，其产率高达83％，合成时间比文献报道的缩短了19h，产率提高了8％。文章确定了催化剂的最佳用量为20gY加入60mg HgCl2/I2，研究了合成产率与HgCl2/I2催化剂和HgCl2催化剂的依赖关系及异丙醇中含水量对合成产率的影响，并对HgCl2/I2的催化作用机理进行了初步探讨。     

Extrusion of pastes with a piston extruder for the determination of the local solid and fluid concentration, the local porosity and saturation and displacement profiles by means of NMR imaging

 Nuclear Magnetic Resonance (NMR) was used to investigate the extrusion behaviour of PTFE pastes in a ram extruder. By means of ¹H-NMR imaging (MRI) it is possible to determine the local proton density and therefore, the local fluid concentration. The ¹⁹F-MRI provides the local solid concentration. Thus the local saturation and the local porosity can be calculated with the information of the local fluid and solid concentration. Furthermore displacement profiles can be derived from NMR images by means of correlation techniques without any preparation or marking of the pastes. Received: 8 May 2000   Accepted: 1 May 2001     

一类机器人系统的最优控制

本文通过把结构阻尼系数当作控制变量来讨论一类弹性机器人系统的最优控制问题 ,并利用Banach空间几何性质证明了最优控制元的存在唯一性     

A comparative study of the structure and crystallization of bulk metallic amorphous rod Pr60Ni30Al10 and melt-spun metallic amorphous ribbon Al87Ni10Pr3

Pr-based bulk metallic amorphous （BMA） rods （Pr60Ni30Al10） and Al-based amorphous ribbons （Al87Ni10Pr3） have been prepared by using copper mould casting and single roller melt-spun techniques, respectively. Thermal parameters deduced from differential scanning calorimeter （DSC） indicate that the glass-forming ability （GFA） of Pr60Ni30Al10 BMA rod is far higher than that of Al87Ni10Pr3 ribbon. A comparative study about the differences in structure between the two kinds of glass-forming alloys, superheated viscosity and crystallization are also made. Compared with the amorphous alloy Al87Ni10Pr3, the BMA alloy Pr60Ni30Al10 shows high thermal stability and large viscosity, small diffusivity at the same superheated temperatures. The results of x-Ray diffraction （XRD） and transmission electron microscope （TEM） show the pronounced difference in structure between the two amorphous alloys. Together with crystallization results, the main structure compositions of the amorphous samples are confirmed. It seems that the higher the GFA, the more topological type clusters in the Pr-Ni-Al amorphous alloys, the GFAs of the present glass-forming alloys are closely related to their structures.     

Remote stereocontrol by the sulfinyl group: Mukaiyama aldol reactions of (S)-2-[2-(p-tolylsulfinyl)phenyl]acetaldehyde in the asymmetric synthesis of β-hydroxyacids and 1,3-diols

(S)-2-[2-(p-Tolylsulfinyl)phenyl]acetaldehyde reacts with different O-silylated ketenethioacetals in the presence of Yb(OTf)₃ yielding β-hydroxythioesters in high yields and diastereoselectivities. The obtained compounds were readily transformed into β-hydroxyacids and their corresponding diols. These Mukaiyama aldol reactions are a direct evidence of the ability of the sulfinyl group to control 1,5- and 1,6-asymmetric induction processes.     

A study of structural, compositional and optical properties of spray-deposited non-stoichiometric (Zn,Fe)S thin films

Non-stoichiometric ternary chalcogenides (Zn,Fe)S were prepared in the film form by pyrolytic spray deposition technique, using air/nitrogen as the carrier gas. The precursor solution comprised of ZnCl₂, FeCl₂ and thiourea. The depositions were carried out under optimum conditions of experimental parameters viz. carrier gas (air/nitrogen) flow rate, concentration of precursor constituents, nozzle substrate distance and temperature of quartz substrate. The deposited thin films were later sintered in argon at 1073 K for 120 min.The structural, compositional and optical properties of the sintered thin films were studied. X-ray diffraction studies of the thin films indicated the presence of (Zn,Fe)S solid solution with prominent cubic sphalerite phase while surface morphology as determined by scanning electron microscopy (SEM) revealed a granular structure.The chemical composition of the resulting thin films as analyzed by energy dispersive X-ray analysis (EDAX) reflected the composition of the precursor solutions from which the depositions were carried out with Fe at% values ranging from 0.4 up to 33.SEM micrographs of thin films reveal that the grain sizes of the thin films prepared using air as carrier gas and N₂ as carrier gas are in the vicinity of 300 and 150 nm, respectively.The diffuse transmittance measurements for thin films, as a function of wavelength reveal the dependence of direct optical band gap on Fe content and type of phase.     

Study of thermal currents in powder β-spodumene ceramics doped with Cuo, FeO and TiO2

Ternary-phase ceramic system of Li₂O Al₂O₃ 4SiO₂ doped with CuO, FeO and TiO₂ has been prepared and subjected to dc electrical conductivity and thermally stimulated depolarization current (TSDC) measurements as a function of temperature (30-250 °C) and field strength. The electrical conductivity results are explained by assuming both ionic and electronic conduction mechanisms coexist with different contributions over the whole temperature range of experiments. TSDC spectra have been found to be characterized by a broad intense relaxation peak, which can be attributed to an ionic charge polarization. The broad relaxation transitions are apparently a result of the nonuniform nature of this process. Activation energies are calculated for both dc electrical conductivity and TSDC according to Arrhenius equation and initial rise method, respectively.     

Hankel convolution operators on entire functions and distributions

In this paper we study the Hankel convolution operators on the space of even and entire functions and on Schwartz distribution spaces. We characterize the Hankel convolution operators as those ones that commute with Hankel translations and with a Bessel operator. Also we prove that the Hankel convolution operators are hypercyclic and chaotic on the spaces under consideration.     

CsI(Tl)晶体中反冲Cs和I核Quenching?Factor的测量

许多实验对用CsI(Tl)闪烁晶体作为探测器来寻找和探测暗物质的可行性进行了研究.本工作利用8MeV单能中子轰击CsI(Tl)晶体探测器来研究Cs核和I核的QuenchingFactor.在数据处理中,运用脉冲形状甄别(PSD)方法来分辨反冲核信号和本底信号.实验结果表明,在7keV到132keV的能区中,Quench ingFactor随着反冲核能量的减少而增加.在探测暗物质的实验中,这一性质对于CsI(Tl)晶体探测器获得较低的能量阈值是很有利的.     

超临界流体触媒作用下石墨-金刚石转变

 研究了超临界流体CO₂在石墨-金刚石转变中的触媒作用。实验中，采用Ag₂O作为流体触媒的先驱材料，在7.7 GPa压力下，Ag₂O在1 200 ℃分解成Ag和O₂，O₂与石墨套管在高温高压下反应形成CO₂超临界流体。研究结果表明，在7.7 GPa和1 500 ℃以上温度条件下，石墨在CO₂流体触媒的作用下可转变为金刚石晶体，在1 500～1 700 ℃温度范围内合成出的金刚石具有完好的八面体形貌，与天然金刚石的生长特征非常相似。