硅钼杂多阴离子薄膜修饰电极线性扫描伏安法测定黑液中可溶性硅

本文报导了以玻碳电极为基体的１：１２硅钼杂多阴离子薄膜化学修铈电极的制备及其电化学特性。并应用于导数伏安法测定。在４．０×１０￣（－３）ｍ０ｌ／Ｌ（ＮＨ＿４）＿６ＭＯ＿７Ｏ＿（２４）－６．８×１０￣（－２）ｍｏｌ／ＬＮａ＿３Ｃｉｔ－０．４８ｍｏｌ／ＬＮＨＯ＿３体系中，硅浓度在８．３×１０￣（－７）～１．７×１０￣（－３）ｍｏｌ／Ｌ范围内与峰电流呈良好线性关系，检测限为８．０×１０￣（－７）ｍｏｌ／Ｌ。对可溶性硅（以ＳｉＯ＿２计）为２４５．０５ｍｇ／Ｌ的黑液，稀释１０倍后，取２．００ｍＬ平行测定９次，ＲＳＤ为０．５８％，加标回收率在９７．３％～１０４．４％间。     

甲醇生产主精馏塔的模拟计算

对甲醇精馏主塔进行了模拟计算，并以一实际生产装置沿塔身的温度与浓度分布进行了验证。结果表明，水和甲醇的平均偏差为０．９％，微量杂质，不计丁基油，平均偏差为４９ｐｐｍ，温度平均偏差为２．９℃。说明本计算方法及采用的模型参数是可靠的，可用于工程计算。本文进一步指出，为降低废水中醇类含量，较理想的方法是选择合适的精甲醇与丁基油的采出量。     

Development and optimization of the determination of pharmaceuticals in water samples by SPE and HPLC with diode‐array detection

This paper describes the development, optimization, and validation of a method for the determination of five pharmaceuticals from different therapeutic classes (antibiotics, anthelmintics, glucocorticoides) in water samples. Water samples were prepared using SPE and extracts were analyzed by HPLC with diode‐array detection. The efficiency of 11 different SPE cartridges to extract the investigated compounds from water was tested in preliminary experiments. Then, the pH of the water sample, elution solvent, and sorbent mass were optimized. Except for optimization of the SPE procedure, selection of the optimal HPLC column with different stationary phases from different manufacturers has been performed. The developed method was validated using spring water samples spiked with appropriate concentrations of pharmaceuticals. Good linearity was obtained in the range of 2.4–200 μg/L, depending on the pharmaceutical with the correlation coefficients >0.9930 in all cases, except for ciprofloxacin (0.9866). Also, the method has revealed that low LODs (0.7–3.9 μg/L), good precision (intra‐ and interday) with RSD below 17% and recoveries above 98% for all pharmaceuticals. The method has been successfully applied to the analysis of production wastewater samples from the pharmaceutical industry.     

Preparation and Characterization of Nanocrystalline Fe-Doped TiO2 Film on Different Substrates and Its Application in Degrading Dyeing Water

TiO₂ and Fe-doped TiO₂ thin films were prepared on the substrates (glass plates and glass microballs) after dipped in colloid and calcined at 500°C. The films have been characterized by UV-absorption, x-ray diffraction and atomic force microscopy (AFM). The investigated Fe-doped TiO₂ (A nominal 10 wt% Fe₂O₃ was impregnated) thin films were obtained by sol-gel method. The characterization results suggest that the calcined thin films primarily consist of TiO₂ anatase. And the light absorption curve of the TiO₂ films modified with Fe showed that red shift had happened by the dope of Fe. TiO₂/beads as photocatalyst were used to degrade the simulated dyeing water which contains reactive deep-blue dye (K-R). Through the degradation experiment, we found that the dope of Fe promoted the photocatalytic activities. The results showed that the dyeing water can be decomposed more effectively by the photocatalytic oxidation of Fe/TiO₂ film on glass micro-balls than glass plates.     

Method Development for the Speciation of Chromium in River and Industrial Wastewater Using GFAAS

A simple, sensitive and inexpensive method for the speciation of Cr(VI) and Cr(III) in river and industrial wastewater was developed, optimized and validated. Samples were collected, filtered and then chromium species were determined in the filtrate. In the filtrate, total Cr was determined directly by Graphite Furnace Atomic Absorption Spectrometry (GFAAS). A portion of the filtered sample was buffered to pH 6.4, extracted with Amberlite LA-2/MIBK and finally Cr(VI) was determined in the organic extract and Cr(III) in the aqueous phase using GFAAS. The method was evaluated by analysis of the certified reference material, CRM 544, and good accuracy was obtained. The limit of detection for Cr(VI) and Cr(tot)/Cr(III) was found to be 0.30 and 0.08 µg L⁻¹, respectively, and a precision expressed as relative standard deviation of better than 11% was achieved for nine replicates. A number of water samples from the Tinishu Akaki River, Ethiopia, and wastewater samples from a chemical plant in Germany, were analysed. In addition to the GFAAS method, Cr(tot) was also determined using ICP-MS (in CRM 544, lyophilized water, and Tinishu Akaki River water samples) and Cr(tot) and Cr(VI) using UV-VIS spectrophotometry (in CRM 544 and industrial wastewater samples). Good agreement between the different methods was found.     

A New Neutral Carrier for Silver Ions Based on a Bis(Thiothiazole) Derivative and its Evaluation in Membrane Electrodes

Membrane electrodes based on 2,2-dithiobis(benzothiazole), DTBBT, as a neutral carrier for silver ions are described. Silver-selective membrane electrodes formulated with 2wt% DTBBT ionophore and 50mol% TFPB in an FPNPE plasticized poly (vinyl chloride) exhibited near-Nernstian responses towards silver ions (60.3±0.5mVdecade^–1) over a wide silver ion activity range of 0.83µM to 94mM. Increasing the amount of anionic sites, TFPB, to 100 or 150mol% (relative to the DTBBT weight) resulted in super-Nernstian responses toward silver ions. Membrane electrodes prepared using a low dielectric constant plasticizer, however, exhibited sub-Nernstian responses. Polymer membrane electrodes with optimal composition (i.e., 2wt% DTBBT, 50mol% TFPB in FPNPE plasticized poly(vinyl chloride)) exhibited high potentiometric selectivity towards silver ions over alkali, alkaline earth, transition metal ions, as well as heavy metal ions such as Hg²⁺ and Pb²⁺. A good correlation was found between the potentiometric selectivity coefficients and the change in the UV-visible spectra of the ionophore upon exposure to different metal ions. The overall performance of the silver-selective membrane electrodes based on DTBBT ionophore, which is available at low cost, was found to be comparable to the performance of silver electrodes prepared with Fluka silver ionophore-IV. A DTBBT-based silver electrode was used as an indicator electrode for titrations of silver ions using standard sodium chloride solutions. Sharp inflections occur at the end point, and the data obtained showed 99.4% recovery with a standard deviation of 0.7% (n=3). In addition, the applicability of the DTBBT-based silver-selective electrode is illustrated by measuring the silver concentrations in natural water spiked with silver nitrate and by analyzing the silver in electroplating wastewater samples. The results obtained utilizing a DTBBT-based silver electrode showed very good agreement with the standard methods of analysis.     

Long-term study of an intermittent air sparged MBR for synthetic wastewater treatment

Membrane bioreactors (MBR) combine biological processes with membrane filtration. Advantages of MBR in municipal wastewater treatment include high effluent quality and reduced space requirements. Steady operation of membrane plants requires careful management of membrane fouling. Even though it might be impossible to prevent, fouling can be limited by techniques such as gas sparging. The injection of gas bubbles increases the shear stress and removes fouling material from the membrane surface. Most cited literature on air sparging refers to short-term experiments, often times in bench scale. The aim of this study was therefore long-term investigations in pilot plant scale of a 70 L reactor fed with glucose-based synthetic wastewater. The main focus was on enhancing permeate flux by air sparging. The results showed that using air sparging significantly increased the permeate flux was doubled even over several weeks. The findings were interpreted using the dimensionless fouling and shear stress number. The fouling resistance was found to decrease significantly with air injection ratios between 0.4 and 0.5. When air sparging was applied after a period without air sparging, the shear stress number doubled. This increase in shear led to a reduction of the fouling number by approximately 30%. During several weeks air sparging only a slow fouling number increase was. In contrast to that after air sparging was ceased, an exponential increase of the fouling number was observed.     

Treatment of coke plant wastewater by A/O fixed biofilm system

The long-term environmental impacts of wastewa-ter from coke plant can be very high, especially due to the discharge of large amounts of wastewater. The composition of coke plant wastewater is complicated and varies from one factory to another, depending …     

Simultaneous Gas Chromatographic Determination of Nitrobenzene and 2,4-Dinitrophenol in Nitrobenzene Manufacturing Plant Wastewater

Abstract

A simple and rapid gas chromatographic procedure is described for the identification and quantification of pollutants in the nitrobenzene manufacturing plant wastewater. The samples were extracted with methylene chloride and subsequently nitrobenzene and 2,4-dinitrophenol were analysed by GC using FID. The method was found to be precise and accurate and applicable for monitoring the effluent treatment system at ppm levels.     

Treatment of dairy wastewater using a selected bacterial isolate, Alcaligenes sp. MMRR7

Physicochemical and biologic analysis of dairy wastewater showed that the effluent had a high organic load (chemical oxygen demand [COD]: 5095 mg/L), an acidic pH (6.4), and a high probability of coliforms (most probable number [MPN]>1100). The various bacterial strains isolated and purified were identified as Sporolactobacillus sp., Citrobacter sp., Pseudomonas sp., Alcaligenes sp., Bacillus sp., Staphylococcus sp., and Proteus sp., as per the Bergey’s manual of systematic bacteriology. Among the five selected bacterial strains, the strain designated as MMRR₇ and identified as Alcaligenes sp. was found to give a maximum reduction in COD (62%) in 5 d of incubation. Chemical coagulation using alum at a concentration of 0.5 g/100 mL was found to be effective in the primary treatment of the effluent. Studies on free-cell treatment of the coagulated effluent with the selected bacterial strain Alcaligenes sp. MMRR₇ gave a maximum COD reduction of 91% in 120 h. This study clearly indicates the possibility of using Alcaligenes sp. MMRR₇ for the effective treatment of dairy wastewater.