Effect of Drying Methods on the Structure and Combustion Activity of Mn—Substituted Hexaaluminate Catalysts

Conventional oven drying (COD) and supercritical drying (SCD) methods were applied to the preparation of Mn-substituted hexaaluminate (BaMnA111O19-α) catalysts. The effect of drying methods on phase composition, specific surface area, pore structure, reduction behavior of Mn^3 ions, and combus-tion activity of the samples was investigated. The homogenous mixing of the components in the sol-gel process could be maintained by SCD, and the hexaaluminate phase was almost the only phase of the resulting materials after calcination. H2-TPR revealed that the Mn^3 ions in the sample obtained by SCD were easier to be reduced than that by COD. Moreover, the samples obtained by SCD have higher surface area, narrower pore size distribution, and higher combustion activity than those obtained by COD.     

水热法制备高纯超细CeO2-ZrO2复合氧化物

Superfine composite powders of CeO₂-ZrO₂ (CZ) and CeO₂-ZrO₂-La₂O₃ (CZL) were prepared by hydrothermal method. The effects of pH、temperature and time for hydrothermal process on the performance of the resulting powders were studied. The optimized reaction parameters were on follows: the precursor′s pH≈9.0, hydrothermal temperature of 200 ℃ holding for 2 h. Thermal stable powders with average particle size smaller than 10 nm and specific surface area of 171 m²·g^-1 were obtained. A BET specific surface area was still at 44 m²·g^-1 after calcination at 1 000 ℃ for 6 hours.     

Factors affecting the combustion toxicity of polymeric materials

Fire gas toxicity is an essential component of any fire hazard analysis. However, fire toxicity, like flammability, is both scenario and material dependent. A number of different methods exist to assess the fire toxicity, but many of them fail to relate this to a particular fire scenario. Sample thickness alone, in a closed box test such as the NBS Smoke Chamber, is shown to change the fire scenario from well-ventilated to under-ventilated. Data from two flow-through tests, the static tube furnace (NF X 70-100) and the steady state tube furnace (the Purser furnace, BS 7990 and ISO TS 19700) show that there are different patterns of behaviour for different polymers (LDPE, polystyrene, rigid PVC and Nylon 6.6). The predicted toxicities show variation of up to two orders of magnitude with change in fire scenario. They also show change of at least one order of magnitude for different materials in the same fire scenario. Finally, they show that in many cases CO, which is often assumed to be the most, or even the only toxicologically significant fire gas, is of less importance than either HCl, or HCN, when present, and in some cases less important than organo-irritants. Nylon 6.6 shows the highest predicted toxicity, the greatest scenario dependence, and the least sensitivity to different apparatuses, while polystyrene shows the highest sensitivity to the different apparatuses, but the lowest to different fire scenarios. PVC shows high toxicity, mostly due to HCl in the fire effluent, under all fire conditions, and LDPE shows a more progressive increase in toxicity from well-ventilated flaming to both smouldering and under-ventilated flaming.     

过渡金属对分子筛担载Pd催化剂上CO氧化性能影响

分别采用共浸和连续浸渍法制备了一系列添加过渡金属的Pd-M-Ox-NaZSM-5(M=Cr，Mn，Fe，Co，Ni，Cu，Zn，Mo，Zr等)负载型催化剂．以CO氧化为探针反应，考察了不同制备方法对CO氧化性能影响，结果表明共浸法制备的各催化剂其活性明显优于连续浸渍法．详细考察了反应温度、Fe含量、氢气预还原、空速以及水蒸气等对共浸Pd-Fe-Ox-NaZSM-5催化剂上CO氧化行为影响，并应用XRD和XPS等手段对催化剂体相结构和表面状态进行了表征．结果表明：加入Fe2O3可明显提高Pd/NaZSM-5催化剂活性，且催化CO氧化的转化率随反应温度及Fe含量增加而增加；空速增加以及H2预还原作用导致Pd-Fe-Ox-NaZSM-5活性有所降低；催化剂对水蒸气较为敏感．XRD测试结果表明催化剂中Pd组分处于较高分散状态，以红铁矿形式存在的Fe2O3的引入，促进了Pd物种在NaZSM-5载体上的分散．表面XPS分析证实Fe2O3与Pd物种间存在较强的相互协同作用，且催化剂表面Pd物种处于较高氧化状态．Pd的高分散及其与Fe2O3的相互协同作用是共浸催化剂具有高活性的关键因素．     

CuO/Ce-Zr-La-O催化剂的表征及CO氧化活性

采用柠檬酸溶胶-凝胶法制备的Ce-Zr-La-O固溶体为载体，制备CuO／Ce-Zr-La-O催化剂，用XRD，Raman，TPR等实验技术对Ce-Zr-La-O固溶体及CuO／Ce-Zr-La-O的物相、Redox性能进行了表征。实验结果表明，Ce0.7Cr0.3-yLayO固溶体的还原性能与La含量有关，适量的La能促进固溶体的氧化还原。CuO的负载量为6％时，CuO／Ce0．7Zr0.15La0.15O的活性最高，高分散且与载体相互作用的CuO是CO氧化活性相。     

Oxidation of Styrene with Molecular Oxygen in Supercritical CO2

The oxidation of styrene with molecular oxygen catalyzed by PdCl2 CuCl2 has been investigated in supercritical CO2 with a batch reactor. The oxidative system of styrene contains four components at the beginning and seven components during the reaction. The critical temperature, critical pressure, and critical density at different conversions are determined by using a high-pressure view cell. The effect of phase behavior on the conversion and selectivity were studied. Experimental results showed that the critical parameters of the reaction mixture at fixed initial molar ratio changed with the conversion of reactant. The conversion of styrene reached maximum near the critical density of the reaction mixture. Product selectivity also varied with density of reaction mixture and could be tuned to some degree.     

Metal-support interaction in mesoporous silica supported cobalt Fischer-Tropsch catalysts

Summary The pore structure of silica supports (SiO₂ or MCM-41) has little influence on the metal-support interaction in silica supported cobalt catalysts. Cobalt dispersion, reduction behavior, and catalytic properties for the Fischer-Tropsch synthesis were primarily affected by the metal particle size.     

Thermal characterisation of alumina supported chromium and platinum–chromium catalysts

This study presented results on reduction of alumina supported chromium and platinum–chromium catalysts using temperature programmed reduction method (TPR). It has been shown that catalysts after earlier oxidation step but without calcinations one undergo reduction in lower temperature in comparison to calcined only catalysts. Moreover, addition platinum to Cr/Al₂O₃ catalysts also caused decrease of reduction temperature. It has been observed that over the examined catalysts oxidation CO to CO₂ and reduction CO to CH₄ occurs. However, on Pt–Cr catalysts both reactions proceed at lower temperature compare to Cr catalysts.     

煤的超临界醇萃取脱硫：Ⅲ.形态硫的变化

本文分别应用Ｍｏｓｓｂａｕｅｒ谱和ＸＰＳ（Ｘ射线光电子能谱）技术考察不同反应 条件下固体产物中的无机硫和有机硫的形态变化，结果表明；在超临界醇萃取脱硫过程中，黄铁矿硫的转化反应如下：ＦｅＳ２－ＦｅＳ＋Ｆｅ１－ｘＳ，，转化的数量和深度主要取决于反应温度。２７５℃时磁黄铁矿（Ｆｅ１－ｘＳ）形式为ＦｅＳ１．１０１，４５０℃时为ＦｅＳ１．０８５；有机硫基团中ＰｈＳＨ ，Ｐｈ２Ｓ和四氢噻吩较易脱除，Ｐｈ２Ｓ     

OH自由基与CO反应的研究

用时间分辨-傅立叶变换红外发射光谱法研究了OH自由基与CO的反应.OH自由基由248 nm的激光光解硝酸得到.在实验中首次观测到了产物CO2的非对称伸缩振动(ν3)的激发态.对CO2发射光谱的拟合结果显示,其振动态的布居在量子数v=2时最大 ,而最高振动量子数达到v=6.由实验得到的CO2振动布居与Schatz等人用全量子化计算该反应的中间物HOCO解离动力学得到的CO2布居结果能很好地吻合.