PbO2阳极在硫酸溶液中的析氧失活行为

采用热分解鄄电镀法制备了以Sb 掺杂SnO₂(Sb-SnO₂)为底层的Ti 基PbO₂阳极(Ti/PbO₂). 采用加速电解寿命测试、电化学阻抗谱、XRD、SEM-EDX 等技术, 研究了Ti/PbO₂阳极在硫酸溶液中的电解失效行为和机制.结果表明,在新制备的PbO₂镀层中, 由于氧空位的存在, PbO₂镀层的内应力表现为拉应力, 随着电解的进行, 阳极表面生成的活性氧原子在向基底扩散的过程中, 将Pb³⁺态氧化为Pb⁴⁺态, 逐渐占据镀层内作为自由电子施主的氧空位, 这不仅导致镀层的导电性能下降, 同时使镀层的应力逐渐由拉应力转变为压应力, 镀层性质逐渐劣化. 这一过程基本结束时,活性氧原子才大量扩散至Ti基底导致基底的钝化, 在Ti 基底和镀层界面出现显著的界面应力, 在界面应力和镀层内压应力的共同作用下, 阳极出现鼓泡、脱落, 迅速进入失活阶段.     

Preparation of Silica-Silk Fibroin-Polyurethane Composite Films via a Sol-Gel Route

A tetraethoxysilane (TEOS)-derived sol aged for 0 h–6 h at room temperature was mixed with a polyurethane (PU) matrix. A composite of silk fibroin (SF) powders and acrylamide (AAm) was dispersed in the sol-PU mixture and dried isothermally at temperatures between 25°C and 120°C to obtain composite films. Three competitive reactions take place, i.e., those between silica-silica, SF-PU and silica-organic phases, during formation of the composite films. These reactions determine the properties such as morphology and homogeneity of the composite films. IR absorption bands for amide groups (–CONH–), C=O (amide I, 1730 cm^–1) and N–H (amide II, 1530 cm^–1) become larger with decreasing aging time of TEOS-derived sol, or increasing drying temperature. DTA exothermic peak due to the thermal decomposition of SF-AAm composite, on the composite films prepared from the 0 h-aged sol or dried at more than 50°C, shifts toward higher temperature by 44 K or more than 63 K respectively, as compared to the SF-AAm composite. Shorter aging time of TEOS-derived sol and higher drying temperature increased the extent of dispersibility, among SF-AAm composite, PU and silica, to bring a composite film more homogeneous.     

SANS study of the aging of xTiO2-SiO2 gels

Silica-titania gels, prepared in acidic conditions, with contents of TiO₂ up to 6 mol%, have been studied by small angle neutron scattering (SANS) as wet gel with increasing aging times. In all samples, small primary particles have been found with a diameter of about 3 nm. At the gel point, cylindrical clusters, ca. 10 nm long, were observed as well. These grow with aging time, becoming branched. The cluster-cluster diffusion limited aggregation model is found to be consistent with the SANS results. The growth process is independent of the TiO₂ content. It is mainly influenced by the ratio of the aging time to the gelation time.     

Texture of zirconia obtained by forced hydrolysis of ZrOCl2 solutions

The structure and surface properties of ZrO₂ strongly depend on its preparation. In the present work the impact of prolonged aging at basic conditions (pH = 9, T = 100°C, t = 48 h), on the phase composition and textural properties, obtained by calcination of the precipitate, was investigated using several techniques conjointly (DTA/TG, DSC, XRD, porosimetry). The thermal effects accompanying the ZrO₂·xH₂O gel formation, the coalescence of the particles and crystallization were evaluated and discussed in terms of the structural differences between the aged and non-aged samples. This revised version was published online in July 2006 with corrections to the Cover Date.     

RESEARCH ANNOUNCEMENTS ON “DPK: DEEP NEURAL NETWORK APPROXIMATION OF THE FIRST PIOLA-KIRCHHOFF STRESS”

1 Introduction and Main Results Consider the first Piola-Kirchhoff stress P defined as[1]P(F)=?W(F)/?F,(1.1)where F and W refer to the deformation tensor and strain energy density.Due to the principle of material frame-indifference and the material symmetry,two important constraints should be satisfied by these relations[1].     

Study of the influence of physical aging on macroradical decay in poly(methyl methacrylate)

The macroradical decay in poly(methyl methacrylate) samples with different thermal histories was investigated in the temperature interval 20–100 °C using ESR spectroscopy and the second order kinetic model. The rate constants exhibit two different regimes with the transitions atT _tr=68±1°C which are independent of thermal treatment. ForT<T _tr andT>T _tr the rate constants as well as the corresponding activation parameters are sensitive to history because of different physical microstructures. The compensation law, i.e., the linear relation between lnk _{o, eff} andE _eff, was analyzed in terms of the so-called compensation quantitiesk _c andT _c and a proximity betweenT _c=T _tr andT _o=53±3 °C — Vogel temperature for -segmental dynamics was found. A comparison of kinetic and dynamic data suggests that the decay of terminal macroradicals in the low-temperature region is controlled by secondary relaxations and that the -mobility contributes to a more rapid decay at higher temperatures belowT _g.     

Residual stress/strain analysis in thin films by X-ray diffraction

Residual stresses are found in the majority of multilayer thin film structures used in modem technology. The measurement and modeling of such stress fields and the elucidation of their effects on structural reliability and device operation have been a “growth area” in the literature, with contributions from authors in various scientific and engineering disciplines.

In this article the measurement of the residual stresses in thin film structures with X-ray diffraction techniques is reviewed and the interpretation of such data and their relationship to mechanical reliability concerns are discussed.     

Preparation and characterization of Fully stoichiometric SrCoO3 by electrochemical oxidation

A nearly stoichiometric SrCoO₃ phase had been prepared up to now only using high oxygen pressure. A new method for preparing fully stoichiometric SrCoO₃ has been proposed using electrochemical oxidation. Brownmillerite-type SrCoO_2.50 is oxidized into a completely stoichiometric perovskite at a potential of 500 mV for 180 hours at room temperature in alkaline media (1 M KOH). The oxidized phase has a cubic unit cell (a=383.5 pm). It is metallic and, at temperatures below T=280 K, it shows ferromagnetic behavior. The magnetic moment at 0 K is 2.1 μ_B. The physical properties of SrCoO_3.00 have been explained in terms of partial occupancy of a σ*e band.     

Effects of steric and hydrophobic forces on the rheological properties of ZrO2 suspensions

 The effect of pH on the flow behavior of ZrO₂ suspensions containing polyacrylic and octanoic acids was evaluated. In the flocculated pH regime, the flow behavior is highly shearthinning and can be described by a power-law model. The shear-thinning behavior increases with increasing degree of flocculation. Maximum shearthinning was observed at the zero zeta potential condition. Hydrophobic interaction arising from adsorbed octanoic acid was found to enhance the shear-thinning behavior. No such enhancement was observed for adsorbed polyacrylic acid. It was also illustrated that the viscosity–pH behavior is a mirror image of the yield stress–pH behavior. A quantitative particle-pair interactions model incorporating steric and hydrophobic interactions was proposed to explain the effects of polyacrylic and octanoic acids on the maximum yield stress. Received: 23 May 1997 Accepted: 4 June 1997