SRPES investigation of tungsten oxide in different oxidation states

The microstructure and morphology of metal oxide films have a large influence on the sensitivity, selectivity and stability of the gas sensors and catalysts. Considering that the sensing properties of thin film sensors are strongly related to their microstructures and to the exact stoichiometry of their surfaces, an accurate control of these parameters is extremely important for the production of sensors with reproducible behavior. In this paper, an influence of preparation and annealing conditions on the physical and chemical properties of tungsten oxide thin film is investigated. Two types of samples having polycrystalline structure were prepared by different methods (deposition under UHV conditions, oxidation of metallic tungsten layer in air). The samples were reduced by heating in UHV at different temperatures and/or by Ar ion bombardment. It was found that the stability of tungsten oxide layer with respect to the treatment procedures depends strongly on the preparation conditions of the sample. The reduction process is discussed in terms of different oxidation states resolved in the W4f photoelectron spectrum. Easy reducibility of the tungsten oxide layer prepared by vacuum deposition was found to be a consequence of its nano-crystalline structure.     

Self-regulated Ni cluster formation on the TiO2(1 1 0) terrace studied using scanning tunneling microscopy

We have studied the growth mode and morphology of Ni clusters on a TiO₂(1 1 0) surface with a wide terrace using scanning tunneling microscopy (STM) at a low coverage (less than 3 atoms nm⁻²). The Ni clusters are formed on the terrace at the low coverage of 0.2 atoms nm⁻². Their average dimensions are constant in three directions up to 1 atoms nm⁻². The Ni clusters have an oval shape with average sizes of 1.8 nm (along [0 0 1]) × 1.4 nm (along (in the [1 1 0] directions). Above the coverage of 1.0 atoms nm⁻², an increase in the cluster height occurs, retaining an almost constant lateral size. It is proposed that the interaction of the Ni cluster and the support surface regulates the Ni cluster size.     

Growth of epitaxial thin Pd(1 1 1) films on Pt(1 1 1) and oxygen-terminated FeO(1 1 1) surfaces

Thin Pd films (1-10 monolayers, ML) were deposited at 35 K on a Pt(1 1 1) single crystal and on an oxygen-terminated FeO(1 1 1) monolayer supported on Pt(1 1 1). Low energy electron diffraction, Auger electron spectroscopy, and Kr and CO temperature programmed desorption techniques were used to investigate the annealing induced changes in the film surface morphology. For growth on Pt(1 1 1), the films order upon annealing to 500 K and form epitaxial Pd(1 1 1). Further annealing above 900 K results in Pd diffusion into the Pt(1 1 1) bulk and Pt-Pd alloy formation. Chemisorption of CO shows that even the first ordered monolayer of Pd on Pt(1 1 1) has adsorption properties identical to bulk Pd(1 1 1). Similar experiments conducted on FeO(1 1 1) indicate that 500 K annealing of a 10 ML thick Pd deposit also yields ordered Pd(1 1 1). In contrast, annealing of 1 and 3 ML thick Pd films did not result in formation of continuous Pd(1 1 1). We speculate that for these thinner films Pd diffuses underneath the FeO(1 1 1).     

Constant time steady gradient NMR diffusometry using the secondary stimulated echo

A pulse sequence producing a second stimulated echo is suggested for the compensation of relaxation and residual dipolar interaction effects in steady gradient spin echo diffusometry. Steady field gradients of considerable strength exist in the fringe field of NMR magnets, for instance. While the absolute echo time of the second stimulated echo is kept constant throughout the experiment, the interval between the first two radiofrequency pulses is augmented leading to a modulation of the amplitude of that second stimulated echo by self-diffusion only. The unique feature of this technique is that it is of a single-scan/single-echo-signal nature. That is, no reference signals neither of the same pulse sequence nor of separate experiments are needed. The new method was tested with poly(ethylene oxide) melts and proved to provide reliable data for (time dependent) self-diffusion coefficients down to the physical limit (D approximately 10(-15)m(2)/s) when flip-flop spin diffusion starts to become effective.     

High sensitivity CW-Cavity Ring Down Spectroscopy of N2O near 1.5 μm (II)

We present the second part of the investigation of the high sensitivity absorption spectrum of nitrous oxide by CW-Cavity Ring Down Spectroscopy near 1.5 μm. In a first paper [A.W. Liu, S. Kassi, P. Malara, D. Romanini, V.I. Perevalov, S.A. Tashkun, S.M. Hu, A. Campargue, J. Mol. Spectrosc. 244 (2007) 33-47] devoted to the 6000-6833 cm⁻¹ region, more than 6000 line positions of five isotopologues (¹⁴N₂¹⁶O, ¹⁵N¹⁴N¹⁶O, ¹⁴N¹⁵N¹⁶O, ¹⁴N₂¹⁷O, and ¹⁴N₂¹⁸O), were rovibrationally assigned to a total of 68 bands. The achieved noise equivalent absorption (α_min ∼ 2 × 10⁻¹⁰ cm⁻¹) allowed for the detection of lines with intensity weaker than 2 × 10⁻²⁹ cm/molecule. In this contribution, the investigated region was extended down to 5905 cm⁻¹ and additional recordings allowed accessing small spectral sections uncovered in our preceding recordings. A deeper analysis based on the predictions of the effective Hamiltonian model has allowed assigning a total of 3149 transitions and lowering the percentage of lines left unassigned from 51% to 28%. It led to the analysis of 35, 6, 7, and 6 bands for the ¹⁴N₂¹⁶O, ¹⁵N¹⁴N¹⁶O, ¹⁴N¹⁵N¹⁶O, and ¹⁴N₂¹⁸O isotopologues, respectively. Forty-two of these 54 bands are newly observed, while the rotational analysis of the twelve others is significantly extended and improved. Most of the bands were found unperturbed and their line positions could be reproduced within the experimental uncertainty (about 1 × 10⁻³ cm⁻¹). The corresponding spectroscopic parameters are reported. Local rovibrational perturbations induced by either intrapolyad or interpolyad couplings were found to affect five hot bands of ¹⁴N₂¹⁶O. Their detailed analysis is presented.     

Epitaxial growth of cobalt clusters on the bare and the oxide film grown on NiAl(1 0 0) surfaces

The structure of the nano-sized cobalt clusters on bare NiAl(1 0 0) and an oxidized NiAl(1 0 0) surfaces have been investigated by AES, LEED and RHEED. The deposition of Co onto bare NiAl(1 0 0) at room temperature led to small crystalline Co grains and surface asperities of substrate. The latter is likely induced by replacement of surface Al, Ni atoms by Co deposit. At 800 K Co particles aggregate to form clusters, but incorporation of Co into bulk NiAl(1 0 0) could occur upon annealing at 900 K. On the other hand, pure face-centered cubic (fcc) phase of Co crystallites of ≈1 nm in diameter with inclusion of smaller-sized particles (D < 1 nm) are observed on Θ-Al₂O₃ after Co deposition at room temperature. After annealing the Co nano-clusters grow larger at expense of small particles (D ≈ 3 nm), where the [1 1 0] and [−1 1 0] axis of the Co(0 0 1) facets are parallel to the [1 0 0] and [0 1 0] directions of (0 0 1)oxide, respectively. The in-plane lattice constant of Co clusters is ca. 4% larger than that of bulk Co, yielding less strain at the Co/oxide interface. A 15° ± 10% random orientation of the normal to (0 0 1) facet of Co clusters with respect to (0 0 1)oxide surface was deduced from the “arc”-shape reflection spots in RHEED. These results suggest that both orientation and phase of Co clusters are strongly affected by the nature and structure of oxide surface.     

A non-thermal chemical synthesis of hydrophilic and amorphous cobalt oxide films for supercapacitor application

Present work explored a room temperature, simple and low cost chemical route for the preparation of hydrophilic cobalt oxide films from alkaline cobalt chloride (CoCl₂:6H₂O) and double distilled water precursor solutions. As-deposited cobalt oxide films showed amorphous nature, which is one of the prime requirements for supercapacitor, as confirmed from X-ray diffraction studies. Changes in direct band gap energy and electrical resistivity of as-deposited cobalt oxide films were confirmed after annealing. Spherical grains of about 40-50 nm diameters were uniformly distributed over the substrate surface. Surface wettability studied in contact with liquid interface, showed hydrophilic nature as water contact angle was <90°. Finally, presence of cobalt-oxygen covalent bond was observed from Raman shift experiment.     

Nd:YAG laser synthesis of nanostructural V2O5 from vanadium oxide sols: Morphological and structural characterizations

Vanadium oxide thin films were prepared by sol-gel method, then subjected to Nd:YAG laser (CW, 1064 nm) radiation. The characteristics of the films were changed by varying the intensity of the laser radiation. The nanocrystalline films were characterized by X-ray diffraction (XRD), X-ray photoelectron spectroscopy (XPS), transmission electron microscopy (TEM) and scanning electron microscopy (SEM). XRD revealed that above 102 W/cm² the original xerogel structure disappears and above 129 W/cm² the films become totally polycrystalline with an orthorhombic structure. From TEM observations, we can see that due to laser radiation, the originally fibrillar-like particles disappear and irregular shaped, layer structured V₂O₅ particles are created. From XPS spectra we can conclude that due to laser radiation the O/V ratio increased with higher intensities.     

Infrared combination and difference bands of the NO dimer

The mid-infrared (1500-3800 cm⁻¹) absorption spectrum of gaseous nitric oxide has been studied at low temperature (99 K) with a long absorption path (160 m) in order to observe weak combination, difference, and overtone bands of the NO dimer. About ten new bands were assigned with greater or lesser certainty. Combined with previous results, they lead to a set of 12 secure and 7 tentative vibrational term values for (NO)₂, essentially doubling our knowledge of NO dimer vibrational states. The strongest non-fundamental bands in this region, other than the ν₁ (symmetric N-O stretch) + ν₅ (asymmetric N-O stretch) overtone, involve combinations of ν₅ with ν₃ (intermolecular stretch). Excitation of ν₅ results in increased frequencies for the intermolecular modes ν₂, ν₃, and ν₄. A new value of 155.5 cm⁻¹ was obtained for ν₄, the elusive infrared-inactive out-of-plane fundamental vibration.     

Synthesis of In<Subscript>2</Subscript>O<Subscript>3</Subscript>nanoparticles by thermal decomposition of a citrate gel precursor

This paper describes the synthesis of indium oxide by a modified sol–gel method, and the study of thermal decomposition of the metal complex in air. The characterization of the intermediate as well as the final compounds was carried out by thermogravimetry, differential thermal analysis, Fourier transform infrared spectroscopy, X-ray diffraction, transmission electron microscopy, and small angle X-ray scattering. The results show that the indium complex decomposes to In₂O₃ with the formation of an intermediate compound. Nanoparticles of cubic In₂O₃ with crystallite sizes in the nanosize range were formed after calcination at temperatures up to 900°C. Calcined materials are characterized by a polydisperse distribution of spherical particles with sharp and smooth surfaces.This revised version was published online in August 2005 with a corrected issue number.