部分空间和部分光谱相干高斯-谢尔模型脉冲光束在自由空间中的光谱和时间特性

 对部分空间和部分光谱相干２维高斯-谢尔模型脉冲光束在自由空间传输的光谱和时间特性做了详细的数值研究。结果表明,部分空间和部分光谱相干高斯-谢尔模型脉冲光束在自由空间传输中发生了光谱移动,光谱移动与场点位置、空间相关长度和时间相干长度有关。在轴上,光谱出现蓝移,相对光谱移动随传输距离的增加而增大,随空间相关长度和时间相干长度的增加而减小,并逐渐趋于一定值。在轴外,光谱出现蓝移和红移,并与空间相关长度和时间相干长度有关。脉冲时间波形不变,对所得主要结果做了物理解释。     

Control of spontaneous emission in a five-level system

We study the control of spontaneous emission in a five-level atomic system driven by four fields. We show that with the variation of dynamical variables, namely, Rabi frequencies and carrier phases of driven fields, a wide variety of the spectral behavior can be obtained, including extreme spectral narrowing. Our system can be found easily in real atoms.     

Comparative Study of Tribological Properties of Polyphenylene Sulfide (PPS), Polyethersulfone (PES), and Polysulfone (PSU)

The tribological properties of polyphenylene sulfide (PPS), polyethersulfone (PES) and polysulfone (PSU), which have similar molecular structures, were investigated using an end-face contact tribometer and a reciprocating tribometer. The thermomechanical behavior of the polymers was analyzed using dynamic mechanical analysis (DMA). PPS exhibited a maximum friction coefficient with increasing load and sliding speed, while the friction coefficients of PES and PSU decreased only slightly. The wear rate of PPS was much lower than that of PES and PSU under high loads and speeds. It is suggested that the main factors influencing the friction and wear properties of the neat polymers are their condensed state and heat resistance. Amorphous PES and PSU showed liquid-like behavior and very low friction when the frictional surface was in the molten-flow state. The macromolecular crystals of crystallizable PPS give it some solid-like behavior and load-carrying capacity; hence PPS exhibited lower wear than PES and PSU.     

Effect of Alkyl Side Chain Length on Relaxation Behaviors in Poly(n-alkyl Acrylates) and Poly(n-alkyl Methacrylates)

Dynamic mechanical analysis (DMA) is used to investigate the effect of alkyl side chain length on the relaxation behavior of poly(n-alkyl acrylates) (PnAA) and poly(n-alkyl methacrylates) (PnAMA) above the glass transition temperature (T_g). Master curves and shift factors (log a_T) were obtained using the time–temperature superposition (TTS) principle. The log a_T curves of PnAA and PnAMA exhibit a dynamic crossover from one Vogel–Fulcher–Tammann–Hesse (VFTH) equation to another above T_g. The corresponding temperature was designated as the dynamic crossover temperature (T_c). It is found that T_c/T_g and the apparent activation energy (E_g) increases, e whereas the fragility index (m) decreases with increasing alkyl side chain length. Further analysis shows that m ∝ T_g, E_g∝ , and E_g∝ m² for both PnAA and PnAMA.     

Spectral study on feldspar thermoluminescence process

Feldspar thermoluminescence fading phenomena were investigated here by using newly-constructed thermoluminescence spectrometer on the basis of charge-coupled detector, and thereafter the discussion and explanation on feldspar TL fading mechanism were presented. The experimental results show that the fading rate of feldspar TL depends on both wavelength and stimulated temperature, and normally the feldspar TL in every region of wavelength and temperature shows different traits, namely the low temperature TL (170°–190°) fading at the rate of logarithmic function and furthermore the TL of different wavelengths fading at approximately the same rate on the condition of 160° preheating. While the medium and high temperature TLs (290°–400°) do not show much thermal fading, their fading rate at room temperature invariably correlates well with their wavelength, namely the longer TL wavelength, the slower TL fading rate. The thermal instability of traps and the quantum-mechanical tunneling effects can explain the above fading phenomena respectively. It is recognized that feldspar TL fading depends on its wavelength, and furthermore new aspects of the solid thermoluminescence process can be displayed by the combination of three-dimensional TL spectral analysis and thermal fading or anomalous fading of TL for feldspar. Supported by the National Natural Science Foundation of China (Grant No. 40534019) and the Knowledge Innovation Program of the Chinese Academy of Sciences (Grant No. GIGCX3-07-10)     

中药黄柏主要活性成分的光谱成像检测技术

为了实现中药主要活性成分的在体检测,运用光谱成像技术检测中药活性成分.使用自行开发的液晶光谱成像装置对中药黄柏的主要活性成分盐酸小檗碱进行了在体检测,选取紫外光源波长254 nm,获取了检品480～700 nm之间的连续荧光光谱图像.在分析检品光谱剖面图的基础上,以中国药品生物制品检定所提供的盐酸小檗碱标准品的光谱剖面图为依据,设计了高通滤波器得到了检品的特征光谱数据.对八种不同来源的市售黄柏饮片特征光谱,以及黄柏与其同科植物黄皮特征光谱的比较显示,使用本方法对中药进行定性、定量的检测,样品无需特殊处理,可在原生态的情况下进行;检测过程无损、实时;检测结果指纹特征明显.     

Synthesis and magnetic properties of Co1−xZnxFe2O4+γ nanoparticles as materials for magnetic fluid hyperthermia

Nanoparticles of the single spinel phase Co_1−xZn_xFe₂O_4+γ of mean size 3-23 nm, as determined by X-ray diffraction analysis, were synthesized by the co-precipitation method followed by a temperature treatment. Magnetic studies carried out in the range of 4.5-550 K revealed gradual transition from ferrimagnetic to superparamagnetic to paramagnetic behaviour depending on the composition and particle size. The observed behaviour indicates a broad distribution of volume sizes of the nanoparticles. Particular importance can be ascribed to the composition of x=0.6 where the observed transition temperature to the paramagnetic state at 310-334 K suggests applicability of this material for magnetic fluid hyperthermia in a self-controlled regime.     

Some theoretical aspects of elastic wave modeling with a recently developed spectral element method

A spectral element method has been recently developed for solving elastodynamic problems. The numerical solutions are obtained by using the weak formulation of the elastodynamic equation for heterogeneous media, based on the Galerkin approach applied to a partition, in small subdomains, of the original physical domain. In this work, some mathematical aspects of the method and the associated algorithm implementation are systematically investigated. Two kinds of orthogonal basis functions, constructed with Legendre and Chebyshev polynomials, and their related Gauss-Lobatto collocation points are introduced. The related integration formulas are obtained. The standard error estimations and expansion convergence are discussed. An element-by-element pre-conditioned conjugate gradient linear solver in the space domain and a staggered predictor/multi-corrector algorithm in the time integration are used for strong heterogeneous elastic media. As a consequence, neither the global matrices nor the effective force vector is assembled. When analytical formulas are used for the element quadrature, there is even no need for forming element matrix in order to further save memory without losing much in computational efficiency. The element-by-element algorithm uses an optimal tensor product scheme which makes this method much more efficient than finite-element methods from the point of view of both memory storage and computational time requirements. This work is divided into two parts. The first part mainly focuses on theoretical studies with a simple numerical result for the Che-byshev spectral element, and the second part, mainly with the Legendre spectral element, will give the algorithm implementation, numerical accuracy and efficiency analyses, and then the detailed modeling example comparisons of the proposed spectral element method with a pseudo-spectral method, which will be seen in another work by Lin, Wang and Zhang.     

Temporal and spectral properties of ultrashort pulsed Laguerre-Gaussian beams in dispersive media

The temporal and spectral properties of ultrashort pulsed Laguerre-Gaussian (LG) beams propagating in dispersive media are studied both theoretically and numerically. It is shown that the on-axis pulse broadens with increasing propagation distance and the on-axis spectrum is blueshifted. For the off-axis spectrum the blueshifts decrease and then the spectrum becomes redshifted as the radial distance increases. The propagation of ultrashort pulsed LG beams in free space and of ultrashort pulsed Gaussian beams can be regarded as special cases of our results, and some interesting properties are discussed.     

Spectral Characterization of Nitrogen in Farmland Soil by Laser-Induced Breakdown Spectroscopy

Nitrogen is one of the most important elements in farmland soil, and nitrogen content is one of the evaluation indicators of fertilizers. It is difficult to measure the nitrogen content in farmland soil because the chemical and physical properties of farmland soil are complex. Through the adoption of buffer gases to remove the influence of the nitrogen in air, this paper studied the laser-induced breakdown spectroscopy (LIBS) characteristics of nitrogen in soil to establish a foundation for in situ measurement of nitrogen in farmland soil. Three characteristic spectral lines have been found. Based on the precise controlling of laser power and triggering of delay time between laser generation and spectra collection, we have studied the effects of laser energy on LIBS spectral characteristics and the time evolution characteristics to supply the basis of parameter optimization for the measurement. In addition, we have studied the relationship between nitrogen concentration and LIBS spectral intensity. The results demonstrated that LIBS was an effective measurement method of nitrogen content in farmland soil with simple hardware structure, fast detection, and high precision.