Copper Solid Amalgam Electrodes

This work describes the behavior of copper solid amalgam electrodes (CuSAE). The applied potential range has been compared with that of the silver solid amalgam electrode (AgSAE) and the hanging mercury drop electrode (HMDE). In 0.05 M tetraborate buffer the applicable potential range of CuSAE is+0.945 V to ?1.75 V excluding ?0.2 V to ?0.5 V, where the anodic oxidation of copper occurs. CuSAE does not need other than electrochemical pre‐treatment, which has been documented by the evaluated repeatability of eleven voltammetric curves of Cd²⁺ (0.1 ppm), Pb²⁺ (0.1 ppm) and Mn²⁺ (0.5 ppm). The obtained results showed that CuSAE could substitute the solid copper, amalgamed copper or liquid copper amalgam electrodes, and can be applied for the study of systems needing an addition of Cu²⁺ ions into the measured solution.     

Effect of nature of support and impregnating agent on lipophilicity determination for nonionic surfactants by reversed-phase thin-layer chromatography

Summary The retention of 9 nonylphenyl ethylene oxide oligomers was determined in 15 reversed-phase chromatographic systems using silicone oils of various molecular mass as impregnating agents and silica, cellulose and alumina supports. The data were evaluated with principal component analysis carried out on the covariance and the correlation matrices. The R_M values did not follow the additivity rule and they did not change linearly with increasing length of the ethylene oxide chain. This is probably due to the folded state of the chain in the eluent. The molecular mass of the silicone oils had a negligible effect on the retention whereas the retention increased with increasing level of impregnation. The support considerably influenced the lipophilicity values of these nonionic surfactants and cellulose seemed to be the most appropriate support. Calculations proved that the application of a correlation matrix may cause data distortion; therefore, the use of a covariance matrix is strongly proposed.     

Synthesis, spectroscopic characterization and reactivities of linear and butterfly chromium/selenium complexes containing substituted cyclopentadienyl ligands: crystal structures of [{η-MeC5H4Cr(CO)2}2Se] and [{η-EtO2CC5H4Cr(CO)2}2Se2]

The Cr-Cr singly-bonded dimers [{η⁵-RC₅H₄Cr(CO)₃}₂] (1, R=Me; 2, R=CO₂Et) reacted with an equivalent of elemental selenium in THF at room temperature to give the linear Cr₂Se complexes [{η⁵-RC₅H₄Cr(CO)₂}₂Se] (3, R=Me; 4, R=CO₂Et), whereas the linear Cr₂Se complex (5, R=MeCO) reacted with excess NaBH₄, Ph₃PCHPh or 2,4-dinitrophenylhydrazine under respective conditions to afford the linear Cr₂Se derivatives [{η⁵-RC₅H₄Cr(CO)₂}₂Se] (6, R=MeCH(OH); 7, R=PhCHCMe; 8, R=2,4-(NO₂)₂C₆H₃NHNCMe). Similarly, while the butterfly Cr₂Se₂ complexes [{η⁵-RC₅H₄Cr(CO)₂}₂Se₂] (9, R=Me; 10, R=CO₂Et) could be produced either by reaction of dimers 1 and 2 with an excess amount of elemental selenium, or by reaction of the linear complexes 3 and 4 with an equivalent of elemental selenium, the butterfly Cr₂Se₂ derivatives [{η⁵-RC₅H₄Cr(CO)₂}₂Se₂] (12, R=MeCH(OH); 13, R=PhCHCMe; 14, R=2,4-(NO₂)₂C₆H₃NHNCMe) were yielded by reaction of the butterfly Cr₂Se₂ complex (11, R=MeCO) with an excess quantity of NaBH₄, Ph₃PCHPh and 2,4-dinitrophenylhyazine. Both the linear complexes 3, 4, 6-8 and the butterfly complexes 9, 10, 12-14 are new, which have been fully characterized by elemental analysis, spectroscopy and X-ray crystallography.     

Lattice Dynamics in LaTa2-2xNb2xVO9-δ (x=0–0.1) Solid Solutions

The oxygen nonstoichiometry (x) of LaTa_2-2xNb_2xVO₉- (x = 0–0.1) solid solutions was studied using Xray phase analysis, vibrational spectroscopy, and radiospectroscopy. A correlation was found between (x) and the unit cell volume V(x) of the solid solutions. It was shown that the infrared spectra of LaTa₂VO₉- change in passing from = 0 to 0. The structural position of the oxygen vacancy in LaTa_2-2xNb_2xVO₉- is discussed.     

The Enhancement of Efficiency of High-order Harmonic in Intense Laser Field Based on Asymptotic Boundary Conditions and Symplectic Algorithm

Asymptotic boundary condition (ABC) of laser-atom interaction presented recently is applied to transform the initial value problem of the time-dependent Schrödinger equation (TDSE) in infinite space into the initial and boundary value problem in the finite space, and then the TDSE is discretized into linear canonical equations by substituting the symmetry difference quotient for the 2-order partial derivative. The canonical equation is solved by symplectic algorithm. The ground state and the equal weight coherent superposition of the ground state and the first excited state have been taken as the initial conditions, respectively, while we calculate the population of bound states, the evolution of average distance and the high-order harmonic generation (HHG). The conversion efficiency of HHG can be enhanced by initial coherent superposition state and moderate laser intensities     

Visual observation of contact-induced intercrystalline migration of aromatic species adsorbed in zeolites by fluorescence microscopy.

Intercrystalline migration and a migration-assisted chemical reaction of adsorbed aromatic species between zeolite particles in physical contact were visualized by fluorescence microscopy coupled with a particle manipulation technique. The luminescence color characteristics of particular zeolite particles originating from the specific photochemistry of adsorbed species was exploited to follow the migration of the molecules. Two examples are shown that are relevant to the visualization of the time-dependent migration process: A one guest-two sets of zeolite crystals system: chrysene (Chry)-loaded zeolite Na+ -X (the sodium form of zeolite X) crystals were placed in contact with unloaded Tl+ -X (thallium-exchanged X) crystals and allowed to stand at room temperature. Initially, the blue fluorescence of Chry was detected only from the Na+ -X particles, but later, the development of green phosphorescence emission was discernible from the Tl+ -X which suggests that Chry migrated from the Na+ -X to the Tl+ -X crystals. A two guest-species systems: Electron-donating Chry-loaded Na+ -X crystals were placed in contact with electron-accepting 1,2,4,5-tetracyanobenzene (TCNB)-loaded Na+ -X or Na+ -Y crystals. With time, the former system (Chry/Na+ -X and TCNB/Na+ -X) gave rise to the emission of Chry-TCNB charge-transfer complexes resulting mainly from the migration of Chry while the latter system (Chry/Na+ -X and TCNB/Na+ -Y) afforded the same emission resulting largely from the migration of TCNB. The present investigation reveals that there is a certain direction for guest migration depending on the zeolite host and the nature of host-guest or guest-guest interaction.     

Modular design of icosahedral metal clusters

The concept of crystalline module, that is, an unambiguously isolated, repeated quasi-molecular element, is introduced. This concept is more general than the concept of crystal lattice. The generalized modular approach allows extension of the methods and principles of crystallography to quasi-crystals, clusters, amorphous solids, and periodic biological structures. Principles of construction of aperiodic, nonequilibrium regular modular structures are formulated. Limitations on the size of icosahedral clusters are due to the presence of spherical shells with non-Euclidean tetrahedral tiling in their structure. A parametric relationship between the structures of icosahedral fullerenes and metal clusters of the Chini series was found.     

Subsolidus phase relations and crystal structure of compounds in the PrOx-CaO-CuO system

The subsolidus phase relations of the PrO_x-CaO-CuO pseudo-ternary system sintered at 950-1000°C have been investigated by X-ray powder diffraction. In this system, there exist one compound Ca₁₀Pr₄Cu₂₄O₄₁, one Ca₂Pr₂Cu₅O₁₀-based solid solution, seven three-phase regions and two two-phase regions. The crystal structures of Ca₁₀Pr₄Cu₂₄O₄₁ and Ca₂Pr₂Cu₅O₁₀-based solid solution have been determined. Compound Ca₁₀Pr₄Cu₂₄O₄₁ crystallizes in an orthorhombic cell with space group D_2h²⁰−Cccm, Z=4. Its lattice parameters are a=11.278(2) Å, b=12.448(3) Å and c=27.486(8) Å. The crystal structure of Ca₂Pr₂Cu₅O₁₀-based solid solution is an incommensurate phase based on the orthorhombic NaCuO₂ type subcell. The lattice parameters of the subcell of the Ca_2.4Pr_1.6Cu₅O₁₀ are a₀=2.8246(7) Å, b₀=6.3693(5) Å, c₀=10.679(1) Å, and those of the orthorhombic superstructure are with a=5a₀, b=b₀, c=5c₀. The Ca_2.4Pr_1.6Cu₅O₁₀ structure can also be determined by using a monoclinic supercell with space group C_2h⁵−P2₁/c, Z=4, a=5a₀, b=b₀, and β=104.79(1)° or 136.60(1)°, V=5a₀b₀c₀.     

Contribution to the techniques of enumeration ofKekulé structures

Four auxiliary classes of benzenoids are introduced, and formulas are given for their number ofKekulé structures (K). An enumeration method forK of different important classes of benzenoids is illustrated by examples. The utilization of essentially disconnected benzenoids is a special feature of the method.

---

Ein Beitrag zur Methodik der Bestimmung möglicherKekulé-Strukturen

Zusammenfassung Es werden Hilfsklassen von benzenoiden Aromaten eingeführt und Formeln zur zahlenmäßigen Auswertung möglicherKekulé-Strukturen angegeben (K). Die Auswertungsmethode fürK wird an verschiedenen wichtigen Klassen benzenoider Verbindungen exemplarisch gezeigt. Die Verwendbarkeit essentiell abgekoppelter aromatischer Bauelemente ist eine spezielle Eigenschaft dieser Methode.