Sulfonated polypropylene ionomers

Polypropylene ionomers have been prepared by sulfonation of copolymers of propene and 7 methyl, 1-6 octadiene, followed by neutralization to cesium salts. Both WAXS and SAXS were used to study the morphology of the samples, while their thermal properties were studied by DSC and their mechanical properties by DMTA. The sulfonation process is shown to cause a further drop in crystallinity in addition to the effect of comonomer incorporation. Ion clustering is observed when the extent of sulfonation is high enough, the limit being dependent on the copolymer composition. The ion pairs which are not incorporated into the cluster cause a small-angle upturn in the WAXS pattern. The mechanical properties are strongly affected by the drop in crystallinity, but may be partly recovered due to ion clustering. No disruption of the ion clusters is observed before thermal decomposition of the polymer.     

Solid Phase Synthesis of 4H-Pyrimido[2,1-b] Benzothiazol-4-ones from Resin-Bound Cyclic Malonic Ester

The solid phase synthesis of 4H-pyrimido[2,1-6] benzothizaol-4-ones has been reported.     

Where are the Sn atoms in LaSb2Snx, 0.1?x?∼0.75?

The composition range and (composite modulated) structure of compounds within the wide range non-stoichiometric LaSb₂Sn_x, 0.1?x?0.75, solid solution is carefully investigated via a combined electron diffraction, XRD and electron probe microanalysis study. Evidence for metastability of the LaSb₂Sn_x phase at the low x composition end of the solid solution is presented. Direct evidence is found for a reasonably (although by no means perfectly) well ordered Sn sub-structure which is, in general, mutually incommensurable with respect to a very well ordered underlying LaSb₂ sub-structure along both a and c directions. The overall (3+2)-d superspace group symmetry is given along with a discussion of the consequences as regards the arrangement of the Sn atoms. The Sn sub-structure c-axis cell dimension shows very little variation with composition x providing direct experimental evidence of the importance of Sn-Sn metallic bonding (along one-dimensional [001] Sn strings) for the stability of the phase.     

Conformational changes of the amyloid beta-peptide (1-40) adsorbed on solid surfaces

The conformational change of the 39-43 residues of the amyloid beta-peptide (Abeta) toward a beta-sheet enriched state promotes self-aggregation of the peptide molecules and constitutes the major peptide component of the amyloid plaques in Alzheimer patients. The crucial question behind the self-aggregation of Abeta is related to the different pathways the peptide may take after cleavage from the amyloid precursor proteins at cellular membranes. This work is aiming at determining the conformation of the Abeta (1-40) adsorbed on hydrophobic Teflon and hydrophilic silica particles, as model sorbent surfaces mimicking the apolar transmembrane environment and the polar, charged membrane surface, respectively. The mechanism by which the Abeta interacts with solid surfaces strongly depends on the hydrophobic/hydrophilic character of the particles. Hydrophobic and electrostatic interactions contribute differently in each case, causing a completely different conformational change of the adsorbed molecules on the two surfaces. When hydrophobic interactions between the peptide and the sorbent prevail, the adsorbed Abeta (1-40) mainly adopts an alpha-helix conformation due to H-bonding in the apolar part of the peptide that is oriented towards the surface. On the other hand, when the peptide adsorbs by electrostatic interactions beta-sheet formation is promoted due to intermolecular association between the apolar parts of the adsorbed peptide. Irrespective of the characteristics of the solid sorbent, crowding the surface results in intermolecular association between adsorbed molecules leading to a strong aggregation tendency of the Abeta (1-40). [Diagram: see text] CD spectra of Abeta (1-40) at pH 7: A) in solution ([Abeta]=0.2 mg.ml(-1)) freshly prepared (line) and after overnight incubation (symbols);B) on Teflon (Gamma=0.5 mg.m(-2)).     

Copper Solid Amalgam Electrodes

This work describes the behavior of copper solid amalgam electrodes (CuSAE). The applied potential range has been compared with that of the silver solid amalgam electrode (AgSAE) and the hanging mercury drop electrode (HMDE). In 0.05 M tetraborate buffer the applicable potential range of CuSAE is+0.945 V to ?1.75 V excluding ?0.2 V to ?0.5 V, where the anodic oxidation of copper occurs. CuSAE does not need other than electrochemical pre‐treatment, which has been documented by the evaluated repeatability of eleven voltammetric curves of Cd²⁺ (0.1 ppm), Pb²⁺ (0.1 ppm) and Mn²⁺ (0.5 ppm). The obtained results showed that CuSAE could substitute the solid copper, amalgamed copper or liquid copper amalgam electrodes, and can be applied for the study of systems needing an addition of Cu²⁺ ions into the measured solution.     

Effect of nature of support and impregnating agent on lipophilicity determination for nonionic surfactants by reversed-phase thin-layer chromatography

Summary The retention of 9 nonylphenyl ethylene oxide oligomers was determined in 15 reversed-phase chromatographic systems using silicone oils of various molecular mass as impregnating agents and silica, cellulose and alumina supports. The data were evaluated with principal component analysis carried out on the covariance and the correlation matrices. The R_M values did not follow the additivity rule and they did not change linearly with increasing length of the ethylene oxide chain. This is probably due to the folded state of the chain in the eluent. The molecular mass of the silicone oils had a negligible effect on the retention whereas the retention increased with increasing level of impregnation. The support considerably influenced the lipophilicity values of these nonionic surfactants and cellulose seemed to be the most appropriate support. Calculations proved that the application of a correlation matrix may cause data distortion; therefore, the use of a covariance matrix is strongly proposed.     

Lattice Dynamics in LaTa2-2xNb2xVO9-δ (x=0–0.1) Solid Solutions

The oxygen nonstoichiometry (x) of LaTa_2-2xNb_2xVO₉- (x = 0–0.1) solid solutions was studied using Xray phase analysis, vibrational spectroscopy, and radiospectroscopy. A correlation was found between (x) and the unit cell volume V(x) of the solid solutions. It was shown that the infrared spectra of LaTa₂VO₉- change in passing from = 0 to 0. The structural position of the oxygen vacancy in LaTa_2-2xNb_2xVO₉- is discussed.     

Indirect thermal lens detection for capillary electrophoresis

Thermal lens detection with a 325.0 nm He-Cd excitation laser is used for thermooptical indirect detection in combination with the capillary electrophoretic separation of organic anions. The optimization of indirect thermooptical detection is discussed. With Mordant Yellow 7 (an azo dye) chosen as a probe ion limits of detection for 1-heptane-, 1-pentane-, 1-butane-, 1-propanesulfonic, and acetic acid at a level of n × 10⁻⁷ M were achieved with a separation electrolyte containing 50 μM of the probe ion and 5 mM Tris pH 9.90. A further increase in the detection sensitivity (twofold decrease in the limit of detection ) was obtained with a separation electrolyte containing a volume fraction of 20% acetonitrile.     

The Enhancement of Efficiency of High-order Harmonic in Intense Laser Field Based on Asymptotic Boundary Conditions and Symplectic Algorithm

Asymptotic boundary condition (ABC) of laser-atom interaction presented recently is applied to transform the initial value problem of the time-dependent Schrödinger equation (TDSE) in infinite space into the initial and boundary value problem in the finite space, and then the TDSE is discretized into linear canonical equations by substituting the symmetry difference quotient for the 2-order partial derivative. The canonical equation is solved by symplectic algorithm. The ground state and the equal weight coherent superposition of the ground state and the first excited state have been taken as the initial conditions, respectively, while we calculate the population of bound states, the evolution of average distance and the high-order harmonic generation (HHG). The conversion efficiency of HHG can be enhanced by initial coherent superposition state and moderate laser intensities