Screening an In-House Isoquinoline Alkaloids Library for New Blockers of Voltage-Gated Na+ Channels Using Voltage Sensor Fluorescent Probes: Hits and Biases

Voltage-gated Na⁺ (Na_V) channels are significant therapeutic targets for the treatment of cardiac and neurological disorders, thus promoting the search for novel Na_V channel ligands. With the objective of discovering new blockers of Na_V channel ligands, we screened an In-House vegetal alkaloid library using fluorescence cell-based assays. We screened 62 isoquinoline alkaloids (IA) for their ability to decrease the FRET signal of voltage sensor probes (VSP), which were induced by the activation of Na_V channels with batrachotoxin (BTX) in GH3b6 cells. This led to the selection of five IA: liriodenine, oxostephanine, thalmiculine, protopine, and bebeerine, inhibiting the BTX-induced VSP signal with micromolar IC₅₀. These five alkaloids were then assayed using the Na⁺ fluorescent probe ANG-2 and the patch-clamp technique. Only oxostephanine and liriodenine were able to inhibit the BTX-induced ANG-2 signal in HEK293-hNa_V1.3 cells. Indeed, liriodenine and oxostephanine decreased the effects of BTX on Na⁺ currents elicited by the hNa_V1.3 channel, suggesting that conformation change induced by BTX binding could induce a bias in fluorescent assays. However, among the five IA selected in the VSP assay, only bebeerine exhibited strong inhibitory effects against Na⁺ currents elicited by the hNav1.2 and hNav1.6 channels, with IC₅₀ values below 10 µM. So far, bebeerine is the first BBIQ to have been reported to block Na_V channels, with promising therapeutical applications.     

海藻酸钠-壳聚糖-海藻酸钠生物微胶囊的制备

采用两步法制备了海藻酸钠-壳聚糖-海藻酸钠(ACA)生物微胶囊,并考察了氯化钙浓度、海藻酸钠浓度、壳聚糖浓度及其pH值以及柠檬酸钠溶液pH值对微胶囊性能的影响.实验结果表明:胶囊粒径随氯化钙浓度和海藻酸钠浓度的增加而增大,胶囊的膜厚随壳聚糖浓度的增加而增厚,随壳聚糖溶液pH值的增加而降低;而在胶囊液化处理过程中,柠檬酸钠溶液的pH值对微胶囊的机械强度有很大的影响.当氯化钙浓度为1.5%,海藻酸钠浓度为2%,壳聚糖浓度和pH值分别为1.5%和5.0及柠檬酸钠溶液的pH值为7.2时,可制得粒径为2.65mm、机械强度为150mN的ACA生物微胶囊.     

Comparing Efficiency of Lysis Buffer Solutions and Sample Preparation Methods for Liquid Chromatography–Mass Spectrometry Analysis of Human Cells and Plasma

The use of a proper sample processing methodology for maximum proteome coverage and high-quality quantitative data is an important choice to make before initiating a liquid chromatography–mass spectrometry (LC–MS)-based proteomics study. Popular sample processing workflows for proteomics involve in-solution proteome digestion and single-pot, solid-phase-enhanced sample preparation (SP3). We tested them on both HeLa cells and human plasma samples, using lysis buffers containing SDS, or guanidinium hydrochloride. We also studied the effect of using commercially available depletion mini spin columns before SP3, to increase proteome coverage in human plasma samples. Our results show that the SP3 protocol, using either buffer, achieves the highest number of quantified proteins in both the HeLa cells and plasma samples. Moreover, the use of depletion mini spin columns before SP3 results in a two-fold increase of quantified plasma proteins. With additional fractionation, we quantified nearly 1400 proteins, and examined lower-abundance proteins involved in neurodegenerative pathways and mitochondrial metabolism. Therefore, we recommend the use of the SP3 methodology for biological sample processing, including those after depletion of high-abundance plasma proteins.     

Sargassum fusiforme Polysaccharide-Based Hydrogel Microspheres Enhance Crystal Violet Dye Adsorption Properties

In this study, a polysaccharide-based hydrogel microsphere (SFP/SA) was prepared using S. fusiforme polysaccharide (SFP) and sodium alginate (SA). Fourier transform infrared spectroscopy (FT-IR) demonstrated that SFP was effectively loaded onto the hydrogel microsphere. Texture profile analysis (TPA) and differential scanning calorimetry (DSC) showed that, with the increase of SFP concentration, the hardness of SFP/SA decreased, while the springiness and cohesiveness of SFP/SA increased, and the thermal stability of SFP/SA improved. The equilibrium adsorption capacity of SFP/SA increased from 8.20 mg/g (without SFP) to 67.95 mg/g (SFP accounted 80%) without swelling, and from 35.05 mg/g (without SFP) to 81.98 mg/g (SFP accounted 80%) after 24 h swelling. The adsorption of crystal violet (CV) dye by SFP/SA followed pseudo-first order and pseudo-second order kinetics (both with R² > 0.99). The diffusion of intraparticle in CV dye was not the only influencing factor. Moreover, the adsorption of CV dye for SFP/SA (SFP accounted 60%) fit the Langmuir and Temkin isotherm models. SFP/SA exhibited good regenerative adsorption capacity. Its adsorption rate remained at > 97% at the 10th consecutive cycle while SFP accounted for 80%. The results showed that the addition of Sargassum fusiforme polysaccharide could increase the springiness, cohesiveness and thermal stability of the hydrogel microsphere, as well as improve the adsorption capacity of crystal violet dye.     

In Vitro–In Vivo Correlation of Tianeptine Sodium Sustained-Release Dual-Layer Tablets

Tianeptine tablets are currently marketed to be designed for immediate-release tablets. The tianeptine has a short half-life, making it difficult to design for sustained-release tablets and achieve bioequivalence with the tianeptine immediate-release tablet (Stablon^®). We established the in vitro–in vivo correlation (IVIVC) of three formulations of tianeptine sustained-release tablets according to their granule size. To evaluate sustained drug release, in vitro tests were performed in pH 1.2 media for 24 h. In vivo pharmacokinetic analysis was performed following oral administration of reference drug and test drug to beagle dogs. The dissolution profile revealed delayed release as the size of the granules increased. The dissolution results were confirmed in pharmacokinetic analysis, showing that the half-life was delayed as granule size increased. The final formulation and reference drug showed an equivalent area under the curve (AUC). Through this, IVIVC was established according to the size of the tianeptine sodium granules, which is the purpose of this study, and was used to predict in vivo pharmacokinetics from the formulation composition. This approach may be useful for determining optimal formulation compositions to achieve the desired pharmacokinetics when developing new formulations.     

Improvement of Biological Effects of Root-Filling Materials for Primary Teeth by Incorporating Sodium Iodide

Therapeutic iodoform (CHI₃) is commonly used as a root-filling material for primary teeth; however, the side effects of iodoform-containing materials, including early root resorption, have been reported. To overcome this problem, a water-soluble iodide (NaI)-incorporated root-filling material was developed. Calcium hydroxide, silicone oil, and NaI were incorporated in different weight proportions (30:30:X), and the resulting material was denoted DX (D5~D30), indicating the NaI content. As a control, iodoform instead of NaI was incorporated at a ratio of 30:30:30, and the material was denoted I30. The physicochemical (flow, film thickness, radiopacity, viscosity, water absorption, solubility, and ion releases) and biological (cytotoxicity, TRAP, ARS, and analysis of osteoclastic markers) properties were determined. The amount of iodine, sodium, and calcium ion releases and the pH were higher in D30 than I30, and the highest level of unknown extracted molecules was detected in I30. In the cell viability test, all groups except 100% D30 showed no cytotoxicity. In the 50% nontoxic extract, D30 showed decreased osteoclast formation compared with I30. In summary, NaI-incorporated materials showed adequate physicochemical properties and low osteoclast formation compared to their iodoform-counterpart. Thus, NaI-incorporated materials may be used as a substitute for iodoform-counterparts in root-filling materials after further (pre)clinical investigation.     

Metal-free synthesis of (E)-vinyl sulfones via denitrative coupling reactions of β-nitrostyrenes with sodium sulfinates

Abstract

A practical metal-free procedure for the synthesis of (E)-vinyl sulfones has been developed through the coupling of β-nitrostyrenes with sodium sulfinates under microwave irradiation. This methodology provides a convenient and efficient approach to various (E)-vinyl sulfones from readily available starting materials with excellent regioselectivity. The present oxidative reaction involves an efficient denitrative radical cross-coupling of β-nitrostyrenes with sodium sulfinates via using AcOH as an additive.     

Microwave-Assisted Direct Synthesis of 4H-1,2,4-Benzothiadiazine 1,1-Dioxide Derivatives

Abstract

We describe a rapid and convenient methodology for the preparation of diverse 3-aryl and 3-trifluoromethyl 4H-1,2,4-benzothiadiazine-1,1-dioxides in a one-pot microwave-promoted reaction between 2-aminobenzenesulfonamides and benzaldehydes, trifluoroacetic acid or benzoic acids.

GRAPHICAL ABSTRACT